Santa FE SM (2001-06) :: Sudden Clunk Then Power Loss And Car Started Shuddering - Throttle Body Or MAF?
Dec 4, 2012
I was driving down the road and the car was driving great. all of the sudden I heard a clunk and the car lost power and started shuddering. I made it home and cut the car off. When I start it now, the car runs rough and stalls out. I can't get it to a place to check the codes so I am trying to self diagnose. I was thinking it might be the MAF so I took it out and cleaned it well. there is still no change in the way the car runs. it seems like the fuel isn't getting to the engine as I put my foot on the gas pedal it stalls out. I'm not too excited about buying a throttle body if it's the MAF. It could possibly be something else.
View 1 Replies
Advertisement
On my '03 Santa Fe 2.7, this has happened twice, with 500 or so uneventful miles in between. At highway speed, it just all of a sudden loses power and will only go about 50 mph with accelerator to the floor. When you stop & put in neutral, it only revs to about 3000 rpm, with pedal to the floor -yet idles fine. Then when you shut it down, wait a few minutes & start it back up, it's fine. Is this a fuel problem or what?
View 6 Replies
Ok,..I've got a late model '04 5.4 150, (some parts matched an '05). About 4 mos ago I noticed a loss of upper end power, no cel, but the temp gauge only went up halfway and stayed there. eventually got a code saying temp sending unit (under manifold) was bad. I replaced the sending unit, gauge started working, no cel, but still some power loss.
After a while, cel again says rt bank faulty knock sensor, pull manifold, replace both, plus changed all 4 oxygen sensors. Last few months no cel, but still some loss of power, local trusted mechanic, thinks it could be a clogged cat / cats,..I was pretty sure it wasn't, sure enough, no back pressure. I'm at a loss, I replaced the plugs at 95,000 has 125,000 now, idles and starts great.
It feels like an old distributor car with a sticky shaft that doesn't want to advance, once in a while it feels almost normal, now a lot of people might not even feel it, it will still go 90, but won't lay rubber for 30ft like it used to, might chirp but definitely something not right,..is there any way to confirm throttle body opening all the way? I don't think it would be wise to run it with air box off and by pass mass air sensor right?
View 1 Replies
Lately having the following issues with my Tig.
When starting up the engine on cold start (or after having the car sit for about 30 minutes) after about 10 - 20 seconds; pretty much right after first acceleration the car all of a sudden looses all power. RPM fall down even when accelerating. Accelerating more only let's the engine stall more.
5-10 seconds later the engine functions normal again.... What problem could that be ?
View 24 Replies
2000 GM Buick Regal. Parked the car overnight and in the morning could not start the car. Mechanic said the BMC memory was completely lost. I would like to avoid this happening again. Car battery is 6 months old and strong. What would cause a total memory loss in a BCM when parked in a lot overnight.
View 2 Replies
Obviously its not a good thing, but this seems a little severe for a truck that hasnt had any issues prior. The truck is a 1998 F150 4.6 and was running just fine until POP!! A puff of grey smoke coming from the throttle body and followed by (obviously) a rough idle. So basically, I know that any metal fragments were directly sucked into the intake and based on the size of the chipped area (roughly 1.5cm). I am wondering what type of internal damage this would (or already has) caused.
View 3 Replies
I've been having trouble diagnosing a loss of throttle at seemingly random times. Sometimes while driving, especially after driving for more than 20 minutes or so, I will experience a hesitation while on the gas pedal as if I have taken my foot off the gas. It makes it impossible to drive until I pull over and unplug my TPS and then I can drive fine in manual mode. Then the next day I can plug my TPS back in, drive around fine for a bit before the hesitation happens again and then I have to unplug the TPS again and drive in manual mode. It doesn't make sense to me why it takes a bit for this hesitation to begin and why unplugging the TPS and driving in manual mode seems to fix the problem.
