Santa Fe (CM - 2007-12) :: Blower Does Not Work
Nov 21, 2016
My blower does not work. I've checked the blower, clock and com1 fuses and they are good.
View 5 Replies
Nov 21, 2016
Advertisement
Santa Fe (CM - 2007-12) :: Climate Control Unit - Blower Won't Work
Have an 07, currently i have the dash all apart and replaced the climate control unit because the blower wouldnt work. Plugged it in and it tested it. Still no blower. What more do i need to check?
View 2 RepliesSanta Fe (CM - 2007-12) :: AC Blower Fan Not Working Sometimes
I have a 2009 Santa Fe . The AC blower fan will have some days where it just doesn't work. I have taken it to the dealer on 4 occasions without the issue being rectified. It seems that unless it isn't working on the day , they won't even look for an issue.
View 4 RepliesSanta Fe (CM - 2007-12) :: Blower Motor Is Much Noisier
12 Santa Fe, I decided I better give it the once over. I found the cabin air filter was pretty bad and that surprised me because I don't drive in dusty areas etc and usually don't drive much at all any more since I got a company car but anyway....to the question: AFTER I changed the filter, making sure the airflow arrow was correct, I noticed that the blower motor is much noisier than before especially when set on the higher fan speeds. The sound is much like a off balance fan with a bit of a thump to it. Could I have dropped some of the dead bugs into the fan when I changed the filter? I was careful and didn't see anything fall into the fan area but the noise is annoying as heck. Is this something that would be covered under Hyundai's warranty? Headed to the Florida Keys Saturday and not looking forward to hearing that racket all the way down there.
View 3 RepliesSanta Fe (CM - 2007-12) :: AC / Heater - Blower Stopped Blowing Air
My 2009 Santa Fe GLS a/c, heater, etc. blower has stopped blowing air. I have checked the fuses, did the push test on the air adjustment button but nothing has worked. Sometimes it's like I can feel a VERY SMALL amount of air blowing out the vents.
View 3 RepliesFord Super Duty (1999-2016) :: 2007 F250 - 2nd Speed For Blower Motor Don't Work
I have and 07 F250 and the #2 speed for the blower motor don't work (hasn't since I bought it) I read that the most common cause of this is the resistor under the hood on the firewall so I replaced that and still no 2nd speed??? Where I look next? Motor itself maybe?
View 11 RepliesSanta Fe (CM - 2007-12) :: Front AC Blower Cutting On And Off For Long Periods Of Time
I have a 2007 Santa Fe Limited and recently the main AC blower has been cutting on and off for long periods of time. The rear blower has not had any issues and has always worked. The main blower cuts off randomly and stays off until I tap under the glove box and then it normally kicks back on. Recently that has stopped working and I need to figure out what the problem is. Having the AC on or off does not effect this issue.
View 7 RepliesSanta Fe (CM - 2007-12) :: A/C Blower Started To Change Speed Then Stayed At Full Blast
I was driving today and at a traffic light a severe smell of burnt plastic filled the cabin and the A/C blower started to change speed than stayed at full blast and even if I'd turn the knob from side to side or tried to shut everything off with the ""OFF""button nothing would happen........so we drove home and at some point it shut itself off...tried it again and seems ok now.....every dealer closed today and leaving for the USA tomorrow morning.... What the problem could be?
View 5 RepliesSanta Fe (CM - 2007-12) :: OEM Interior Light Does Not Work
I have a 2007 santa fe, the oem interior light does not work. I looked in the fuse box but there is no fuse for that light. Will buying a different interior light work and does there need to be a door jam switch in order for it to work. I have looked at other vehicles from that make model and year. They all have a unit that has a "door" button on that device.
View 4 RepliesSanta Fe (CM - 2007-12) :: Headlight Low Beam Doesn't Work At All
I have 2007 sante fe. I just replaced the low beam,now the low beam doesn't work at all. I checked the fuse .. Just fine checked the wiring harness and plug no broken wire, no corrosion....
