Santa Fe (CM - 2007-12) :: Erratic Gas Gauge And Check Engine Goes On
Apr 21, 2010
Having 55k on my 2007 Santa Fe, and having brought it in 1 month ago for that 46k check up, this is my problem since. It started with an erratic gas gauge last Friday ,my tank said empty knowing i still had 1/4 tank, so l filled it up, 30 minutes later light goes on seems no gas in it, 30 seconds later check engine goes on, the Fe is running fine though, I called the dealer and made an appointment for next week, he said as long as car runs fine I can drive it.
Engine light goes off when fuel indicates 3/4 full, but erratic gas gauge seems to fluctuate.
View 46 Replies
Advertisement
I have an 08 Hyundai Santa Fe. Check engine light comes on, fuel gauge goes from empty to full, to half, to 1/4, just all over the place. Even ran out of gas a few times on the side of the road not knowing how much fuel I have.
What exactly causes this problem? I've heard "fuel sender" I've heard "fuel pressure sensor" etc. All are different parts. Need to get this repaired asap.
View 8 Replies
I have a 2007 Sante Fe with the 3.3 engine. Having a problem with the Fuel gauge not reading correctly and a check engine light. The engine code indicated that the problem was with the sending unit in the tank on the "A" side (behind the driver). I checked with Hyundai and with a tech line service and they indicated that it was a common problem and I needed to replace both the "A" & "B" units to correct the problem. I did that and cleared the codes and it set another code indicating that the "B" unit was the source of the code. I pulled the "B" unit again and checked the wiring and the problem still was there. I switched out the units on the "B" side again with the old unit and the problem is still there.
View 4 Replies
My dads 05 f250 6.0 PSD. He says he'll take off in the morning and the fuel gauge will randomly drop to empty and trigger the low fuel light, but then also the Check Engine Light will come on. My brother did a code scan and no codes come up. Where we should be looking to remedy this one?
View 14 Replies
My wife was complaining of the ESC light came on and off. Rough idle. Also has a check engine lite.
View 23 Replies
My 2007 Hyundia Santa Fe has an erratic knocking/clicking sound when idling & has for about 6 months or so. Other than the clicking noise it drives just fine. I am wondering if this may be a result of a bad oil change experience I had in 2012. I'll explain ....
When driving home, once the car had warmed up, my oil pressure warning light came on whenever I came to a stop or idling. I thought this was strange but thought maybe it had to do with new oil fill & would go away.
All I knew was I didn't have the problem before the oil change - nor have I ever in all the time I have owned the car - seen the oil pressure light come on and stay on once the car is started. So I brought the car into Hyundai as soon as I could to explain the situation. They opened the oil filter compartment and quickly realized that whoever changed the filter neglected to put back a part that sits on top of the filter that regulates the oil pressure (only a $15 part without which the damage & cost of driving without is potentially huge).
There is more, but I think you get the drift. So, I am wondering if possible damage as a result of that faulty oil change might have something to do with my current problem or is it not possible given the time/km between when that happened and now? The car had just over 80,000 km at the time and currently has aprox 105,000. I have properly maintained the oil etc since that as well as prior to.
View 13 Replies
It came on 2 months ago, took it to dealer, code said "erratic idle", it idled fine, smooth as it always has been, dealer turned of lite, said let him know if it comes on again.
View 2 Replies
I have a 2009 Santa Fe, v6, and the check engine light and "ESC OFF" lights are on consistently.
I read the check engine light may be the gas cap so I replaced it but the light is still on. Took the car to Advanced Auto Parts and they said it was related to the cruise control.
I also read that the ESC OFF light may be due to alignment issues. I had an alignment done last Saturday but the light is still on. When they checked the check engine light they said it was related to the emissions. This was at a Firestone shop.
Any common cause for these lights to be on at 30,000 miles? I changed the transmission fluid also recently which the manual says to do at 30,000 miles.
View 4 Replies
I just purchased a 2005 elantra with 133k on it and she runs fine other than a slight erratic idle. And by slight I mean it will jump about 50-100 rpm idling and every blue moon it will jump up to 250 rpm sitting there. After idling for a while my CEL came on with the following codes.
P0507 idle air control rpm high
P0506 idle air control rpm low
P0170 fuel trim malfunction bank 1
P0121 throttle position sensor
What could be causing this? I took the iac off and cleaned it with maf cleaner but it didn't work.
View 9 Replies
At roughly 140,000 miles, my wife's '07 Santa Fe GLS has thrown a P0456 code. Does this code on a Santa Fe common?
It is "evaporative emission system leak detected (very small leak)." The good news, I guess, is that it is 'very small.' However, being small may make it more difficult to detect.
View 3 Replies
I've recently bought used Hyundai SantaFe 2007 and the engine check light lit up. I've bought EML327 OBD2 scanner, it showed P1405 meaning "EGR tempereature sensor incorrect". Some of my friends says it has something to do with CPF filter and EGR valve. They think, i should clean both CPF and EGR. Car service told me that DPF (not CPF) filter cleaning costs arround 350eu and one service told me to simply take it out and reprogram car computer. As far as EGR valve cleaning goes, no service wants to do this. I don't really know much about cars, so my main question is what would be my next step in trying to fix this error.
