I cant find the location of the Turn signal relay, its not in the Relay box under the hood nor is it on the fuse panel under the dash, i'm planning on installing LED blinkers and i want to switch out the relay to a LED compatible one, where it is?
2008 Santa Fe GLS ....
I've changed out all of my external lights for led's, including the turn signals. I had planned on replacing the turn signal relays with led comparable versions but have been unable to find the relays in the fuse boxes. The box that does the actual clicking under the dash seems like it could be it but it looks completely proprietary to this model, and not readily available in the compatible version.
I ended up installing resistors for now but that's caused other problems with my lights. Now when I turn my high beams on all 4 turn signals light up solid and I am unable to use them until I turn the highs off.
So, I would love to know if I do have a relay replacement option for my 2012 Santa Fe...
Where the turn signal relay is located? I want to change my stock turn signals to LED. However, I don't want to use those "load resistors" or "cancelers". iJDMtoy sells an LED relay for the 14' IS (confirmed). After looking through the manual and at all 3 fuse/relay locations I can't locate it.
View 3 RepliesWhere is the signal flasher relay located. I can hear it but can't track it down.
View 5 RepliesLong story short, my truck's front turn signals and rear turn signals/tail lights won't work. I am thinking that the relay is burnt. Whenever I look in the manual I can't seem to find the location for this relay. Is is built into the flasher?
Also, I am just assuming because the rear turn signals and tail lights are the same bulb that fixing this should clear up both problems. Am I right in thinking that?
I have already checked all of the fuses. Also, the Hazards don't work either.
I need to know the Location of the turn signal relay, my left front bilnker is super dim, and the rear left blinker is normal brightness as well as they blink rapidly. I've replaced both front and back bulbs as well as the flasher and turn signal fuses, so I am assuming the last and final one is the turn signal relay.
View 2 Replies2007 Santa Fe. Recently my turn signal has not been working. It seems to act finicky and not want to work every time I need it too. I noticed that this happened once every blue moon in the winter time when I purchased the vehicle new back in '07. However it has been occurring more frequently as of the past 3 days.
I have checked the fuse and it is fine. My hazard signals work when my turn signal works if that is any additional indication of what might be going on. What can be done to remedy the situation?
All my turn and hazard signals work normally when engaged but when it snaps back into the off position the turn signal (sound only) keeps going rapidly. It goes on and off randomly. It's the sound in the dash only. What it is? I can replace it myself I just need to figure out what it is.
View 44 RepliesMy wife's '07 has that fast-blink thing going on with the left turn signal. The thing is, none of the bulbs are out. It does appear that the front ones are dimmer than the ones on the right (which work fine).
View 8 RepliesI'm trying to figure out what has failed on my 2008 Santa Fe.
After stopping at a gas station today, my right turn signal came on and stayed on. By this I mean that the right turn arrow on the dash is illuminated and both the front and rear right turn signal bulbs are illuminated. They are all on steady, not flashing. Moving the turn signal stalk/switch does nothing. They all stay on when the car is turned off and the key removed. I have to disconnect the battery to get them to shut off. I tried pulling the turn signal, hazard and cluster fuses in the dash, but they had no effect. The switch for headlamps/park lights has no effect on the right side bulbs.
The left turn signal works normally.
Also, it may be related to having unplugged the battery a couple of times, but now the CD player shows "initializing" and I can't use it. The am/fm stereo works normally.
My 2008 Santa Fe has a problem where the heater & A/C work fine, the fan is blowing a lot of air but it will not switch between the defrost, heat & floor locations. Right now about 90% of the air is blowing out on the floor(freezing my feet with A/C) while about 5% comes out of the dash vents and 5% out of the windshield vents. No amount of adjusting will change these. I've changed the cabin air filter which didn't work and have ruled out the fan as it sounds great and pushing a lot of air out at the lower vent.
View 1 RepliesMy 2007 Hyundai Santa Fe right hand turn signal light bulbs flash rapidly both in the front and rear, the left hand side is normal. I am trying to locate the turn signal flasher module but without any luck, looked under the dash in the fuse box and under the hood in the relay box. Is it in the relay box...
View 7 RepliesEngine light came on a week ago, finally made it in to get the code pulled yesterday : P0441
From reading on this site, thinking its a faulty purge valve.
I have found pics of its location on an 04, but cant seem to find it on my 08 2.7L.
My left turn signal stopped working all together after months of toggling the hazards to get it to work. I attempted to solder the combination relay myself but bridged two contacts together. I guess I didn't do a good job separating them again cause when I plugged it back in, neither signal worked and it must have burnt out the #20 10a fuse cause the heater control had no power, neither did the heated seats. Also found the #26 15a fuse was blown too. But before I replaced the fuses I got a used combination relay I pulled from a jeep at a junk yard (free). Plugged that in (nothing changed) but then replaced the fuses. Heater control and heated seats came back, had hazards but no directionals. Took used relay out and heated that one up to reactivate the solder, plugged it back in and had a left signal but now no right. Tried to reflow the solder second time but still just the left. Dropped $58 on a new relay at the dealer, plugged that in but still no right signal!! I tried other fuses in those to spots I replaced, pulled everyone of the others and checked them, checked the fuses under the hood and still no right.
View 1 RepliesMy turn signal relay clicking and stuttering randomly. When turn or warning signal used it operates normally with absolutely no problem and sounds healthy. But when not used and supposed to be quite - it goes again. When stuttering - there is absolutely no indication other than clicking sound that something is wrong.
View 11 RepliesI'd like to put in a louder turn signal flasher on my 2007 F150 - where is it located and where I can get a louder one ?
View 1 RepliesIs the turn signal relay the same in my 97 Mountaineer as in my 97 Ranger? If so, what does it look like, and where might I find it?
View 11 RepliesI installed an EP27 electronic turn signal relay and changed the tail bulbs to Sylvania red 3157Rs in our Exped and everything works fine. I installed another EP27 in our Excur and the relay starts clicking when nothing is on and nothing else has been changed - all stock bulbs and working fine before.
No lights are blinking, but the EP27 turn signal relay is clicking away. Select left turn, right turn or hazard lights and they blink fine. Deselect the lights and the relay continues to click. Swapped the relay from the Exped to the Excur and it clicks, too. Reinstalled the stock turn signal relay and all is fine. There must be some difference or problem in the wiring, it doesn't make sense.
The turn signal lights in my brother's 2000 passat are staying lit when he turns the signals on. They work sometimes, for a few clicks, but then stop working.
1. is it the turn signal relay. It sounds like its in the middle of the dash.
2. how do you get to that relay?
Have to remove the HVAC controls? if so, how the heck do you do it?
[URL] ....
I have an issue with my 2003 Prius. The reverse lights do not turn on when I put the vehicle in R. Checked the bulbs and they are fine. Checked all the relay (fuse) boxes and didn't find any burnt fuses.
I have a Haynes Manual and other than a circuit diagram, there is nothing that I could find about the location of the backup light relay. By the diagram I can tell that it is connected to a "HOT IN RUN or START" circuit and a 10 A fuse. Although it is useful for showing the wire routing, it doesn't tell me where it is!!
What is the location of the taillight relay? My taillights (and all other exterior marker lights) have gone out and the display no longer dims at night. The fuse has no supply voltage. My best guess from the wiring diagram is that the taillight relay is toast. It would seem a simple operation to pull the relay and just check it. The problem is finding it. The repair manual says it is in the fuse/relay box over the drivers side front tire. However there is no relay in that box marked as taillight and all the relays are accounted for from the diagram. The car is an 08.
View 3 Replies