I have a santa fe 2002 2.7 gls 4X4 automatic. I put today for the 1st time supreme gaz and the level of the gas stuck in the 1st quarter even if i turn the engine off...
View 1 RepliesI have 2001 EX with the 7.3 and my rear vent windows stuck open and I am stumped as to what might be the culprit. There isn't any power getting to the switches in the overhead console.
I replaced the relay 204 in the engine compartment, I believe that is the correct one.
Where the actual fuse is located for this and its number? Because both of them are stuck open not just one side.
Here is my problem I own a 2006 2.7l santa fe and I will be sitting there with a quarter tank of gas I then my gas light will come on I will look and I am outta gas then it will go back to a quarter, I am noticing it more often.
View 2 RepliesI have a 2008 3.3 base model in which the climate controls wont change exhaust location. That is to say, it is stuck on bi-level right now. Recirculation still functions.
At least a year ago, it started making an unusual fast clicking/grinding noise whenever I switched from defrost or bi-level to a vent positions. The noise can be best described as something you would expect to hear from a Lego electric motor. It didn't sound serious and it only made this noise a few seconds as the vent changed. Recently, it remained in the vent position and would not move to defrost. Then, suddenly one day it changed to bi-level and has never made a noise or changed position since.
Summer heat here is unbearable and I need the A/C to blow out the vents so I want to manually change the position if I cannot fix the problem altogether. Just don't know if this is vacuum controlled or an electric servo and where it may be located or how much effort to get to it.
Drained and refilled 4qt on my 02 Camry. Also changed the trans filter. It used to be all the way up to "HOT", but very low after refill. What's the trick here? Need another qt?
View 14 Replies2012 F-150 ecoboost oil level rising up to 1 qt over full. Took it to the dealer, They are installing a block heater and a new vent line. Cannot see what a block heater is going to do for me in a warm climate. I will let them do there thing and see what happens. 24,000 mils on the truck and warranty runs out in Dec 2015.
View 14 RepliesI know the code is fuel level sensor, but i can't find the parts online. nothing comes up with the part name fuel level sensor. What is the part number for this or the number for kit because i believe there are 2 sensors?
View 1 RepliesI am having this issue if it's one. With the fuel level below last quarter, I'm having the time of starting the engine longer (cranking time). I tried several times, leaving the fuel level reach the last quarter, with same result. Reaching that level of fuel the problem appears.
Another issue is that sometimes when the day is hot and the fuel level is not necessary below quarter, the starting time is longer too. It's a Santa Fe AWD 2.4L Automatic.
I bought a used 2013 Santa Fe Sport 2.0T Limited in August from a Hyundai dealership near Vancouver, BC. The vehicle had fairly high mileage (95K) but had been well-cared for and I got it for a fair price.
After a few days I noticed there was a "crunching" noise coming from the rear driver's side quarter panel area when going over the u/g parking ramp into my condo. The rear seats also jiggle and rattle at moderate speeds. Didn't really notice either on my test drive before buying it, as I just went over smooth roads.
I searched this forum and found some good leads, such as the inner quarter panel being loose, rear trailing arm issues, or perhaps some faulty welds. I printed out this info. reported by other owners and brought it to the dealership.
As kind of expected, the technician each time has said he couldn't hear anything unusual. (selective hearing?) The suspension system is supposedly sound.
My friends and family members all hear this creak (under the right conditions when the rear wheels are at uneven heights)...it's not my imagination. I've taken out the styrofoam cargo support and nothing changed.
I had a loaner 2015 Santa Fe and there was no such noise.
The rear seat jiggle is also irritating. I've experimented with putting the seat backs at different angles and nothing really works.
The vehicle has about 500KM left on its 100,000KM warranty.
Its not my car but my sister in laws. She stopped by our house tonight to pick up her kids and when she put the car in drive it showed both drive and 2nd gear. we tried disconnecting the battery so she could at least get it home (3 min away) but it didn't change anything.
She left with it still in 2nd thinking she could make the short drive without any problems but half way home it shifted down to first and it wasn't even driveable. Everything i have read on the web (which was not really specific to the santa fe) was say that its stuck in safe mode. What could have cause the problem? So far no check engine light has come on.
2003 Santa Fe 41,000 stuck in first gear.
View 1 RepliesI have a 2002 petrol, manual, 2.4 Santa Fe
It only had one key when I got it so I ordered a replacement key online -uncoded and uncut. When it arrived I got it cut - looked good. Before getting it coded I thought I would just test the cutting. Opened doors ok so tried it in ignition - fitted and turned engine over - did not start as not coded I presume.
However, when I tried to get the key out again it would not come out. Could this be to do with it's transponder not being coded? Any way I can get it out??
My wife has a 2006 santa fe 3.5l limited over the winter it started acting up went into limp mode and would only go 20mph so I went and picked up a TP sensor well it went out of limp mode so I never changed the sensor well last month it started doing it again so I changed it out didn't work!!! comes up with 2 codes sometimes p2110 and p2118 but normally its p2110 2 times.
If I hit the break it kinda bogs down and pulsates.i took it to my mechanic since I couldn't figure it out and with advice from a hyundai mech. He changed APS didn't fix it so we changed throttle body with used of course didn't work I checked wires and didn't fined any open circuits what are the chances that i got a bad APS or TPS...
