2007 SF SE 3.3, approaching 60,000 miles. I'm feeling a front steering wheel shimmy on "heavy" braking, as in a recent trip into the Adirondack mountains with twisty roads.
View 5 RepliesI have a 2007 Sante Fe Limited that has 93k on it. Within the last year I have noticed the steering wheel will shimmy when you apply the brakes at high speeds, it's slowly came to the point now that anything above 40mph will cause the steering wheel to shake while applying the brakes. I am guessing I have warped or unevenly worn front rotors. The car supposedly had a break job done at 74k and this started happening at about the 90k mark.
I was looking at these : Front Performance Brake Rotors Posi Quiet Ceramic Pads for Santa FE 07 09
Second question, any tool list or required sockets sizes to complete a front rotor and pad replacement? I have a floor jack, jack stands, a set of 3/8 deep metric sockets. I also have a breaker bar. This is my only car so I want to make sure I have everything I need before I start taking stuff apart.
Recently picked up a 2007 Escape with 108,000 miles. The vehicle is in great condition with a full service history. Recently I've noticed a bit of shimmy in the steering wheel and noise from the front drivers side wheel accompanying the shimmy.
At speeds of 50mph+ the shimmy will start. When going straight there is not much of an issue but when a gradual right hand turn on the highway the shimmy starts. Back to straight and it goes away. Not really noticeable on left hand curves.
Steering issue?
Tie Rods?
Bearings?
I'm going to dig into it to get it fixed.
Have a 2009 BMW 328i with 78,000 miles. In the last year, the front brake pads and rotors have been replaced by the dealer 3 times, each time because of "warping" which is their diagnosis of a steering wheel shimmy (left to right oscillation) that occurs under light to moderate braking, especially at highway speeds.
The strange part: replacing the rotors and pads seems to solve the issue, but only for a few hundred miles.
I am led to conclude that something is causing very accelerated uneven deposition of pad material to the rotors - but what could it be? Suspension components and bushings have been inspected and check out. So do calipers. Recently completed: four wheel alignment, wheel rounding and balancing did not solve the issue. One dealer will no longer look at problem until "all four tires replaced" - but tires look fine, they are OEM RFTs with about 4/32nd's of tread left. Car seems fine cruising on highway - steering wheel shimmy only occurs under braking.
I recently bought a 1998 f-250, regular cab, long bed, 4x4, 5.4l triton, automatic. The truck was involved in a wreck by the previous owner and I am trying to repair the damage. He hit some ice, slid off the road, and collided with a log cabin.
The visible damage was done to the driver side front. The bumper, grill/surround, header panel, headlight, turn signal, fender, and hood all need to be replaced. When you drive the truck there is a shimmy coming from the front that can be felt in the steering wheel. When going straight and releasing the steering wheel it pulls to the passenger side. The driver side front rim might be bent? Which might prove interesting if I have to replace it (7x150mm).
This is my first Ford truck. I was willing to take the gamble on fixing it up. I hope that it works out and I am able to do so. What years/models can I source these parts from?
For the past few months when the vehicle is cold (by "cold" I dont mean physically cold, just mean it has been sitting all night in my driveway and it's still 90+ degrees outside) and I start driving, I seem to have this shimmy or shake in the tires/steering/steering wheel. Once my car seems to "warm up" (driving a mile or two) it goes away and my car is extremely smooth.
Could it be tires (I've tried rotating)? Suspension? Wheel bearings? I'm lost for even imagining what it could be. I don't believe it is engine/trans related, as it idles/revs just fine and shift perfectly...
santa fe 2009 - 77000KM - AWD
Few months ago , I notice that the steering getting heavy after driving like 15Kms. At the morning it's normal , and while driving also normal , Just heavy when the vehicle at low speed. I checked the Fluid , it was very dark , SO i changed it with new oil , but after like week , it be heavy all the times , also some noise sound at the power steering bump when move the steering .
I check at work shop, the advice me to change the fluid again, since they assumed that the fluid not suitable for the vehicle.
Lexus es 350 steering wheel is heavy/tight when turning?
View 2 RepliesDriving 30 mph, oil light came on, immediate loss of power braking and steering. Engine did not stop, oil light disappeared yet still had loss of power steering and brakes. Still in D. Policeman had to stand on brake pedal to get into Park so that engine could be turned off. Towed to dealer in next state and dealer said cannot replicate so cannot fix.
Car is 2012 Santa Fe w/ less than 6,000 miles on it.
I've owned my IS F for a little over two weeks now, and I have noticed under several occasions under heavy breaking (close to 70-80% breaking capacity) that I have to fight the steering wheel to keep the car tracking straight. This is anywhere from speeds of 80-90 mph coming down to 40-50 mph. Could this be an issue related to the front control arm bushings? My F only has ~41,xxx miles and tires are brand new (OEM Spec) Continental ExtremeContact DWS. No other alignment issues known as the car doesn't track left or right either.
