Santa Fe (CM - 2007-12) :: 2010 - Remote Start Key Fob Not Responding
Dec 31, 2013
Recently my 2010 Santa Fe's remote start key fob is not acknowledging a response for any function on it and there is no blue light activating behind rear view mirror. I figure it has to be something fairly simple since it worked just fine last week. I have two remotes and when buttons are pushed I'm getting bright blue lights on both key fobs so I doubt if both batteries are bad, the factory key fob for door locks still works fine. I've read other posts and I'm aware that there is not many fans of the remote start feature. Its been -30 here in MB for far too long and I need this feature to work for me.
View 2 Replies
Advertisement
I've 2014 Santa Fe Sport 2.4 AWD. From past few days my Front Passenger Door Lock/Unlock is not responding when i try to open via remote lock/Unlock buttons. All other door locks are working fine. I googled and found some issues with door actuators.
View 8 Replies
The 2012 SF I bought last weekend has a sticker on the radiator brace near the left head light stating the vehicle has a remote start function and there is a blue button with a key symbol on the fob that (I think) is supposed to make it work, but I have yet to get the remote start to operate. What's the secret? Is there a selection in the ECU that enables/disables it? Do I need to cross my eyes when I push the button? This would be great to have on cold or hot mornings - if I can get it to work.
View 4 Replies
I have a 2010 santa fe ,when I push the remote start button on the fob the park lights blink 2 times and no attempt to start I checked the rear hatch switch, door switches and the hood switch and they are working. What is the troubleshooting procedure for the remote start system.
View 6 Replies
I have tried to program 2006 Toyota camry for remote key activation .. but after all the steps completions the locks are not responding to activate the remote key.
Have tried many times as shown in videos but car not responding.
View 3 Replies
I have a peculiar problem with my 2010 Santa-Fe 3.5L
Every now and again, and more often recently, when I try to start the car with the ignition switch, it cranks well, but doesn't, or takes a while to start. If, after trying to start it with no success, I give it a few seconds, I usually get it going, but not always instantly like it used to.
However, If I try to start it with the remote, it starts instantly, every time. What could be the cause?
View 11 Replies
2010 Santa Fe V6...about a week ago the starter started acting up. When you try to start the car, you would hear 3 clicks before the engine would start normally. The clicking is random and does not happen every time. The dealer could not find anything wrong other than the battery was reading 440CCA vs the 600CCA it was rated. Starter clicked first thing today on the way to local mechanic to get brakes replaced. They tested battery and it tested good. What could be the problem?
View 4 Replies
Our 2010 Santa Fe SE V6 just developed a problem where when we turned the key, the car wouldn't start, and there was a loud clicking sound during start attempt. Battery tested 100% OK.
This often points to a starter problem, but a telling symptom was than the headlights would dim, almost going out, along with the dash lights and most any other lamp. If it was just the starter, unless dead short, this associated dimming would not happen. I also put a volt meter on the battery and watched battery voltage during cranking attempt, and the voltage showed minimal drop, so once again the battery was not the problem.
Traced the problem to the ground strap from the battery which terminates to the driver side front wheel well. Two bolts hold the strap to the wheel well, and they are oxide coated and the contact point on the wheel well is painted. This means all the current returning to the battery is essentially passing through the bolt threads and cap where the oxide has been scratched enough to be conductive.
I sanded underside of the bolt heads to remove oxide, sanded the ground strap itself which seemed to have some sort of clear coating, and sanded the paint away from the wheel well where the strap makes contact. I didn't have star washers, but if I did they would have been a good addition.
Car now starts with no problem.
I am concerned with the possibility of corrosion under the strap where I sanded away the paint, but will monitor this. I think the contact between the strap and fender wall is tight enough with the two screws to seal out moisture and oxygen.
I am also going to locate and check any other chassis to engine ground straps so I don't have any new problems in the future.
View 6 Replies
I had a remote start installed on my santa fe and initially it worked great. Recently it stopped working correctly. The car still starts but my heat/defrost will no longer turn on. I have tried every combination possible but when I get in the car the heat is turned completely off and will only turn on when I put the key in the ignition and manually start the car.
