Santa Fe (CM - 2007-12) :: 2011 - Headlights (High And Low) Suddenly Not Working
Nov 8, 2012
Both of my 2011 Santa Fe's headlamps (high and low) are not working. The fuses seem to be ok (ohm meter checked) and so do the relays (swapped with other relays). When I switch the lights on to the first position, I hear the relay for the 'parking' lights switch on and those lights work. When I move it to the headlight or auto positions, I don't hear the headlight relays click in.
Is there a schematic/parts location/troubleshooting diagram anywhere (they are not on the HMA web site)? Is there a known connector/wiring issue? I just found a diagram for the multifunction switch on steering wheel, with a pin out of the connector, but that's all I have. This will be hard to trace without some idea of where the wires are going.
View 2 Replies
Advertisement
The normal lo-beams won't turn on no matter what I do, but the brights still work. The bulbs are good, the fuses are good. I've tested and changed those. They're good. 2008 Santa Fe ....
View 13 Replies
I've seen a couple posts about low beam lights not working suddenly, but no real fixes to the issue. Looking for an actual fix that worked.
My lights; running, fog, high, and low beam, all worked yesterday. This morning when I try to go to work, all but the low beam lights work. Nothing was done differently, all fuses and relays appear to be intact, and the bulbs appear to be fine.
View 12 Replies
I had a new condenser put in last summer and the aircon has worked fine since then. Hot weather last week, aircon worked for a few days, then suddenly not working any more. The ac magnetic clutch is kicking in, the fuses all seem ok, I removed the low and high pressure caps and there seems to be a bit of freon fizzing on the valve after I removed the caps so I assume pressure is ok (don't have gauges -maybe Ill buy on ebay). Is there a low pressure switch that I can bypass to see if that makes it work?? or something else I can do? I assume if the clutch is kicking in and there is no squealing, that the compressor is probably ok?
View 6 Replies
My headlights worked on Tuesday. Wednesday night driving home I put my headlights on and neither is working. My brake lights, directional and highbeams work. The only thing that doesn't is the headlights.
I replaced both headlights and still not working. I purchase fuses 15A and switch the fuses which were blown and it resulted in my horn going off. I had someone check with a gauge and there is power in the light socket. We tried to replace the fuse again and the horn went off. We removed the fuse for the horn and replaced the fuses for the headlights and the horn still went off even though the fuse was missing.
The mechanic, checked my fuse box and wires around it and was not able to determine the issue.
View 9 Replies
Aircon suddenly stopped working. Seemed to be due to faulty valve on low side (bubbles coming out when cap removed). However- when testing- the clutch still kicked on ok even though it was not blowing cold air. After a few weeks I had time to look further however it suddenly started squeaking. Turns out the bolt holding the ac clutch plate has sheared. see pic.
Question: is it possible the compressor has seized due to low freon and that's why it sheared? Is it possible that it sheared for any other reason? Is compressor replacement difficult?
View 10 Replies
My New (weeks old) 2011 SF GL V6 speedometer reading is way to high. I've confirmed this with my GPS. My last 2 cars were Honda`s - one with a digital speedo (Civic) amd they were both bang on with the GPS.
So, my issue is why is the speedo so far out - 10%. I have to drive 110 km/h for a 100km/h on the GPS. On the positive side - I'll never get a speeding ticket.
But to all of you that claim to drive at 75mph and get 25mpg - I'm guessing your really traveling way slower. What can be done. In this day and age a calibrated speedometer isn't asking for much.
View 16 Replies
Ever since passing on an opportunity to trade in our 07 Santa fe for something new, and deciding to keep this car until the end, we have come across a few electrical issues.
The highest speed setting on the windshield wipers have stopped working. The wipers just freeze. The drivers door lock no longer auto locks when you hit the lock button on the way out of the car.
View 5 Replies
I have a 2007 Hyundia Sonata. Currently have a 7" after-market head unit, four after-market speakers and a sub that is currently not plugged in. I also put HIDs in the low beams. It has about 73,000 miles on it. I bought it when it had 36,000 about a year and a half ago.
The first time I noticed an issue was about 3-4 months ago. Both of my stock headlights went out at the same time. I checked all fuses, nothing blown. Odd right? I thought there might be something going on with the electric but I was like O.K. i guess i'll get new ones, i could use some brighter ones anyways. So I went with Sylvia SilverstarUltra's. These lasted 2-3 months before one went out. I didn't think at the time that this was connected to the previous problem because only one went out and I drive a LOT with my headlights on during the day and SilverStarUltras have a short life span. So I bought an HID kit off ebay (just the ballast and bulb, not really a 'kit'). I installed them on Jan 28th. Today, Feb. 25, they both went out. NOT COOL!
Electronics : Sometimes as I am driving the electronics in the car "de-surge" if you will. Another words, they seem as though they have less power, the interior lights dim, the fan for the heats slows. This happens only for a second and then returns to normal. It has happened a few time. I don't remember the stereo being effected however.
Sub : The sub on my speaker system. A couple of months or so ago I noticed that my sub on my speaker system had stopped working. It was installed late last summer. I investigated and found no potential short, the ground was secure, and no fuses were blown. I didn't even think this could be related to everything else until today, but it kinda seems like it might be.
