Santa Fe (CM - 2007-12) :: Oil Light While Braking Hard
Jan 13, 2013
2011 Santa Fe with 3.5L V6 and AWD, 38000 Kms:
Very recent work (last month or so) - new battery (old one had a bad cell), brake light switch and for a repair of the seat adjustment bar (not sure what it is called). The most recent oil change was done by me in November and I have only put about 1600 kms on it since. I put 5W20 Castrol Syntec and a made in Korea WIX filter. I fill the oil to just a hair below the top dot on the dip stick. I torque everything properly.
OIL LIGHT PROBLEM:
When I was driving home from work this evening, I had to brake a little harder than I normally would when I was turning into the back lane (about 8 houses from my house). I thought I saw the oil light come on, but I wasn't sure. I continued down the lane when someone walked out in front of me and I had to brake again. This time, the oil light did come on for sure and then went off when I took the brakes off. It was -20 C outside, so I continued to my house which was now 4 homes away. I braked to go into my (heated!) garage and the light came on again as soon as I touched the brakes.
I decided to let the car sit for an hour to get an accurate reading on the dip stick. I checked it and the level read exactly where I had filled it - just a touch below the top dot. I took the oil filter out to check that it was still seated properly and was not obviously clogged. It looked just fine. No signs of any leaks in the engine compartment or under the vehicle. I decided to take the car out again to go around the block - maybe not a great idea. The light didn't come on again when I braked until the vehicle had warmed up again.
What could the problem be?
I guess I need to take it in, but I start work at 7 AM and my wife is on maternity leave and she needs a car tomorrow. So, this means me taking the Yaris is out. She can't take the Santa Fe to the dealer with my infant son and so I guess I have to get it towed. This is bullshit. This POS has been in the shop several times since November.
View 25 Replies
Advertisement
Driving 30 mph, oil light came on, immediate loss of power braking and steering. Engine did not stop, oil light disappeared yet still had loss of power steering and brakes. Still in D. Policeman had to stand on brake pedal to get into Park so that engine could be turned off. Towed to dealer in next state and dealer said cannot replicate so cannot fix.
Car is 2012 Santa Fe w/ less than 6,000 miles on it.
View 2 Replies
My son brought his 2007 Santa Fe over to troubleshoot a squeak upon braking. It took about an hour, but I isolated it to the braking switch. Took it out and attempted to lubricate the plunger. So for some dollars and a trip to the store and the squeak is gone. Just thought I would post this if others have an annoying squeak and don't know where to start.
View 11 Replies
My 2007 Prius brakes extremely hard at low speed (while I am applying the same amount of pressure). While decelerating, I let the regen braking do most of the work until I get to about 10mph, then I press the brake so I will have equal pressure until I stop. When I get to about 5mph I feel almost a lunge where the brakes aren't working as hard and then the brakes take hold extremely hard. My prius has been doing this for awhile not depending on the weather, but I finally noticed it worse than normal yesterday when it was raining and my car braked hard and actually skid and the traction control light came on.
View 19 Replies
Whenever I step on the brakes the lights on the instrument panel go out. When I take my foot off the brake they come back on. When I use the right blinker they blink. They do not blink when I use the left. What is this?
View 4 Replies
I have a 2010 Santa Fe AWD, I notice that when I apply the brakes at 100 KM or higher I hear a 'thumping' noise, the noise is hard to describe, thumping is the best I could come up with, the noise goes away once the vehicle is down to 80 KM, why this is?
View 7 Replies
2007 SF SE 3.3, approaching 60,000 miles. I'm feeling a front steering wheel shimmy on "heavy" braking, as in a recent trip into the Adirondack mountains with twisty roads.
View 5 Replies
I slammed on my brakes the other day because a car pulled out in front of me. When i let off the brakes i noticed the car did not move for a good 1-2 seconds and a traction control light was flashing. I didn't think much of it until i was sitting at a light and decided to see what happens if i press my brake pedals in hard again... the traction light turns on again and the car doesn't move when brakes are disengaged for a few seconds. Is this normal? It feels like my hill assist on the BMW. Why the traction light turns on? My car is a 2010 Prius III with 5k miles.
View 5 Replies
2007 Santa Fe, hard to start after fueling up, after that one time it cranks fine until I fuel up again.
View 1 Replies
I need to know if this is considered "normal" behavior of the transmission. This cold morning while driving in traffic the car just jerked really hard while shifting from 3rd to 2nd and as described in other threads its like someone rear ended the car.
