When I am driving and I start to slows down to a store my head lights dim when my transmission shift down (A/T). At first it didn't bother me but now since I have noticed it, it is annoying. Although the dimming in not super dangerous but I am worried there might be a bigger issue.
2009 Automatic Santa Fe
I just bought a 2007 Santa Fe 3.3ltr with auto trans and all wheel drive. When I purchased it the speedometer did not work. I bought the VSS gear and installed it and now my transmission does not shift properly. Also I had it to the dealership for an ECU update and they said that their computer could not connect to the ECU.
View 2 RepliesWe've got a new 2010 Santa Fe AWD LTD with about 2800km on it. About once or twice a week, under normal driving, we've noticed very harsh shifts. It seems to be the 2-3 shift and is around 40km/h. Just normal acceleration from a stop sign. And just recently a new issue. It seemed like it got stuck mid-shift...
I was accelerating slowly from a stop and on the 2-3 shift the engine revved up above 3000 as if it was in neutral. I eased off the gas and then it completed the shift. My wife took it into the dealer today, but I'm worried they'll send it back as "unreproducible" as we've only had about 1 problem for every 10 hours of driving. We'll see what they say. As you can imagine, I'm not very impressed that we're having these issues before our first oil change...
Somebody mentioned that maybe there's something sticking in the transmission and it builds up enough pressure and then finally makes the shift. But I'm not a transmission expert by any means...
My parents are having trouble with there 2008 Santa fe 3.3 L. The transmission won't shift and the rpm's climb really high. Does that mean the transmission is going or is it something else.
View 15 Replies2008 Santa Fe. Removed 2 bolts and 1 nut as shown in manual. cleared the clip at the bottom outboard corner. What else am I missing? I'm still Unable to remove the headlight bucket. It will only come out about an inch or so then feels like something else is holding on.
View 8 RepliesWhere the adjustment knobs are for the low beam specifically? 07 Santa Fe 3.3L.
View 6 RepliesI have 2007 sante fe. I just replaced the low beam,now the low beam doesn't work at all. I checked the fuse .. Just fine checked the wiring harness and plug no broken wire, no corrosion....
View 2 RepliesI have a 2003 Santa Fe automatic transmission that sometimes will not shift out of 1st gear. Sometimes it works great. I took it to my local garage and he told me that it needed a transmission control module and to take it to the dealer. I took it to the dealer and they said nothing wrong with it at all. I brought it home and still some days it works great and some days will not shift out of 1st gear. What part needs replacement?
View 2 RepliesI have a 2010 Santa Fe Limited. When I first bought it, I'm pretty sure the headlights would delay turning off for a few seconds after removing the ignition key. Now they turn off as soon as the ignition key is turned off. Is that normal? I can find nothing in the User Manual and the dealer does not seem to know how it works.
View 2 RepliesI have a 2004 manual transmission Santa Fe. I've maintained it very well since new.
About 6 months ago I noticed it was getting difficult to manually shift gears. It wasn't grinding or anything, just "hard" to get it to go into the various gears while driving. Before, I could shift into any gear with just 2 fingers on the gearshift and it was smooth as silk.
I went in and had the gear oil changed. This was something I didn't even know needed to be changed and the guy said most people never do. They showed me the oil they took out and it looked more like black water than oil and smelled kinda funky. They changed the gear oil out, but still no difference, and in fact it's getting worse.
The best way to describe it is the only way I can really shift gears now is to find that "sweet spot speed" where the gears will change on their own (so to speak). I find it particularly difficult going from 1st to 2nd, such as when starting from a stop light. People almost rear-end me now as it takes me longer to get it into 2nd gear.
Once in gear it runs perfectly, no problems. The clutch seems to be working normally, except perhaps while stopped in 1st gear, it sometime seems to jerk a bit, and I find this most noticeable if I'm stuck in very slow moving heavy traffic with the constant stopping and then moving forward slightly and such.
It is almost impossible to "gear down" into a lower gear unless I'm at the speed where it would normally go into that lower gear on it's own. The best way to describe it is how it is possible to drive a standard transmission car WITHOUT a clutch if you shift at just the right time/speed. But I DO use my clutch, but if I'm not close to "that speed" it's really, really difficult to force it into another gear, and the few times I do try and force it, I'll often get a bit of grinding.
Model is 2008 Hyundai Santa Fe GLS 2.7L
A month ago I started noticing it was sluggish to shift from P to R/D but i had no issues starting in P mode and the car would drive fine. I thought it might due to cold weather so didn't think of it too much.
