Santa Fe (CM - 2007-12) :: 2008 Vehicle Pulling Towards Right


Sep 30, 2014

When driving I seem to be constantly applying pressure to the left side of my steering wheel to keep the vehicle from moving to the right. I've had the car aligned made sure my tire pressures were correct and had my mechanic check the undercarriage to make sure ball joints tie rod ends etc. are all in good working order. Despite all this the vehicle seems to want to wander right and I'm constantly putting pressure on the left side of the steering wheel.

View 4 Replies

Advertisement

Santa Fe (CM - 2007-12) :: 2008 - Cylinder 3 Misfire / Vehicle Is Idling Rough

I have a cylinder 3 misfire and the vehicle is idling rough so I took it to the deal because I have a power terrain warranty. They're telling me I'll need a new manifold and plenum, coil pack, plugs, and gasket. Could this be accurate? I don't want to get screwed over...

View 9 Replies

Santa Fe (CM - 2007-12) :: 2008 - Grinding Noise Coming From Front Of Vehicle When In Neutral

When I start my vehicle, it makes a grinding noise, sounds like it's coming from the front of the vehicle, when I put into gear it stops. It started gradual and is getting worse. It's a 6 cylinder automatic, with 108 k miles.

View 3 Replies

Santa Fe (CM - 2007-12) :: 2008 - Random Cylinder Misfire / Vehicle Shuttered And Driving Power Lost

I have 62,500 on my 08 Santa Fe... never had any engine problems, but today, started the vehicle, drove 1/2 mile in town at 25 mph, turned a corner and the vehicle shuttered and lost driving power. At the same time, the check engine light came on and flashed continuously. I drove 1/2 block (around two corners in town) with the on/off studder and loss of power. I pumped the accelerator just to keep it from killing. As I stopped at the next corner and idled the vehicle regained power. I pulled over and called the dealership service department and they recommended I drive it home (blocks away) and turn the engine off, then try to restart it and if it started drive it 30 miles to dealership.

Did that, engine light came on steady and vehicle had full power. Long and short... the code was P0300 Random CYL Miss Fire Fault (random cylinder miss fire). After scanning the vehicle, test driving it and inspecting it as they do, they could not find a source of the problem or duplicate it. They cleared the code and promised that if it happened again they would credit me the $90 diagnostic fee I paid today for them to find nothing and apply it to a problem they couldn't find. They were willing to try and warranty it even though it is 2,500 over warranty if it had needed parts. Has this cylinder misfire happened to any of you? I've never had a problem like this really go away, so I'm expecting it will show up again. Also, they want to replace the timing belt (at 60K) as a preventative measure. What do you think? Can I wait till 80K?

View 7 Replies

Santa Fe (CM - 2007-12) :: 2010 - Pulling To The Left

My Santa Fe 2010 is pulling to the left and the dealer has tried everything to eradicate the fault without success. What might be causing this?

View 4 Replies

Santa Fe (CM - 2007-12) :: 2010 - Pulling To The Passenger / Right Side

My santa fe was pulling to the passenger side and i got it aligned again at shop but after that was done its still pulling to the right side. What could be a cause of that? it only has 17 000 km.

View 10 Replies

Santa Fe (CM - 2007-12) :: Small Jerk From The Car When Pulling Away At Low Revs

Over the last few months I've noticed that there was a small 'Jerk' from the car when pulling away at low revs. It seemed to happen around 1200 RPM/20 MPH put only when pulling away very gently. It has been getting worse in the past two weeks. The car needs a service and I was going to get the fault looked at when in for service. Last night the 'ESP OFF' and the 4WD fault indicator came on (4WD lamp flashing). Since the fault lamps have illuminated, the car has stopped 'Jerking'.