View 2 RepliesSanta Fe (CM - 2007-12) :: Right Brake Light Does Not Work All The Time
I have a 2007 Santa Fe 3.3L v6 and the right brake light doesn't work all the time. When the vehicle is parked ignition on motor off the light works. Yet when driving I have been told my right brake light is out. I read that the turn signal switch assembly could be the problem.
View 4 RepliesSanta Fe (CM - 2007-12) :: 2008 - High And Low Beams Do Not Work
08 SANTA FE, NO HI OR LOW BEAMS. Daylight running lites work, fog lites work, checked all fuses, relays, and bulbs,& connectors.
View 9 RepliesSanta Fe (CM - 2007-12) :: Headlights Don't Work But High-beams Do
The normal lo-beams won't turn on no matter what I do, but the brights still work. The bulbs are good, the fuses are good. I've tested and changed those. They're good. 2008 Santa Fe ....
View 13 RepliesSanta Fe (CM - 2007-12) :: Driver Side Door Lock Will Not Work With Key Fob
My driver door lock will not work with either of my key fobs. or with the switch on the inside. it has to be manually locked/unlocked or the key used in the door..
View 18 RepliesSanta Fe (CM - 2007-12) :: Wiper Motor Does Not Work On High Mode
I changed the motor, switch and checked relay and still can not find out why wipers stopped working on high mode.
View 1 RepliesSanta Fe (CM - 2007-12) :: 2011 Limited - HVAC Blower Doesn't Turn On From Time To Time
Over the past year we have been noticing that the HVAC blower doesn't turn on from time to time. All settings in the control panel seem normal and the fan speed is turned on. Most of the time everything is working normally, sometimes when the car starts the blower isn't working and then starts after a minute of driving. Sometimes I notice the blower isn't working and I turn up the fan speed and after a few clicks it starts working normally for the remainder of the drive. And then sometimes the blower doesn't ever start and I need to turn off and restart the car a few times. When the blower hasn't been working the a/c compressor has been turning on, something in the blower circuit is failing.
There are five possibilities:
The HVAC controller isn't telling the blower to turn on
The power relay isn't always working
There is a wiring or connection problem
The blower motor itself isn't working
The power mosfet is failing.
What needed to be replaced?
Santa Fe (CM - 2007-12) :: P0463 And P2067 - Fuel Sensor On Instrument Cluster Doesn't Work And MIL Is On
2007 Santa Fe Limited. The matter is that, fuel sensor on instrument cluster doesn't work and MIL is on. I replaced both fuel sensors and it didn't work. May be instrument cluster is bad? Or should I replace ECU? I don't know what to do.
View 3 RepliesSanta Fe (CM - 2007-12) :: 2008 - Driver Side Low And Right Side High Beam Don't Work
I have a strange problem. My driver side low beam dont work and my right side high beam dont work. Try different relay (switching), check fuse, bulb etc. Also in my dashboard the right green arrow for the flasher always still on(solid).
If I activate (with the control arm) the right turn flasher the flasher light blink in the dash board and my outside flasher bulb flash but my left high beam also blinking in the same time!
Ford A/C :: Blower Will Only Work On High
When turning the ac/heat on it will only work on the high setting and none of the lower ones - 2003 f250 .....
View 3 RepliesS-10 :: 94 Blazer AC Blower Fan Work On Low And Medium But Not High
94 blazer ac fan will work on low and med but not high replaced resistor under hood but still no high speed fan?...........
View 8 RepliesRodeo :: 1995 - Heater Blower Does Not Work
1995 Isuzu Rodeo.
My heater blower does not work. I pulled the connector to the resister behind the glove box and couldn't find any current going to it. I had the key on. I checked and also replaced the blower fuse in the box under the hood (just in case) and checked all the fuses in the fuse box by the driver's door.
Is there somewhere else I should check to see why I don't have any power going to the resister?