Santa Fe (CM - 2007-12) :: AC Stopped Working?
Oct 28, 2014
About a month ago my ac stopped pushing any air out, but it only lasted for a day or so...then it has worked fine for the last month.
This morning it stopped again. No obvious signs of anything wrong, what might be causing this? not enough freon? I do get air when I turn it to the button that shows air coming from outside when I am at fast speeds, but not on the recirculation button. (I don't know the technical names of these button modes)
I have the 2012 Santa Fe Limited, bought brand new 0 miles off the lot.
View 14 Replies
Advertisement
My headlights worked on Tuesday. Wednesday night driving home I put my headlights on and neither is working. My brake lights, directional and highbeams work. The only thing that doesn't is the headlights.
I replaced both headlights and still not working. I purchase fuses 15A and switch the fuses which were blown and it resulted in my horn going off. I had someone check with a gauge and there is power in the light socket. We tried to replace the fuse again and the horn went off. We removed the fuse for the horn and replaced the fuses for the headlights and the horn still went off even though the fuse was missing.
The mechanic, checked my fuse box and wires around it and was not able to determine the issue.
View 9 Replies
Front wipers stopped working while driving. trying to trouble shoot problem. wondering what fuses to check?
View 2 Replies
I had a new condenser put in last summer and the aircon has worked fine since then. Hot weather last week, aircon worked for a few days, then suddenly not working any more. The ac magnetic clutch is kicking in, the fuses all seem ok, I removed the low and high pressure caps and there seems to be a bit of freon fizzing on the valve after I removed the caps so I assume pressure is ok (don't have gauges -maybe Ill buy on ebay). Is there a low pressure switch that I can bypass to see if that makes it work?? or something else I can do? I assume if the clutch is kicking in and there is no squealing, that the compressor is probably ok?
View 6 Replies
I just bought a used 2011 Santa Fe. Two weeks ago, the right window stopped working. Neither the left or right switch had any effect. All other windows worked. A few minutes later it was ok and has been since. Today the left window did the same thing; was inop for a while then ok.
View 2 Replies
I have a 2007 Santa Fe. The drivers door handle has stopped working. I can open the door with the inside handle. The locking mechanism is fine. I took the interior panel off and found there is a middle metal panel, which stopped me from getting to the exterior door handle mechanism to see what is wrong. I can't find any information on how to correctly remove the middle panel. I remove the bolts but am not sure how to deal with the two cables from the inside handle to the lock and if there is anything else needed to release the middle panel.
View 8 Replies
Aircon suddenly stopped working. Seemed to be due to faulty valve on low side (bubbles coming out when cap removed). However- when testing- the clutch still kicked on ok even though it was not blowing cold air. After a few weeks I had time to look further however it suddenly started squeaking. Turns out the bolt holding the ac clutch plate has sheared. see pic.
Question: is it possible the compressor has seized due to low freon and that's why it sheared? Is it possible that it sheared for any other reason? Is compressor replacement difficult?
View 10 Replies
On our 2007 turbo diesel auto santa fe the audio controls first and now the cruise has stopped. Had problems turning cruise on would have to press buttons 3 / 4 times to work now nothing.
View 1 Replies
I was driving my F2007 Ford Focus and all the lights on the dash went on and then all the power went off and the car stopped. Once it stopped, there was no way to get the power on and I couldn't switched gears. I guess I shifted into park once the car started freaking out and now it's impossible to switch to neutral. The only light on the dash that works is the anti-theft symbol, which seems to go on for a second when I turn the ignition on. It doesn't stay on solid.
From what I've googled, it seems like the car's computer got tripped into activating the car's anti-theft locking system? I'm not really sure. (I was driving the car while this happened -- scary!) But AAA towed the car to a random auto repair shop near my house. Should I be having a Ford dealership look at this? Or is it fine in the hands of a private repair shop? Timing couldn't be worse -- I was going to drive my car across country for a new job in two days, so I'm hoping this can be sorted quickly and my car will be safe to drive by then.
View 13 Replies
03 santa fe... During a stereo install the door panels were off and somehow we found a way to screw up the window switch. (the good new's is the stereo sounds awesome) and I can't pass it back onto the installer, he's my brother
all 4 windows stopped working, and of course, they are in the down position which complicates things just a bit
I checked the fuses but they seem ok at least on a visual, although I haven't eliminated that all together the likelihood that its a fuse, or multiple fuses is moving to the bottom of the list.
The window switch, it looks ok on a visual, anything obvious that I can check or look for ? No loose or crimped wires that I can spot.
If the switch itself somehow got fried I can get a replacement, but I'm hesitant to just go out and buy one right now (75ish + ship) and get it in the mail, to get the ball rolling, and god knows what the dealer would want for the part locally. I'll also check local salvage yard to see if at least I can get the part faster if it comes down to that.
