Santa Fe (CM - 2007-12) :: AC Blowing Fuse And Check Engine Light Code P0441
Jul 22, 2012
Have 2 problems that are giving me major problems.....especially with 100 degree heat in Dallas.
1. Ac stopped blowing cold last night out of blue. Still blows just not cold. Replaced bad fuse and drove for 5 minutes. Blew again. Checked out the control/ circuit board but looks ok. Really cant afford dealer.
2. Check engine light problem for months. Gas gauge wasn't working. Replaced fuel sending units and it fixed that but still light. Code says p441. Dealer said need solenoid valve. Replaced both the solenoid valve and the purge control valve. Still check engine light.
View 2 Replies
Advertisement
About two weeks ago, while driving on a hot, humid summer night, the check engine light in my 1998 Toyota Corolla came on. The following day, I took it into my mechanic, who plugged it in and came up with the code P0441 (Purge flow fault). He told me it was likely related to the fuel vapor canister, though I see this can also have to do with vacuum lines for the purge valve and canister or a bad purge valve itself. My gas cap was, and had been, tight, so it wasn't something as simple as that.
Reluctant to deal with this immediately, I went back to driving it, and lo and behold - the light went off after several days! Unfortunately, the light came BACK ON after several more. And most recently (a few days after coming on again), the light has now gone off!
Both times the light has gone off, the weather has been rather wet, but otherwise, there doesn't seem to be a clear pattern. What this on again off again pattern might say about the problem?
View 10 Replies
At roughly 140,000 miles, my wife's '07 Santa Fe GLS has thrown a P0456 code. Does this code on a Santa Fe common?
It is "evaporative emission system leak detected (very small leak)." The good news, I guess, is that it is 'very small.' However, being small may make it more difficult to detect.
View 3 Replies
I've recently bought used Hyundai SantaFe 2007 and the engine check light lit up. I've bought EML327 OBD2 scanner, it showed P1405 meaning "EGR tempereature sensor incorrect". Some of my friends says it has something to do with CPF filter and EGR valve. They think, i should clean both CPF and EGR. Car service told me that DPF (not CPF) filter cleaning costs arround 350eu and one service told me to simply take it out and reprogram car computer. As far as EGR valve cleaning goes, no service wants to do this. I don't really know much about cars, so my main question is what would be my next step in trying to fix this error.
View 3 Replies
My 2010 Santa Fe is only 2 month old and has 2000km now the check engine light is on. Went to the dealer and found out the code is P200A -Intake manifold runner performance. And they just clear the code. What does this code mean?
View 22 Replies
2009 Santa Fe GLS 2.7L ~63,000 miles .... Check engine light came on, scanner gave code P0441, but check engine light shut off later the same day. Since then the fuel gauge has been moving around inconsistently. Took it in to mechanic, he said he replaced a leaking hose. Next day, fuel gauge is still a moving target.
View 1 Replies
Engine light came on a week ago, finally made it in to get the code pulled yesterday : P0441
From reading on this site, thinking its a faulty purge valve.
I have found pics of its location on an 04, but cant seem to find it on my 08 2.7L.
View 14 Replies
Just received a P0441 CEL (Evap Emission System Incorrect Purge Flow). I have a 2.7l engine, 2WD. I've read other forums and it seems it's most likely the purge valve or charcoal canister.
View 7 Replies
2007 2.7 GLS ... I like many have encountered the P0441 code and my Santa Fe stalls after fueling and requires constant revving for a bit to stay going. Previous threads seem to point to the Purge Control Valve.
View 10 Replies
I've had the check engine light come on and was told it was probably from topping up too much and that it would go off on it's own... I should say I have no issues with idle or rough starts.
I had it scanned at Auto Zone. The print out shows: "EVAP emission system incorrect purge flow probable cause
1) Faulty purge control solenoid
2) Faulty vent solenoid
3) Blocked vapor canister
Previous posts suggest if it were a blocked vapor canister I'd have trouble completely filling the tank so I am hoping it's one of the others. Almost everything I see suggests the purge control and that looks like an easy fix. My concerns are a) if it is the vent solenoid - how hard is that to get at and b) what is the part number as I can't find it listed anywhere? I want to have both on hand before I start trying to fix this. Lastly if it is the vent solenoid should I just give up and see a dealer??