View 3 Replies
My 2010 Santa Fe is only 2 month old and has 2000km now the check engine light is on. Went to the dealer and found out the code is P200A -Intake manifold runner performance. And they just clear the code. What does this code mean?
View 22 Replies
i have a 2008 santa fe with a 2.7 61,000 miles 2nd owner ,out of warranty. It started missing and the check engine light came on. I took it to a local parts store who put an analyzer on it an it showed the #3 spark plug was misfiring. I am hoping its the plug. I do my own work but havn`t been able to find a correct sequence to replace the plugs.
View 3 Replies
I recently bought a Santa fe 2007 Limited 3.3L, it has 101500 miles. The issue is that when i run the scan it has 3 minor sensors that needs to be replaced but my biggest concern is that the check engine light does not come on in the dashboard even when i turn the ignition to on.
I need to know if there is a fuse that can cause this or a bulb in the dashboard that i can replaced for myself or if it is something else.
View 7 Replies
I have a 2008 Santa Fe with 64341 miles on it. This past weekend we had it inspected at the dealer. Drove it home, in the rain/snow, and it sat in the drive way for a day while it was raining. This morning when I went to go to work, still raining, the check engine light came on and was flashing. Went to auto zone to get the check engine light code, the said that it was a P0303 which according to them was a misfire in cylinder 3. So I brought it to the dealer to leave it and have them check it out. On the way their the check engine light started to flash, when I walked in and told the service desk that they said that it was a catastrophic failure.
View 10 Replies
I have a 2011 Santa Fe 3.5 6, FWD, 54k miles, that has been having the check engine light go on and off. Recently with in the pass month and a half the dealership has perform the recall adjustment, changed the manifold intake assy, changed the ECM with all visits rendered a P200A code. After changing the manifold assy, check engine light was off and fuel gage was at a 1/4 tank. Stop by a gas station and filled up and the light comes on. Remove gas cap after turning off engine and secured gas cap as directed on the cap of one click and light stays on. Turning into the dealership for the 4th time.
View 4 Replies
My 2008 just showed the light at 108,000 kms. Its a long drive to the dealers. My old Hondas would flash a code number in the instrument cluster if I shorted out a pin under the dash. Is there a way to do this with the Fe?
View 6 Replies
To start off with I am not car smart! I have a 2008 Santa Fe 3.3L V6. Last year about this time (December) I had problems with the vehicle upon start up would be miss firing and the check engine light would come on. I would turn the vehicle off and restart and it would be fine and not happen again sometimes for a week and sometimes for months. I hooked it up to the computer and found that it was missing on the #6 cylinder. I had the coil pack replaced and that seemed to fix the problem (replaced spring 2011). About a week ago it started doing the same thing (December 1). Upon initial start up when the car is cold and the outside air is very cold it started missing again and having a rough idle. Would turn of the car and restart and would run fine but check engine light would come on.
Hooked it up to the computer once again and it read random misfire. This has happened twice now in two weeks with the same reading each time. Always when it is cold (engine and outside temp) and seems to reset itself when turned off.
I spoke with a mechanic who recently had this same issue with a different vehicle and after trying many things replaced the engine coolant temp sensor and that did the trick. He said it was a cheap start therefore i bought the part and now am looking to replace it. The only problem being i am car dumb and cant find it. I have done many searches and the diagrams i have found don't do me any justice. The past posts on here have given pictures of older models that dont match what i am looking at. It probably is right in front of my face. Any picture of a 2008 that will show the correct area I should be looking at? The vehicle only has about 57,000 miles on it.
View 9 Replies
My 2007 Sante Fe had problem this week. Took 6 attempts to start engine, then ran smoothly the rest of the night. The check engine light came on while trying to start vehicle.
Next day I changed the spark plugs but now find that the vehicle jerks when idling. Runs fine when going but jerks and bucks at stop lights and stop signs. Just added fuel injection cleaner to see if that may support the situation.
Engine light has come back on again since resetting. I have read several suggestions on internet regarding leak in vacuum line, Coil Pack damage due to faulty hose, even faulty 02 sensor.
View 2 Replies
I have been having this same problem over and over again. Check engine light comes on with P2127 and P2106 codes. 1st time they said they needed to flash the computer. Worked fine for maybe 6 months and then again. While this is happening you cant go over 2500 rmp with it floored and takes forever to get up to 60-80 kph which is the fastest it will go. Sometimes after starting stopping 5-8 times it will be fine. The second time they replaced the gas pedal because the sensor was deemed bad. Now about 8 months later here up it comes again. This time I was pulling my boat and I thought I wasn't going to make it up the hill. I don't trust this car anymore especially for long trips. So anyway they updated the computer again, and then 4 days later up it comes again. Also inner tie rod ends I have replaced 3, just so you know I only have 52000 kms on this 2008.
View 10 Replies
I have a 2009 Sante Fe with 60,258 miles. I had the timing belt changed at 60,000 miles at the dealer. I now have a check engine light that shows the following two codes.
P0321
P0612
These codes are related to a timing belt change? Could a sensor have been removed for the work and not replaced correctly?
View 5 Replies
