I have a 2011 Santa Fe limited and it beeps when the radio is turned on, key in accessory position and vehicle is off. With the vehicle turned off and the radio on, it continues to beep and drives me nuts. Should only do this with the key in the ignition and turned off, with the door open.
View 13 RepliesI have a 97 Bravada. Recently the check engine light came on and then went off. I didn't think anything of it at the time till the other day I drove it to work and back fine without any issues, then the next morning I tried starting it and nothing happened. No cranking, no interior lights, no sounds.
I tried jumping it thinking the battery was dead but that didn't work. Now my key is stuck in the ignition in the accessory position. It will not turn all the way back to release the key.
I have a 2003 Saturn Vue. My wife left the key in run or Accessory position overnight and drained the battery. Now that I have recharged the battery the car will not start. The dealer where I bought it said to turn the ignition to the run position for an hour to reset the security system. Then turn it off and start it. They said this would reset the computer and reenable the fuel pump. Didn't work.
View 30 RepliesWhen the key is switched to the accessory position, none of the things that are supposed to work in accy do. It's been like that ever since I bought the truck, but I never gave it much thought. Other than look for bad wiring, I really haven't tried anything. Where should I start?
View 6 RepliesI'm using the 2011 Santa Fe.Got few question to ask.
1.When start to move there is a thump noise and sometimes it feel like going over something from the rear area.Happen only when start to move.
2.Using the keyless remote. Sometimes push the rear trunk button to lock and arm the car there but will be a beep sound continuously. Sometimes the rear trunk button are unable to open or arm the alarm system.
The passenger side 3rd row seat is stuck in the down position. The driver side lifted and locked in place just fine, but when I pull the release lever on the passenger side the outer part releases but center portion won't budge at all.
I've tried everything I can, which isn't much other than pulling and grunting at the same time (usually works for me )Critical because I need to set the 3rd row up in order to reach the bolt holding the 2nd row seat so they can be removed so I can access the fuel covers in order to replace the faulty fuel sensors so my gas gauge will work.
Replacing the tps themselves? Is it something a newbie at diy car stuff can do? I'm getting codes P2016, P1295 and P161B, and I see no problem with the car except one thing, when the engine is cold the shift from P to D is rough. Is the tps causing this?
View 9 Replies2011 Santa Fe limited fwd
Bought as 6 month old demo in 2011 and from day one rear driver side power window has gone up and down slower than other three windows. Going up decidedly worse. My fault for not having it looked at while still under warranty.
Behavior the same using either driver's switch or the rear switch.
Well, now it occasionally gets stuck in down position. Neither switch works. But, if I press switch and pull up on window I can eventually get it to close.
I looked at other posts and saw no clear solution for this intermittent problem.
The headrest of back seat will bend over when fold down the seat. But one of the headrests can't go back to original up position. The dealer has adjusted the cable but this just temporarily fixed the problem. The problem is back again. I will go back to dealer but can they really fix it? Should I ask for a replacement of the whole seat?
View 1 RepliesIs there a way to get the vehicle to honk or beep when locking the car with the remote? I tried single click, double click, and triple click on the lock button and the lights flight, but no audible feedback. Is this really not an option? I checked my horn, it works.
View 24 RepliesI am hearing a new beep sound (It's a quick double high pitched beep) when I start my car. What it could be? I do not see anything that indicates there is an issue with the car (i.e. no warning lights) but it double-beeps every time I start it now.
View 6 RepliesWinter is coming and I often leave the car running in the morning when stopping a few minutes to drop off the kids, etc. (otherwise it all fogs up and I need to wait a few minutes again before I can leave).
Issue is, when the santa fe engine is running, if I close the door, the car beeps for like 5 seconds, every time I close a door. (Close my door, beepppp, get the kid, beeeeeepppppp, get the bag, beeeepppppppppp) and then, I cant lock the doors so I have to leave the car unlocked after it has beeped 3x 5 seconds to alert anyone around that the doors are unlocked and that it's still running.
Hyundai is supposed to install my remote starter next week, which at least will fix the issue of being unable to leave the car running with the doors locked, but the beeping all the time is REALLY ANNOYING. I KNOW THAT MY CAR IS STILL RUNNING. Dealer is telling me they cant disable the beep.
