The vehicle has 80,000kms, and from a cold start it is having this problem more and more frequently. I must crank the engine 3+ times, and then she starts. A prolonged cranking period doesn't seem to work, and this only occurs when cold. The car starts fine when warmed up. I have scanned the car with a generic OBD2 reader and there are no codes. Once the car is running, it runs great with no misfires.
View 1 RepliesOur 2009 Santa Fe AWD Limited shifts hard first thing in the morning when my wife shifts into reverse to back out of our parking space. This is a real hard THUD kind of shift, where the car jerks. After that, all shifting is normal. We don't have any other problems with the transmission when driving.
View 6 Replies2011 Santa Fe 3.5 L
I've isolated this rattle down to the cam phaser( CVVT) in the right cylinder head. It rattles bad for 2-3 secs on cold start or after it sits for 3 hours.
I've put in 5w20 synthetic oil and synthetic Lucas additive and it cleared up the noise for short interval start ups.
I changed the cam phaser in the right head with a used one ( 40k ) but it didn't make a difference. I should change out the attaching cam as well.
I have an issue for the last couple of years. I drive a 2006 hyundai santa fe with 168,000 km's on it. the problem I am having only happens on any cold day and never above zero celcius and when I start the vehicle on a cold day and go for a short trip to the store run in for about 5-10 minutes and I come back out and it won't start, there is lots of power but it wont roll over at all but after trying many times it will eventually start and there is no CEL showing and I have never plugged it in on a cold day and as cold as the canadian winters get here its been down to as low as -40 in the morning and no problems at all, a little roll and a groan and away she goes which is typical in our cold climates.
View 5 RepliesI own 2005 Santa Fe. Vehicle is a 3.5l V6. 90,000 miles. Transmission flushed few months ago. Few weeks ago I notice that transmission jump hard and bucked on cold start then smooth out once the engine warm up. Is it normal? if not what could be a problem.
View 3 Replies2007 Santa Fe, hard to start after fueling up, after that one time it cranks fine until I fuel up again.
View 1 RepliesMy Santa Fe was really hard to start this morning..it seems when it rains overnight it seems to spin and spin and spin and take some time to start.. Could a low voltage battery be in cause ?
When it starts, i see no loss in performance or any CEL that's come up and runs like it always did before.
Any quick tests that could be done before i take it back to the dealer for a diagnosis ? I have a multimeter so i guess i could check my battery voltage to see if it's the source of my problem.
When its under ca -5degrece my oil lamp lighten up ca 8 sek. My oil pressure at warm motor is 3.3 bar, what is wrong...
View 2 RepliesMy 2007 Civic Hybrid is having trouble starting. This happens when it's cold out, it's been sitting outside overnight (I don't have a garage), and the IMA battery is low. I've taken it to the dealership but they were not surprisingly no luck. The car has about 65,000 miles and a new battery - the one in front - was put in not too long ago and tests fine.
View 5 RepliesI drive a 2011 Limited. Three out of the past four mornings the car has been reluctant to start. It is cold out, but not super cold. This morning it was 1C (34F).
When I turn the key, it cranks but does not fire. I Held the key for what felt like forever, but in reality it was probably only 6 seconds. I let go of the key, waited a few moments and then tried again. After the third try, it finally fired and ran normally. It didn't stutter or otherwise seem to have any problems.
At this point I went inside and found my basic scan tool. No codes were stored and the voltage was between 13.5v and 14.6v. After I drove to work, I turned it off. The voltage dropped to 12.1v. When I cranked it again at work, I saw the voltage drop to 9.5v for a second before it fired up and jumped to 13.5v, then 14.6v.
The car has the original battery. Could it be as simple as a battery? Oh, I Just remembered, when the car did start, the radio was off. Upon turning it on, it was reset to defaults. Other than this starting issue that has only recently started, pun intended, and the radio I am having no other issues with the car.
