Santa Fe (CM - 2007-12) :: 2009 - Small Leak EVAP Code P0456
Apr 22, 2015
2009 santa fe 67000 miles. Replaced fuel senders approx a month ago. All was fine. On about the 3rd fill up the cel came on. Code was for small leak evap. checked the gas cap, no problems. Replaced the purge valve and disconnected the battery while doing so. Cel light went off and stayed off thru one tank of gas. Filled up again and thought I detected a little fuel smell shortly after and cel came on again. I only smell fuel when its full and down to just before 3/4's. The light came on right before 3/4's. My husband is beyond frustrated and wants to smash the car lol. Once I get him calmed down where should we be looking for a leak and how to fix it? We can't afford a dealership bill right now and of course it's due for inspection next month.
Code was p0456
The only answer I got in the DIY section is to check around the fuel senders again but I'm leery to do it as I can't see how there would be a leak there, the covers go on SO hard even with that tool.
View 39 Replies
Advertisement
Wife's car had a check engine light this morning, code is PO456, small evap leak, I took gas cap off cleaned the filler neck and solenoid the gas cap seal, and reset the light. I filled her car up on Sunday (2011 Sonata 2.4 80000 miles). Where to go next if light comes back on? Purge valve ?
View 9 Replies
My 2007 Sonata continues to throw a P0456 code, small evap leak detected, gas cap is tight, getting ready to check the evap hoses. The question I have is the evap system covered under the emissions warranty at all ?
View 4 Replies
It all started with a fuel cap loose light (it wasn't) after a day or two the MIL came on and got this code I reset it but I'm sure it'll come back since there's probably a real leak. What can I check myself to find this leak?
View 11 Replies
This is the code i pulled from Vag. Its not the gas cap...
VCDS Release 805.0: Generic OBD2
Mode 03: Emission related fault codes
Address 10 (Engine): 1 Fault Found:
P0456 - EVAP System: Very Small Leak Detected
View 8 Replies
2004 VW touareg v6 - engine light on - autozone diagnosed as code P0456. Possibly gas cap, so I replaced with aftermarket gas cap from auto zone. Light still on. What can I do or replace to fix problem. I read something about a N60 or N80 valve. Is this something I can buy and replace myself. Most of my mechanical experience is related to working on a 85 CJ7 with an inline 6cyl or Chevy trucks. If the N valve is a easy fix, any instructions and pictures of how to do this.
View 1 Replies
CEL came on after a couple of driving cycles showing code P0456 (evap emission control system very small leak detected)............. car drives fine has good gas mileage.....
View 13 Replies
I have a 2005 1.8 TJetta GLI owned for about 2 months now. Gas cap warning pops up then goes away when I turn off the car then check engine light comes on. I've change the gas cap to new oem one changed the purge valve [URL] .... After a couple of weeks same issues again brought it to my mechanic he ran a leak detector and told me that there are Evap leaks. I read somewhere that I might need a need charcoal canister and a fuel tank.
View 12 Replies
I have a 2011 F-250 6.2l with a P0456 code. Is there a common fix for this issue?
View 9 Replies
So I have had this code P0442 for a long time and I just kept clearing it. The attached picture (at an angle) shows the hole in the small line attached to the fuel neck filler exactly behind where the plastic wheel well cover touches it. Just ordered a new one from rockauto for about 65 shipped.
View 5 Replies
Got a CEL tonight while driving. Originally I was driving and the light came on saying that my gas cap was loose. I corrected the problem when I got home and tightened again. The light stayed on however. I ran a scan with the OBDII and it gave me a code for EVAP- Very Small Leak .
I was reading around and some people suggested the MAF. Which would make sense because I recently had all of that stuff off and gave the engine a deep cleaning while it was exposed. I just don't see how the MAF could relate to the code my car is pushing?
View 6 Replies
My 2009 santa fe with the 2.7 has a check engine light. p2422 evap vent solenoid stuck closed. I replaced the charcoal canister and the light came back on. I replace the solenoid by the throttle body and the light came back on but took longer to set. My wife said that she was having problems filling the tank but when I changed the second solenoid the problem was gone but the light had returned.
View 6 Replies
I've gotten the P0442 "small leak - intermittent" code and "service now" warnings on my 2007 2.0T Passat. I have also occasionally gotten the "check gas cap" warning and icon on the dash, but it always goes away quickly. The car runs fine. The VCDS scan shows as follows:
Address 01: Engine Labels: 06F-907-115-AXX.lbl
Part No SW: 3C0 907 115 S HW: 8P0 907 115 B
Component: 2.0l R4/4V TFSI 0020
Revision: --H14--- Serial number: VWZCZ000000000
Coding: 0404010A19070160
Shop #: WSC 24125 444 85663
VCID: 3041CBF8A31AF19890B
1 Fault Found:
001090 - EVAP Emission Control Sys
P0442 - 001 - Small Leak - Intermittent
[Code] ....