Over the past few days driving my ls460 I've had a niggling feeling that something isn't quite right. The power delivery seems a bit inconsistent and although the engine sounds fine, I can feel something a bit 'rough' through the pedal.
At first I put it down to my imagination, but a few minutes ago I was driving along at a steady 40 and for a brief second the engine power cut right down and something flashed up on the screen along with a beep.
It happened so quick I couldn't have read it even if I were staring at the screen.
03 santa fe... During a stereo install the door panels were off and somehow we found a way to screw up the window switch. (the good new's is the stereo sounds awesome) and I can't pass it back onto the installer, he's my brother
all 4 windows stopped working, and of course, they are in the down position which complicates things just a bit
I checked the fuses but they seem ok at least on a visual, although I haven't eliminated that all together the likelihood that its a fuse, or multiple fuses is moving to the bottom of the list.
The window switch, it looks ok on a visual, anything obvious that I can check or look for ? No loose or crimped wires that I can spot.
If the switch itself somehow got fried I can get a replacement, but I'm hesitant to just go out and buy one right now (75ish + ship) and get it in the mail, to get the ball rolling, and god knows what the dealer would want for the part locally. I'll also check local salvage yard to see if at least I can get the part faster if it comes down to that.
Maybe when the new speaker wires were fished through the flex boot we disconnected or loosened the connector under the dash that goes to the switch ?
After heavy rain yesterday my 2005 2.7 Santa fe wouldn't start today. Had it towed to nearby dealer. The crankshaft position sensor needs to be replaced. He claims its melted to the block and oil pan needs to be dropped to remove it.
View 5 RepliesI have a 2001 Santa Fe, and the key is stuck in the ignition. I can't even get it to turn to the Lock position, so it's stuck in accessories. Since I haven't had the funds to do so, I haven't gotten it checked out yet, and it's started to drain my battery. I have to jump it every single morning, so I'm wondering if there's anything I can do until I can gather up the money to fix it.
I have tried moving the steering wheel and shifting it all over the place and spraying DW-40 in there and a whole bunch of other things I've seen work for people on a bunch of different forums, but nothing works. I don't know if this matters, but before it got stuck, it would sometimes be hard to pull out or push the key into the ignition.
My 07 Camry SE just started doing this. I turn off the vehicle. Lock the car with the remote. After a few minutes, the car beeps 3 times. I've checked all the doors, windows, lights. Everything is closed or off. It keeps beeping 3 times after every few minutes. This Camry does not use a smart key.
View 2 RepliesIs it possible for me to enable the beep when locking the car?
The manual says it should be there by default so I expect that it has been turned off. If it is a short beep, I would like to have it back.
Will I be able to do this once I get my SG2 working with my 2007 Prius (European) ?
It's been my goal to get my car to run a 13 on the stock turbo for years. I got bored last night and decided to roll out to the track and finally did it. In the past I had tried just about everything, pulled the back seats out, ditched the spare, and hours of data logging timing trying to dial it in just right but never could. Of course last night I was running with a full interior, spare and even had a passenger with my timing still pulled back -2.25 deg from the summer heat, didnt even check my oil or air pressure and I pull this off
R/T: .498
60': 2.147
1/8: 8.983@79.47mph
1/4: 13.818@102.59mph
Only problem is this was really my only goal for the car so I dont know wtf to do now??
2002 My friend's 2.7L sante fe crankshaft position sensor went bad and I went to replace it. Removed bolt, it was stuck fast, tried to pry out and it broke off leaving the last 1/2 inch stuck in block. Tried drilling a hole in it and using a screw to get it out but no luck. Afraid to keep drilling that I might damage something behind it. How to get it out?
View 9 RepliesI have searched and have not found any information on replacing the throttle position sensor. My Santa Fe was running normal. I changed my tp sensor and how it limps along. When I loosened the old TPS, not even removed it, I heard a noise inside the TPS. When I replaced it I adjusted the TPS to read between 9 and 10% on my reader. But when I push on the gas pedal with the key on position the percentage doesn't move. Also when I drive it now it limps along and does not accelerate.
View 2 Replies