I've had my '07 Volvo S40 2.4i for almost a year. It has a little over 60K miles on it and is serviced regularly. Within the last 3 months, I've noticed some weird things happening occasionally:
-Trouble starting when cold (I understand this is pretty common with a lot of cars.)
-Headlights & interior lights flickering
-Going over "bumps" in road causing dash display lights to illuminate for a second, radio to shut off, and loud system "BEEP" comes through the speakers (this has happened 3 times total, all on the same day.)
-AC stops cooling periodically I've had the system scanned for the AC issue and it seems that there was a "Pump pressure" message that cleared itself at one point and am guessing the same thing has happened the next few times it's done this.
I also asked that the battery be checked to see if it needed to be replaced soon. The mechanic said the battery was fine and thinks it's something wrong with the entire electrical system.
Question about the oil light. On a cold start the oil pressure light goes out immediately.
After driving around for a while (engine warmed up) and shutting off the engine for anywhere between 45 to 60 minutes or so and then starting the engine again, the oil light will go out immediately, but then SOMETIMES, pop back on, MAYBE flicker, then stay off. This all takes place in less than a second, almost a microsecond. This is all very intermittent too, No rhyme or reason as to temp or time between starts. Engine is very quiet, except for a COLD start (over night). I use 5-20 and it makes no difference whether using conventional or synthetic.
I change my own oil, but dealer did it once and I still get the same issue. I suspect the sending unit, or is this 'normal'?
07 Santa Fe 3.3 with 155k miles has lifter noise all the time. Much more pronounced in cold weather upon start up when the engine is cold. These miles are mostly highway and I change oil every 5-6k with Citgo synthetic blend. Is this just normal wear or could the engine be getting gummed up? I was thinking about treating the engine with some Marvel or Rislone but I really don't like putting solvents in my crankcase.
View 3 RepliesI've been driving my wife's 2001 Ford ZX2 for the last ~9 months.
Early on in taking over driving it I noticed that it was difficult to start, so I had the battery checked. One place said it need to be replaced, but I wanted confirmation so I had it checked at two other places--it was in the normal range. So then I thought it probably needed a tune up since, as far as I know, it had never had one (has ~50K and I know it should've been done earlier). But, that didn't seem to fix it either.
I then had the fuel filter replaced. Nothing. I generally turn the key over for a few seconds before I actually crank it to let fuel in. It is now taking 3 times each startup to do this. And, right after starting it feels like the car is struggling to get gas (as if the fuel filter is completely stopped up or a fuel link is kinked).
Once the car is warm it cranks over on the first time (as if nothing is wrong). The last time I was at the shop they told me I need to have my fuel injection system cleaned. I have doubts about this--they based it on mileage not any sort of actual diagnostic or inspection. I use quality gas and run a fuel injector cleaner at each oil change.
Truck: 1999 Ford Truck F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F
Problem: Especially when it is cold outside . . . The truck takes forever to start and while doing so a ton of white/grey smoke comes out of the exhaust.
My starting schema: Turn the key on have the gas pedal pushed to the floor until the "wait to start" light goes out. Then, I turn the key off and back on while still pressing the gas pedal all the way down. When the "wait to start" light goes out again I remove my foot from the pedal and try to start it. I never leave it cranking for more than 5-7 seconds. If, after trying this process several times I will not push the pedal in at all. Also, sometimes I will leave the pedal pushed in while I am cranking it over.
The truck used to start after a couple of tries but lately it won't start at all, even after 20 tries. Sometimes it will spin up for a second as if the engine gets going but then just doesn't continue running. When it is warm out it will usually start after a few tries but doesn't seem normal to me. After I first bought the truck(used) it would start up within half a second after turning the key.This all started after I had to fix an o-ring that was damaged on the top/back of the motor that was dumping all my oil out of the top/back of the motor.
I recently purchased a 2011 F-350 w/6.7 diesel. When I first start it & let it run say 30 seconds and take off it shifts fine from 1 to 2 but when it goes from 2-3 it hangs there a second and then finally shifts into 3rd hard. 3rd to 4th is ok but 4-5 again is a hard shift and from 5 to 6 is OK. It will do this for a while like through the neighborhood and down the road 10 miles then it is fine. Shifts beautifully when warmed up.
