I have a 2007 Santa Fe with the 2.7L engine and 62K miles. At 65-70 mph I have a very noticeable miss. The check engine light has not come on and a scan at a Parts House shows no trouble codes.
View 15 RepliesWe have had had our Santa Fe for a year, done 38000 km and love it. The car will start up and drive around town fine but as soon as the engine is under load at highway speeds or driving up a hill it loses all power.
In Automatic when this happens the gear will drop back to third. You can switch it over to manual mode and slowly accelerate back up to around 80-90km/hour with your foot flat to the floor but the rpm don't get above around 2000 to 3000.
If you stop and turn the engine off for a minute or so, when you start again everything will appear to back to normal but after another minute or two the problem will be back. The engine malfunction light comes on and sometime it's flashing but at other times it's constant.
The car's been in at our local Hyundai dealer for a week but at this stage they still can't quite figure out the exact cause of the problem. The code they pulled out suggested it was the exhaust particulate filter (apparently quite an expensive part) so they replaced that but it didn't fix it. They've also replaced the fuel filter and some temperature sensors that are part of the particulate filter apparently but still no joy.
I have a 2010 Santa Fe AWD, I notice that when I apply the brakes at 100 KM or higher I hear a 'thumping' noise, the noise is hard to describe, thumping is the best I could come up with, the noise goes away once the vehicle is down to 80 KM, why this is?
View 7 RepliesGot a strange one here. 1995 Buick Park Avenue, supercharged 3800, 159K miles... an older car, but an unmolested one. A little over a week ago I began to notice an occasional miss when cruising along at highway speeds, along with a slightly rougher idle. Both the fuel filter and the plugs/wires predated my ownership of the car (a little more than 6 months); so seeing no obvious culprit, I replaced them and hoped for improvement.
Unfortunately, neither had any impact. The missing continued to become more noticeable. It was never present under acceleration. Most of it was like a split-second long version of "bucking" that could be observed while cruising at lower (<2000) RPMs. It was also very noticeable at idle. Eventually a code was set: P0341, camshaft sensor issue. If the story had ended there, it would have been just another night in the garage. But it didn't.
As I was noticing the aforementioned symptom increase, I also noticed my voltmeter would occasionally "twitch" in the downward direction. Eventually I had an incident where I came to a stoplight... transmission in Drive, foot on brake, gauge dropped to around 10-11v. It returned to 14v momentarily, but dropped back down, held there for several seconds, returned, etc. No particular rhyme or rhythm. Of course my first guess was that the alternator was failing; a separate problem from the other.
I checked all the relevant connections (at the battery, at the alternator, etc), and cleaned them for good measure. All were tight, relatively clean, and the cables showed no resistance on the ohmmeter. It happened that I had another correct alternator on hand (used/working pull), so I swapped it in. No change. I reinstalled the original and was back where I started.
On my most recent drive, I noticed both issues had become very noticeable. The drop in voltage was happening at nearly every stop, and the missing was happening a few times per minute while coasting along. There seemed to be some correlation between the missing and voltage fluctuating, but it wasn't absolute.
I decided to attack the voltage issue again. Re-checked all the cables; same result as before (all OK). Looked all over the car for possible bad grounds, loose connections, or other visible problems, but found none. My next thought was to run a jumper from B+ to the voltage regulator's Sense input (have seen issues there on more than a few older vehicles) - but after reading that this car uses the PCM as the voltage regulator, I didn't proceed.
Just to be certain I'm going to have the alternator tested by the local auto parts store. But I suspect it'll pass.
165k miles 4x4 6 speed, bone stock unmolested
Slowly progressing problem over 6 months. Occasional miss at highway speeds uphill has progressed to bucking and jerking during even gentle acceleration attempts.
I hadn't got my cam sensor recall done but no change after that procedure completed yesterday. Oil recently changed as well.
I have a torque pro but it never finds any fault codes even though 'service engine' light comes on sporadically. I'm not sure I'm operating it properly but it at least reads rpm when its running.
I'm contemplating the hutch mod but I'd like to have an official diagnosis beforehand if its possible in my case.
My '04 Santa Fe (135K miles) has been doing this for a little while.
Between 65 - 75 MPH on the highway, under acceleration, I experience what I can only describe as a "shudder".
I don't believe it's a wheel balance issue, because if I'm coasting or maintaining that speed everything is stable.
