Santa Fe (CM - 2007-12) :: Fuel Level Sensor - Gas Gauge Started To Fluctuate From Full To Empty
Jan 16, 2016
2008 hyundai santa fe. 106,000
Bought the car six months ago.Found out 2 weeks later we couldn't put gas in it. Dealership refused to fix it because we bought as is. So we managed to find one gas station in a 20 Mile radius that we could put gas in it.It takes around 10 minutes to put half a tank in. Shortly after that the gas gauge started to fluctuate from full to empty. And the check engine finally came on. Had the the check engine light checked.Fuel level sensor A was faulty. Took it to a local Goodyear in stead of the dealer ship. The sensors were 119.00 a piece and the labor was 145.00 to replace both. Had both replaced .Fuel gauge is working correctly now. But still having issue putting gas in car.
View 1 Replies
Advertisement
My car is still at the dealer after having the recall done because they can't get the fuel gauge to start working after they performed the recall. But the gauge had nothing to do with the recall you might say. Correct. But prior to the recall being done the gauge was acting funny. Going from full to empty to 3/4 back to the current level.
I told the dealer about this and they looked into it as they were doing the recall. Now they said they replaced the fuel level sender unit, certain wiring connections but to no avail they still can't get it to work. So my question is, what is the type of Gremlin that could be causing this?
View 4 Replies
My 07 Santa Fe fuel gauge doesn't seem to be working. what can the problem be??
View 106 Replies
When my fuel gauge gets to 3/4s full it stops working and goes to empty. My range display also goes off. When I refill it works again until it reaches the same point.
View 5 Replies
I have a 2007 Santa Fe Limited with 112000 miles on it, and its having some issues with the fuel gauge. It doesn't tell me the accurate gas level in tank.. it's either half-full or on empty. The check engine light is also on. What could be the problem? Is it an expensive fix?
View 1 Replies
I have a 2000 Silverado Z71 with the fuel gauge swinging from empty to full and all in between. I have heard of others doing this. I guess maybe its time for a new fuel module. It's been doing this for a couple of years, just keep putting it off. Is it easier to move the bed back or drop the gas tank? Also I have developed hard starting problems here lately, It having too crank extra long before it starts up. Could this be a sign the fuel pump is getting ready to go out.
View 8 Replies
Full tank and the gauge reads empty. Has happened to me a few times. Occurs after a fillup and disappears after the car is left to sit for a while off. I would hate for this to happen on a long drive. Dealer hasn't been able to duplicate the issue. Am wondering if this might be related to the hiccup in some way. Also, am wondering if this is a fuse issue.
View 8 Replies
I'm new to the Gen 1.
All has been well in just over a month of driving the car and about 3300 miles logged. The 12v, Aux battery was dead from the car sitting on the lot for so long (I replaced with a new OEM Toyota 12v battery) After a week of the car experiencing dim headlights, and various other electronics
No codes or CEL though.
Now that the 12v battery has been replaced, the car runs exceptionally well, aside from an intermittent fuel gauge issue where it only reads full bars (completely full) if I let the tank get to empty (Flashing single bar) or close to that. If I fill the tank from s
View 4 Replies
The fuel gauge on my 2000 Blazer is flipping from empty to full. (Even as I drive down the road it moves.) And nothing in between. The fuel pump was replaced about a year and a half ago. I've been told the fuel pump controls the fuel gauge. So I'm wondering if there could be a loose contection or if this is a sign the pump will go bad again.
View 6 Replies
So yesterday I was driving home from work.. I know my tank was 3/4 full. All of a sudden, my low fuel light came on and my gas gauge needle went to empty.
The needle sits at E, but it still says about 20 miles till empty on the MFD. When I left the house this morning, it said 5miles till empty.. by the time I got to work, it said 20. Kinda odd..
I will hook up the vagcom when I get home tonight, any area I should scan for? or just a complete scan? There is no CEL error on the dash though. What I could look at to fix this?
View 4 Replies
I have a 2003 Buick LeSabre Limited, and everything was going fine with it till recently. The Fuel gauge started to go haywire as in the needle would go to full, then go back down to a Quarter, then back to 3/4, then drop all the way down to Empty, this is still occurring. At first I believed it to be the fuel level sensor, but then I started to notice something else.
A warning message came on stating that the oil level was too low, but when I checked the oil level it was fine, and last night when I was driving with the air conditioner on, I hit a bump and the air conditioner stopped working. I pushed the off button, and was successfully able to make the air conditioner to come back on with out having to restart the car.