My local Ford dealer has a guy that is supposed to be very knowledgeable with Super Duty trucks. I have had it to him twice and he says this is normal. All shift hard until the transmission is up to operating temperature. Says the engine is very powerful and until everything is up to temperature this will happen. If so then it would be normal to let it sit and run for a while before you take off in the morning. I am getting ready to hook the truck up to my 33' camper and go on our first camping season with the trailer/truck combination and if I need to leave it sit and warm up I will.
2011 Santa Fe with 3.5L V6 and AWD, 38000 Kms:
Very recent work (last month or so) - new battery (old one had a bad cell), brake light switch and for a repair of the seat adjustment bar (not sure what it is called). The most recent oil change was done by me in November and I have only put about 1600 kms on it since. I put 5W20 Castrol Syntec and a made in Korea WIX filter. I fill the oil to just a hair below the top dot on the dip stick. I torque everything properly.
OIL LIGHT PROBLEM:
When I was driving home from work this evening, I had to brake a little harder than I normally would when I was turning into the back lane (about 8 houses from my house). I thought I saw the oil light come on, but I wasn't sure. I continued down the lane when someone walked out in front of me and I had to brake again. This time, the oil light did come on for sure and then went off when I took the brakes off. It was -20 C outside, so I continued to my house which was now 4 homes away. I braked to go into my (heated!) garage and the light came on again as soon as I touched the brakes.
I decided to let the car sit for an hour to get an accurate reading on the dip stick. I checked it and the level read exactly where I had filled it - just a touch below the top dot. I took the oil filter out to check that it was still seated properly and was not obviously clogged. It looked just fine. No signs of any leaks in the engine compartment or under the vehicle. I decided to take the car out again to go around the block - maybe not a great idea. The light didn't come on again when I braked until the vehicle had warmed up again.
What could the problem be?
I guess I need to take it in, but I start work at 7 AM and my wife is on maternity leave and she needs a car tomorrow. So, this means me taking the Yaris is out. She can't take the Santa Fe to the dealer with my infant son and so I guess I have to get it towed. This is bullshit. This POS has been in the shop several times since November.
I need to know if this is considered "normal" behavior of the transmission. This cold morning while driving in traffic the car just jerked really hard while shifting from 3rd to 2nd and as described in other threads its like someone rear ended the car.
It has only 2650 km, it's a 2012 2.4 6sp automatic 4wd Santa Fe, should I waste my time going to the dealer? It only happened once, no engine light no nothing. Could it be just a "glitch" in the ECM? I read some other threads before posting, but they were a bit older. Has experienced such a shifting bang under low speed with so little mileage?
I'm experiencing a weird problem with my 09 Santa Fe (just under 15k miles). A few times, while in slow and heavy traffic (and ONLY then) I experience a hard jolt or jerk. The 1st time it happened I thought someone had hit me in the rear but that was quickly ruled out.
I suspect this has something to do to do with the tranny. Though it occurs maybe once or twice monthly, I am beginning to have concerns and suspect that the problem will get worse with time.
I just bought this 2008 santa fe with a 3.3 V-6. It has 200kms on it. Here is the problem- I start the engine, and for the 1st second of running there is NO noise,.....but a second later it sounds like a chain slapping around in the engine HARD. it lasts for about 2 seconds and then the motor is quiet. It seems like the longer the car sits,..the worse it gets. If your only letting it sit for 20 minutes or so, you wont hear it.
View 5 RepliesGot in to go to work this am, and the gear shifter was difficult to move. What to check?
I drove 70 miles to work and didn't seem like any issues with the transmission shifting.
Got in to go to lunch and it seems even more difficult to move...
Shifting back and forth in the selector seems to loosen things up a little.
A friend move the selector while I looked at the linkage and the bracket that support the cable is flexing while shifting between gears....More likely a transmission issue or something with the linkage?