Santa Fe (CM - 2007-12) :: Power Failure Upon Starting
Feb 21, 2012
The past two days my 2008 Santa Fe has been exhibiting power failure upon starting. When the ignition is switched on then to start all power is lost immediately with no start nor crank. I hear a metallic click seemingly too light a sound for a starter solenoid but since this has not happened before it could be a solenoid sound. All power is lost including dash and marker lights. After about 5 seconds or so the marker lights and dash will return and the car will start normally. I expect a circuit breaker is resetting. This has happened three starts in a row at least eight hours apart. This morning the dash clock was 8 or so hours behind but the car started normally. 62k on the car.
View 6 Replies
Advertisement
This car is turning out to be a huge disappointment. Bad battery right away, oil pressure switch, brake lamp switch, front driver seat guide rails broken and now premature shock failure.
I had taken the SF to get a tire plugged after vacation as I had picked up a nail. The car was a bit noise riding along the way home, but I just chalked it up to crap Manitoba roads. The tech who fixed my tire showed me the oil leaking from both front shocks.
Told me that the driver side was pretty much 100% pooched. 2011 with only 42,000 KMs. On top of the other things this car has needed, I am ready to trade it in for a truck. A truck will meet our needs much better.
View 4 Replies
At 37000km we put new tires on and after about 1000km started to hear a high 'woo-woo-woo', from the rear, not really loud but a new noise. Guessing it might be tire noise I checked them for wear and thought the left rear was a bit sharp sliding your hand one direction but smooth sliding across the other way. Went for an alignment....it was only slightly off and the mechanic found the right rear wheel bearing was kaput.
It was done under warranty......but, do these vehicles are subject to premature bearing failure or was this a fluke? I did not see the bearing so I don't know if it was one of two or a pressed-on type or whatever. It would be nice to know that a wheel won't come flying off or seize up when we're halfway to nowhere if a bearing goes bad again.
View 16 Replies
Electric power steering failing when starting the car and driving right away without warming it up?
My 2009 ISF has recently started doing this occasionally. It was when I started the car for the first time of the day, and pulled away within 10 seconds or so. When I let it "warm up" for a minute I have not had it happen.
But the thing is, I've had the car for a few months and have never had this happen until now. My mechanic plugged it in to the computer and there are no codes up, or in the history.
View 14 Replies
Having problem with their Electronic Power Steering (EPS)? My new 2011 Sonata SE's EPS failed numerous times at ~500 miles. Failures all occurred shortly after starting the car when it had been sitting for a couple of hours. The EPS and ESC fail lights came on and I lost my power steering when I tried to make my first turn. The problem always cleared when I shut the car off and restarted. My dealer service department reset the computer in the steering column and noted that this is the first time they've had to work this sort of problem. Hopefully that fixed it for good...two days so far with no problems. Maybe a software glitch?
View 12 Replies
My 2008 Santa Fe (3.3 2WD) produces a knocking sound from the front every time I go on a bump while the wheel is turned. I can pretty much reproduce it at will. Occasionally, I hear the same sort knock from the rear as well, but I cannot confirm that it is consistent.
I do suspect that something is wrong with the struts. The only issue is that the car has 67k KM (41k miles), and to me, that seems a little early for that sort of thing to happen. My driving is pretty standard on standard roads, although winters up here tend to produce potholes that I sometimes cannot avoid.
I've had my struts fail on my last car (2000 Mazda Protege), but that was 9+ years old and with almost 3 times as much mileage on it.
View 2 Replies
Well its the coldest this SF has endured while in my barn. It was -23C last night or early this morning went we got up. -19C now but it doesn't warm up with a slight change sitting outside. I started it ok but these newer vehicles sure make a lot of whining and other noises when its this cold until they run for a minute they quiet down.
My old Grand Cherokee was a lot quieter even with near 300k on it it. But my wife's Jeep Compass a 2009 made enough noises as well. Both have synthetic oil in them. I just don't like hearing all that and wonder what its like for you that are in much colder climate with your SF since -30 to -40C is common in other parts of Canada in the Winter. Just curious because it cannot be good and the PS pump must be one of the complainers I am sure.
View 13 Replies
My santa fe just recently quit starting. Thought it was a bad battery and I replaced it but it didn't work. When I try to start the relay clicks like low voltage but I am measuring the battery voltage while trying to start and it doesn't drop. After trying to start the instrument lights go out and the key chime quits beeping. Remote key locks work but the horn doesn't sound if I click lock twice. I have measured the battery voltage from Battery plus the the frame and the voltage is good during the start attempt. If I measure the battery voltage from battery plus to the engine as ground there is no voltage. I have tried to jumper the engine block to the frame and still the relay just clicks during start.
View 2 Replies
My 2009 awd SF is less than 4 years old and has about 81500 km on. In the past few days, I start to feel a little hesitation while starting the car. I have an incident today in which the car barely turn over - behaved exactly as if the battery is dying. Took it to the dealer and spent 55$ for a diagnosis => alternator is OK (what a relief) but the battery is weak. I do not think battery would die (stop holding charge) this soon. I expect at least 5-6 years of service from a battery.
View 31 Replies
It seems like I have to jiggle the steering wheel, about 1/2 the time, to get my ignition key to turn to the start mode. I've owned quite a few other vehicles and this has happened occasionally on some of the others, but never as often as with the SF.
