2010 UK Santa Fe manual box, suddenly will not set Cruise Control. At same time gear change advisory indicator also stopped working. OBDII tester will not initiate to check things out but first time I have tried this. Fuses checked all OK (I think).
View 1 RepliesI have to press Cancel before I can get my cruise control to work. I had a problem about a year ago where my cruise control wasn't working, and found out that a blown brake light fuse was the problem. Now I turn my CC on and the "Cruise" light comes on, I then press the set button, and nothing. I then press the cancel button and then the set button and then the "Set" light comes on.
View 2 RepliesI have a 2003 2.7 auto. Quite suddenly the speedo and cruise control have stopped working. Everything else works just fine...
View 2 RepliesMy 2002 Santa FE's cruise control has stopped working, light comes on but no hold or anything, any obvious faults they have that I can try. I checked the fuse, that's OK...
View 7 RepliesI was recently on a road trip, using my cruise control extensively (like usual) when it just quit working. I tried to reset to a lower speed, but it would rev itself back up to the original speed. I turned off the cruise control, drove a mile or so and turned it back on. The cruise dash light came on, but the right control buttons no longer worked. No check engine light. It's never worked since.
My local tire shop checked codes and found the tcm not communicating with the mod (cruise module?). I'm looking to take it to the dealer, but I'd like to be better informed with what I may be dealing with before I get there.
Just as the topic states. Works fine in fifth but not in sixth.
View 9 RepliesI have a 2011 Santa Fe 3.5L automatic with AWD. I have had a issue with the traction control indicator locking up. The traction control light on the dash goes on and cannot be canceled by the on/off control. It will reset when the engine is turned off and restarted. It is my understanding that the indicator should be lit when the system is actively meeting a traction control issue.
The dealer has performed service on the vehicle twice for this issue, and on a recent trip the system triggered again. It has engaged and locked on dry surfaces during a moderate turn while accelerating (merging from exit ramp). I have seen it engage under slippery conditions (snow... we live in Wisconsin) while turning and then return to normal once the conditions are stable.
My concern is that since the traction control affects braking in order to achieve stability under unusual conditions, that the possibility exists for a malfunction under braking conditions that might cause more problems than it solves.
Question regarding a 2002 Dodge Dakota, 2wheel drive ext cab 100,000 miles 6 cylinder engine. Cruise control stopped working, get the indicator light on dash, but no cruise.
Would I start with the Clock Spring? Will Durango parts interchange? ABS Light, was told the problem is the main unit that mounts on the driver side fender. Have tried replacing with other units from the local scrap yard, but still get warning lights/sounds.
Got our 2014 back in March and it still hangs in fourth gear after downshifting with the cruise on. Downshifting from 6th to 5th for small hills is fine but on steeper hills when it drops to 4th and hangs in there uncomfortably long.
What I've been doing is switching over to manual and bumping it up to 5th and then 6th. When I don't, it will hang in 4th and rev high and then eventually shift into 5th and 6th one right after the other long after the road has leveled out..
Never had any issues with it before and was working fine on a trip a couple of weeks ago. On the way home I had it on, we stopped to get some food, and then when we started up again cruise control wouldn't turn on at all. I tried turning on and then setting, but nothing happened so I don't think it's the light. Checked the fuse and it looks fine (no noticeable distortion or break to the wire anyway) and brake lights all work.
View 8 RepliesI have a 2004 Santa Fe GLS that the cruise control just stopped working. It will not turn on when I press the ON button. Could it be a blown fuse? I recently had a new AC compressor installed. Could it be related to that? Maybe something didn't get plugged back in?
View 1 RepliesI found two times the cruise control auto on by itself while I was driving on the road.