It has only 2650 km, it's a 2012 2.4 6sp automatic 4wd Santa Fe, should I waste my time going to the dealer? It only happened once, no engine light no nothing. Could it be just a "glitch" in the ECM? I read some other threads before posting, but they were a bit older. Has experienced such a shifting bang under low speed with so little mileage?
View 7 Replies
The vehicle has 80,000kms, and from a cold start it is having this problem more and more frequently. I must crank the engine 3+ times, and then she starts. A prolonged cranking period doesn't seem to work, and this only occurs when cold. The car starts fine when warmed up. I have scanned the car with a generic OBD2 reader and there are no codes. Once the car is running, it runs great with no misfires.
View 1 Replies
I'm experiencing a weird problem with my 09 Santa Fe (just under 15k miles). A few times, while in slow and heavy traffic (and ONLY then) I experience a hard jolt or jerk. The 1st time it happened I thought someone had hit me in the rear but that was quickly ruled out.
I suspect this has something to do to do with the tranny. Though it occurs maybe once or twice monthly, I am beginning to have concerns and suspect that the problem will get worse with time.
View 7 Replies
My Santa Fe was really hard to start this morning..it seems when it rains overnight it seems to spin and spin and spin and take some time to start.. Could a low voltage battery be in cause ?
When it starts, i see no loss in performance or any CEL that's come up and runs like it always did before.
Any quick tests that could be done before i take it back to the dealer for a diagnosis ? I have a multimeter so i guess i could check my battery voltage to see if it's the source of my problem.
View 1 Replies
I just bought this 2008 santa fe with a 3.3 V-6. It has 200kms on it. Here is the problem- I start the engine, and for the 1st second of running there is NO noise,.....but a second later it sounds like a chain slapping around in the engine HARD. it lasts for about 2 seconds and then the motor is quiet. It seems like the longer the car sits,..the worse it gets. If your only letting it sit for 20 minutes or so, you wont hear it.
View 5 Replies
Got in to go to work this am, and the gear shifter was difficult to move. What to check?
I drove 70 miles to work and didn't seem like any issues with the transmission shifting.
Got in to go to lunch and it seems even more difficult to move...
Shifting back and forth in the selector seems to loosen things up a little.
A friend move the selector while I looked at the linkage and the bracket that support the cable is flexing while shifting between gears....More likely a transmission issue or something with the linkage?
View 24 Replies
Our 2009 Santa Fe AWD Limited shifts hard first thing in the morning when my wife shifts into reverse to back out of our parking space. This is a real hard THUD kind of shift, where the car jerks. After that, all shifting is normal. We don't have any other problems with the transmission when driving.
View 6 Replies
This happens to me again on a very hot day. The symptom is: all of sudden, the brake pedal becomes stiff. I mean I can only depress down the pedal just a little bit. Then when I want to accelerate, the engine works very hard and speed picks up very slowly. RPM will shoot to 3000. When I remove my foot from the gas pedal, the speed drops very fast. The car slows down much sooner than usual. So my feeling is the brake is dragging the car. The dealer cannot duplicate the problem during short test drive. So what can be wrong? The brake booster was replaced a few months ago. Is it possible it provides too much boost?
View 17 Replies
I'm having issues with my 2012 Hyundai Santa Fe. I have the 2.4L engine and having some issues with the vehicle. The car idles low at a light right about 500 rpm. The rpms drop when you place it when gear. The car jerks and bucks while driving. The feels like its stumbling when you slow down. I do have a custom exhaust, just the muffler. What would cause the car to act this way? The dealer could not duplicate the problem.
View 46 Replies
This week my oil light came on, really was flickering on and off. I parked it and called the dealer, towed it just in case.
Dealer tested the oil pressure cold and hot, all is good. So they think it is the oil pressure switch, which they said was very unusual with a new vehicle (11,000km). They opened an inquiry with Hyundai, but they have not got back to the dealer yet. So they have ordered a new switch, but to replace it they said they have to remove some manifolds and stuff to get at it, so they have ordered all the caskets etc....
It only seem to flicker when at operating temperature. I really don't like to see them pull manifolds etc... on a new engine, but I need to be sure I can rely on the indicator. Right now the dealer said I have no problems driving the vehicle till the parts come in.
View 14 Replies
The car had its first service last month but since then the ESP light has come on permanently on three separate occasions and has to be reset by turning the ignition off. Suppose I will have to book it back in -I read elsewhere it could be cause by wheel alignment or faulty connection somewhere?
View 1 Replies
What are the steps involved in replacing my fog light bulbs? One burned out. And what's the correct bulb replacement number?
View 5 Replies