We have an '03 Santa Fe (2.4L). We are the original owners.
About 18 months ago, one of our Ignition Coils cracked and caused a misfire when then engine was under load. I replaced the coil, wires, and plugs myself at that time.
Since that time, we have experienced intermittent engine jerking while at highway speeds. There does not seem to be any pattern, and it does not happen every time we drive it.
I took it to the dealer who diagnosed a valve cover leak. They replaced the gasket, one ignition coil, wires and plugs. The problem still happened intermittently after that. I brought it back to the dealer, who diagnosed a valve guide/seat leak. Oil is getting into the cylinder and fouling the plug they say.
I could not afford the fix (and was very dissatisfied by the service I received) so the dealer recommended to change the plugs every 3 - 5K miles to get me through. I was told this on 03/31/09 (125695 miles). I replaced the plugs, wires, and BOTH coils again at that time.
Last week @ 130K miles the engine jerked again. I replaced all four plugs again Sunday morning, but the ones that I pulled were NOT look oil fouled. I showed them to a mechanic friend and the guy at the auto parts store. Both agreed that the spark plugs looked almost new. Sunday evening, while driving on the freeway, the car jerked again!
Since this happened again SO soon after changing the plugs, I really have a hard time believing the valve guide diagnosis. Some possibilities I have seen/heard:
- Crank position sensor or camshaft sensor (This was replaced at 78K miles along with the all of the belts)
- Clogged fuel filter
- Bad O2 sensor
- Vacuum leak from the hose that is between the throttle body and the engine casing
- The dealer's valve seat suggestion
I recently had my 2013 Santa Fe Sport serviced at a dealer and finally remembered to tell them about the front windows wind noise at highway speeds. It has been ongoing for quite some time. When the service rep brought my vehicle back to me he told me that Hyundai was aware of the problem, and that it was caused by the moon roof. I did not see any recent posts to the forum or on the internet regarding the window noise, except for some older ones referencing noise related to the side view mirrors and adding insulation to them.
View 3 RepliesNoticed the seat shaking when at highway speeds or when you go over bumps in the road? When my seats are empty, they shake and make an annoying rattle, shakey noise. I had them looked at by Hyundai and was told that there was nothing that Hyundai was going to do to fix them. After battling that for a while, Hyundai did reimburse me a car payment for me to "live with it" and, quite frankly, to shut me up.
View 5 RepliesOwned my 2009 for 6 months now. Ever since purchasing it, car will vibrate significantly at highway speeds when first driving it, then decrease by 90% after a few miles. At first, since I purchased in winter, thought it was cold flat spots on tires. Dealer changed tires 3 times, finally with a new set of Turanza OEM tires. Still does it.
Service manager said he drove new 460's and they all do the same thing for a few miles. I have seen other comments on internet from other owners who report the same phenomenon. Don't think it is the tires since we went through 3 sets and it still does it in the summer. What else could cause a vibration until the car is warmed up?
I own a 2007 Acura TL (3.2) with 130K miles. Last October I hit a pot hole which blew my front driver side tire and bent my rear driver side wheel and upper control arm. After replacing both tires, wheel, control arm and having the car realigned twice by two different Acura mechanics over the past 6months, my car still pulls left at highway speeds. I've noticed that the tires have gotten louder while driving and that both passenger side tires have worn significantly but only on the outer most edge (left side facing car). Before I buy any more tires and spend more $ on alignments, why is the car pulling left? What else could wrong with my suspension?
View 10 RepliesI replaced my tires yesterday with Bridgestone Turanza ER33 (245/45/19).
After replacing the tires, there is is an extreme vibration in the front end of the car when braking at highway speeds (60+ mph). Braking at sub 50mph speeds is completely normal. No lights, no vibration while driving. What could be the reason?
Also while removing the lug nut locks, the locks key broke apart (the black piece came out of the key). After like 45mins of trying, finally we got the locks out. I threw them away.
I searched online for regular lug nuts, but couldn't find any beside ebay. The local dealer says I need to wait for 3 weeks to get them from Japan! Where can I get a set of 4 regular lug nuts online?
I'm now running on 4 lug nuts on each wheel. Could this cause a problem? Could the vibration be caused by not having a 5th lug nut in place?
