My new SANTA FE has merely covered 10000 km. The vehicle is running fine except a very irritating loud knocking noise from top of front windshield area. The noise is generated as soon as vehicle goes over a minor irregularity on road or even if you make a sharp right or left turn.
View 24 RepliesI have a 2009 AWD Santa Fe with a little over 43K miles. Over the past few months it's developed a knocking noise that is most audible from the front drivers side area. The knocking speeds up or slows according to the car's speed, and appears somewhat louder when the steering wheel is turned. My initial suspicion from my surfing here is either a CV joint or wheel bearing.
I took it to the dealer that sold it to me and am getting increasingly frustrated with their work. The first irritation was yesterday when the service advisor called to say the problem was corroded rear rotors and brake pads; both wear items not covered under warranty. Though skeptical (since I was hearing the noise coming from up front, not from the back) I authorized the $300+ for turning the rotors, replacing brake pads and flushing the brake system.
When I showed up to retrieve the car I was told it'd been test driven and the problem was fixed. I asked the tech specifically whether he'd checked the CV joints and he assured me he had and they were fine. Upon driving away it was immediately obvious the knock was still there. Back to the dealer. I had the tech drive it with me in the passenger seat. He acknowledged he could now heard the knocking, but claimed he previously couldn't hear it over the horrible loud squealing from my rusted rotors; nor had he heard it on his alleged post-fix test drive. The problem with that is I've never heard this claimed horrible loud squealing, nor has my girlfriend, nor have any other regular passengers.
Back at the dealership the situation escalated when the service advisor, in defense of his tech, also claimed the horrible squealing rotors had drowned out any other noises. The problem with that is he admitted he'd not come along on any of the previous claimed test rides, and claimed to have heard the horrible squealing rotors only while the car was in the shop and/or up on the lift while the tech was turning a rear wheel by hand. Err, if the car was not driven any for distance or speed, of course you wouldn't have heard any knocking up front.
Yesterday evening I got a call from the shop advising the problem had now been diagnosed as a bad wheel bearing, front driver's side. I was assured it'd be fixed and ready this afternoon. All well and good. I showed up this afternoon and the service advisor stated the car was just getting buttoned up and we're going to test drive it. Fine, I'd like to come along on the test drive I said. He agreed, asked me to sit in the waiting room. In a few short minutes though - not long enough IMO - he came back out to advise the tech had just test driven the car (without me?!) and the knock is still there.
As of this writing I have no info from them as to what it might be. I left the car with them and asked the service advisor to have the tech(s) double check the CV joints. He got huffy with me and declared that if if the tech said he'd check them, there's no need to do so again. At this point I'm not sure whether I can trust this dealers' service department. I don't think the service advisor is being honest with me - I think he's been caught in a minor fib re: test riding and is compounding the situation by sticking with it.
Last night my front driver side windshield wiper malfunctioned - it was operating normally then 'jumped' off of the windshield and stayed in a rested position draped over the driver's side mirror. When placed anywhere on the windshield it doesn't function.
Would this be a problem with the linkage? The passenger wiper operates normally.
My 2008 Santa Fe (3.3 2WD) produces a knocking sound from the front every time I go on a bump while the wheel is turned. I can pretty much reproduce it at will. Occasionally, I hear the same sort knock from the rear as well, but I cannot confirm that it is consistent.
I do suspect that something is wrong with the struts. The only issue is that the car has 67k KM (41k miles), and to me, that seems a little early for that sort of thing to happen. My driving is pretty standard on standard roads, although winters up here tend to produce potholes that I sometimes cannot avoid.
I've had my struts fail on my last car (2000 Mazda Protege), but that was 9+ years old and with almost 3 times as much mileage on it.
I have a 2012 Santa FE 2.4L, I have a knocking sound happening in my front passenger side once I go over bumps. Would like some info on the different parts that can cause this.
View 10 Replies2009 Santa Fe only 40500 miles ... Should I Be concerned about the noise it has done this since I bought it in 2010 ...
View 2 RepliesMy 2007 CM Santa Fe 45K miles began acting up intermittently. We have owned it 5 years from new and never any issues whatsoever. My wife told me that first thing in the morning it made a horrible clanking noise and the entire car shuddered so she shut it off. Then it cranked and ran for days normally. The other morning I got in it and cranked it and man, it sounded like rods knocking, pistons slapping the crank, it was awful. Actually it sounded like premature or off time detonation, the engine would not idle and would die.
After a couple more tries the engine cranked and ran smoothly but with increasing idle speed and after two instances of normal cranking but idle increasing ever upward (same morning in sequence of 10 minutes or so of trying) I called AAA and had it carried to the dealer afraid oil pump giving out, timing belt jumped, bad crank / cam sensors, who knows? Oil was changed 5K ago with Hyundai toilet paper filter.
Anyway dealer found a code, something about engine torque excess - who knows - it wasn't causing the horrible cranking idling banging noise... did some ECM/ECU update, and repaired a TSB for the passenger side Airbag seat detector. They kept it over night and still could not make it occur.
My wife is really worried because honestly it sounds like it's going to throw a rod or something *I know it doesn't have them*. It's just a horrible gut wrenching noise. Dealer mechanics could not find anything wrong and they kept it overnight to crank it cold, and when we picked it up today it cranked fine.... She can't trust it anymore.
I am getting a loud knocking noise from the engine on my Santa Fe. The car is very low mileage of around 51K and has regular service and oil change.
Not sure what has caused this but there is a loud tapping/knocking noise coming from the engine. Have got it locally checked with the garage and Hyundai Workshop also but both have suggested that Oil levels are appropriate and they need to open engine to investigate more.
At a higher RPM the sound becomes more loud and recognizable.