View 3 Replies

Santa Fe (CM - 2007-12) :: 2011 Vehicle Will Not Crank Over (sometimes)

I have a 2011 Santa Fe SE. Drove it the other day, vehicle sat for about 45 minutes, got back in and it would not crank. It had lights and power, but made no cranking sound when the key was turned. Tried to start it numerous times, waited 15 minutes to an hour then it started just fine. This has happened 3 times total. Each time the vehicle was driven for about 15 minutes then sat for awhile then would not start, but was able to start after waiting for awhile.

Brought it to a garage/mechanic who could not get the problem to repeat itself. He checked the battery hookups and looked it over, but did not see anything out of place. He did not hook it up for a diagnosis.

View 5 Replies

Santa Fe (CM - 2007-12) :: Vehicle Stalled Out - Cranks But Won't Start

Wife called me this evening saying she's stuck at work. She was parked in a parking garage on the 3rd level, she started the car up, coming down the ramps of the garage and on the first floor at a stop sign, the vehicle stalled out on her. She went to restart it, but it will not turn over. I come out and tried to start it with no luck. I did notice on the positive side of the battery terminal there was a lot of corrosive discharge. I cleaned that all up, but still no luck. Everything has power, bright interior lights and headlights okay. I originally thought it was just cold or lean... But still won't kick over.

View 11 Replies

Santa Fe (CM - 2007-12) :: Hazard / Turn Signals On Randomly When Vehicle Off

I have had an ongoing issue with my 2010 Santa Fe Limited with the battery randomly being drawn down and would not start the vehicle.

I saw a post somewhere on the internet to remove the Negative connection on the fender and grind it down to the bare metal so that it has a good ground connection.

I have done that last week, but last night before turning in for the night i looked out the window and saw lights in my driveway. I went out to investigate and found that the Santa Fe's turn signal/hazard lights were all on front and back and not flashing.

I got in the vehicle and turned the lights on and off with no keys and they all went out.

I got the schematics for the Santa Fe and i believe it could be the Hazard relay that seems to be located inside the I/P Junction box or could be the Hazard Relay Control in the BCM.

View 1 Replies

Santa Fe (CM - 2007-12) :: Ticking Noise That Slows After Vehicle Is Turned Off

I recently purchased a 2012 used Santa Fe. I've only had it about 2 weeks and just noticed something the other day. When I shut the vehicle off and exit, I hear a very low ticking noise coming from behind the front grill vents. It lasts for about 15 seconds and slows down until it stops completely.

I'll be the first to tell you that I know absolutely NOTHING when I comes to cars (other than how to drive one ). My guess would be that it sounds like some type of fan coming to a stop. If this is the case, I'm wondering if one of the blades could be bent, and how potentially serious of an issue this might be? Other than that, it drives great, with no other notable noises while in motion.

View 8 Replies

Santa Fe (CM - 2007-12) :: Driveshaft Clunk Noise In The Front Of Vehicle

Got a 2007 Santa Fe CM (Europe) with 160k km. I'm currently trying to figure out how to fix the clunk noise in the front of the vehicle. I am aware about the TSB 12-DS-002 where they recommend changing the drive shaft washer, but since that's a lot of work I want to make sure that this is really the problem.

The noise is not always there. Sometimes you can hear the clunk when decelerating, but not always. You can also sometimes hear a clunk when going from D to R. It sounds like a driveshaft has some play, and a change in the direction of the force causes it to slam into the other side. However, you can't feel it, so there is definitely not a lot of force behind it. You can only hear it.

However, I asked some guys to shift between R and D while I'm outside so that I can figure out where the sound comes from. However, murphy's law, it didn't made any clunk. And after shifting between R and D for like 20 times I felt bad for my transmission and stopped it.

The clunk is not always there, just sometimes. It doesn't really make sense to me, if its really play in a driveshaft it should be always there? Also the clunk started at about 155k km, now I got 160k.

Is there any further diagnostics I could do?

View 5 Replies

Ford F-150 (2004-2008) :: 2007 - Jerking While Pulling Trailer - Changing Plugs?