So it's dark out and very cold so I have done nothing yet to see if it is easy. However my '03 3.5 acts as if the rear brakes are stuck or the "E" brake is stuck. Put the car in in drive or reverse and you can feel the grab. Same thing in Neutral. Not sure what is really going on. Will get it jacked up in the morning.
View 7 RepliesI am the proud owner of a 2001 2.7L V6 Santa Fe. His mileage is roughly at 170,000 and I keep up with fluids and minor repairs (except an oil change, oops). Yesterday I was out with my fiance and our German Shepherd, we stopped at a restaurant and while we were inside our dog decided to redecorate the gear shift (PRNDL) with my ice tea. I noticed a problem immediately.
When I started to drive, there on the dash board was the normal "D" with and added "1" as if it were stuck between automatic and sports mode? I attempted to shift it to full sports mode to manually shift; I couldn't get him (the truck) to go above first gear, and nothing happened. I then attempted to fiddle with the gear shift to see if I could some how "knock" it back into automatic but nothing I tried worked.
The truck shifts easily into reverse, there's no abnormal sound coming from the engine, it drives just fine but refuses to go above first gear. I did discover tho that if I shift the engine quickly into neutral while driving and then down shift back to "D", the engine will shift easily but I assume this is not good on my transmission.
D and 1 light are on
Won't shift past first gear
Reverses just fine
Kicking it to neutral then D will shift the engine
Spilled something on the gear shift
I will try to upload a photo of what's going on with my dashboard lights referring to the "D" and "1" light.
I have an 01 and 02 santa f. I took the v6 out of 01-and put in the 02.put new gaskets on engine new timing belt etc. Got engine in and runs like a champ. But the tranny which looks new I assume its been replaced. It starts out in 2 or 3 all the time want shift into od. Reverse works. So I found one plug dangling I couldn't figure out where it went then i found it. It plugged up on top of tranny. Well now it starts out in first and shifts through all the gears. Drove it down the rd shifted fine. Turned around and put in reverse then when i went to drive it jerked real hard. Shifted out fine so I went to floor it to make it kick down and it jerked again. This time it was hung in 3 or drive cause when I pulled into my driveway it was in high gear and u can put it in manual mode and the light only goes to second and d when it acts up like this. So i killed the car started back up and know it will go into first in manual mode and shift out and do fine?
View 3 RepliesLast night my girlfriend and i were coming home in her Sante Fe and it was driving perfectly fine. The check engine light was on, but it occasionally comes on so i figured it was probably just a sensor.
When we got in the car this morning and i put it in drive (automatic trans) it was in sports mode (i'm assuming because a "1" popped up under the "D")
And now i cant figure out how to just put it into normal drive. We spilled a tiny amount of soda on the shifter last night, maybe 3/4 a cup at the most.
I have an 02 Santa Fe and last night while driving the fan would not turn off. It also started switching speed by itself.
View 2 RepliesSo my wife's santa fe will randomly get stuck in 3rd gear and not shift up or down (automatically or manually). It does not appear to be slipping as it speeds up slows down fine. The check engine light is on but have not read the codes yet.
View 5 Replies2001 2.4 L AWD Manual Transmission.
Live data readings from vehicle continuously indicates "open loop- driving" for the Fuel System Status (Fuel System 1) . During idle and on open high way driving as 120 km for 10 minutes. I use an ELM327 diagnostic device with ScanMaster-EL 2.2 software.
After establishing this initially I disconnected the battery to do a complete ECU reset. I do not get error codes.
O2 Sensor1 Bank1 constantly reported as 1.275 V and sensor 2 as 0.02 V. I believe however the constant readings are as as a result of being in open loop.
No error codes reported.
The software report OBD1 ability on the diagnostic link.
During driving I got the following readings:
Fuel System 1: open loop-driving
Fuel System 2: not supported.
Calculated load: 6.27 to 83.14, avg 40.6
Fuel trims: 0
RPM: 1008 to 3988, avg 2407
Speed (km/h): 0 to 122, avg 77.66.
Timing Advance #1 degrees: 7 to 44 degrees, avg 22.42
Intake Air Temp (degrees C). 19 to 24
Air Flow Rate - (g/s): 3.18 to 69.27, avg 25.46
The software reports that the O2 Sensor bank 2 is not supported. I am not certain whether I should trust the software. In South Africa cats are not mandatory, hence is it possible explanation.
2) Is it possible to send a command on OBD to force closed loop?
I have a 2001 Santa Fe, and the key is stuck in the ignition. I can't even get it to turn to the Lock position, so it's stuck in accessories. Since I haven't had the funds to do so, I haven't gotten it checked out yet, and it's started to drain my battery. I have to jump it every single morning, so I'm wondering if there's anything I can do until I can gather up the money to fix it.
I have tried moving the steering wheel and shifting it all over the place and spraying DW-40 in there and a whole bunch of other things I've seen work for people on a bunch of different forums, but nothing works. I don't know if this matters, but before it got stuck, it would sometimes be hard to pull out or push the key into the ignition.