The horn has also started to go in and out, and I do not know if they are all linked together by a type of computer or if they are separate.
View 8 Replies
Ok so the fuel gauge says empty and the low fuel light stays on even though the tank is full. I'm assuming its either the gauges or the sending unit. If it is the sending unit where is it located on this car?
View 4 Replies
fuel gauge does what it wants? It goes down to half way then goes back to full or sometimes even empty. Not a big deal for me because I have gotten used to it. But I would hate to have my wife in here and she thinks it's good and run out.
View 14 Replies
My fuel gauge acted pretty weird today. When I left my house today it was just above half a tank. I was sitting in traffic quite a bit and then looked down and it was below the e. I knew it wasn't empty so I kept going. Got to work. Went for lunch and it said full drove about 5 mins to eat and it went down to half a tank. What's going on? I am thinking of the fuel sender or wiring?
View 3 Replies
I have an 03 f350 4x4 cc long bed and I seem to be having a problem with my fuel gauge. It doesn't show the true amount of what's in the tank and because of that I have run out of fuel a few times.
sometimes when I'm driving the light will come on and the gauge will drop all the way to empty then a little later it will go to almost full even with only putting 10 gals in the tank.
Any fix for this or do I need to replace the sending unit?
View 3 Replies
In the last 24 hours my fuel level sensor is failing intermittently. After filling yesterday the fuel gauge went to zero and the MFD read "---" for any range or fuel calculations. Rebooted the car ( ) and it came back on, then off again. today it seems to be working, but I'm waiting for the other shoe to drop.
View 5 Replies
I've been having a very erratic fuel gauge issue as of about 2 months ago. My fuel level would register full, when in fact I knew it only had 1/2 a tank or so. Then 5 minutes later it would be pegged on full. Under a 1/2 tank the gauge would read any where from 1/2 to empty from 1 minute to the next. So last week I decided to drop my tank and take a look. I was thinking maybe my fuel sender was broken, maybe a loose wire in the tank, or even that my float had dropped off in to the tank.
After dropping the tank, I removed the PK-Up and sending unit and everything was intact. I placed my ohm meter on the sending unit and it checked out fine. So I took the Pk-up and rolled back up underneath the truck and plugged it back in. I had my son turn the key on and off while I moved the float to different levels in order that it would register. It registered empty, 1/4/, 1/2, 3/4 and full just fine as I moved the float to those levels. If you leave the key in the run position and move the float, it won't register or better said, the in cab gauge will not adjust with the movement.
You have to turn the key off move the float and hold it there, then have your assistant turn the key on and the gauge will show the position that you've moved and held it at. I simply removed the plastic cover from the sending unit, and sprayed it down real good with electrical contact cleaner. I didn't scrub the copper contact area at all.
I was concerned that scrubbing might remove more than I wanted to, and really mess things up. I attached an Ohm meter and checked resistance thru out the float travel. All checked out good and I reinstalled it. So now my fuel gauge is working as it should be. I did make a video while I ohmed the Sender Unit thru it's travel, but for some reason it won't load.
[URL] ....
View 5 Replies
I have had my PIP for just about one month now and I have only filled up twice. This car is awesome! I noticed when I filled up the last few times that the last block on the fuel gauge started blinking and my miles to empty reading was pretty low. However, when I filled up the tank, it only took around 9,2 gallons. Doesn't this car have a 10.6 gallon tank?
View 19 Replies
I have a 97' F-150 4.6 L and I've been having some fuel gauge issues.... I filled up my tank up and I drove it 130 miles and it still said full tank... even when I had 1/2 I would start it and every time I started it it would jump up all the way to full and slowly drop down. Then randomly last night it started working... I noticed as I hit rough patches in the road and bumps it would usually fluctuate, but it would also fluctuate up... It read I have 3/4 tank last night and I go to start it today and its back up to full! I don't understand... Wouldn't a bad sending unit just stop all together?
View 1 Replies
When the gas gauge of my recently purchased 2007 Santa Fe GLS 2.7 automatic is on E it will only take approx. 40 liters (11 gallons) at the pump. Manual says it's a 75 litre (19.8) gallon tank. Called dealership and service advisor said "they are all like that, you can go quite some distance on E". I think he's full of something that creates gas and there's a problem with either my float or the sending unit in the tank. Why in the world would anyone make a vehicle with a "reserve" pass E almost as much as what the gauge reads before E?
View 6 Replies
I know the code is fuel level sensor, but i can't find the parts online. nothing comes up with the part name fuel level sensor. What is the part number for this or the number for kit because i believe there are 2 sensors?
View 1 Replies
