Santa FE SM (2001-06) :: TCS Off / ABS Lights Turn On And 4WD Light Starts To Blink While Driving
Apr 7, 2012
I have a '06 santa fe 3.5L My "TCS OFF" light "ABS" light turn on and my "4WD" light starts to blink while I am driving. Also my Transmission shifts hard and the engine revs funny (hard to describe what it actually sounds and feels like) when the automatic transmission shifts from 2nd gear to 3rd gear. It shifts find from 3rd to 4th and down shifts from 3rd to 2nd just fine. Just have problems shifting from 2nd to 3rd and it only seem to happen when the lights I mentioned above turn on. What going on? Is this all being caused by a speed sensor? My ABS also seem a little touchy activating when road conditions are not that bad.
View 1 Replies
Advertisement
All the service lights will blink and flash whilst driving. After turning the car off and restarting the radio and clock all reset and the dash lights are gone. The car starts right up with no problem. I checked fuses and none are blown. What may be causing this? It is a 2009 Santa Fe 2.7. It has approx. 95,000 miles. The battery is a couple of years old.
View 7 Replies
My dash lights have a weird glitch when the headlights are on. I can hear a click and the dash lights will go out and immediately back on almost like a blink.
View 13 Replies
So We just got this car from a used dealer 10 days ago!!! Already has multiple issues even though it only has 115K miles on it!
1. Brake lights will not turn off! All 3 rear lights stay fully on even with no power unless I disconnect the battery or remove the fuse. Made sure all the doors are closed and the trunk is too. Only way to keep it from killing the battery has been to take the fuse out when I park, then putting it back in when I leave, but wife usually drives it so it needs to be fixed ASAP.
2. AC blew a fuse after 3 days!! They claimed to have replaced the compressor, but I cant understand how a fuse blows on the AC. Is this normal or just a fluke?
3a. There is an on off switch next to the drivers right leg along the center panel to the left of the radio. It's a simple on off switch, but I dont see it anywhere in the manual. Is this a switch to turn on the 4WD?? I can't figure out what it is for.
3b. only the 2 right side window switches also dont work. They work with the drivers main panel. I assume its the switches in the doors that are bad and I need to replace them? Hope that will not be too much drama to find and do.
4. It has a preinstalled video dvd system. It only turns on when the engine is on, or key is in on position, but when I restart the car it has to reboot and reload! Any way to rewire it or jump the fuse / relay so it's always on standby and getting power so it doesn't do this? Which fuse is for this unit??
View 1 Replies
What are the common misfire problems with the mk4 R32? My R is acting funny every once in a while it runs perfect then some other times it seems to big and the check engine light starts to blink but doesn't stay on I ran for codes and it said I had a miss fire but after that the code never came up again but it still blinks.
View 7 Replies
Ok so my santa fe is doing some weird things. No dashboard lights work the car wont turn over, it has new battery new starter new ignition and no fuses are blown. Basically it seems electronically dead.
My mother in law was driving it and it just killed, my brother in law changed the starter and battery first then the ignition switch.
I have been working on cars for 15 years and i've never come across this problem.
View 4 Replies
There's a clicking noise in the dash behind the headlight switch and all the cluster lights blink on and off when I turn the key. If I try to start it-nothing! If I pull the key out and try again all the blinker lights stay on. Could it be my aftermarket alarm or something else? I didn't have much luck searching.
View 7 Replies
So, the alternator in my 2000 Mitz Galant just went out and my dad and I changed it, now when I drive my car sometimes the brake and battery lights come on while I'm driving and come on and blink with my turn signals (both of them). It is an intermittent problem, and I took it to Advanced and they said everything looked fine. what's wrong with my car?
View 1 Replies
So I lent my santa fe to a buddy to do some hauling, I got it back yesterday and the turn signals and the brake lights don't work...notta. Regular running lights are working without issue, but no turn signals, no hazards, no brakes. Even the "tick, tick, tick" of the turn signal is gone, it's just dead.
View 1 Replies
I have a 2004 Santa Fe with 327,000+ miles on it (the speedometer doesn't work any longer - another problem).
Last July/Aug (2012) I had the driver window fixed (didn't go up or down) after it was fixed all the interior lights stopped working...dome light, map lights...they will not work automatically by opening a door nor manually. Even the rear hatch light will not turn on. Its not the fuse.