Maybe when the new speaker wires were fished through the flex boot we disconnected or loosened the connector under the dash that goes to the switch ?
View 4 Replies
The rear wiper on one of my two 2004 Santa Fe has stopped working. Checked that the fuses are OK.
Then I swapped the wiper motor and then the control unit to the other Santa Fe & both work in it so are OK.
What else could be causing the problem?
View 9 Replies
My 2002 Santa FE's cruise control has stopped working, light comes on but no hold or anything, any obvious faults they have that I can try. I checked the fuse, that's OK...
View 7 Replies
I own a 2004 hyundai santa fe and just recently my turn signals have stopped working. My bulbs are fine because they still light up when I lock my car and my hazards work too. The flashing arrows on my dashboard wont show up for my turn signals but they will show up for hazards. I checked the fuse and its completely fine. I am so confused with what is wrong. The only thing I was doing before was messing with my new head unit which involved unplugging a lot of the stereo and fog lights and hazards but that all should have no affect on my turn signals.
View 6 Replies
This morning my speedometer started behaving erratically. The needle would swing plus or minus 10 miles per hour. driving home from work eventually it would not respond at all. I also noticed when I attempted to use the cruise after that it was not working either. I'm thinking these issues are connected. Do i need to replace the speed sensor that is on top of the transmission?
View 2 Replies
Never had any issues with it before and was working fine on a trip a couple of weeks ago. On the way home I had it on, we stopped to get some food, and then when we started up again cruise control wouldn't turn on at all. I tried turning on and then setting, but nothing happened so I don't think it's the light. Checked the fuse and it looks fine (no noticeable distortion or break to the wire anyway) and brake lights all work.
View 8 Replies
Low beams don't work. The fuses are fine (under the dash, and in the engine compartment) and the bulbs look good. The fact that both went out at the same time has me wondering. One post on this forum for something not related mentioned a headlight relay behind the fuse panel?
View 9 Replies
I have a 2004 Santa Fe GLS that the cruise control just stopped working. It will not turn on when I press the ON button. Could it be a blown fuse? I recently had a new AC compressor installed. Could it be related to that? Maybe something didn't get plugged back in?
View 1 Replies
I have a 2004 Santa Fe, recently all the door locks stopped working at once. When I use the Key Fob The Blinkers flash like they are supposed to but it does not lock/unlock the doors. The panic button also works. When I use the key in the door it only unlocks that door, meaning when I double turn the other doors do not lock/unlock. Now that this happened all at once I do not believe all the actuators broke at once. Is there a fuse or a relay that might of broke or blown?
View 8 Replies
Last week out of the blue, the lock/unlock button the driver's side door stopped working altogether. It's not stuck, as I can definitely feel it click when pressed. Also, the passenger side button works just fine. This is very annoying after spending a year without ever having to use the actual key fob.
View 7 Replies
Purchased this vehicle new in Dec. 2011.Within a day or so,I noticed a hesitation when completely stopped and waiting for traffic to pass to make a left turn.
I started to proceed for this turn,but,no power when I slowly accelerated. All of a sudden,big surge of power ! Went to the Dealer to check this out.They said they drove the car for 7 miles,checked it scanner,etc.,but could not find the problem.
View 27 Replies
I bought my 2007 Santa Fe with 112,000 miles in April. It ran fine until about a month ago. When I turned the key to aux, the radio and lights came on but when I tried to start it I lost all power. Turning the key off and back on had no effect, it acted like the battery was dead. I opened the hood and noticed the pos cable was loose on the terminal. As soon as I touched it I heard a click, the security light started blinking and it started fine.
A week later as I was driving on the highway the electricity started blinking in and out and the car would shutter as it lost and regained power, then eventually died completely but the radio was still on. I got to the shoulder and tried to turn it back on but even though the radio and lights worked, nothing happened when I tried to start it. I lodged a matchstick between the pos terminal and the cable to make sure the connection was tight and it started. Driving home the power would occasionally stutter when I hit a bump but it never died completely.
I used a battery and alternator tester that plugs into the cigarette lighter and both registered as fine. I've driven it to work, about 2 miles, several times since and the power sometimes cuts out at bumpy parts of the road and it has died completely twice while sitting still at a light. The clock doesn't reset when it dies so, knowing nothing about electrical systems, I would guess that the electricity isn't being entirely lost. Every time it dies the radio and lights still come on but I have to get out and jiggle the pos cable to get it to restart. While driving the battery and seat belt lights flash randomly. A friend told me to try removing the pos cable while it's running and that if it died, it was probably the alternator. Tried it and the engine died immediately. Don't know what this means since the alternator tested fine.
View 6 Replies