I've recently replaced my crankshaft position sensor, idle air control valve, purge control valve solenoid and TPS. When I recently placed the TPS, the hesitation problem and another problem I've been having recently, a high idle in park, seemed to be fixed, but then the hesitation problem popped up again. When I unplug the TPS, the hesitation disappears and I can drive fine but the high idle in park problem is back! I'm suspecting some sort of wiring problem to the TPS. I just went on a 100 mile camping trip in manual mode no problem, but I can't be driving around forever with no TPS.
View 1 Replies
Driving in sunny so cal yesterday never a problem with the car just an oxygen sensor- I was cruising along at 75 and all of a sudden the oil light comes on - immediate loss of power and i pull over to the side of the road and shut it down. try to restart and it just clicks.....tugged on the crank through the wheel well and it will not budge...oil is ok and plugs were pulled and they seem fine....oil pump...fuel pump....starter hopefully something simple and inexpensive I hope.....what is the difficulty in changing out the starter and could this be the issue?
View 3 Replies
My wife has had her 2010 3.5 Santa Fe since new. Over the past year it's been having a clunk develop when accelerating, happening a few times from a start until highway speed. The clunks almost feel as if one is driving over bumps - that's what I thought at first. The power doesn't seem to be there anymore either. I have been driving her vehicle the past three years and it was fine when I first started driving it. But the past couple years I first noticed a problem and it seems it is getting progressively worse. My wife now notices it quite a bit too.
View 1 Replies
I've been having this problem where as i'm driving (mostly highway) all of a sudden I get the feeling like i've let go of the gas pedal but I haven't. The mpg meter goes from about 40 to 100 as if its on straight battery power and I have to really press the pedal down to get any decent acceleration. Once in awhile i'll get the big orange triangle warning and the little pic of an exclamation point in an outline of a car. But after a day it may go away.
One time it didn't and I brought it in. I spent 80 bucks for them to find nothing wrong and say the alert had something to do with an oxygen sensor (its was awhile ago, i dont quite remember exactly)
View 18 Replies
I'm usually over in the EX forum but today was working on my brothers 1998 F150 - V8 4.6L. Had the EGR code P0401 and due to FTE I found the problem took the throttle body off and found it was definitely plugged. One of the bolts was really loose and came off way to easily. Didn't realize until cleaning why... Now I drilled 8 studs out of my aluminum EX heads but this one has me pondering how I'm going to clamp this thing down and center a bit..
1st pic - ports WOW - guessing this was the problem ...
2nd pic - bigger issue ...
3rd pic - the ports cleaned up ...
View 8 Replies
I have a 2001 f250 super duty extended cab with the v10. Over the past week it has been running fine and it will all of a sudden lose power and dies. I've been able to start it back up once right away and a few times it started up after a few hours of messing with it.
So, after the truck dies it will crank and crank but will not start. We have checked fuel pressure and nothing. Then we applied direct current to the fuel pump and it turns on. Then we applied direct current to the fuel pump slot in the fuse box and got a fuel pressure reading of 40 psi. But when we crank we have no pressure.
When we apply direct current to the fuel pump slot in the fuse box the truck will only crank and not start.
View 11 Replies
My excursion suddenly lost power after sitting in a long traffic jam. I have a scan gauge II set up and didn't see any signs of over heating however when I went to accelerate back up to highway speed my motor revved up to 3000 rpm and just lost power I ended creeping on the side of the road at about 15 mph and barely maintaining that. The motor was not willing to revv up. I reached a spot to pull over and shut it down for about 15 minutes and started back up and drove off with no noticable issues. I have 211,000 miles on this motor and I am going to change my coil packs, I think they have been there since the truck was sold new....I changed four of them to address a miss and have six left, I will also be changing my fuel filter. We are about to pull our camper across country....about 1400 miles..
View 5 Replies
I have had the Santa Fe back and forth to the garage no power. We where driving it and all a sudden dropped power can't rev motor over 3000 rpm. Garage said they fixed it with dry gas and more gasoline b/c it was "low" between 1/4 and empty?
