Santa Fe (CM - 2007-12) :: Horn Fuse Burned In Hood Relay Box
Dec 29, 2014
Just noticed I have no more horn... I had car alarm issues for a while and the alarm would sound all day in the parking garage while I was at work (was keeping the car unlocked at home...) Finally fixed the hood pin.
Going back to the horn, the horn fuse was burned in the hood relay box, and when I replaced it and tried the horn again, it burned again... Where to start? Do I go for new relays, new horns, new wiring or all of the above...
View 8 Replies
Advertisement
I have a 2000 LS, V6, that won't start, had the battery and alternator checked and are fine, last week i notice when I turn the switch to start up there was a 1 or 2 second delay then it would start, the other day the wife called me at work to tell she she was out and it wouldn't start as I was talikng to her she tried it and it started right up, didn't do it again until this morning, check the fuses and all were ok, it started 2 times then about 30 minutes, nothing, and i mean nothing, the security on the dash doesn't indicate a problem, I turn the switch everything lights ups as it should, everything works(radio...etc.) go to start and nothing but click, sounds like it comes from the fuse/relay box under the hood, starter maybe? relay?
View 3 Replies
Well, it's starting to look like I may have to build my underhood harness from bits of multiple harnesses. I found a 2000 Excursion harness, but the engine plugs and wires were hacked off during engine removal.
After in-depth study of wire diagrams, it looks like I can just get a pickup harness and combine it with the aforementioned damaged Excursion harness to get what I need- and do it for about 50 bucks.
I also notice that there are a few Ebay sellers who just sell the fuse/relay box with the wiring harness hacked off of it. So my question is- how do you remove the wires (including the terminal ends) from the fuse/relay box? I've fiddled around with my burned up parts and can't seem to figure it out.
View 2 Replies
Where is the horn relay for a 2007 Buick Lucerne?
View 3 Replies
I have a 2004 Hyundai Sante Fe 2.4L that keeps blowing the ECU fuse under the hood when the ignition is turned on. We have replace the fuel pump and the inertia switch. I have tested the relay, ignition failure sensor, both coils and O2 sensor wiring.
View 10 Replies
My wife's 07 Santa Fe goes into limp mode while she's on the freeway. Had it towed to a mechanic. They report codes were: 0101, 0102, 1295, 2105, 2106, 2173. They said the sensors in the gas pedal were sending bad signal to throttle which burned out the actuator. So they wanted to replace throttle body and gas pedal sensors. They wanted $895.
Didn't seem right, so towed it to dealer. They said the first mechs were just guessing. Only the throttle body needs replacing. They wanted $960 total.
I bought a used throttle body off another 07 SF with similar vin number to avoid needing the ecm to be reprogrammed. Cost $225.
Couldn't find procedure for replacement in my pdf shop manual. Seems like this should be simple though. Anything special I need to know? Am I on the right track?
View 39 Replies
My girlfriend went to start her car this morning only to find that it would not start and there is a click coming from the horn fuse. Went to try to jump start the car and the horn actually came on, but still would not start. I have researched a little and found this can be a common problem with the rubber bumper under the hood or caused by unlocking the door with the key and not not the remote start. She called hyndai and they suggested to charge the battery and then try to shut the alarm off with the fob.
View 2 Replies
My father is having electrical issues and I'm hoping this is the cause. Where this ground cable originates from?
He replaced the battery last week after vehicle would not start. Noticed he blew a radio fuse but nothing else until yesterday. Major issues of all instruments, ac, windows, etc going out. Unable to start vehicle without jump.Had a error code B1676. So today we switched the battery, all is good (for now) except for horn fuse that keeps blowing.
It's a 2007 ford explorer 2wd v6
View 2 Replies
New 2012 Santa Fe with factory remote start alarm (installed at the dealer). Had it for a few weeks now. Park it in the garage with our other vehicles. In the middle of the night I wake up to hearing a horn going off at irregular intervals for about 20 seconds. Since this was very sudden and startling to say the least, I waited to see if it would stop before running downstairs with the baseball bat . Also the alarm system on the home was not tripped so I hesitated to jump to that conclusion. So after what appeared to be 20 seconds the horn stopped and I grabbed the key fob and locked the doors twice and heard the confirmation horn beep.
Now about the horn... like i said it wasn't at regular intervals as you so often hear as car alarms have. Instead it was irregular as if someone was just sitting in it and honking the horn as they wished. Second, the horn tone sounded like the loud horn on the Santa Fe. I say this because I've come to learn that all our other vehicles parked in the garage don't have horns as loud as the Santa Fe. This distinction I clearly picked up on from day one. Now at 4 in the AM is it possible I was wrong and it was one of the other vehicles?... possibly I guess, but the likelihood is not since I've had those other vehicles for a long time and this never happened before the Santa Fe.
