Santa Fe (CM - 2007-12) :: Creaking Noise From Front End When Turning The Wheel
Jul 23, 2012
My parents have a 2007 hyundai santa fe AWD and recently there is this creaking noise from the front end when you have the car in reverse and you're foot on the brake and turn on the wheel, I had someone in the car and I stood outside it sounds like its coming from the center of the wheel near the hub it has that sound like a rusty door hinge, is there a problem with front wheel bearings on these cars we had the two rear ones replaced under warranty because of a humming thrumming noise and now there is a humming thrumming noise again but hard to tell if front or rear and the tires are in good condition no cupping.
Is there an easy way to check the hubs on these cars besides the normal move the tire up and down for play. By the way the car has 105000 kms on it...
View 9 Replies
Advertisement
Our '07 Santa Fe (3.3 L) has began making a terrible noise when turning the steering wheel. It is a deep, whining screeching noise that seems to come from the front passenger side of the car. It isn't a metal-on-metal sound, but is similar to the sound my old skid-steer loader used to make at work when the hydraulics were going out. It also seems to be worse when turning right.
At first I thought it was the power steering pump, but looking at some diagrams online it appears that the pump is to the rear of the motor.
The wife says that the sound seems to get worse after it rains. Saturday she drove into Austin to run some errands and when she got back home the sound was really loud. I drove it into town and after a while the noise went away. She says that the sound has returned, but not as bad as it was this weekend.
View 1 Replies
So the car was making a strange creaking noise from the column (the point where the wheel attaches to the column); then on a drive up north, i noticed that the horn had stopped working. Shortly after, the airbag light and warning came on, and I lost all power functions to the wheel (phone and radio control). Cruise, etc, all still work.
I'm guessing that the power harness took a dump, but unsure. Car going in on this weekend.
View 14 Replies
I have a 2010 Santa fe ( since new) 28k miles - I'm getting a grinding noise that seems to come from the front right wheel - noticeable only when doing a right hand turn or going around a roundabout.
So, Is this likely (from my terrible description) to be a wheel bearing problem....
View 10 Replies
My wife has a 2010 Santa Fe with AWD and 40,000 miles on it, and my daughter has a 2008 AWD with 38,000. I don’t drive my wife’s car much but after taking it on a trip I noticed that the front wheels/tires seemed louder than normal, exactly like a bad wheel bearing or when you are running snow tires. I had the tires balanced and inspected and took the car to the dealer sure that there was a front wheel bearing going out but they said it was fine. A week later I was driving my daughter’s 2008, same noise. Tires on both cars are fairly new and don’t appear to have any problems. So, is this common to these cars and considered normal?
View 2 Replies
I have a 2007 Honda Pilot. 65K Miles.
Several months ago, when turning left, regardless of speed, my wife starting hearing a noise. It is not a knocking or harsh grinding noise, but a low grumble (I don't have a great word for it). It's definitely rotational, it doesn't get any louder as speed increases, but it obviously happens more often. It seems to come from the right side of the car, I originally thought it was from the wheel, but just now I had it jacked up and had a neighbor who works on cars look at it with me and now I'm not so sure.
When I described the problem to him, he first thought it was a CV joint, or possibly ball bearing. After a few minutes looking under the hood, he quickly ruled those out. Boots were in great condition, and he remarked that everything seems to be very solid around the wheel.
I thought that noise was a result of weight shift to the right side of the vehicle when making right-hand turns, but we had the car up on two jacks stands placed on the jack braces, turned the car on and gave it some gas with the wheels turned left, and you can definitely hear the noise with zero weight on the wheels or axles. When you straighten the wheel, the noise subsides.
View 12 Replies
Well, even though I love my 2010 SF SE I have had a few issues. I've had my power steering pump replaced twice and now I'm hearing a clunky/creaky noise coming from the right from wheel. I"m thinking it is a sticky caliper. It happens most frequently when I am just starting out from having the car parked for a while. When I put my foot on the brake and then release it I get the noise. It seems to go away after I have been driving a while.
Can't say I ever had this much trouble with my previous generation SF. Nothing major but annoying none the less. BTW I have just under 30k miles.
View 1 Replies
I bought an '08 Elantra about a month ago. A few weeks after buying it i noticed a creaking noise while turning the steering wheel to the left. It happens at low speeds or when stopped, but I haven't heard anything at high speeds. I can't tell for sure but it sounds closer to the inside of the car than the outside and will happen the entire time the steering wheel is turning to the left. No sound turning it to the right.
My brother liked my car so we test drove 3 other Elantras, 2 '08s and an '09. Two of them made the exact same noise. He ended up liking the one that didn't but after a while his started making the EXACT same noise too. I'm thinking this must be a common problem with the '07-'10 Elantras as all 4 cars had the same noise, but I can't find anything about it.
My right strut is bad and I'm having both front struts replaced Monday, so if it's something that can be done while he's doing the struts I'd like to find out before he takes everything apart so he doesn't have to do it twice.
View 1 Replies
Truck has 1800kms on her, pretty much brand new but there is an odd clicking noise on the front drivers side wheel when I adjust the steering from left to right and vice versa. Its quiet if I am going straight, but it sounds like there is a linkage loose. Its not too loud or noisy, but having problems with tierods/knuckle assy?
