Santa Fe (CM - 2007-12) :: Loud Clatter From The Flywheel (dual Mass)


Oct 29, 2016

I know I am stating the obvious but a clutch job on a 2010 Santa Fe CM (diesel) takes a lot of time.

My brides Santa Fe has over 280,000 km (175000miles) and has had the loud clatter from the flywheel (dual mass) for quite some time and more recently the pedal started to remain on the floor and the 'fix' of bleeding and flushing new fluid through the system stopped being effective. When a leak from the slave developed I was forced to accept that I would have to either fix or sell the vehicle.

By far the biggest obstacle I found was the non availability of a workshop manual to guide the task as it would no doubt speed the process massively for a number of reasons, some of which are listed below:

* Having a structured step by step procedure to follow, showing hidden bolt placement, torque settings, specific tools required and little tricks.

* By allowing one to assess the extent of the task and determine if one has the time/skillset/tools to deal with it would be great.

* Taking the guesswork away and thereby preventing unneeded parts removal.

* Having actual parts numbers to confirm parts suppliers supply correct parts.

Finally, of note is the way in which vehicle manufacturers assemble cars on the production line by using subframe cradles etc places massive extra difficulty with a task such as this as the clearances for tools, hands, arms and body are very very tight indeed.

I don't intend to outline a step by step process as others are far more qualified to do so, however I will point out some tricky things I have learned during the experience which may assist others. I will list them in no apparent order and will add others when I think of them.

1. The flywheel bolts are Torx T60.
2. The flywheel bolt access aperture had blocked access to the head of two of the bolts that required the use of a die grinder to remove some flywheel material. Not sure as to why this occurred or how.
3. Initially, I intended to remove the gearbox from the bell housing and remove both separately to make it easier but after removing the available bolts and prying the two apart (unsuccessfully) I removed the unit as a whole. Once on the bench I saw there were 4 bolts going into the gearbox from within the bell housing. So this unnecessary attempt needed me to split the two on the bench, scrape and clean old gasket material away and rejoin them together with new gasket silastic.
4. I supported the gearbox and bell housing from the top with an engine hoist and lowered it to be wrestled out.
5. I only dropped one side of the cradle but would remove it entirely if doing it again.

Probably enough for now i guess

View 2 Replies

Advertisement

GTI 337/20th Anniversary :: Clunking Sound When The Clutch Is Released - Dual Mass Flywheel Go Bad?

My car makes a clunking sound when the clutch is released, it's not the throw out bearing or the pressure plate, as they have been replaced twice already???? Have dual mass flywheel go bad, what were the symptoms?????

View 10 Replies

Golf VI R :: Noisy Dual Mass Fly Wheel?

I have had this basically since i got my car. I brought it up with VW and the best explanation they could offer was the DMF. When i set off, more so at low rpm and under load (like reversing out of a spot and continuing forward) i get a knock from the drivetrain. Its not super loud, but it is certainly noticeable. Everyone i have asked has said it just sounds like the Dual Mass Flywheel making noise, but should i be at all worried? I made sure i have it on record with VW that i noticed the noise and they said its no big deal.

View 4 Replies

Santa Fe (CM - 2007-12) :: Buzzing On Dual Control And Temp Panel

Had a buzzing on my dual control and temp panel. Buzzing finally stopped, and now I have no control over temp on passenger side. It blow cool air regardless of the temp I put or taking it off of dual. Doesn't matter, it just blows cool air. I can have it set off dual at a high temp, driver side will be hot, passenger side will be cool. What broke?(blend door?)

View 3 Replies

Santa FE SM (2001-06) :: Starter Motor Scream As Plunger Turns Transaxle Flywheel

I have a 2001 Santa Fe 2.7l automatic. I recently changed out the automatic transmission (transaxle) as the old one had died. Now the starter motor plunger is not disengaging quick enough on start up and a screaming noise is made as flywheel turns as engine first turns over. I have just put a new starter motor in with exactly the same (screaming) result. The flywheel looks to be in reasonable condition as I inspected it when being put in, no teeth mangled and all teeth there. The transmission replacement was from a wrecked vehicle, I was told from same model vehicle but maybe a 2003 Santa Fe.

View 1 Replies

Santa Fe (CM - 2007-12) :: Loud Thump When Fueling Up

When I fuel up I hear a loud thump in the back of my vehicle, I then hear the gas pump nozzle click off after about another half gallon is pumped in. Without understanding the design of a tank or the gauge float etc. I am guessing that something is getting stuck and releasing under pressure once the tank fills up. Of course this has me more than somewhat concerned from a safety perspective. Note that this vehicle was brought in under warranty for the fuel sensor issue and the part was replaced, would this be related to that? Will the repair still be cover as a part of that work even though my vehicle is now out of warranty?

View 5 Replies

Santa Fe (CM - 2007-12) :: Loud Bleep Inside The Cab When Driving

Santa Fe auto 2.2diesel 2007. Intermittently I get a loud bleep inside the cab when driving ... its the same sound as when the front parking sensors activate ..... only appears to happen in the rain ...

View 1 Replies

Santa Fe (CM - 2007-12) :: Loud Thud While Driving After Slowing Down Then Giving Gas

My 2011 Hyundai Santa Fe as reached 40 MPH. While driving, after slowing down then giving the car gas, it would make a very loud thud and I would be jolted forward. At times it sounded like the transmission was going to be left on the roadway. Is it common problem?

View 2 Replies

Santa Fe (CM - 2007-12) :: Loud Tapping / Knocking Noise From Engine

I am getting a loud knocking noise from the engine on my Santa Fe. The car is very low mileage of around 51K and has regular service and oil change.

Not sure what has caused this but there is a loud tapping/knocking noise coming from the engine. Have got it locally checked with the garage and Hyundai Workshop also but both have suggested that Oil levels are appropriate and they need to open engine to investigate more.

At a higher RPM the sound becomes more loud and recognizable.

View 2 Replies

Santa Fe (CM - 2007-12) :: Loud Bang And Twang When Driving Down The Highway

I was driving down the highway when I had this loud bang and twang, after inspecting the car I realized it was the left rear seat belt that was broken. The seat belt fails to retract and cannot be pulled. I'm guessing the retractor is the fault.

View 2 Replies

Santa Fe (CM - 2007-12) :: Loud Gear Whine With Light Acceleration

'07 FWD Santa Fe exhibits pretty loud "'gear whine" with light acceleration.

Recent ATF change got loads of nasty gook and metallic sludge out of trans.. but no change in gear whine.

Dumb question, but do 2wd Santy's have a differential that I can drain and refill to quieten this whine down a little?

View 7 Replies

Santa Fe (CM - 2007-12) :: 2011 - Loud Horn Sound On Locking

If you push the remote lock button twice the horn beep is very load and startling. Can this be programed for a lower volume sound?

View 5 Replies

Lexus GS 2006-11 :: 2007 GS350 Clatter Noise Upon Engine Start After Sitting For A While

I have a 2007 GS350 that seems to "clatter" when I start the engine after it's been sitting for awhile. The clatter only lasts a couple of seconds but it's annoying....sounds like metal on metal. It does not happen when engine is cold or should I say first thing in the morning. It happens after the car has been driven, sat for a few hours and then the clatter occurs when I start the engine. This started a couple of weeks ago....I have 29,000 miles on it.

Took it to the dealer last week, the service rep told us that this is somewhat common and is due to the high pressure direct injection system on this particular engine. He also said this started when they switched from the GS300 to GS350. I'm wondering why it never happened before. The service rep said there's nothing they can do about relatively new Lexus with relatively low miles.

I've always used premium gasoline, got all my oil changes and maintenance done at the Lexus dealership thus far.

View 14 Replies

Camry :: 2007 - Single To Dual Exhaust Conversion

I would like to retrofit the Lexus LS exhaust tips on my 2007 4 cylinder SE 4 Cyl, only if dual exhaust conversion doesn't have any adverse effects on my car.