I just bought the car a less then a month highway speeds car shakes at 120km/h. I just complained to Toyota dealer ship and they put on brand new front rotors and did alignment at highway speeds the car still is shaking and it pulls to the left can it just be tires alone or back rotors because they didn't replace those.
View 6 RepliesI recently bought a 2007 Sonata V6, and the brakes pulsate (when applied) at highway speeds, so I am looking to replace the front rotors & pads. I have been told that the OEM rotors/pads aren't great & that as a result many owners have a brake pulsating/vibration issue.
View 9 RepliesI have a 2007 F150 King Ranch Super Crew 5.4 3v and it makes a ticking sound. I have read about the VCT solenoids and the phasers. My issue is that the ticking noise can be heard at Highway speeds. At it seems to be quicker as the engine speed increase. Not sure what to think. No rough idle. What could this be.
View 3 RepliesFirst, details about my truck. 2007 F150 SuperCrew, 2wd, 5.4, 203,xxx miles on it, leveled with Hell Bent Steel 2.5" kit last year, has been aligned professionally since then, tires are good and balanced.
The issue I have is a vibration, kind of the same feeling when driving on a road surface that has had the top level of asphalt removed before it's resurfaced. It's mostly noticable at highway speeds. Its not a violent type vibration, but you can feel it. There is also a sound, similar to tires with a deep off road type tread.
The sound and vibration more noticeable when making lane changes or when wheel turned towards left, at highway speeds, not as much to the right. I've checked front wheel bearings, they are good, zero play, no loose suspension parts, u-joints are good, no leaks anywhere.
Since it makes the noise and vibration a bit more when moving wheel, could it be a power steering pump? The pump is the original.
So I have been noticing a shimmy/bouncing at highway speeds (between 60-80mph) for a couple of months. It started right after I had a local indy tire shop swap my sliver stock wheels for the chrome version of the same wheel I picked up locally.
Funny thing is I did my front brakes last Sunday and after putting the tires back on, the ride felt smoother at highway speeds. I figured perhaps the indy shop didn't torque the wheels properly (which I'm sure they didn't as they didn't ask me the torque spec and didn't look it up, and used an impact gun to tighten bolts). I torqued my front wheels to 103lb by hand after doing front brakes.
This Thursday, I did my rear brakes and torqued the rears to 103lb. On the highway the shaking/bouncing is back and dare I say more noticeable.
Could it be that I did something incorrect when installing the rear wheels? The tires are Michelin Pilot Sport A/S 3 with about 15k miles on them. Look to be wearing evenly.
I have an appt. on Monday to have the tires balanced at Discount Tire. I asked about their machine and he said it's a Hunter which I take to me Hunter Road Force balancing machine. Is there anything particular that I should ask or know prior to going in?
When I am driving, especially at high speeds on the highway, the Navigation System on my Prius runs pretty slow. As the GPS icon is traveling, the movement is very choppy. It is not a smooth transition. Is there any way that I can fix this?
View 1 RepliesI notice that recently my Santa Fe does not run over 3.000 RPM in highway. Motor goes to close 3.000 RPM but does not shift to next speed and it feels as a lack of power, especially when uphill. Stopping, turning engine off and then on again seams to solve this problem, everything runs ok but suddenly the problem appears again.
My Hyundai is a 2007 New Santa Fe CRDI 2.2 (Diesel engine), automatic.
Im a newbie to the Camry's. Picked up from a relative a 07 Camry for $5k. It has 103K on it.
It has an issue to where it has some codes and the check engine light on with P0018, P0019, P0300, P0302, P0306 codes. They just all cam eup al lof a sudden while driving. Slight miss at idle which is the misfire codes but I can't pinpoint the issue for the P0018 and P0019 codes.
I recently got a used 2000 silverado 1500 ext. cab with a short bed. Has a 5.3L engine. I noticed it has vibrations at highway speeds. I thought it was the crappy tires on it so I had all the tires replaced and balanced. Now it has all new tires and does the same thing. Runs really smooth all the way up to 40mph and then the vibrations begins. It is mostly felt in the steering/dash and pedals. A little more pronounced on accel. but vibrates if your on the gas on not.
Once your reach 65mph, the vibrations stop. I have also noticed that asphalt makes it vibrates more. When I go over concrete overpasses in the problem area of 40 to 65mph it smooths out. I took a look under the truck and saw nothing obvious. U joints feel tight and no play, seen it had weights which appeared welded onto the one piece drive shaft.