View 12 Replies
What Is that little hose for? I can Smell the gasoline whenever i start the car in the morning. It is cracked But i recently heard a z-zzing Under the hood. Is it an expensive hose? What about the hose clamp.. it looks weird.. is its special for that application ? I wanna replace it myself but I don't want to do it wrong and turn my car on fire.
View 4 Replies
My 2005 elantra hvt 2.0 has oil leaking into the air filter coming through or near the throttle body, I've been told its an egr valve.
If it is...where is it and how much for a new one and is it an easy fix? If not what could be causing the leak?
View 4 Replies
2001 Excursion 7.3 started missing the other night. Great loss of power, but made it home. Rough idle, "clacky". Next morning, did the following in order: 1) Pulled the fuel filter inspected, 2) removed all fuel from the bowl 3) replaced bowl fuel with Seafoam 4) installed new filter (my typical procedure). Without starting, I then 5) removed HPOP oil from reservoir and 6) filled with fresh oil using exact amount removed as a gauge for what to replace.
Started, idle smooth for a time. Increased rpm by depressing accelerator. Began running rougher and rougher accompanied by white smoke. Finally quit and would not restart. Cranking easily, tachometer showing RPM during crank. Suspected no fuel getting to fuel bowl. 7) Drained fuel bowl using valve on back of bowl. 8) Turned ignition to "on" to get fuel pump to run 9) removed new filter, no fuel in bowl 10) With fuel filter out of the bowl, removed fuel filter and quickly cycled the ignition to "on" and back off -- no fuel entered the bowl. 11) Removed leads from fuel pump. 12) Checked voltage across leads as ignition cycled to "on": 6.5 volts. 13) Checked fuel pump fuse (20A Maxi fuse in location 112 -- BLOWN!) 14) Replaced fuse, performed voltage test: 11.55 volts 15) Checked battery voltage: 12.44Volts.
So, with all that, how in the world does the fuel pump get 6.5 volts with the fuse blown? I looked closely at the fuse and there was no slag or connection in the element. Today I have pulled the 9-pin and 42-pin connections on the valve covers as well as the connectors to the glow plug relay module (used on Ex's) to inspect wires and connections. All looked fine. I plan to us some LP5 electro contact cleaner to clean all the connections and put some electrical grease on the connections, but the big question is where did that 6.5V come from with the fuse blown. I plan to pull the fuse and do the same test to see if the 6.5V is still there.
View 8 Replies
I have an 02 2.4 gas SF. After a good while, the car will run rough, lose power and will not take any throttle. As if it is starving for fuel. But it will idle fine and if it does stall, will restart. On a hill, I have to drop into first and keep it at 1000 RPM (yikes!)
If I keep going with very little throttle, it may resolve itself. It is always fine after a complete cool down. I checked for vacuum in the tank by opening the filler while it was misbehaving. I have a new CPS, new coil packs, new filters. I've have enough gas fill ups to eliminate water in the gas.
It has thrown no codes. I went ahead and ordered a MAF sensor and a cam position sensor...just guessing. (it had failed emissions which I resolved by cleaning the MAF.)
View 16 Replies
My father owns a 2003 Santa Fe GLS with the 2WD 2.7L V6 engine.
Recently it has been having lots of power loss issues. It vibrates/misses when idling, if you put your foot down on the gas pedal, whether under load or not, it sometimes stalls or just sits there. We took it to Hyundai, and they had no error codes. They charged us $150 to tell us nothing is wrong with it, when clearly something is. The car has become downright dangerous to drive because it cannot make it up hills without stalling/losing power.
The most recent thing we had done to it was the wires/spark plugs changed, which I think was at 65k on the odometer?
View 14 Replies
2003 Santa Fe - Loss of power while driving on highway. Dropped from 60 to 15 MPH in matter of seconds. Feels like a couple of cylinders (3.5 liter) are not working.
View 2 Replies
I have a Santa fe 2002 crd 2.0 4x4 and recently had a lot of black smoke and a loss of power when driving, it starts fine but when revving it blows black smoke from exhaust and has no power to pull away, been told its possible turbo problem or fuel problem.
View 1 Replies