Idk much about piping and exhaust systems. Where would the second pipe split from, after or before cat? what pipe diameter? Should the pipe diameter for both exhausts be smaller? Will it affect my hp/torque? Would it be louder or quieter? Any other forseeable effects?

View 14 Replies

Santa Fe (CM - 2007-12) :: 2009 - Loud Squeal Sound When Apply The Brakes

I just installed new brake pads in my 2WD 2009 Santa Fe. I bought the cheapest AutoZone pads. Now I have a loud squeal sound when I apply the brakes. If I apply a hard brake the squeal goes away. Until I apply the brakes again. Now, after install...I have been researching and noticed that the stock pads are ceramic. I did apply (Not once but twice) break grease on the pads. What the problem might be? Oh yeah, I did see that after 2007, oiling the caliper springs is required and might be the problem too. But I do not know where the spring in question is and how to oil it.

View 4 Replies

Santa Fe (CM - 2007-12) :: Loud Tapping Noise Coming From Engine As It Seized

I'm having an issues with my Santa Fe MY07 - Basically I was driving down the dual carriage way last week when suddenly the oil light came on and with the 500m it took me to stop a loud tapping noise was coming from the engine as it seized - The break down people came out to the car as they were inspecting it they informed me that the Sump cap was missing - the car is under warranty - however Hyundai as say that because the cannot find out why the sump cap had came off (and that in there mind they cannot give any reason why it should of) it is there for NOT a manufacturing issue and that they would not cover the repairs under warranty...

View 4 Replies

Santa Fe (CM - 2007-12) :: Loud Thunk Then Couldn't Accelerate And Engine Light Came On

2007 Santa Fe 2.7 engine

My wife was driving along and she said she heard a loud 'thunk' and then she couldn't accelerate and the engine light came on. I don't know if she had to restart it or what but she finished out her day and made it home ok. The engine light went off. When she got home I put the scanner on it. I have a Actron 9580A. It came up with 3 codes.

P2106
P1295
P161b

From what I've read on here and what the codes tell me I guess I need a throttle position sensor and that a computer update is needed. Is the ECM update something that can be done without taking it in? If I do need someone to update it is the dealer the best place? Can I install the TPS then drive there? Or does it have to be done at the same time? I was just thinking I might save a few bucks doing it myself.

Prior to this the Santa Fe had no codes. I do need to replace the battery which tested bad last month. I think the battery will need to be replaced before doing the update.

View 8 Replies

Santa Fe (CM - 2007-12) :: 2011 - Loud Rattle On Cold Startup For 3 Seconds

2011 Santa Fe 3.5 L

I've isolated this rattle down to the cam phaser( CVVT) in the right cylinder head. It rattles bad for 2-3 secs on cold start or after it sits for 3 hours.

I've put in 5w20 synthetic oil and synthetic Lucas additive and it cleared up the noise for short interval start ups.

I changed the cam phaser in the right head with a used one ( 40k ) but it didn't make a difference. I should change out the attaching cam as well.

View 21 Replies

Santa Fe (CM - 2007-12) :: 2010 - Loud Whirring Sound After Engine Turned Off

I turned off the engine and I get a whirring sound, quite loud, that seems to be coming from the top of the engine around where the injectors are.

View 51 Replies

Santa Fe (CM - 2007-12) :: Loud Throbbing Noise Suddenly From Rear Speaker

A loud throbbing noise suddenly started last night in the rear speaker of my 2010 Santa Fe. I think the speaker is blown. Can I pull the fuse until I can get this to the dealer? Which fuse? I can not locate a fuse map. I tried #13 and #31 based on an old fuse map online but the noise continued.

The noise is loud and I can't drive with my toddler in the car.

View 14 Replies

Santa Fe (CM - 2007-12) :: 2010 - Loud Clacking Noise And No Response When Pressing The Accelerator

My wife was driving our 2 young kids on the highway and the accelerator was making a loud clacking noise and then there was no response when pressing the accelerator. She managed to get to the shoulder. Mechanic says the engine is totally cooked (long block replacement). Only 32K miles and all scheduled maintenance done.

View 7 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved