Santa FE SM (2001-06) :: Transmission Stuck In 3rd Gear
Dec 16, 2013
I have an 01 and 02 santa f. I took the v6 out of 01-and put in the 02.put new gaskets on engine new timing belt etc. Got engine in and runs like a champ. But the tranny which looks new I assume its been replaced. It starts out in 2 or 3 all the time want shift into od. Reverse works. So I found one plug dangling I couldn't figure out where it went then i found it. It plugged up on top of tranny. Well now it starts out in first and shifts through all the gears. Drove it down the rd shifted fine. Turned around and put in reverse then when i went to drive it jerked real hard. Shifted out fine so I went to floor it to make it kick down and it jerked again. This time it was hung in 3 or drive cause when I pulled into my driveway it was in high gear and u can put it in manual mode and the light only goes to second and d when it acts up like this. So i killed the car started back up and know it will go into first in manual mode and shift out and do fine?
View 3 Replies
Advertisement
My 2010 Santa Fe's transmission has been smooth since the TCM update except there's always a clicking sound when the speed first reaches 30 km/h. The sound only happens once during each trip. It seems like it only happens when the fluid is cold. Once it's warmed up, it's fine.
Yesterday all of sudden I feel something is dragging my car. I noticed RPM is over 2000 when the speed is only about 60 km/h. (not mile). And the ECHO light is not ON. So I shift to '+/-' mode and the display shows 4. I guess it means it's in 4th gear. I shift up to 5th gear and RPM drops right away. ECHO light comes back ON. So is this a symptom of 2010 Santa Fe transmission?
I also feel my brake pedal is very stiff when this happens. And the brake pedal has not much travel distance. If the brakes are dragging car down, can this cause the transmission stuck at low gear?
View 2 Replies
Finding a solution to my problem with Santa Fe, the gear gets stuck up on the 3rd gear. I have changed all the solenoid and it is still the same.
View 2 Replies
My transmission got stuck in 3rd gear on the way home recently. I tried disconnecting and re-connecting the battery and that didn't work. Looks like there's fluid around the casing, but I wasn't sure if that was already there or not. What it could be? '07 Santa Fe (3.3L)
View 4 Replies
Its not my car but my sister in laws. She stopped by our house tonight to pick up her kids and when she put the car in drive it showed both drive and 2nd gear. we tried disconnecting the battery so she could at least get it home (3 min away) but it didn't change anything.
She left with it still in 2nd thinking she could make the short drive without any problems but half way home it shifted down to first and it wasn't even driveable. Everything i have read on the web (which was not really specific to the santa fe) was say that its stuck in safe mode. What could have cause the problem? So far no check engine light has come on.
View 2 Replies
2003 Santa Fe 41,000 stuck in first gear.
View 1 Replies
So my wife's santa fe will randomly get stuck in 3rd gear and not shift up or down (automatically or manually). It does not appear to be slipping as it speeds up slows down fine. The check engine light is on but have not read the codes yet.
View 5 Replies
My 2001 Santa Fe 2,4l - Have suddenly lost the abillity to shift gear. Its stuck in 2 and the shift stick is very loose in the "front to back and back to front" motion.. in other words there are resistance sideways.
I suspect it to be a broken shift cable. So my question is : changing shift cable on a santa fe easy? Is the best approach to start from inside the vehicle or from transmission side?
View 6 Replies
I have a 2004 Hyundai Santa Fe, has 99,000 miles 3.5L. After changing the alternator (alternator did die and drained my battery, the shop recharged the battery) now it seems be stuck in 3rd gear and does not wont to shift (it is a automatic). Fluids are good, transmission was flushed between 50-60,000 miles.
View 3 Replies
I just picked up another GTi and knew the transmission was iffy when I bought it. I had to deal with the serpentine belt tensioner which is now new and also a new waterpump since it was wobbling.
I've already drained and replaced whatever oil was in there with VW G60 Gear Oil which is what my Dealer here told me to put in and it shifts smoother now but still has the same issue. I also did the Shifter Cable adjustment to see if that was the problem but that only made it easier to shift but it still got stuck.
Basically what happens is when driving I shift into 3rd gear and when I go to shift out of 3rd it comes out of gear but it's like it hits a brick wall and will not go into the home position. I was hoping the adjustment and new oil would work but it hasn't done anything.
View 2 Replies
I have a 2005 2.7L Santa Fe that was shifting poorly and getting stuck in limp mode intermittently. I read up on it and found that it was probably an issue with the input/output speed sensors. The codes confirmed my suspicions and I replaced both the input and output sensors. The codes cleared and the tranny shifted like a dream. Unfortunately after 2 days and 100+ miles the car suddenly started down shifting randomly on my way home from work. The CEL came back on and the car went into limp mode. Could the sensor have gone bad again? Or could it be the wiring harness that plugs into one of the sensors? I don't understand why the car would be fine for a few days and then all of a sudden be acting the same way.