View 1 Replies
My SO has a Hyundai Santa Fe - 03 2.4L with the 4 speed auto with 130500 miles.
While driving tonight, the interior lights started blinking. Which was kind of odd. Apparently when this happens, the tail lights (but not headlights) go out.
I did a quick bit of research on it and apparently there is a "bus" that goes bad and causes this. What is a "bus"? And how do I replace it? Is it something like a fuse that is getting corroded?
Also ... I think there may be something up with the a/c. When I turn on the A/C or defroster (any setting that activates the compressor), I smell a burning rubber smell in the dash. I'm not seeing the belt slip on the compressor and not hearing any slippage but there is a definite burning rubber smell. When the HVAC is on something that does not activate the AC Compressor (top vent) we do not get the smell.
Lastly, there are some transmission issues it seems. There is a shift flare between the 2-3 shift and the 3-OD shift sometimes is very firm/abrupt ... it appears to be locking the torque converter during a very hard shift.
View 1 Replies
I have checked all fuses, checked wires on top of steering column all checked out ok. Hazards work but when I press brake tail lights just blink with no brake light but the 3rd brake light works??? Signal switch maybe??
View 14 Replies
I have a 2001 Santa Fe with manual (knob) A/C control panel. the problem i am having is that when i turn the A/C on the A/C light on the control panel comes on and it works fine but in the last few months i have noticed that the A/C light will turn off intermittently. This almost seems like the A/C button has a bad contact because i just touch it and the light comes on and I feel cold air again.
1. I have not taken the panel our but is this serviceability or do I need to replace the whole control unit?
2. Also is this a dealer or junk yard part only or are the there third party manufacturers for it?
3. Since i have the manual control and if i have to replace the unit can i order the digital (push button) control and just easily connect it or is it more involved that that. like i might have to replace other components for the digital control to work or modify the opening or what not.
I do not believe this is the compressor because it seems more related to the the A/C button itself. I checked refrigerant and everything seems ok.
View 2 Replies
How can i turn off check engine light (hyundai santa fe 2003 3.5) by fuse ? I do not have any code scanner.
View 10 Replies
The green lights work on the AC and Max AC buttons. However, when I attempt the ignition on, fan off, press AC button 3x, fan to auto - nothing happens. No light blinking at all.
View 1 Replies
I've just bought a 2.0D Santa Fe (I am UK based) and when I turn on the ignition the warning lights light up and then go off - which I believe is the light check.
However, the transmission warning light does not come on during this check period. Is there an easy way to test this? I'd like to know when the 4WD kicks in or there is a problem but don't know if there's a bulb fault or not.
View 4 Replies
I have problems with my SF 2002. When i turn on my headlights, the instruments panel (odometer, shifts indicator and others) has no lights. Turning off them, the shift indicator lights again.
I have notice that when days ago, i have changed my radio the problem began. Maybe the problem is related with this.
View 12 Replies
I just have my 2013 Prius C3 for two months and few days back I noticed that the Slip Indicator light blink a few time when I went through pot hole/uneven road (low speed, ~20mph). In the same time, I can hear as if there is a piece of metal sheet somewhere in the car vibrated. Is this normal?
View 10 Replies
I just did a brake job on my 2002 2.7l and 10 minutes after driving both the e brake and battery indicator light came on not the abs. It is not throwing any dtc codes also. Did I do something wrong or is it a coincidence meaning my alternator is crapping out? I replaced all pads and front rotors and sucked out some dirty fluid and added clean fluid. It brakes properly and I do not believe I got air in the system.
View 4 Replies
My wife's car is throwing at p0306 code. I have changed the park plugs and the check engine lights comes on after 5-10 minute of driving and gives the same code. Can I move the spark plug wire to another ignition coil bank to test the coil? The picture shows the current plug locations on the ignition pack. Is there any certain order they need to be in or can I just swap 6 and 5 since they are the closest together?
View 6 Replies
Two Issues....
1.My rear dome lights work when manually turned on. They do not come on when the door is opened. However, the front dome lights do.
2.The lights on my side mirrors turn blink when using the turn signal, and when hitting the lock/unlock/remote start buttons. They do not work when driving around with my head lights on.
View 7 Replies