View 1 Replies
I'm a new owner of a Santa Fe 07. My car will not completely lock with the remote. I have to remember to manually check it if the alarm doesn't beep. All the other doors will lock except this one door behind the driver. My model is AWD, it the 7 passenger one . It's not the base model. I didn't have the hard copy of the manual but I have a digital copy. We just got this on 4/24/15. It has 90 warranty but don't think they will fix this issue that I thought was only the childproof lock mechanism somehow or was not a big deal but now I'm not so sure.
View 9 Replies
I purchased a NEW 2008 Hyundai Keyless Remote on the internet. It didn't come with programming instructions. How to program this remote.
View 15 Replies
I have a 2011 Santa Fe. I had to take it in for service in April because the shift lock was not acting correctly. Since I have gotten it back, it will not honk when I press the remote button twice. It did before the service was performed. The lights flash properly and the doors are locked, but I still want it to honk sometimes. Is there something that was turned off that I can turn back on?
View 8 Replies
I have a 2011 Hyundai Santa Fe, mileage is under 50000.
The remote Door lock, does not lock or unlock drivers door. But locks/unlocks all the other door.
View 5 Replies
When lock button on the remote is pressed twice and held for 3rd time , lights flash but car won't start. I just put fresh battery in remote Haven't used remote start since last winter..
View 1 Replies
Any way to set the seat heaters to turn on when the car is remote started?
View 42 Replies
I had my dealership install a car starter when I purchased my 2014 Santa Fe a year and a half ago. I noticed that this blue flashing light constantly flashes up by the rearview mirror. It looks like an anti theft device which it isn't' and really bothers me especially at night because it lights up the whole dash. How to disable this and still keep the remote functional?
View 2 Replies
I received a remote start for xmas and I'm usually pretty handy, but I've hit a wall today. I've got it responding to the code and turning the car on but it doesn't spin the starter. I've checked the hood switch by holding it down while hitting the code and it doesn't appear to be prohibiting starting.
2007 Camry XLE
[URL] .....
Here's the Main Power Harness and my connections:
Red, Red + White -> Black: Constant 12v
Violet -> Blue: Starter
Pink -> Yellow: Ignition
Pink + White -> Pink: Ignition 2
What would be keeping it from cranking the starter?
View 5 Replies
Have a few questions about remote start for the Camry. I have a 2007 Toyota camry SE (6/2006) model. I'm interested in doing an OEM remote start set up. I've gone to the toyota dealership before and i inquired about remote start and they stated there wasn't any for the 2007's but i see YouTube videos and ECU's on ebay that indicate otherwise. Now if i were to do remote start. Could i just purchase the Ecu and i guess get someone to install it and then use my 4 button fob to sync it? or is there more work to it than that or my car will only work with a certain ECU.
View 3 Replies
My remote start isn't working. I'd just like to make sure I haven't overlooked any obvious fix before I schedule a service appointment.
View 6 Replies
I have a 2012 RX350 with about 25k miles. Remote FOB will not start the car. Strange problem that I cannot find anywhere. The batteries were replaced in both FOBs because they were showing 2.6v. Still will not start.
Pressing LOCK, LOCK, HOLD LOCK you can hear the click of the doors locking but the flashers do not flash. After holding lock for the 3 seconds the flashers will flash 4 times, then nothing. All other functions of the fob work correctly.
I was thinking about removing the car battery for awhile (kind or a reboot, maybe) before bringing to dealer (110 miles away).
View 4 Replies
My remote starter didn't want to start the car this morning. It's been working fine up until today when the temperature dropped to 5-F last night. I sat in the car and used the remote start to see what was going on, and it fired up the motor for a second or so, then it shut down again right away. My in-car test was the 3rd start attempt.. When I pushed the in-dash start button, the car started just fine..
Any insights as to why the remote starter doesn't seem to like the cold? The entire reason I purchased that option was to avoid going outside when it was that cold.. and if that's when it doesn't work....
View 19 Replies
