Santa Fe (CM - 2007-12) :: Adjusting Headlight Beam?
Aug 30, 2016
Where the adjustment knobs are for the low beam specifically? 07 Santa Fe 3.3L.
View 6 RepliesWhere the adjustment knobs are for the low beam specifically? 07 Santa Fe 3.3L.
View 6 RepliesI have 2007 sante fe. I just replaced the low beam,now the low beam doesn't work at all. I checked the fuse .. Just fine checked the wiring harness and plug no broken wire, no corrosion....
View 2 RepliesI have an 07 Passat Wagon. The headlight malfunction indicator light came on for my passenger side low beam. I replaced the bulb, which was visibly burn out (broken filament), but with a new bulb in, the light still is not working and the malfunction indicator is still on. What is the cause of this? I have the regular headlamps, not the xenon lights.
View 2 RepliesI drive a 96 Subaru Legacy. What does it mean when one of the high beams is dimmer (less light output) than the low beam? I am using a brand-new bulb. It's not an adjustment issue because I was looking at the bulb when it was outside of the housing and it clearly gets dimmer when you switch to brights. However, they are equally bright when on low-beam, so I don't think its just a crossed wire.
View 2 RepliesI am trying to figure out how to adjust my low beam headlights. i just need to move them up a little bit.
View 42 RepliesI have a 2008 Hyundai Santa fe and have recently had both low beam headlights go out. The running lights and high beams still both work. I read both bulbs as sat 0.5ohm(left) and 0.5ohm(right). Connections were right. I also read fuses in engine compartment HLP LO for both RH and LH. Still I swapped them both with the HHP HI and both worked for high beams but no change for low,on,either side. My next idea is the switch but I am not sure how to test it.
View 5 RepliesDoes 2008 Santa Fe have horizontal lowbeam aim adjustment? After driving my Dad's Santa Fe, I notice the low beam casts a U-shape light pattern on the ground, makes it extremely hard to see what's on the ground right in front of the car. I've attached a picture of what it looks like driving it at night.
View 10 RepliesA few weeks ago my passenger side low-beam failed to come on during a short road trip. After a failed attempt to find a replacement at 9PM I had no choice but to continue on my way, about an hour later, as I was driving along, it suddenly came back on with no trouble since. I haven't touched any wires or fuses.
View 3 RepliesI have a short somewhere in my 2007 Hyundai Santa Fe. I got in one night and had no lights. Found a fuse that was blown and thought i solved the problem. The left Low Beam is still out.All other lights work. I used a light tester and I get power on both sides LH Low beam fuse where on the right side low beam and all other fuses I only get power on one side (Light Lights up). The low Beam left relay is same way. I get power in center of relay where I don't get it power in center on right low beam relay. I have switch all bulbs. Even switched entire light assembly with the right side thinking short could be there but the left side low Beam still has no power to bulb and same short in fuse and relay. So somewhere from fuse box under hood to the Multifunction Switch is a short and is it possible for an average DIY to fix this. Is Multifunction Switch easy to replace and would that be the cause or is it inside tightly taped wire bundle or something else I am missing.
View 8 RepliesOn driving it at night I have noticed the main beam is not very bright, dull in fact. Took it to Hyundai and they re seated the bulbs and realigned the lights, although slightly better they still seem dull. My last car had zenons....
View 7 Replies2008 Santa Fe. Removed 2 bolts and 1 nut as shown in manual. cleared the clip at the bottom outboard corner. What else am I missing? I'm still Unable to remove the headlight bucket. It will only come out about an inch or so then feels like something else is holding on.
View 8 RepliesWhen I am driving and I start to slows down to a store my head lights dim when my transmission shift down (A/T). At first it didn't bother me but now since I have noticed it, it is annoying. Although the dimming in not super dangerous but I am worried there might be a bigger issue.
2009 Automatic Santa Fe
I have a 2010 Santa Fe Limited. When I first bought it, I'm pretty sure the headlights would delay turning off for a few seconds after removing the ignition key. Now they turn off as soon as the ignition key is turned off. Is that normal? I can find nothing in the User Manual and the dealer does not seem to know how it works.
View 2 RepliesThis morning a dash light informed me a headlight bulb was out. It was my DTR light on the passenger side.
I purchased Sylvania H7 high intensity, installed it and it failed to work properly. Daytime light on only drivers side works.
High Beam on , both lights works.
I checked my manual and it said to check fuse in the 5 slot on the driver side dash/door panel and there actually is no fuse in there. I checked the driver side and there was no fuse there either.
I replaced my driver side bulb last year and it took 5 mins....i am already 4 hours into this!
I have a strange problem. My driver side low beam dont work and my right side high beam dont work. Try different relay (switching), check fuse, bulb etc. Also in my dashboard the right green arrow for the flasher always still on(solid).
If I activate (with the control arm) the right turn flasher the flasher light blink in the dash board and my outside flasher bulb flash but my left high beam also blinking in the same time!
My passenger side low beam head light is dim. I changed the bulb and still have the same issue. High beams are ok.
View 4 RepliesI am planning to replace the headlight (high beam) light of my 2006 Toyota Camry. The original OEM light lasted for nearly 6/7 years.
I noticed in some forum that "Sylvania 9005SU SilverStar Ultra High Performance Headlight Bulbs" is good, but it has short life of less than 1 year.
So I finally got my car back after being repaired from the fender bender I was in, and I had to get a new right headlight but I just noticed that the beam pattern isn't right. I just picked up the car and brought it home so I'm not sure if this is a characteristic of a new headlight and bulb. I feel like they put in the wrong bulb or they didn't install it correctly?
View 4 RepliesOn my W8 sedan the passenger low beam is out and it looks like its an HID headlight... How do you change them in these cars? Also is it HID? It's odd sometimes it is on and sometimes it is not, but today I think its out completely...
View 4 RepliesMy 04 Toureag has one headlight (low beam) that flickers on and off. I can shut the door and it will flicker on. This happens both for daytime running lights as well as regular headlights. It also at times registers on the dash that a light is burnt out. Yet all the lights are on and working.
View 1 RepliesI have a 2006 VW Passat which has been eating low beam bulbs. I've probably replaced this one 4 times in the last 12 months. The last time I replaced was 2 days ago with a Sylvania bulb. Yesterday on my way to work it burnt out. Then on my way home last night I was pulled over by a cop for it. That really annoyed me.
Having issue with Passat burning through headlight bulbs? Do I need to have the wiring assembly checked or possibly replace the entire headlight assembly? I'm getting really tired of changing these bulbs so often.