View 3 Replies
I have a 07' hyundai santa fe and recently I had a 10 amp fuse blow labeled A/CON and so I replaced it and it worked for about 2-3 weeks and it blew again, and so I'm getting more fuses Monday to see if it keeps working, but from what I read online it looks like the field coil is the culprit, I tried to read the ohms from the relay and got .5 kohms (which I see its supposed to be 3-4ohms) but i have a crappy multimeter and I'm not sure if that's right anyway.
View 8 Replies
My 2010 Sante Fe started blowing the BCM 1 fuse.The vehicle will not even crank over. Its at the dealer for the 3rd time time this week. 1st time thought it was a faulty fuse, 2nd time replaced the drivers door lock actuator.
View 1 Replies
Just tried to leave for work and my check engine light came on. Luckily I just got a scangauge and the error codes are P0441 and P0445. I checked online and for regular Prius is says it could be the fuel system, fuel cap, etc. I'm scared to drive it now and wonder if I should call Toyota Care to tow my car to service.
View 6 Replies
Check engine light on, car stalled once. Pulling code p0320 "Engine Speed Input Circuit Malfunction." Tachometer works intermittently. Where do I start?
View 2 Replies
Recently got check engine light fault code p0320
2005 3.5 with 172k miles
View 2 Replies
After running to operating temp, if the car is turned off then restarted (like you would at a gas station, which is where I notice this) the engine will turn and turn and turn but not fire. I have noticed that stomping on the acceleration will cough it into life during this procedure. This doesn't happen every time and I have recently run high octane gas during a long distance trip.
106K miles...
Recent p0441 fault codes and gas cap warning light...
No other problems or codes...
View 4 Replies
I have a 2009 Santa Fe, v6, and the check engine light and "ESC OFF" lights are on consistently.
I read the check engine light may be the gas cap so I replaced it but the light is still on. Took the car to Advanced Auto Parts and they said it was related to the cruise control.
I also read that the ESC OFF light may be due to alignment issues. I had an alignment done last Saturday but the light is still on. When they checked the check engine light they said it was related to the emissions. This was at a Firestone shop.
Any common cause for these lights to be on at 30,000 miles? I changed the transmission fluid also recently which the manual says to do at 30,000 miles.
View 4 Replies
I own the 2014 Santa fe turbo 2.0 litre limited which has 4000 km on it. Within 210 km the engine light came on 3 times. I took it into the shop and they ran a code of P0303 which is a misfire, they changed the coils #2 and #3 and cleared the code. The second time it showed the same code but the shop said it was in the history so that is why the same code came up again. They ran an update ECM? and all was good. Now the 3rd time they tell me no code has come up and can't do anything about the engine (they cleared it) but it was like chasing ghosts. My vehicle runs great so not sure why I am constantly having this issue.
View 68 Replies
My check engine light came on the other day and the code stated the the "throttle position is open" so after researching and everyone telling me that i need to change the sensor. I did everything after was fine running better but today only after 3 days replacing it i get the same problems. car has no get up and go hardly can push to 20 mph and when in idle i press the break it starts to bog down and almost want to shut off! and can be really loud...
Santa fe 05' 3.5L ....
View 5 Replies
i have a 2008 santa fe with a 2.7 61,000 miles 2nd owner ,out of warranty. It started missing and the check engine light came on. I took it to a local parts store who put an analyzer on it an it showed the #3 spark plug was misfiring. I am hoping its the plug. I do my own work but havn`t been able to find a correct sequence to replace the plugs.
View 3 Replies
I recently bought a Santa fe 2007 Limited 3.3L, it has 101500 miles. The issue is that when i run the scan it has 3 minor sensors that needs to be replaced but my biggest concern is that the check engine light does not come on in the dashboard even when i turn the ignition to on.
I need to know if there is a fuse that can cause this or a bulb in the dashboard that i can replaced for myself or if it is something else.
View 7 Replies