View 6 Replies
My 2009 Santa Fe (2.7 L V6 GL, 5 months old 7500 kms) just recently started making some very pronounced knocking noises on startup when the engine is cold. It never did this before and only lasts a minute or less, it's not that the engine itself is very cold since I keep it in a heated garage all the time when it's home, but when the engine is starts first thing in the morning it's very noticeable.
I have an appt. at a dealership tomorrow to get it checked, outside of an oil change I never dealt with these guy's before. What it could be? It's full of oil which they just changed 4 weeks ago.
View 34 Replies
My car has less than 500 miles on it. Yesterday when I started it, I heard a knocking sound. I only put 87 octane gas in the car as the manual said 87 or higher. I don't know if I made a mistake putting 87 in there.
View 4 Replies
I'm a Santa Fe owner since I bought a 2007 2.2CRDI 4 wheel drive model in 2008. It's been a great machine with over 340000 Km on the clock.
This motor has caused no problems until now, and oil & filter changed as specified. This motor had never needed engine oil top-ups until recently, and my tale of woe started about two weeks ago when I got a "sump level low" light when stopped on a steeply inclined drive. I stopped the engine and rolled back to flat ground where the light disappeared on re-start. I duly topped up the engine oil, and it took about two litres to bring it up midway on the dipstick.
All seemed ok until about a week later I spotted a longer than usual shut-off of the oil pressure warning light, and over a period of three maybe five startups from cold it has gone from a delay of two seconds to five, even six. The oil in use is a 10/40, so clearly that will suit cold starts best. Once the light has gone out it stays out, even after a long drive though a short stop/start will show a delay of up to a second before the light goes out. The engine still sounds smooth with no rattles that might associate oil starvation.
My mechanic thinks it may be the oil strainer in the sump, or worst case scenario the oil pump. There has been a whining noise from the engine for some time which raises with the engine rev's, and this seems (according to some blogs) maybe to be associated with oil pump wearing out?
View 14 Replies
Well, even though I love my 2010 SF SE I have had a few issues. I've had my power steering pump replaced twice and now I'm hearing a clunky/creaky noise coming from the right from wheel. I"m thinking it is a sticky caliper. It happens most frequently when I am just starting out from having the car parked for a while. When I put my foot on the brake and then release it I get the noise. It seems to go away after I have been driving a while.
Can't say I ever had this much trouble with my previous generation SF. Nothing major but annoying none the less. BTW I have just under 30k miles.
View 1 Replies
UK 2.2 Diesel
Problem for about 3 years. Always starts in neutral, rarely starts in park.
Any possible cause. Maybe a micro switch or a cable adjustment.
View 8 Replies
I have year 2011 santa fe, while mileage after 7000km, i have problem in air-cond, when i returned to my car within 3 minute to 5 minutes and start engine i can smell some source of chemical smell from air-cond for 3 second, why ? if i started engine after an hour then there is no smell, why ?
View 5 Replies
The 2007 my wife drives has no power assisted steering as of yesterday. This afternoon I drove it around the neighborhood and yup, its like driving a 42 DeSoto.
The red triangle is on the dashboard
NO CEL
NO MFD message - everything is normal
Plugged in my ScanGauge II and there are no DTC codes. Am I correct that this is a failed steering ECU?
View 5 Replies
I have a 2007 Chev Tahoe. Description of Problem: Past month engine light came on. Then some days for a short time will go off. When light is on the auto start wont work. Battery has been drained so today I changed the battery and have a total electrical power system failure. Zero power to anything. Last month I put a scanner on it but i didnt save the code. It was related to a "throttle body module" i think. Have been reading about the BCM also so im at a complete loss...
View 4 Replies
The EPS on my 07 Elantra has failed, the steering is very stiff and the EPS light is on. On occasion in the past, the EPS light has come on but started working again after restarting the vehicle. Now the light comes on as soon as I turn the key.
How should I proceed? I don't mind spending a few hundred on a fix that may not work. Is it likely to be a torque sensor / input sensor problem similar to the EPS recall on 2008-2010 Elantras? Are there other electrical issues that could cause this?
View 3 Replies
i drive a 2007 XC90 V8 with 76000miles and recently i got a power system failure message and battery light went on , so took it to my mechanic and he tested the car and it was tuning out 11volts so he concluded it was the alternator, so he recommended changing the regulator and i got a new regulator made by Bosch and it was installed and upon starting the message came back on and the battery light as well and upon testing it was producing 15.4volts , now its overcharging , what do i need to do ? should i buy another regulator ? as my mechanic says alternators hardly ever get damaged but the regulator is the one that usually gets damaged...
Attached File(s) :
- regulator1.jpg ( 314.57K )
- regulator_2.jpg ( 290.61K )
View 3 Replies
Bought my Santa Fe GLS less than 2 months ago and ran fine. Last week, went to store no problems and then went out 5 minutes later, put it in reverse and it stalled. I go to the store, and it lacks MAJOR power.
Now, if I leave it alone for a while it will normally start right up. While idling, everything seems fine. Then my "ghost" takes over the vehicle making it less responsive to the gas pedal. Also, at 3000 rpm, it sounds like its skipping a cylinder. When reading the gauge, it skips between 3000rpm to abut 2800 rpm.
View 6 Replies