View 13 Replies
I am having this giant problem with my 2008 Santa Fe. The battery died and I replaced it and I think that the security system is locking out from starting the car. Step by step of what happened:
1. Connected battery terminals
2. Horn goes off (continuously not beeping)
3. Try and start the car but it does not start. Doesn't turn over nothing at all but the interior and dash lights do work but it does not let me unlock the doors using the button (not sure if that means anything).
4. Pull horn fuse because it's waking up my neighbors.
At this point the car has been sitting for about two weeks, the battery is not connected and I'm really stuck. I've tried connecting the battery, locking the doors and letting it sit for 45 seconds and that didn't work. I replaced the battery in the key fob and that did nothing. My last step was to reach out here and honestly next would be to tow it to the dealer.
View 3 Replies
I've changed out all of my external lights for led's, including the turn signals. I had planned on replacing the turn signal relays with led comparable versions but have been unable to find the relays in the fuse boxes. The box that does the actual clicking under the dash seems like it could be it but it looks completely proprietary to this model, and not readily available in the compatible version.
I ended up installing resistors for now but that's caused other problems with my lights. Now when I turn my high beams on all 4 turn signals light up solid and I am unable to use them until I turn the highs off.
So, I would love to know if I do have a relay replacement option for my 2012 Santa Fe...
View 1 Replies
Have had my '11 Tiguan with 46K miles on in it into the dealer twice now for this issue. The first time they diagnosed the issue as a faulty control module, ordered one from Germany, installed in and the issue went a way for a while...
Over the past week the problem has come back with a vengeance. The Tiguan would complain that various headlights, fog lights, blinkers and backup lights were out. Sometimes turning on the lights and turning on the high beams would fix the issues, other times turning off the car and starting it again was necessary. Went into the dealership today and the issue was diagnosed as a burned fuse block.
View 9 Replies
If you push the remote lock button twice the horn beep is very load and startling. Can this be programed for a lower volume sound?
View 5 Replies
I cant find the location of the Turn signal relay, its not in the Relay box under the hood nor is it on the fuse panel under the dash, i'm planning on installing LED blinkers and i want to switch out the relay to a LED compatible one, where it is?
2008 Santa Fe GLS ....
View 8 Replies
My driver side door has not been working for about a month now. It started gradually opening after a million tried but now it just wont open. Tonight one of my lamps stopped working when I was trying to install HID's. I suspect the fuse is burned out but cant get to it cause the door wont open. How can I get my door open. Need headlights as I get out of work late night and dont want to get pulled over for a headlamp being out.
View 8 Replies
Gps and satellite radio plug in power line fuse burned out three times. What could be the issue with Toyota Camery 2012 plug in. Toyota Camery 2012 recall list have no mention about plug-in issues. What is the problem with the plug in power line?
View 1 Replies
My horns aren't working. I'm getting power at the horn fuse, but no power at the horn connectors. Where is the horn relay located? Is it in the fusebox under the hood? There are many relays, but none of them labeled "horn".
View 7 Replies
I have a 07' hyundai santa fe and recently I had a 10 amp fuse blow labeled A/CON and so I replaced it and it worked for about 2-3 weeks and it blew again, and so I'm getting more fuses Monday to see if it keeps working, but from what I read online it looks like the field coil is the culprit, I tried to read the ohms from the relay and got .5 kohms (which I see its supposed to be 3-4ohms) but i have a crappy multimeter and I'm not sure if that's right anyway.
View 8 Replies
My 2010 Sante Fe started blowing the BCM 1 fuse.The vehicle will not even crank over. Its at the dealer for the 3rd time time this week. 1st time thought it was a faulty fuse, 2nd time replaced the drivers door lock actuator.
View 1 Replies
I have a Santa Fe 2001 and I towed a trailer today. It was fine at first but when we were trying to position the trailer at the destination the brake light fuse blew which meant the gear stick would not move. Figured out how to start the car again and used the shift lock release to move into drive to get the car off the road. I had to keep pushing that shift lock release button in to change the gears. I had the RACV guy come and change the blown fuse for me, and brake lights are fine now and the car starts, however the gear stick is still playing up. It went ok from park to drive, but then on the way back to park it got stuck at Neutral. Then had to use release again. Checked the fuse and brake lights, all is good there. What could be causing the gear stick to get stuck now? RACV guy couldn't understand why, he said replacing the fuse usually solves the problem.
View 1 Replies
My horn isn't working. The under-dash fuse is OK and was going to check the horn relay, but can't figure out which one it is despite numerous FTE and Google searches. I pulled the cover on 2 power distribution boxes under the hood, driver's side. One box has 2 relays. The other has 4. Which one controls the horn?
Then...how do I test it to see if it's good/bad?
View 8 Replies