View 2 RepliesI own Sta Fe 2014 DM CRDi 2.2L diesel engine automatic transmission. Recently I am encountering a problem on my unit, firstly the ABS, ESC, and Hill descent alarm indicator shows on my dash brought it to Hyundai and they replace wheel hub assembly on the rear right wheel. after a week it goes lit again but doesn't stays long it disappear right now it happens from time to time only. Secondly my cruise control wont engage the light stays on but could not keep the speed, Ive check the brake lights they are not busted. The service technician doesn't now what to do and no error code showing on the computer. Last is during start up transmission on neutral or park position the speedometer fluctuates then warning light on ABS, ESC appears.
View 6 RepliesThe Crusie control has a habit of not always operating. Sometimes it will sometimes it wont. I have tried switching off the ignition and restarting without success.
On occasions after not working for 30 or 40 miles it will start working again. Difficult to get the dealer to do anything as they cannot replicate the fault.
My 2007 Santa developed these symptoms recently and need to know if they are related or independent.
1) ESC off message is always lit and button doesn't work.
I checked and replaced fuse 19 in engine bay. Light didn't lit up for next 500 feet and I was able to turn and off with ESC button near knee panel. after that it was back on. My guess is one of 2 Or both 40amp relays in engine bay for ESC is/are bad.
2) Cruise control on/off works but Set doesn't and Cruise is inoperable.
Don't see any fuses for cruise control in engine bay or interior fuse panel.
Same car I posted about a couple of days ago. It was running fine. My son was driving on the freeway, and tapped the brakes to disengage the cruise control, and the transmission just stopped working. It was not in gear after doing this and the transmission would not engage. It was nothing like a slipping transmission. The engine just revs with no resistance.
Got it towed home and checked the codes: P1529, generic 'Check Engine' light from the TCU; P0760 Transmission solenoid C and P0765 Transmission solenoid D. I have googled these codes individually, but not sure how they tie together.
Oh, I overfilled the transmission. Probably a quart too much because I didn't know how much extra I needed for the torque converter. I doubt this is the issue, but I will drain the excess. Where to check next?
My 2010 Santa Fe has some transmission issues.
Now and then I notice the vehicle is kind of slow and every now and then when going from P to R, or R to D, it enters with a bang and after that the Gear indication in the dashboard disappears. At that moment the car is completely sluggish, like if it is some kind of lock mode. I have to turn it off and on again and all is back to normal, however, after an episode that it enters with a bang the transmission doesn't react as well as normally, it takes a while for the car to behave normal again.
The fact that the gear indicator disappears from the screen on the dashboard suggests to me that this is a computer problem more than a mechanical issue.
I just noticed the other day that my cruise control stopped working.
The cruise light will come on, but when I try to set it...nothing. The speed just drops off.
I just recently started having trouble with the cruise control on my 2007 Chevy Malibu.
Last weekend, I went on an 800 mile trip (cruising most of the time) but stopped to have the tires rotated and balanced, and my oil changed halfway through (I was up for an oil change anyway). Got home late Monday, everything was fine. Then Thursday, my cruise control stopped working. The light on the steering wheel comes on to show that it is engaged, but I cannot set the speed.
The owners manual suggested it might be caused by low brake fluid. Checked that, saw it was a little low, maybe a centimeter, and filled it, but the cruise control still doesn't work. Thought maybe it was a fuse, but there wasn't a bad one.
I've seen some talk about it possibly linked to break or a transmission issue. For a few weeks, my Malibu has been making a lawnmower-ish sound when I drive 40 mph or faster. The problem persists whether its in manual or automatic. I didn't notice anything until I got my car back after loaning it to my parents for a weekend.
I bought the car used July 2010 from its first owner with about 37,000 miles. It's about 72,000 now.
On our 2007 turbo diesel auto santa fe the audio controls first and now the cruise has stopped. Had problems turning cruise on would have to press buttons 3 / 4 times to work now nothing.
View 1 RepliesThis morning I was cruising down the highway with cruise control set at 63 mph. All of a sudden the car slowed down and the "Slip Indicator" was displayed and the cruise control was now off.
View 2 Replies