I have a 07 with the 5.4 engine and it has started to jerk or miss sometimes when I'm pulling my trailer. I'm thinking about changing the plugs, but the dealership is telling me they will break off in the head.

View 11 Replies

Santa Fe (CM - 2007-12) :: Check Engine Light Came On - Vehicle Jerks When Idling

My 2007 Sante Fe had problem this week. Took 6 attempts to start engine, then ran smoothly the rest of the night. The check engine light came on while trying to start vehicle.

Next day I changed the spark plugs but now find that the vehicle jerks when idling. Runs fine when going but jerks and bucks at stop lights and stop signs. Just added fuel injection cleaner to see if that may support the situation.

Engine light has come back on again since resetting. I have read several suggestions on internet regarding leak in vacuum line, Coil Pack damage due to faulty hose, even faulty 02 sensor.

View 2 Replies

Santa Fe (CM - 2007-12) :: ESC Light Is On After Towing Boat / Vehicle Won't Shift Into Or Out Of Park

We went camping and my girlfriend wanted to take her brothers fishing boat for him, on the way back the electronic stability control light came on and when we reached our destination we discovered it wound not shift into or out of park without using the key override.

2011 front wheel drive santa fe ...

View 24 Replies

Santa Fe (CM - 2007-12) :: Loud Click Noise Coming From Front End Of Vehicle When Apply Brakes

I get this loud click noise coming from the front end of my vehicle when I apply the brakes. It seems to happen much more often than not, especially at low speeds. I can only describe it as some sort of loud clicky clanky sound, it's also a single sound, it doesn't go on and on and it only happens when I apply the brakes.

View 2 Replies

Touareg :: Vehicle Pulling To Left And Right More Than Steering Wheel Is Turned

My Touareg started to have a weird sensation recently. As I turn to the Left the vehicle turns Left more then my steering wheel is turned, It seems to dive in that direction. It just started do do this going Right also. I thought I saw something on this topic before but was unable to find it.

View 13 Replies

Ford F-150 (2004-2008) :: 2012 Side Mirror Fit In 2007 Vehicle?

I broke my passenger side mirror on my '07 and I have a guy that will sell me a set off of a 2012... will they fit?

View 2 Replies

Santa Fe (CM - 2007-12) :: 2008 - No Response To Key

The other day, I had occasion to try to start my '08 Ltd, and there was no starter response to the key. Everything lit up and didn't dim when turning the key. Jiggled the key a few times, no change. Jiggled the shift lever a few times, no change. Turned the key a few more times, and it started. Yes, the vehicle was definitely in Park at the time.

This one has an automatic, so I'm assuming it was either a shift interlock switch (aka Neutral Safety Switch) or possibly the ignition switch itself, but as noted, neither responded to my ham handed approach to solving the problem. First time, it took about half a dozen start attempts. The second time, only three.

Haven't had the problem since then, but then again, I haven't been cycling the ignition as much as I was that day (probably 20 start stop cycles). Now I'm just wondering where and when it will bite me again. Some of the places I take this vehicle to the boonies in the Rocky Mountains would cost me dearly in tow charges.

Encountered this on an earlier CM model? I don't recall ever seeing this mentioned here over the years.

View 2 Replies

Santa Fe (CM - 2007-12) :: 2008 - Hum Noise From Driveline

Have 2008 Santa fe with a driveline hum noise. Originally thought is was a wheel bearing so I replaced what I thought was the suspect ones (1 in front and 1 in the back). Noise still there! Carrier bearing on the drive shaft? Front axle shaft? I'm at a lose.

View 7 Replies

Santa Fe (CM - 2007-12) :: 2008 - Misfires On All 6 Cylinders

Just replaced all 6 plugs after getting p0300-p0306 codes. Still getting all codes, always starting with p0305. Was told coil was bad cause the shop only was getting p0305, but I have all misfire codes. We have over 95k on it, have owned since 2008. Its the 2.7 in it.

View 11 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved