Santa FE SM (2001-06) :: Rattling Sound In The Engine - Timing Chain Or Belt?
Dec 26, 2007
My 2003 Sante Fe has developed a rattling sound in the engine. The oil level has been good. I took it to a dealer for diagnoses and they told me that the engine was gunked up and the timing "chain" tensioner couldn't move to keep it tight and it was rattling. They put some engine cleaner in and changed the oil and wanted me back in 500 to clean it again. I did that again, but the rattle is still there. It gets a little quieter after I have driven it for a while.
My question is doesn't the Sante Fe have a timing belt? If that is the case what do you think the rattle is?
View 6 Replies
Advertisement
The car has a rattling sound on start up and I read here that is the timing chain tensioner. The quotes for fixing it has been huge(from 900-2000 just for labor).
And I changed front struts and had Monroe put on the car, the ride is very soft and a bit bouncy. I had a 2004 Altima and the ride was very stiff and I loved it. By the way, the car is a 2006 V6 with 111000miles.
View 9 Replies
95 nissan maxima decelerated on highway, i heard a clunking sound, and then it shut off, i opened the hood and it smelled like burnt rubber. Checked all of the belts i could see..no problems. Car wouldn't start after this...and all i could hear was a clicking sound. Pulled 6 codes for the car including bad speed sensor and a misfire, as well as bad EGR...i think the timing chain/belt broke..but i can't access it.
View 3 Replies
I recently purchased a 2006 Hyundai Azera which has developed a rattling sound upon cold start up. Based on service bulletin 06-20-002 I believe the issue is with the timing chain tensioners. I am looking at getting a DNJ TK147 timing set kit to replace them with. Do this kit contains the updated tensioners? It is located on rockauto.
View 4 Replies
I was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 Replies
My daughter just bought a 2002 Santa Fe LX which is drooling oil all over the alternator and everything else in that area. I found what (I think) is the source (but you have to be a contortionist to see it.) I haven't been able to find any good parts identification photos of that area, but I think that this is the bottom corner of the lower timing belt cover.
I guess the repair will require going through the first several steps used when replacing a timing belt. I don't plan on going any further than needed to fix this leak, though, since the timing belt was reportedly changed about 25K miles ago.
Before I start taking all this apart, I have a couple questions:
1. What might be holding this corner out, away from the block?
2. Is the timing belt cover supposed to snap into place over a lip on the block? Or, should it be sealed with gasket sealer -- or something similar?
View 6 Replies
I recently replaced timing belt and balance belt on my 2004 santa fe 2.4l and now the engine runs like crap and shakes badly. I went over all timing marks again and again and I am at a loss.
View 9 Replies
Looking for info if the R32 has a timing belt or is it a chain and at how many kilometers shows it be changed.
View 5 Replies
I just installed a new timing belt, balance belt, idler, and both tensioner pulleys but am getting a little whine. I adjusted the balance belt but the noise does not change. No other belts or items are hooked up yet this was a dry run. Car seems to run fine and idles well. The hydraulic unit seems to be working fine and it's a OEM Hyundai piece.
Anything common I can look for that should stand out? 2002 Santa Fe 2.4L
View 6 Replies
I have 130K miles on my Santa Fe. I just replaced the timing belt without the water pump being replaced. Picked it up from the mechanic and the check engine light was on and it was idling very rough. Left it there for him to recheck. He said maybe he didn't plug in the Cam Sensor all the way or at all. Next day he called me and said that the cam sensor was bad and he replaced it for free. Picked up the vehicle and the idle was a little rough but got worse on the ride home.
View 1 Replies
My 2003' Explorer XLT (4.0L V6) has an oil leak. I tracked it down to the passenger side, rear, bolt head on the valve cover (back by firewall). I took it to a guy who replaced the valve cover gaskets, but it is still leaking. He claimed when he had the cover off he looked for any cracks on it, but did not see any at the time.
Anyways, I was searching around and found several explorers leaking in or around the same area of the valve cover. And it turned out that there issue stemmed from bad timing chain guides, causing the valve cover to crack.
I do notice that on a cold start, I hear a rattling when I first start it up. It rattles for maybe that first 1-2 seconds when starting. Is this my timing chain rattling around? If that is the case, how much this could set a guy back on repairs?
