Santa Fe (CM - 2007-12) :: Right Turn Signal And Bulbs On Steady All The Time
Jan 31, 2015
I'm trying to figure out what has failed on my 2008 Santa Fe.
After stopping at a gas station today, my right turn signal came on and stayed on. By this I mean that the right turn arrow on the dash is illuminated and both the front and rear right turn signal bulbs are illuminated. They are all on steady, not flashing. Moving the turn signal stalk/switch does nothing. They all stay on when the car is turned off and the key removed. I have to disconnect the battery to get them to shut off. I tried pulling the turn signal, hazard and cluster fuses in the dash, but they had no effect. The switch for headlamps/park lights has no effect on the right side bulbs.
The left turn signal works normally.
Also, it may be related to having unplugged the battery a couple of times, but now the CD player shows "initializing" and I can't use it. The am/fm stereo works normally.
View 19 Replies
Advertisement
My 2007 Hyundai Santa Fe right hand turn signal light bulbs flash rapidly both in the front and rear, the left hand side is normal. I am trying to locate the turn signal flasher module but without any luck, looked under the dash in the fuse box and under the hood in the relay box. Is it in the relay box...
View 7 Replies
Over the past year we have been noticing that the HVAC blower doesn't turn on from time to time. All settings in the control panel seem normal and the fan speed is turned on. Most of the time everything is working normally, sometimes when the car starts the blower isn't working and then starts after a minute of driving. Sometimes I notice the blower isn't working and I turn up the fan speed and after a few clicks it starts working normally for the remainder of the drive. And then sometimes the blower doesn't ever start and I need to turn off and restart the car a few times. When the blower hasn't been working the a/c compressor has been turning on, something in the blower circuit is failing.
There are five possibilities:
The HVAC controller isn't telling the blower to turn on
The power relay isn't always working
There is a wiring or connection problem
The blower motor itself isn't working
The power mosfet is failing.
What needed to be replaced?
View 2 Replies
I picked up a set of harley davidson look-a-like headlights online for my 05. I go to install them and when I tighten them up it causes the turn signal bulbs to push in towards the fender on both. I put my hand back there and it feels like the bulb socket is being forced against the header panel assembly. Am I missing something?
View 2 Replies
I have a chevrolet optra 2007 and the hazard lights won't work unless the turn signal (left or right) is switched on at the same time. Turn signals work perfectly fine.
View 7 Replies
2007 Santa Fe. Recently my turn signal has not been working. It seems to act finicky and not want to work every time I need it too. I noticed that this happened once every blue moon in the winter time when I purchased the vehicle new back in '07. However it has been occurring more frequently as of the past 3 days.
I have checked the fuse and it is fine. My hazard signals work when my turn signal works if that is any additional indication of what might be going on. What can be done to remedy the situation?
View 24 Replies
I've changed out all of my external lights for led's, including the turn signals. I had planned on replacing the turn signal relays with led comparable versions but have been unable to find the relays in the fuse boxes. The box that does the actual clicking under the dash seems like it could be it but it looks completely proprietary to this model, and not readily available in the compatible version.
I ended up installing resistors for now but that's caused other problems with my lights. Now when I turn my high beams on all 4 turn signals light up solid and I am unable to use them until I turn the highs off.
So, I would love to know if I do have a relay replacement option for my 2012 Santa Fe...
View 1 Replies
All my turn and hazard signals work normally when engaged but when it snaps back into the off position the turn signal (sound only) keeps going rapidly. It goes on and off randomly. It's the sound in the dash only. What it is? I can replace it myself I just need to figure out what it is.
View 44 Replies
My wife's '07 has that fast-blink thing going on with the left turn signal. The thing is, none of the bulbs are out. It does appear that the front ones are dimmer than the ones on the right (which work fine).
View 8 Replies
I cant find the location of the Turn signal relay, its not in the Relay box under the hood nor is it on the fuse panel under the dash, i'm planning on installing LED blinkers and i want to switch out the relay to a LED compatible one, where it is?