Two weeks ago it was really hard to shift the gear from P mode and I nearly got stuck in middle of the road unable to shift from R to D. I applied a lot of force on the shifter and it finally budged into D and car drove with no issues. I parked and did my chores came back and the car would not start at all.I put the car in N and it started and was hard to shift back in D but I drove home without any other issues.
It died again in my drive way but this time the gear was nearly impossible to shift and I thought I almost broke it and the panel was not registering it was in P and the key was stuck in the ignition. After messing around for some time I was able to get it into N and put my hand brake on left the key in the ignition and disconnected the battery.
Today I opened the center console & battery tray these are my findings. The inhibitor switch was slightly misaligned from the N position.
1. The shifter moves freely once the linkage is disconnected by removing the tiny pin.
2. The inhibitor switch was slightly misaligned from the N position. Once I manually adjusted it I was able to start the car.
3. I reconnected the linkage pin, make sure the inhibitor switch was in N position and started the car but it was again nearly impossible to switch to P/R/D
4. My brake lights work fine.
5. I was able to remove the key once I completely disconnected the battery.
What can be the issue here ? Inhibitor switch ? The shifter assembly ? Linkage?
While driving today I noticed that something didn't look right in the gearbox of my santa fe. It turns out that the cover for the shift lock release is gone. I have no clue what happened and for some reason its bugging me so I need to get one.
View 7 RepliesI have a 2008 2.7 all wheel drive santa fe automaic. It has 110 Kilometers on it. It is stop and go traffic everywhere, terrible roads, and lots of hills. I have actually only owned it for about 14k kilometers.
It has been fine since I bought it a year ago up until about 2 months ago. I was coming to a stop and as I got right to the end of my stop, the car jerked and made a clunk sound. No smell. I could tell it was when the tranny was coming down from 2nd to 1st. I tried to replicate it but got nothing. Ignored it but then it happened again. It seemed more prevalent when I was moving from 1st to second to stop over and over.
As I began to pay attention more and more, it happens much more when going up a hill or down a hill and almost always happens when I am about to make a u-turn and the wheel is turned all the way to the left. When it happens, it isn't always a big jerk. It never happens at speed, the other shifts are fine, and if I shift from reverse to drive too fast and accelerate, I get a clunk as well.
I'm new to this and not really sure if I'm doing it right. I need to know how to take the gear shift knob off my 2008 santa fe.
View 3 RepliesOn my Santa fe 2009 , Just noticed that I can shift from PARK to R, N, D or anything else without pressing on the brake. I checked the gear sticky by the mechanic , and we found that the lock on the gear sticky not exists. So I am worry if that normal and it's like safety option that not exists on my car? Also , is it something that may case damage to the transmission , or just Safety option .
View 8 RepliesI have a 2009 3.3L santa fe integral transmission and for the second time they have a really bad shacking in the steering wheel and in the stick shift when I'm on the road the same thing like your drive on the side road bump to wake you up. I stop two times on the side of the road to find if they have anything abnormal but with no resolute.
My oils are all ok and no loss of performance of the car except they consume a little bit more gas (around 10L/100Km. The last time this happened the arm shifter vibrated.
Having issue with those plastic shutter flaps under the gear shift console? I think something might have been spilled in there because they have a tendency to be 'sticky' when moving the gear shift back and forth. Sometimes it gets bad enough that they get jammed up trying to move it forward into park. What I'd like to do is take the console cover off to get at them to either clean or replace them. Have part of the gear shift console off?
View 2 RepliesOur 2009 Santa Fe AWD Limited shifts hard first thing in the morning when my wife shifts into reverse to back out of our parking space. This is a real hard THUD kind of shift, where the car jerks. After that, all shifting is normal. We don't have any other problems with the transmission when driving.
View 6 RepliesWe went camping and my girlfriend wanted to take her brothers fishing boat for him, on the way back the electronic stability control light came on and when we reached our destination we discovered it wound not shift into or out of park without using the key override.
2011 front wheel drive santa fe ...
The area where you shift transmission gears isn't lighted. Find that strange even though you can see what gear you're in on the lighted panel. Gear not the right term, but think you know what I mean.
View 4 RepliesI notice on cold days my transmission hesitates to shift and holds 2nd - 3rd for a long time before finally shifting. Once the car warms , all is fine. Will and what could the dealer do for this? I would like it looked after before my warranty runs out.
View 11 Replies