Santa Fe (CM - 2007-12) :: Left Side Low Beam Short
May 15, 2012
I have a short somewhere in my 2007 Hyundai Santa Fe. I got in one night and had no lights. Found a fuse that was blown and thought i solved the problem. The left Low Beam is still out.All other lights work. I used a light tester and I get power on both sides LH Low beam fuse where on the right side low beam and all other fuses I only get power on one side (Light Lights up). The low Beam left relay is same way. I get power in center of relay where I don't get it power in center on right low beam relay. I have switch all bulbs. Even switched entire light assembly with the right side thinking short could be there but the left side low Beam still has no power to bulb and same short in fuse and relay. So somewhere from fuse box under hood to the Multifunction Switch is a short and is it possible for an average DIY to fix this. Is Multifunction Switch easy to replace and would that be the cause or is it inside tightly taped wire bundle or something else I am missing.
View 8 Replies
Advertisement
I have a strange problem. My driver side low beam dont work and my right side high beam dont work. Try different relay (switching), check fuse, bulb etc. Also in my dashboard the right green arrow for the flasher always still on(solid).
If I activate (with the control arm) the right turn flasher the flasher light blink in the dash board and my outside flasher bulb flash but my left high beam also blinking in the same time!
View 3 Replies
A few weeks ago my passenger side low-beam failed to come on during a short road trip. After a failed attempt to find a replacement at 9PM I had no choice but to continue on my way, about an hour later, as I was driving along, it suddenly came back on with no trouble since. I haven't touched any wires or fuses.
View 3 Replies
This morning a dash light informed me a headlight bulb was out. It was my DTR light on the passenger side.
I purchased Sylvania H7 high intensity, installed it and it failed to work properly. Daytime light on only drivers side works.
High Beam on , both lights works.
I checked my manual and it said to check fuse in the 5 slot on the driver side dash/door panel and there actually is no fuse in there. I checked the driver side and there was no fuse there either.
I replaced my driver side bulb last year and it took 5 mins....i am already 4 hours into this!
View 4 Replies
The air con seems to work OK on the right side outlets, but the air comes out warm on the left side outlets.
View 1 Replies
I just got my 337 a few days ago and I got out today after a short drive and smelled coolant. Immediately thought the worst but luckily I found this hose to be leaking. What hose this is its on the left side just about the throttle.
View 11 Replies
My Prius is a 2012 Two model. The headlight is my low beam on the left side. Is this something I can so myself?
View 5 Replies
We just bought our first Prius about six weeks ago. We purchased a used 2008 model with 83,000 miles. So far we have loved the vehicle. Tonight as we were driving home we noticed that the left headlight was out. I ran some quick tests and determined that the left high beam, low beam, and side marker light were all unresponsive. The left blinker is working fine. I checked the fuses for the left lamp (separate fuses for low and high beam) and all seem to be in good working order. Everything on the right side of the car is working fine.
View 9 Replies
Where the adjustment knobs are for the low beam specifically? 07 Santa Fe 3.3L.
View 6 Replies
I am trying to figure out how to adjust my low beam headlights. i just need to move them up a little bit.
View 42 Replies
I have a 2008 Hyundai Santa fe and have recently had both low beam headlights go out. The running lights and high beams still both work. I read both bulbs as sat 0.5ohm(left) and 0.5ohm(right). Connections were right. I also read fuses in engine compartment HLP LO for both RH and LH. Still I swapped them both with the HHP HI and both worked for high beams but no change for low,on,either side. My next idea is the switch but I am not sure how to test it.
View 5 Replies
I have a low beam that just isn't working at all on the right side. I changed the bulb 3 times now, confirmed I had the right dual beam bulb (Sylvania 9003) and still the same result. The low beam doesn't work on the right side, but the high beam works.
2002 Hyundai Santa Fe GL 2.4 CYL ...
View 9 Replies
Does 2008 Santa Fe have horizontal lowbeam aim adjustment? After driving my Dad's Santa Fe, I notice the low beam casts a U-shape light pattern on the ground, makes it extremely hard to see what's on the ground right in front of the car. I've attached a picture of what it looks like driving it at night.
View 10 Replies
I have 2007 sante fe. I just replaced the low beam,now the low beam doesn't work at all. I checked the fuse .. Just fine checked the wiring harness and plug no broken wire, no corrosion....
View 2 Replies
On driving it at night I have noticed the main beam is not very bright, dull in fact. Took it to Hyundai and they re seated the bulbs and realigned the lights, although slightly better they still seem dull. My last car had zenons....
View 7 Replies
Noticed my passenger side HID low beam went out about a week ago... 2008 ls460, out of warranty
1 - changed HID bulb, still out
2 - checked applicable fuses in fuse box in engine compartment, all seems fine
3 - changed to new ballast, still nothing
All the other lights in the headlight are operating fine, only the low beam is still out. Somehow the ballast is not receiving power.
View 12 Replies
My passenger low beam headlights went out. I replaced the burnt out bulb but it still won't work.
View 2 Replies
I have an 07 Passat Wagon. The headlight malfunction indicator light came on for my passenger side low beam. I replaced the bulb, which was visibly burn out (broken filament), but with a new bulb in, the light still is not working and the malfunction indicator is still on. What is the cause of this? I have the regular headlamps, not the xenon lights.
View 2 Replies
I have a 2007 Ford Escape with a passenger side low beam that won't turn on when the headlights are turned on. I have replaced both low beam lights and checked all the fuses. Fuses are ok,none are burned out. My high beams work perfectly as well as my fog lamps. I need any and all advice and information , including any simple wiring diagrams that could be of use . Is it possible that the multi function switch for the turn lights and headlights is the problem?.
View 10 Replies
My Santa Fe 2010 is pulling to the left and the dealer has tried everything to eradicate the fault without success. What might be causing this?
View 4 Replies
Need to identify what could this be? It used to come and go, now it's constantly here. I took it to the dealer but there was a 3 hour waiting time, so I might have to go another time. If you do know what is it, could I fix it myself? While driving there's no squeaking, but I can hear a metal on metal sound while on bad roads, the type of noise you would expect from a bad tie rod or something like that, on good roads it's fine. The noise you can hear on the video happens when I push the car side to side. [URL] .....
View 1 Replies
