Santa Fe (CM - 2007-12) :: 2011 3.5L Engine Noise Upon Startup
Oct 23, 2014
While we continue to enjoy our recently acquired Mineral Gray 2011 Santa Fe, I have noted a momentary engine noise upon startup after it has been shut down for say 2 hours or more.
The noise reminds me of having an oil filter with a malfunctioning or absent drain back valve where by the bearings will complain for 2-3 seconds until oil pressure rebuilds
The SF has but 20.7K miles on it to date. Do we know of this is usual for the V6, or should I be concerned and planning a dealer visit?
I love the power of the V6! We test drove a 4 cylinder model first thinking that was the way to go for economy reasons. I found this one with such low mileage, AWD, and the V6 at a great price so we jumped on it.
I am a little disappointed though that the AWD does not function "full time" like that on my 04 Dodge Durango. The SF runs rings around the Durango in the mpg department though.
View 3 Replies
Advertisement
I have a 2011 santa fe limited with the 3.5 and 35k miles that has a noisy timing chain rattle upon start up after sitting for a few hours,it's my understanding that the cause is no oil pressure to the tensioner because the oil drains back into the oil pan after sitting for a while. Is there a solution for this situation like a spring loaded tensioner-it seems to me that replacing the tensioner and chain does not solve the problem.
View 32 Replies
2011 Santa Fe 3.5 L
I've isolated this rattle down to the cam phaser( CVVT) in the right cylinder head. It rattles bad for 2-3 secs on cold start or after it sits for 3 hours.
I've put in 5w20 synthetic oil and synthetic Lucas additive and it cleared up the noise for short interval start ups.
I changed the cam phaser in the right head with a used one ( 40k ) but it didn't make a difference. I should change out the attaching cam as well.
View 21 Replies
Twice this week our 2009 SantaFe (3.3l) had a squeal from the engine upon cold startup. The first time it was very cold (-20C or so) and this was louder and longer than the second time (-10C or so). The squeal lasted only a few seconds and trailed off to nothing. Each time the heater controls were set on defrost (fyi). In order of likely suspects, I suspect one of the following:
-compressor engaging and causing sudden increase in resistance on the belt or compressor engagement clutch noisy
-idler pulley for some reason causing belt to slip at first, but don't suspect idler bearing as noise disappears right away
-belt slippage due to resistance somewhere else--e.g. water pump or alternator.
This may not happen when I take the vehicle in for its next scheduled maintenance as by then the weather will likely be warmer. This has 76000 km on the clock.
View 2 Replies
For the past year or so my Santa Fe (49,000KM) the engine will knock for 5-45 seconds when I start it up after its been sitting a while. I asked the dealer and they said this is "normal" and cannot be adjusted.
View 16 Replies
To start off with I am not car smart! I have a 2008 Santa Fe 3.3L V6. Last year about this time (December) I had problems with the vehicle upon start up would be miss firing and the check engine light would come on. I would turn the vehicle off and restart and it would be fine and not happen again sometimes for a week and sometimes for months. I hooked it up to the computer and found that it was missing on the #6 cylinder. I had the coil pack replaced and that seemed to fix the problem (replaced spring 2011). About a week ago it started doing the same thing (December 1). Upon initial start up when the car is cold and the outside air is very cold it started missing again and having a rough idle. Would turn of the car and restart and would run fine but check engine light would come on.
Hooked it up to the computer once again and it read random misfire. This has happened twice now in two weeks with the same reading each time. Always when it is cold (engine and outside temp) and seems to reset itself when turned off.
I spoke with a mechanic who recently had this same issue with a different vehicle and after trying many things replaced the engine coolant temp sensor and that did the trick. He said it was a cheap start therefore i bought the part and now am looking to replace it. The only problem being i am car dumb and cant find it. I have done many searches and the diagrams i have found don't do me any justice. The past posts on here have given pictures of older models that dont match what i am looking at. It probably is right in front of my face. Any picture of a 2008 that will show the correct area I should be looking at? The vehicle only has about 57,000 miles on it.
View 9 Replies
I have santafe 3.5 2012 4WD , it's 51K on odometer, the problem when cold startup , Noise and small vibrate form front side , its look like from gears
When put to reverse (R) sound is louder and strong vibration from front side, all this problem gone when drive about 15 minutes.
I have visit 3 local shop they check the engine, gear box, everything normal, no check indicator appears.
View 5 Replies
I have a 2011 Santa Fe 3.5L with about 108,000 kms (roughly 65,000 miles) that seems to have produced a bit of a whining sound from the engine. It will do it in park, or in gear, and the sound seems to increase slightly with an increase in RPMs.
View 7 Replies
My car has less than 500 miles on it. Yesterday when I started it, I heard a knocking sound. I only put 87 octane gas in the car as the manual said 87 or higher. I don't know if I made a mistake putting 87 in there.
View 4 Replies
I own a 2011 santa fe with approx 49,500 miles. in the past few weeks i have begun hearing a "whirring" (or more like a 'zzzzzzzzzz') noise when turning the steering wheel. I've taken it in to the dealership who tells me this noise is "normal".
This was hard for me to believe since it just started occurring in the past few weeks. I checked P/S fluid before taking to dealership and all was okay. also no leaks seen on garage floor.
Why this noise all of a sudden??
View 1 Replies
I have an 07 SE (manual transmission). In cold climates has noticed a noise at startup on a cold engine when the temperature is below freezing (colder than -5C or so)?