I have santafe 3.5 2012 4WD , it's 51K on odometer, the problem when cold startup , Noise and small vibrate form front side , its look like from gears
When put to reverse (R) sound is louder and strong vibration from front side, all this problem gone when drive about 15 minutes.
I have visit 3 local shop they check the engine, gear box, everything normal, no check indicator appears.
I have a 2010 Santa Fe V6 2WD. When I rock my steering wheel back and forth, I hear a knocking sound when engine is off. Sounds like maybe the steering gear box has play in it.
View 5 RepliesHaving issue with an occasional whistling noise. Mine seems to happen once I get to 80km/hr(50mph) or above. Seems to be coming from the drivers side area around the side mirror or windshield frame. Being winter the windows and sunroof have been closed and it doesn't seem to be consistent so it's hard to figure out what could be causing it.
View 16 RepliesLast oil change at the dealer (they're free) I informed the service desk of some knocking and grinding noises that are happening from time to time in the front end.. and fluid in the driveway.. they did the oil and said they saw nothing... so I have to go back next week for my last free oil change and before I made the appointment, I dropped in to see my regular mechanic.. steering rack is leaking on the passenger side and has been for a while as the fluid is down to the minimum line in the reservoir.
Made the appointment with the dealer, informed them about the noise again and fluid on the driveway.. again. Let's see what they say this time.
I took my car to the dealer last week to repair a clicking noise coming from the juncture of the right front windshield and dash. They said they added felt to the speaker grill and fixed it. NOT SO, still makes the noise, it is better though seems to get better when the weather is warmer. How to get the speaker grill off without damaging it. If so I will try to address the thing myself.
View 14 RepliesSounds like a servo maybe opening a door or flap. Comes on every few minutes. Can make it activate by turning the passenger side temp control.
View 4 RepliesI have a 2010 Santa fe ( since new) 28k miles - I'm getting a grinding noise that seems to come from the front right wheel - noticeable only when doing a right hand turn or going around a roundabout.
So, Is this likely (from my terrible description) to be a wheel bearing problem....
My wife has a 2010 Santa Fe with AWD and 40,000 miles on it, and my daughter has a 2008 AWD with 38,000. I don’t drive my wife’s car much but after taking it on a trip I noticed that the front wheels/tires seemed louder than normal, exactly like a bad wheel bearing or when you are running snow tires. I had the tires balanced and inspected and took the car to the dealer sure that there was a front wheel bearing going out but they said it was fine. A week later I was driving my daughter’s 2008, same noise. Tires on both cars are fairly new and don’t appear to have any problems. So, is this common to these cars and considered normal?
View 2 RepliesI have a 2012 Santa Fe that I took in today for the first 3,000 mile oil change. Everyone that rides with me say they hear a popping noise coming from the front passenger tire? I asked them to check it out at the dealership and they say all is fine. Some one said sounded like the strut top plates were loose.
View 11 RepliesI have a 2007 SF Ltd. About 6 months ago I noticed a tiny grinding noise coming from the front end. I took it to the place that installed the brakes and rotors and had them look at it. The said that they didn't see anything but the cleaned up the rotors and oiled the slide pins. That didn't seem to sold the problem, so I took it to the shop that does all my inspections and such. They mentioned that they didn't see anything and that if if was only first thing in the morning, it might be some very minor rust that is building and being worn off. Lately, the grinding noise has gotten much more consistent and loud. Both places said the pads looked almost new and other than the turning of the rotors, they looked fine. If it isn't the pads or the rotors, what could be causing the grinding noise? A friend of mine had the same issue but his dealer told him that his vehicle "just had noisy brakes". That doesn't see to be an acceptable answer.
View 3 RepliesGot a 2007 Santa Fe CM (Europe) with 160k km. I'm currently trying to figure out how to fix the clunk noise in the front of the vehicle. I am aware about the TSB 12-DS-002 where they recommend changing the drive shaft washer, but since that's a lot of work I want to make sure that this is really the problem.
The noise is not always there. Sometimes you can hear the clunk when decelerating, but not always. You can also sometimes hear a clunk when going from D to R. It sounds like a driveshaft has some play, and a change in the direction of the force causes it to slam into the other side. However, you can't feel it, so there is definitely not a lot of force behind it. You can only hear it.
However, I asked some guys to shift between R and D while I'm outside so that I can figure out where the sound comes from. However, murphy's law, it didn't made any clunk. And after shifting between R and D for like 20 times I felt bad for my transmission and stopped it.
The clunk is not always there, just sometimes. It doesn't really make sense to me, if its really play in a driveshaft it should be always there? Also the clunk started at about 155k km, now I got 160k.
Is there any further diagnostics I could do?
Well, even though I love my 2010 SF SE I have had a few issues. I've had my power steering pump replaced twice and now I'm hearing a clunky/creaky noise coming from the right from wheel. I"m thinking it is a sticky caliper. It happens most frequently when I am just starting out from having the car parked for a while. When I put my foot on the brake and then release it I get the noise. It seems to go away after I have been driving a while.
Can't say I ever had this much trouble with my previous generation SF. Nothing major but annoying none the less. BTW I have just under 30k miles.
My parents have a 2007 hyundai santa fe AWD and recently there is this creaking noise from the front end when you have the car in reverse and you're foot on the brake and turn on the wheel, I had someone in the car and I stood outside it sounds like its coming from the center of the wheel near the hub it has that sound like a rusty door hinge, is there a problem with front wheel bearings on these cars we had the two rear ones replaced under warranty because of a humming thrumming noise and now there is a humming thrumming noise again but hard to tell if front or rear and the tires are in good condition no cupping.
Is there an easy way to check the hubs on these cars besides the normal move the tire up and down for play. By the way the car has 105000 kms on it...