2008 Santa Fe GLS ....
View 8 Replies
I want to install some LED turn signal bulbs and lights but the flasher will flash twice as quick because of the burnt-bulb detector.
I have taken the flasher apart and tried all the tricks on the book to isolate each pin on the IC and changed the timing resistor without avail. I do not want to put in load resistor on the bulb end to fool the detection circuit.
I want to modify/cut off the detection circuit?
View 14 Replies
I need detailed instructions for how to replace the right (passenger's side) rear turn signal bulb socket and the subassembly that holds the remaining bulbs and inserts into the tail light assembly. I've done this once before successfully but now can't seem to make it work now.
Without the subassembly inserted and locked into place with its locking tabs, the turn signal bulb locks into place in its socket, and that socket in turn easily inserts and locks into place in the hole in the outboard corner of the lens through the rear of the lens assembly. However, I can't seem to install both the turn signal bulb in its socket and the subassembly that holds the rest of the bulbs. The two contacts on the underside of the rim of the turn signal bulb socket would indicate that that the socket installs after the subassembly, but then it has nothing to plug into. When it's installed first, I don't see how the bulb would be energized.
The owner's manual of course says to have the dealer handle maintenance in this area.
View 1 Replies
I have been reading threads all day. Noone seems to have exactly the same issue so I'm just looking for some clarification. Turn signals dont work but lights work as "parking lamps" and internal climate lights are not illuminating either. Also, my blinkers making the clicking noise but much faster when the turn signal bulbs are not flashing. I had a radio issue but that is resolved. Where do I start? Do I go right for the hazard relay? I read somewhere there was an ignition relay that could potentially be causing all of this?
View 7 Replies
What are the steps involved in replacing my fog light bulbs? One burned out. And what's the correct bulb replacement number?
View 5 Replies
I was on the way home tonight and I noticed the driver side HID headlight turn off after putting my turn signal on.
I have LED DRL fog lights installed and they're wired with no relay and plugged into the Engine Compartment fuse box. The installer connected them on the left side (where the wires come in, from the two black components by the air filter).
Could this wiring setup be interfering with the HID's?
View 9 Replies
I see a lot of VW Passat 2006 who have the turn signal lights on all the time, like this. How do I get them like that?
View 10 Replies
Right turn signal stays on all the time. What's up?
View 2 Replies
Last oil change at the dealer (they're free) I informed the service desk of some knocking and grinding noises that are happening from time to time in the front end.. and fluid in the driveway.. they did the oil and said they saw nothing... so I have to go back next week for my last free oil change and before I made the appointment, I dropped in to see my regular mechanic.. steering rack is leaking on the passenger side and has been for a while as the fluid is down to the minimum line in the reservoir.
Made the appointment with the dealer, informed them about the noise again and fluid on the driveway.. again. Let's see what they say this time.
View 9 Replies
2012 F250 left turn signal on all the time no right turn signal.
View 2 Replies
I could not find a picture of the 2013+ SFS headlight harness connector. I'm trying to wire a 6 ohm resistor across the turn signal as my LED upgrade is causing the fast flash problem(I expected this). The only place I can tap into that circuit is probably the headlight harness, preferably through the connector. I tried to measure the voltage on the connector, but the contact is too small and narrow for the probe to make physical contact. I even tried to put a cutout paper clip into those tiny holes, but still no dice. The wire colors are different between driver and passenger side, and the Sonata forum was indicating it is the top right corner for the positive lead of the turn signal. Which wire is the + & - for the turn signal.
View 14 Replies
2004 Santa Fe 2.7L
When the headlights are on the left turn signal stays on(but does not blink). The right turn signal functions ok. With the headlights off both signals function normally. The headlights work correctly.
This issue happened once a year ago but just started reoccurring two days ago.
View 13 Replies