I was wondering if maybe I had created a short of some type when installing the stereo system. However nothing in the stereo system seems to be effect besides the sub. Which gets it's power directly from the battery, not the stereo system.
I read on another thread about a older Elantra that had this problem and someone mentioned that it could be the regulator in the alternator going bad and intermittently outputting too much voltage. Although I don't know why that would make the fan and lights in the car slow/dim. I'm currently trying to find someone who can lend me a voltmeter.
How I could locate an electrical problem with my stereo install, or elsewhere in my car?
View 8 Replies
Well a few days ago I pulled up to a gas station on my way to work for some coffee and since I leave for work before 6:30 AM my headlights were on. Well only the running lights were working. Well I shrug it off and later that night I come to the realization that both headlights weren't working. I tried the high beams and they do work. I also pulled both bulbs and both the filaments on each bulb seemed to be intact. What could cause this? I checked fuses 9 and 11 under the hood and they were both fine. I'm kinda at a loss right now.
View 9 Replies
My brother in law is on a road trip and his radio suddenly stopped working. The radio panel displayed "No Radio." He stopped for gas, turned the car off and the radio was working again when he restarted the car. Is this normal or could he have a more serious electrical or computer problem
View 3 Replies
Never had any issues with it before and was working fine on a trip a couple of weeks ago. On the way home I had it on, we stopped to get some food, and then when we started up again cruise control wouldn't turn on at all. I tried turning on and then setting, but nothing happened so I don't think it's the light. Checked the fuse and it looks fine (no noticeable distortion or break to the wire anyway) and brake lights all work.
View 8 Replies
I added plow lights to my truck and something quit when I had the high beams all on at once. All 4 shut off. Low beams still working. What I fried or where to check? Its a 99 F250 superduty.
View 14 Replies
My 2012 V6 Santa Fe turned itself off on the freeway today, only 3500 miles,
was in stop and go traffic, stopped and the car just turned off! No shaking or anything. Turned back on (so its not the battery, and YES it had plenty of gas), went about 100 ft and turned off again! Took into the dealer, they won't have an answer until Monday.
View 6 Replies
So I bought an 01 GTI last week with a decent amount of things pre-modified including a Jetta front end swap? Anyway the guy I bought it from knew absolutely nothing about what had been done to the car other than the fact that there was an HID kit installed and it was set up to run high beams only.
I figured I'd remove the HID's until i drop some cash on a pair of nice projector housings. I removed them and plugged up some nice sylvania bulbs as per the OEM standard 9007, and figured I'd have no issues... They are still stuck on high beam only... What could be causing this?
View 1 Replies
Low beams don't work. The fuses are fine (under the dash, and in the engine compartment) and the bulbs look good. The fact that both went out at the same time has me wondering. One post on this forum for something not related mentioned a headlight relay behind the fuse panel?
View 9 Replies
Looking for a tip on how to remove headlights. I have followed owners manual for my '08 Sante Fe Ltd on removing the two screws on top and retaining nut on back of light and unplugging the wire harness but the---- thing doesn't want to slide out. Is there a clip or screw that I am overlooking? I have watched the video on the Sonata. It feels tight on the tapered side(turn signal). I afraid of muscling it too much because there is so much plastic.
View 12 Replies
2007 SE. When the car downshifts the head lights dim for a few seconds. I have a 2007 santa se. one mechanic i know says it could be a ground problem or a electronic transmission control.
View 3 Replies
I have a 2.7L Santa Fe 7 seat automatic in Shanghai, China, imported new from Korea in 2007.
When it is raining outside with the air conditioning turned on and then I turn the headlights on, the A/C goes off. there are no lights on the console and the fans stop blowing. If I turn the headlights off again the A/C works again.
View 8 Replies
I bought a used 2002 Camry (at a discounted price because of a few dings and dents) and the headlights are not working. The high beams and turn signals work but not the headlights. I changed the bulbs, checked all the fuses and got a new relay but still nothing. I brought it to an electro-mechanic and he told me the ECM was busted and that he could maybe grind it down. This seemed odd to me so I called my old mechanic in the states who said he has never heard of an ECM causing headlights not to work and suggested I install a toggle switch. Does this sound like it could work? Could I do this on my own? I'm pretty handy but am a little hesitant to try any electrical work on my car as I have no experience with electrical work.
View 3 Replies
I am using a Hyundai Santa Fe (Petrol, 2011 Model) here in Saudi Arabia. On July 17 (11:30 pm), I was driving in a highway at about 80-90 kms/hr when suddenly my vehicle lost power (steering wheel, brake, etc).
Baed on the diagnosis of our company mechanic, it was an alternator problem. He said the alternator bearing got stuck up.
Prior to this incident, on July 7, the same vehicle got stalled twice while it's parked. In the first case, I was able to use it after jumpstarting. In the second case in the same day (4 hours after the first case), jump starting didn't work so they have to replace it with a temporary used battery. I noticed that I had a hard start (the engine responds only after 3-4 key ignition). After replacing the battery with new one, I was able to drive normally from July 9 to Jul 17, and then the incident happened as I described in the first paragraph.
Question: Is there a way to detect the alternator bearing problem before it actually breaks down? If there is, what procedure or predictive test is normally followed to identify potential problems in an alternator?
View 1 Replies