If I clear this code, it comes back within a day or two of driving, but not immediately. I have already replaced the gas cap and N80 valve. The other component I'm aware of possibly failing is the check valve. It's just downstream of the N80 valve, circled in red here:.
I put a vacuum on this part, and it had a very slow leak, losing about 3psi (starting from 20psi) every minute. That seems too small a leak for this to be a problem? Is this thing supposed to be absolutely air tight? Since this part is more expensive ($80) and bit more hassle to replace than the N80 valve, I'd like to know more about this before I just blindly replace it.
If this check valve isn't the problem, then what to check? Although the car runs fine, I need an inspection and would prefer to not have to clear the codes and hope for the best just before taking it in.
View 7 Replies
so my girls car is throwing an evap code (P0442) small leak detected. I bought a new oem gas cap and replaced the purge valve solenoid under the hood. that didn't work, CEL still comes on about 100mi after clearing the code.
I have checked the rubber hoses that were attached to the purge valve solenoid when i replaced it and they are fresh, no dry rot or cracks that i can see. The hose on one side goes to a hard line that runs under the car to the back, the hose on the other side of the solenoid runs under the intake to the throttle body. That hose was fine as well. Connections were tight and i even put better clamps on the hose ends that attach to the solenoid. So I have ruled out that portion of the system (under the hood).
I also removed the rear seat to access the fuel pump. All those connections seem nice and tight, I don't smell any strong gas fumes indicating a leak so i don't think the fuel pump gasket is the problem either. Finally, i checked out the hard lines running under the car front to back and I see no apparent or obvious damage. I assume my next step is to pull off the rear passenger wheel well liner and asses the charcoal canister and the LDP connections, correct??
The last thing I will mention is, Idid notice the 2 fuel lines that attach to the fuel regulator are in pretty rough shape, however not leaking any fuel. Are both of these lines actual liquid fuel lines? I am thinking one of them is a vapor return which may be part of the EVAP system. If it's dry-rotted and leaking vapors could that be the culprit??
View 2 Replies
Threw this code p0442 evap emission control small leak. I see its a popular code to have....
View 14 Replies
I had a check engine light cane on. I took it for it to get checked and they gave me this code- P0457 EVAP small leak detected. ECM has detected a large leak in the EVAP System during a system monitor test.
The paper said I had a leak in the Evap canister or hose. I took the truck to a mechanic and was told I had Bad oxygen sensors. Can Bad/Dirty oxygen sensors make this error code come up?
Exactly where the oxygen sensors are? I was told they were behind the mufflers but I didn't see any and the diagram I found was not accurate.
2002 Ford Ranger XLT v6 extra cab.
View 2 Replies
The CEL is on for a evap leak. I replaced both packing O-rings for the fuel pump, which I should have done when I replaced the fuel level senders. I have driven the car for a week with no resolution. I did try a new gas cap before I replaced the O-rings, but it didn't resolve the problem. I realize that I may have more than 1 issue, so I'll put the new gas cap on shortly. Just wondering if there's anything else I should check before I put the seats back. Are there any other common areas to fail that I need to check?
View 10 Replies
At roughly 140,000 miles, my wife's '07 Santa Fe GLS has thrown a P0456 code. Does this code on a Santa Fe common?
It is "evaporative emission system leak detected (very small leak)." The good news, I guess, is that it is 'very small.' However, being small may make it more difficult to detect.
View 3 Replies
My CEL came on a few weeks ago on my 2010 gti, I scanned it and got a code for evap (P0456). I figured it was from filling the tank while the car was running, so I cleared it and went on with my week. About a week later it came back on and when I scanned it, I got the same thing. I haven't had time to smoke test the system but the last couple days i have heard a clicking/tapping noise coming from the rear passenger side of the car. Could the flapper in the filler neck be malfunctioning or gas cap be leaking.
View 2 Replies
Just received a P0441 CEL (Evap Emission System Incorrect Purge Flow). I have a 2.7l engine, 2WD. I've read other forums and it seems it's most likely the purge valve or charcoal canister.
View 7 Replies
I've had the check engine light come on and was told it was probably from topping up too much and that it would go off on it's own... I should say I have no issues with idle or rough starts.
I had it scanned at Auto Zone. The print out shows: "EVAP emission system incorrect purge flow probable cause
1) Faulty purge control solenoid
2) Faulty vent solenoid
3) Blocked vapor canister
Previous posts suggest if it were a blocked vapor canister I'd have trouble completely filling the tank so I am hoping it's one of the others. Almost everything I see suggests the purge control and that looks like an easy fix. My concerns are a) if it is the vent solenoid - how hard is that to get at and b) what is the part number as I can't find it listed anywhere? I want to have both on hand before I start trying to fix this. Lastly if it is the vent solenoid should I just give up and see a dealer??
View 3 Replies
