On driving it at night I have noticed the main beam is not very bright, dull in fact. Took it to Hyundai and they re seated the bulbs and realigned the lights, although slightly better they still seem dull. My last car had zenons....
View 7 RepliesI turned on my lights, as you do whilst driving and the main beam came on, it WILL NOT GO OFF no matter which way i turn the switch etc etc etc. Its stuck on permanently, and the blue warning light on the dash board is on and wont go off neither. I have a seat ibiza 1.4 sport 2007 ....
View 2 RepliesNewly acquired 2011 Santa Fe GL. Recently had a 2008 Azera GLS.
We received the Santa Fe a week ago and have since put 600 km on her. I took her into my work (auto mechanic) to wash and wax, looked underneath the engine and noticed 2 drops of what appeared to be engine oil. Between the transmission and engine block there are 2 10mm vertical bolts. The drops of oil have accumulated on the head of the bolts. There is a small "plate" between trans and engine with oil "weepage". My guess is the engine rear main seal is leaking! Not a small repair and certainly at 600 km.
Where the adjustment knobs are for the low beam specifically? 07 Santa Fe 3.3L.
View 6 RepliesI am trying to figure out how to adjust my low beam headlights. i just need to move them up a little bit.
View 42 RepliesI have a 2008 Hyundai Santa fe and have recently had both low beam headlights go out. The running lights and high beams still both work. I read both bulbs as sat 0.5ohm(left) and 0.5ohm(right). Connections were right. I also read fuses in engine compartment HLP LO for both RH and LH. Still I swapped them both with the HHP HI and both worked for high beams but no change for low,on,either side. My next idea is the switch but I am not sure how to test it.
View 5 RepliesThe main right beam not working message came on in my dash. I have hids in and did the vag com already. I have had them for like three months now and the warning came on today. My lights still turn on and work fine.
View 3 RepliesDoes 2008 Santa Fe have horizontal lowbeam aim adjustment? After driving my Dad's Santa Fe, I notice the low beam casts a U-shape light pattern on the ground, makes it extremely hard to see what's on the ground right in front of the car. I've attached a picture of what it looks like driving it at night.
View 10 RepliesA few weeks ago my passenger side low-beam failed to come on during a short road trip. After a failed attempt to find a replacement at 9PM I had no choice but to continue on my way, about an hour later, as I was driving along, it suddenly came back on with no trouble since. I haven't touched any wires or fuses.
View 3 RepliesI have a short somewhere in my 2007 Hyundai Santa Fe. I got in one night and had no lights. Found a fuse that was blown and thought i solved the problem. The left Low Beam is still out.All other lights work. I used a light tester and I get power on both sides LH Low beam fuse where on the right side low beam and all other fuses I only get power on one side (Light Lights up). The low Beam left relay is same way. I get power in center of relay where I don't get it power in center on right low beam relay. I have switch all bulbs. Even switched entire light assembly with the right side thinking short could be there but the left side low Beam still has no power to bulb and same short in fuse and relay. So somewhere from fuse box under hood to the Multifunction Switch is a short and is it possible for an average DIY to fix this. Is Multifunction Switch easy to replace and would that be the cause or is it inside tightly taped wire bundle or something else I am missing.
View 8 RepliesI have 2007 sante fe. I just replaced the low beam,now the low beam doesn't work at all. I checked the fuse .. Just fine checked the wiring harness and plug no broken wire, no corrosion....
View 2 RepliesSo I have MFD display errors for "main beam not working" on both sides but both of my headlights, lows and highs both work fine. this has been like this for a few months now. I can clear the codes with my VAGCOM and after a day or two they come right back. I do have LED license plate lights but for at least a year i only got the error code on startup for the plate lights but never headlights. A little confused as to what is tripping the headlight codes
View 3 RepliesThis morning a dash light informed me a headlight bulb was out. It was my DTR light on the passenger side.
I purchased Sylvania H7 high intensity, installed it and it failed to work properly. Daytime light on only drivers side works.
High Beam on , both lights works.
I checked my manual and it said to check fuse in the 5 slot on the driver side dash/door panel and there actually is no fuse in there. I checked the driver side and there was no fuse there either.
I replaced my driver side bulb last year and it took 5 mins....i am already 4 hours into this!
I have a strange problem. My driver side low beam dont work and my right side high beam dont work. Try different relay (switching), check fuse, bulb etc. Also in my dashboard the right green arrow for the flasher always still on(solid).
If I activate (with the control arm) the right turn flasher the flasher light blink in the dash board and my outside flasher bulb flash but my left high beam also blinking in the same time!
I have a Santa Fe 2001, 2.0 Crdi.
My low beam have shut down. I have checked the fuse for right and left, and as I can see, it's the same fuse as for the high beam ...
Is there any known problems regarding this faults ? Of course, the bulbs are ok ...
Hopefully this isn't a big issue, but I got in my car this morning and tried lowering the windows and only the driver window would function from the driver controls. The windows work fine with their own door control, but not from the driver's seat.
View 8 RepliesAfter returning from vacation, I found that one door of my 2007 Prius was left open while we were gone. I tried jumping the car. Long story short, I accidentally reversed the polarity and fried the main fuse block. I just replaced the fuse this last weekend and it's been running fine.
Until today
I drove to work and everything was fine. Then at lunch I got in the card and started it up. The red triangle came on with the exclamation point. Also the VSC light and the orange exclamation point in the Circle with the ( ) around it.
I have a low beam that just isn't working at all on the right side. I changed the bulb 3 times now, confirmed I had the right dual beam bulb (Sylvania 9003) and still the same result. The low beam doesn't work on the right side, but the high beam works.
2002 Hyundai Santa Fe GL 2.4 CYL ...
Low beams don't work. The fuses are fine (under the dash, and in the engine compartment) and the bulbs look good. The fact that both went out at the same time has me wondering. One post on this forum for something not related mentioned a headlight relay behind the fuse panel?
View 9 RepliesI'm trying to troubleshoot an odd issue.
When the lever is in low beam mode I have no headlights or fog lights. (parking lights fine.)
When the lever is forward in high beam mode I have no headlights or fog lights. (parking lights fine.)
But if I hold the lever back in "fash the high beam" mode the high beams turn on. This got me home last night, but I don't know where to start looking for the issue?
Faulty relay? Faulty switch? Something else?
(2004 Santa Fe)
Both low beam headlights went out at the same time on my 2012 ES 350, What can I check for before I go to the dealer?
View 1 Replies