View 6 Replies
I have a 2003 Santa Fe 3.5l FWD 155k miles. Car has been incredibly trouble free until now. When the transmission up-shifts from 2nd to 3rd there is a hard jolt. All other up-shift and down-shift points work smooth. Occasionally will shift smooth just after I start the car or if I am accelerating hard. The rough shift happens whether I am in D or use the "manual" shift control. This coincidentally(?) started just about the time I had a battery die hard and an O2 sensor fail. Both have been replaced. Changed the AT fluid and no difference. No engine codes, but I think the AT codes don't show there? What might be going on? Any chance the battery failure had anything to do with this? Seems odd that battery, O2 sensor and transmission all start acting up at the same time.
View 5 Replies
My car is a 2004 Hyundai Santa Fe 6 cylinder all wheel drive. Had an issue with the transmission continually dropping down a gear when keeping the car at about 35mph... no codes were showing nor any lights on the dash were on indicating a problem... dealer said the catalytic converter was the problem. changed it and it did not fix the problem...brought the car back to them and they said it now is showing a code and the service engine light is now on... the code showed that the Crank Sensor and the Throttle Position Sensor were bad... I asked why they had to change the cat and they explained
That they had to change the catalytic converter to get the correct "back pressure" so the computer would then recognize the actual problem and would direct them to the real issue... They assured me the cat was bad...in other words they had to change the cat out or they would not have found the problem... I think i got scammed and they really didn't know what they were doing and it cost me a bunch of money... is there any connection with the cat and those two sensors that could cause this scenario?
View 5 Replies
A few years ago my auto transmission in my 3.5 L engine hyundai santa fe started shifting rough from 2nd to 3rd gear, i did a trans flush and changed the input output sensors, anyway last week it started again, so i just changed the input output sensors again, it did not fix the prob this time, do you think a flush would work.
View 4 Replies
I have an extracted T18 transmission and it appears to be stuck in gear, preventing the Shift Control Housing (top part of trans.) from being removed. Would pulling the shifter remove that top plate? As it is I can get that plate lifted about an inch while I notice the in/output shafts turn, which leaves me to believe it's stuck in gear.
View 2 Replies
I have a problem with my transmission I believe. Its 2004 passat 4-cyl turbo. Not sure whats wrong. When i start the car the entire display (P-R-N-D) is lit up like they are all in gear. It drives but seems to be stuck in 3rd gear I would guess.
View 2 Replies
making a right turn and accelerating up a slight incline trans hangs in 2nd gear to 4000 rpm until I hit the + paddle. Dealer says this is normal for the DSG. I'm not buying it! Occasionally it is reluctant to upshift from 2nd on a straight way during normal acceleration. 2014 sel v6 dsg.
View 6 Replies
So couple of days ago, I went shopping. no issues. after shopping i fired it up, no issues, put it reverse, car was shaking, put the car in neutral. No issues, put the car in drive car is shaking again. i started to drive no shaking, however the car felt like it had no power, I only felt shaking during switching from R TO N TO D. So I change to manual mode and see the gear was 3rd. i was not able to change gears manually, neither did the tranny switched them for me. I drove home about a 3 miles. shut the car off, restart it...gears and car drives normal. Took to dealership, they checked it...and of course no issues. Ihave 44k miles and 50k warranty expires next week, nice, huh? got another year of powetrain warranty left.
View 3 Replies
04 deville. Trans is stuck in gear. Or seems to be. Car is off. Crank car, starts fine so gear selector/neutral safety switch is ok? Car is running, shifter is in park, take foot off brake amd car moves forward. Since its in gear. Apply brake, shift to neu or rev and car will still move forward. The 2000 caddys had an external neutral safety switch. The 04 cars have an internal switch. If that has an bearing on discussion. Could trans shifter linkage inside trans be messed up? So spool valve in trams is always in gear but shift selector works properly so car can be started?
View 2 Replies
1995 Chevy Saburban, currently at 150,000 miles, Prior owner had transmission rebuilt prior to 100,000 miles. While towing my 18ft camper trailer on a recent trip every time I started off from a stop I had to really push on the gas to get going. At first I though the emergency brake was on, or I had a flat tire. I then noticed the automatic transmission was not shifting when I had it in D. Checked the transmission fluid and it was full. The transmission seems to be stuck in 3rd gear. When I move the shifter to 2 it will shift down. Reverse is also still working.
View 2 Replies
have had this car for 2 years with out any problems whats so ever. Drove home from work today parked in drive went to leave again and transmission is stuck in first will not shift.
View 10 Replies