View 1 Replies
I'm getting a squeaking/creaking noise from the front when turning and over some bumps. It has ST coilovers already and read a post from the previous owner here and he said the noise started after the install and he was told ot was the upper mounts??? Does this sound correct?? Also i noticed it when parked and just turning the wheel back and forth, popped the hood and had my son turn it and it did sound like it was coming from the upper strut area....
View 12 Replies
I've got a 2008 santa fe limited 3.3 awd with about 170000 km on it. Lately when I brake I've been hearing a clicking noise coming from what sounds like the driver side front wheel area.
Had it in to my mechanic who checked the brakes and said that pads/calipers/rotors were all fine. They replaced the passenger side front bearing on the lower control arm a few weeks ago and said there is no play or noise coming from any other suspension components.
Where to look next? My mechanic isn't sure what it is so I was going to take it to the dealer and see if they can fix it. Also had new tires installed about a month ago
View 7 Replies
My front passenger wheel began creaking when driving over uneven surfaces after work was done on 12/29/14 to replace the wheel bearing, stud, and nut for the right front. I've been dealing with this noise for 1.5 years, but to my luck, when I take a test drive with a mechanic, it does not reveal itself, so they will not take a detailed look at it and open it up. It is more prominent in cold weather. Pushing down on the front of the car for a strut test does not produce the noise.
View 9 Replies
I have a 1991 Toyota Corolla Wagon (150,000 miles) with noise coming from right front wheel well. My car is making groaning and creaking noises like the hinges of an old wooden door. CV joints serviced <5000 miles and the boots are clean and intact. There is no clicking noises during a turn Left or Right. Bouncing the right front corner does not replicate the sounds, tho' there is some slight squeaking noise not heard from the shocks/struts in the other corners. The sound is NOT heard in the morning going to work, but is very noticeable driving home at 5pm. I notice the sound going downhill at 35 mph, but goes away with light braking, Going over railroad tracks does not affect the noises. I'm thinking this could be worn bushings, strut mounts or who knows what?
View 1 Replies
Quick question : I just noticed a strange "creaking" or "squeaking" coming from my front suspension when I turn the wheel back and forth - while having the car at a stand still in the driveway...
I'm assuming my Strut Mounts (bushings) and/or Strut Bearings have gone and need to be replaced? As the creaking sound really souds like it could be the rubber bushing buckling?...
I just want to be 100% sure this is my issue before ordering the parts. Need to confirm that this noise I'm hearing is bad mounts or bushings? Or is there something else I should take a look at before ordering the parts?
[IMG] [URL]....
View 5 Replies
MY '07 SuperCab just started making a strange rhythmic sound as I drive. It is coming from the drivers side front wheel area. It is like a short creaking sound. It stays the same if I am turning the tires. Seems to go away if I put the brakes on hard, but I slow down so much I am not sure. Front CV Joint?
View 1 Replies
I gotta a roaring noise coming from my right front while turning. Planning on replacing just the wheel bearings tomorrow & not the whole hub assembly(2008 2wd). Is there a thread that lays out the steps and other parts I may need? I've seen alot different stories on the net on how to do it. Everthing from I can press new bearings to I have to do 4x4 hub conversion. Seems to be some confusion.
View 2 Replies
When turning the steering wheel slowly while from a stop or slow speed there is a grinding sound coming from the front end. It isn't very loud but you can also feel it in the steering wheel.
Is there a common thing/problem with these? I know there isn't a pump. There isn't any kind of a vibration or wobble at highway speed.
View 13 Replies
I am hearing a grinding noise when I turn the wheel to the left.. and when I straighten it again the noise goes away.. no noise at all when turning the wheel to the right. what could it be? 2006 Hyundai Santa Fe / 205,000 km's
View 4 Replies
Ok I changed the 2 front struts on my Santa Fe. And the strut mounts. Rides alot better and no shimmy in the wheel but I noticed a knocking noise when turning the wheel sharp. What I have come to find out the top of the spring it turning the whole cup or top hat it sits in. I put the cup in the right spot because there is a flat spot on the thread of the the strut.
View 13 Replies
I'm having a hard time diagnosing a creaking noise that is coming from the front driver side area. Since the Camry is pretty quiet, this is the one stand out noise that annoys me while driving. I placed my phone next to the front windshield to get as close as possible to the noise but am having trouble locating the exact spot. Where it's coming from.
The noise tends to appear when outside temperature is spring/summer like. In the winter I really didn't notice it. So that tells me the interior temperature is irrelevant despite warming up the cabin in winter. How this is linked to outside temperature I have no idea.
Ignore the large thump in the middle of the video as that is noise from going over potholes.
[URL] ....
View 6 Replies
I know this can bring many speculations. I've recently install new 034 strut mounts and new bearings. Stiffer mounts and the new bearings took care of the "compression" noise going over bumps. The bearings were shot.
Just returned from a trip, driving the R now I've notice a slight creaking noise while making left or right full turns at slow speed. I haven't noticed it at high speed yet or maybe its because our cars are pretty loud with an aftermarket exhaust but i don't suspect there's noise going straight.
I tried to see if there's anything out of the ordinary. I noticed that the driver side spring moves slight while the steering wheel is turned either left or right. I suspect that this slight movement is causing the spring to rub on a rubber component of the wheel bearing thus causing the noise.
View 15 Replies