I guess I don't know whether to just replace the valve cover, or if I should dig into it to see if the real issue is the timing chain guides/tensioner. Mileage is approximately 121,000....
View 1 Replies
I recently replaced the timing belt, tensioner, and roller in my car. Today I became concerned that I hadn't tightened the tensioner properly so I did a quick check (it was). I also noticed the timing belt felt a bit loose, so I tightened it to what I thought was about 1/4" deflection with 5lbs pressure—not what that feels like in that tight space.
When I started the car there was a noticeable whining sound. Before I changed the belt there was a slight whining sound (but there was no whine after I changed the belt). So I loosened the belt a bit and there's now a slight whine. I feel like the whine shouldn't be there but it's hard for me to imagine that the belt should be any looser since I can move it 1/4" inch without much effort.
So, should I be tightening the belt to the point where the whining is gone, or is a slight whine ok?
View 2 Replies
I have a 2009 Tiguan 2.0t 4 motion and recently has started having a very high pitched squealing noise coming from either the accessory belt area or the timing chain. The noise is constant until you are under acceleration and then it goes away. The CEL came on but when scanned it said no codes. and now sometimes the CEL will flash and the car has been idling rough. What it may be?
View 3 Replies
2007 Santa Fe GLS 2.7 V6. T belt replaced by dealer at 62K. Noticed engine vibration when picked up vehicle. RPM is steady, engine runs smooth, no error codes, no strange noises. Mechanic who did the work confirmed vibration problem and recommended bringing it back - had no answer on the cause but mentioned lose motor mounts which I doubt - the car ran perfect until the dealer did the work.
View 3 Replies
Son has a 2004 Hyundai Santa Fe 2.7 motor. The timing belt broke before we could replace it. Long story short, 24 valves, gaskets, timing belt, water pump, new belt tensioner and new pulleys. The motor is back together. The only problem is when you turn the ignition switch on, it blows the CPU fuse. The only electrical part we replaced was the purge valve.
View 3 Replies
I have a 2009 Sante Fe with 60,258 miles. I had the timing belt changed at 60,000 miles at the dealer. I now have a check engine light that shows the following two codes.
P0321
P0612
These codes are related to a timing belt change? Could a sensor have been removed for the work and not replaced correctly?
View 5 Replies
I read for a few second at start up ok . Have it checked : [URL] ...
I will be opening up the case in next few days. Chain still on holding by a few teeth. Metal wedge between teeth and chain.
View 22 Replies
My 2007 3.3l SF timing chain cover is leaking.It has 93,000Kms and is still covered by warranty.The Dealer said it was a 17hr break down job to do.
I am wondering if there are things I should get done/replaced when they open the engine up. I had asked at the dealer if there were other parts that should be replaced at this time, but was told that there was not.
View 1 Replies
I just bought this 2008 santa fe with a 3.3 V-6. It has 200kms on it. Here is the problem- I start the engine, and for the 1st second of running there is NO noise,.....but a second later it sounds like a chain slapping around in the engine HARD. it lasts for about 2 seconds and then the motor is quiet. It seems like the longer the car sits,..the worse it gets. If your only letting it sit for 20 minutes or so, you wont hear it.
View 5 Replies
I have a 2011 Limited and I wanted to mention that I brought it in for the ECM service campaign and to have an oil leak looked at. The reflashing went as expected, I am still trying to decide if the car behaves any different. It seems like the engine RPM drops a little bit when slowing down then bounces back up. Nowhere near enough to stall or anything.
While I had it in the shop, I had them look at an oil leak that I have been having. According to the dealer, it is leaking from the timing chain cover. They have ordered some parts and I will be taking it in for the fix next week. I don't have a full list of which parts they will be replacing, but he did mention removing the valve covers and installing a new oil pressure switch while they were in there.
View 4 Replies
My 2010 Santa Fe is leaking oil. I bought it in April & it has under 8,000 miles. After parking the car, I see oil spots that range in size from a Silver Dollar to a CD after a few hours.
First, the dealer said it was a cracked oil filter cap, so they replaced that...I brought it home and it was still leaking.
Brought it back to the dealer, and now they are saying the Timing Chain Cover Seal is leaking.
View 24 Replies