The engine has to be cold (like sat overnight) and the outside temp has to be cold. Then at start when I turn the key, the engine starts fine, but as I release the key from the start to the run position I hear what sounds like the starter motor make a noise (short zipping sound).
At first I wondered if it might be slow to disengage, but if that shouldn't make a noise because the gears should be meshed ok? There is no noise with a warm engine, or with a cold engine on a mild day.
View 14 Replies
I just purchased a 2011 LE Santa Fe,(2400 mi) and have a question regarding water leaking from bottom of the engine. I called the dealer and service rep explained it is more than likely from condensation build up on heater coil and being drained through the vent tube. I believe this is normal and have observed on other vehicles I have owned during the summer months when using AC.
I don't believe I have seen this condition in the winter months 40 - 50 F degrees when using just the heater. I'm hoping this isnt systematic of another problem, that was simply explained away by dealer. It sounds logical but then, again, I have never seen it when using the heater. I do leave heater at full blast when I start the car remotely to warm up cabin temp on those cold chilly mornings.
View 4 Replies
I have a 2011 Santa Fe 3.5 6, FWD, 54k miles, that has been having the check engine light go on and off. Recently with in the pass month and a half the dealership has perform the recall adjustment, changed the manifold intake assy, changed the ECM with all visits rendered a P200A code. After changing the manifold assy, check engine light was off and fuel gage was at a 1/4 tank. Stop by a gas station and filled up and the light comes on. Remove gas cap after turning off engine and secured gas cap as directed on the cap of one click and light stays on. Turning into the dealership for the 4th time.
View 4 Replies
Newly acquired 2011 Santa Fe GL. Recently had a 2008 Azera GLS.
We received the Santa Fe a week ago and have since put 600 km on her. I took her into my work (auto mechanic) to wash and wax, looked underneath the engine and noticed 2 drops of what appeared to be engine oil. Between the transmission and engine block there are 2 10mm vertical bolts. The drops of oil have accumulated on the head of the bolts. There is a small "plate" between trans and engine with oil "weepage". My guess is the engine rear main seal is leaking! Not a small repair and certainly at 600 km.
View 13 Replies
Bought 2009 santa fe new [3.3]. after cold start up tac is moving up and down and it seems to be missing. After temp is reached tac is steady but there still seem to be a hesitation when driving. 21,000 miles on vehicle. could it be a bad tbs?
View 4 Replies
As the weather is getting colder I noticing again my RPM's taking longer to drop down to 1200 or less. Upon startup the engine rev's to 2000 and drops in 2 sec quickly to around 1500 (all these are based on the crude gauge readings, not a digital tach).
I don't like high RPM cold starts in the first place and why its stays just around 1500 and lower for about 2 minutes before it lowers to around 1200RPM. I don't like engaging the transmission at those high RPM's. My other vehicles did nothing like this and the increased start RPM was down 1000 within a minute.
What sensor is having the computer run it like that and not let it drop faster. I doubt its the O2 sensor since its the same on a hot day just doesn't rev up to 2k but 1500 or so. Jabs at the gas pedal doesn't work it drop any sooner either.
View 23 Replies
We have a 2011 Santa Fe GLS with 3000 km on her. 3.5L with 6spd Shiftronic transmission. Had a "jolting" feeling when first start up after sitting for 4 hours? Of course this doesn't happen every time but more often than not.
We will turn ignition, CUV will start and then a "jolt", like you had high RPM and slammed in gear. Not lurching forward or reverse, but a "bump". Of course that is what it feels like but it happens within 1 second of start-up.
I think it may have something to do with the transmission but not sure. Maybe line pressure too high and torque converter "jolting/jumping/bumping" ....
View 10 Replies
My 2008 Santa Fe 3.3 with 18,000 miles, developed an annoying surging when first put into gear after sitting overnight. I must keep my foot firmly on the brake as I back out of the driveway. If I press gently on the brake I can feel the car jerk or surge and show higher than normal rpms on tach. The jerkiness will go away entirely after a few miles and the rpms will return to normal at idle at a stoplight or stop sign. Is this something that would be covered under my factory warranty? Car was purchased Jan. 2009. I also notice that when the car starts in the morning it goes to a very fast idle. Is that normal? I would think that with the way the oil filter is mounted that the engine might have to wait for oil to return to the filter before it can get to the engine. What could be the cause of my problem? And is it likely my warranty should cover the repairs?
View 4 Replies
I have a 2010 santa fe ,when I push the remote start button on the fob the park lights blink 2 times and no attempt to start I checked the rear hatch switch, door switches and the hood switch and they are working. What is the troubleshooting procedure for the remote start system.
View 6 Replies
On my 2012 Santa Fe I'm getting a whining noise from the engine while it is park. I think it might be alternator.
View 3 Replies
I recently purchased a 2011 Santa Fe SE with the 3.5 V6 Engine. When I start it up for the first time in the morning or after its been sitting for a few hours, the engine sounds likes it's insides are rattling for about 10 seconds or so... I believe the lifters are probably pumping up and it's a valve train noise... but is this normal? I don't like this sound. the previous owner used Mobil 1 synthetic oil and that is what is in there now. Is this a good choice for this engine? Is there an oil filter with a check valve that can be used to hold pressure to the valve train on start up? Is this cartridge type oil filter all that is used on these engines?
View 18 Replies