View 14 RepliesI've got a 2006 Camry (4cyl) with 136K miles. Yesterday, I noticed a mild shimmy in the steering wheel around 35 mph. If I take my hands off the wheel it shimmies back and forth about 1/4 inch or so. I pulled over and checked my tires, but didn't find any obvious defects. The shimmy goes away at higher speeds, and drives fine at freeway speed.
I am somewhat certain that I need new struts pretty soon because there is some slight inside cupping on the front tires.
2004 Dodge Intrepid. 70000 miles. Shimmy in steering wheel. Seems to come and go at about 7 second intervals. Suspension, tires, balance, alignment all check OK. One mechanic suggested steering rack valve problem. Could the computer possibly have anything to do with the 7 second interval?
View 16 Replies2003 Honda Civic. Any speed between 30 and 50, car suddenly starts pronounced steering wheel shimmy, too intense to ignore. You can park, start up again and it's gone.
View 1 RepliesI'm wondering if I have a problem or if its a matter of not used to this new "fly-by-wire" steering system cars are going to.
When I put my hands at 11 and 2 on the steering wheel and slowly slide my hands down to 9 and 3, the steering wheel has a shimmy/vibration. Doesn't happen while driving, turning, or anything. Is this normal? I could get the camcorder out and do a small video of it.
I have a 2005 Subaru Legacy and the steering wheel shimmies all the time. My Subaru mechanic can't find a reason for this. I did try another general mechanic, without telling him that this appointment was really a 'second opinion' and after rotating all the tires, numerous test drives he couldn't figure it out either and referred me to my original mechanic, telling me that he's the best Subaru guy in town.
View 5 RepliesMy wife's Corolla has 71k on it. She recently had tires put on, and now she has a shimmy from about 30mph on up. It seems worst at 60-65. In all of my years, this is a classic example of a tire(s) out of balance.
I've taken it back to the shop that replaced the tires twice to make sure they're balanced, and then took it to a second shop to be certain that the first shop was on the up and up and actually balanced the tires. Everything checks out as being balanced.
Another possible cause could be a bad/worn out axle. The whole front suspension was rebuilt 9,000 miles ago. Everything checks out and there are no leaks anywhere. So that rules that this as well.
What else could it be? Is it possible that one (or more) of the new tires are out of round? Maybe a bent rim? But is seems awfully coincidental that this only started happening after the tires were replaced. What might be the cause of this mystery shimmy?
I recently bought a 08 question Sante fe we just drove it. When it got to 70 to 80 mph i could feel a vibration in the steering wheel. What it could be. I bought it with 56k on it. Put new tires on it cuz the original tires were worn on the inside on the rears.
View 11 Replies2002 SC430 with 50k miles. I have a set of aftermarket Dolce rims that are 18" with the stock size tires. I have the eccentric spacers on them as well. They have been mounted and balanced. I also have a set of Dunlop snow tires on my stock rims. Obviously I do a seasonal change over.
With either set of tires I am getting a steering wheel shake at 60-65 mph. By 80mph its gone and the car glides perfectly. There is no pulsation in the brake pedal and there is minimal wear on the pads. Below 60mph there is no issues as well.
Tires are wearing evenly. Some roads will make the movement worse, but it always goes away at around 80 mph.
Now both sets of tires were mounted and balanced by the same shop. I assume that could be it...there machine is faulty. But I would like some other possibilities before I try somewhere else.
I have a 2001 Toyota highlander with 160000 miles on it. I recently got new tires and alignment. The problem is when I reach 65 my steering wheel starts to shimmy. The wheels were balanced and the shimmering last for ten to fifteen minutes. What might be causing this?
View 5 RepliesVibrating at 50-55mph, also at 75+, was reduced considerably when forward transmission mount was replaced. Still shimmies and feel little in the steering wheel. Have replaced tie rod ends, back struts and tires. Need to figure out what I am missing.
View 2 Replies2010 FJ Cruiser has an intermittent shimmy that you can feel in the steering wheel at highway speeds. Noticed it not long after new tires. Go around a long curve and it starts, then stays until you go around another curve and then stops. It is as if the wheels have to align a certain way for some harmonic effect. I had the tires rebalanced and rotated. My mechanic said they balanced up very well. Shimmy is better but not gone. Wierdest thing is that when it happens, if I keep my foot on the gas and gently press the brake the shimmy stops and the returns as soon as I let up on the brake. When I asked my mechanic if it could be 2 slightly warped rotors he said the shimmy would be worse braking not better.
View 4 Replies