Santa FE SM (2001-06) :: Engine Racing At Idle And Then Dying At Stop Light
May 4, 2008
Bought a 2001 from a used car dealership about 2 months ago. A week later it started acting funny. It would often race the rpm's about 2000 when at at stop light and then others times would act like I was out of gas when I would take off. Sputtered and then finally run normally. Then other times it wouldn't start and just crank over and over. After 10-15 times it would fire up and then act like nothing was wrong. It was a total crap shoot whether it would start or not each time.
Took it back to dealership and supposedly their mechanic installed a new fuel pump. Ran like a champ for about another two weeks and then exact same symptoms started showing up.
View 7 Replies
Advertisement
Once warmed up, while sitting at a stop in Drive, there is what feels like an engine stumble every so often. Good guess is every 45-60 seconds, so it only happens once, maybe twice at long stops. There is a sudden change in pitch the engine, and the car - for lack of a better term - shudders. The thing I have noticed is that when it does this there is no indication anything has happened with the tachometer - RPMs hold perfectly steady. Additionally, there is no shudder when sitting in park or neutral, only drive.
I initially thought it might be an ignition fault, so when I replaced the balance shaft belt I also replaced the crank sensor. No change in behavior. I did some googling, which suggested the issue might be related to the EGR not closing properly. I changed all the vacuum hoses and removed the switching solenoid to test - it seems to be doing its job. I have not removed or inspected the EGR valve itself. However, because there is no symptom in engine speed and the sensation doesn't happen in park or neutral and only happens when warm, I am starting to suspect the transmission itself is the culprit - I can imagine if the torque converter quickly engaged and disengaged - and a little power made it to the wheels - the same result would happen.
There is nothing else odd about the engine or transmission. No codes. Runs like a top. Transmission always shifts perfectly. Fluid was changed two years ago, about 15,000 miles. What came out looked good as well. I'm okay with replacing EGR components, but I don't want to throw money at the problem unnecessarily. Maybe try driving around with the EGR vacuum hose pinched off or disconnected?
View 5 Replies
I drive a 2009 Kia Spectra. Mileage - 89,000. About a year ago, very infrequently, I started noticing that the engine would start racing when I would try to come to a stop. Now, almost every time I start the car, the engine is racing while it is still in park. And when I come to a stop sign or stoplight, the engine races when I put on the brakes. This is NOT an issue with the mat hitting the accelerator. Lately, also, the car is starting to die for no reason when I bring it to a stop. I took this in to a mechanic, they could not find a problem--they cleaned off some cables but the engine was racing when I turned it on to drive home.
View 5 Replies
I noticed this past weekend that when I stopped at a stop light for a long period of time, the engine would misfire for a split second, random, just miss for a moment, then do the same after 15 or so, sometimes less. Other times, no issue.
View 1 Replies
My 02 camry recently started dying at a stop and would not idle above 1000 rpm. I cleaned the throttle body(very dirty) and the car started right up idling at about 1500-2000 rpm i walked away for a minute and came by to drive it and no acceleration would come as well as when i start it up now it just goes back to idle at about 500 rpm.
I am not sure what the problem may be, my air filter box is not on properly I am going back to the car to tighten it down today but i highly doubt it will fix anything. I also read something about the computer needing reset, if i go and unhook the batter for 30 min and hook it back up will the computer reset and possibly fix my acceleration problem?
View 6 Replies
I have 104k miles on car, had tune up back in 09, new die hard battery from sears spring '10, just today my car started to shake when in idling, check engine light flashing. It seems to shake itself even while driving, when in idle it will then kill or die. Had radiator flushed January 2nd, 2011 due to heat not pumping through, still doesn't work (I know heater core) like it should. Finally the other problem is when I start & turn the car on it won't turn over-it wants to but takes a few tries like turning key each click like as if it were alternator, does sound like it would if it did turnover but like I said it takes a while & maybe will fire/catch. What the heck is going on? 2001 flex fuel as well but I only once put it in.
View 10 Replies
For the past month or so, my 2002 Kia Sedona has been stalling/dying whenever I stop at lights or signs. We've gotten the alternator fixed, gotten a new battery, replaced the ignition coils, but still have the same problem. A friend of mine says that there is probably an issue with the idle air control valve and suggests I replace it. Looking online, it seems like I can possibly just clean it out, but I don't know where to begin. Where exactly is the IAC valve and is replacing/cleaning it a basic DIY job?
View 8 Replies
I have a santa fe from the year 2008 and recently i had a trip where i would get tons of white smoke every time the car was at idle at the stop light. upon inspection, i saw that the coolant level was below the low line so i had it topped up and the problem disappeared. Everything was fine until today when the problem occurred so i checked the coolant level on the side of the road but the coolant level was fine and still is upon inspection when the car was cooled off. After i stopped to check the coolant level and restarting the car, the smoke was gone and did not appear again. I checked the internet for solutions and some suggest blown head gasket but many of the symptoms do not make sense in my case since the engine never overheats and the coolant level hasn't gone down in the past week.
View 3 Replies
I have a 2004 4 cyl. Santa Fe. The stop/tail light burnt out. Replaced it but still not working. Checked to see bulb was in correctly. Checked wires and bulb holder. Still not working. Back up and turn are working. Could it be a fuse?
View 3 Replies
I have a 2004 Santa Fe (4 cyl 2.7 L FWD) with only 42,000 miles on it. Coming home from work I was stopped at a stop sign and after stepping on the gas (halfway thru the intersection) my engine stalled - coasting to a stop (while crossing a very busy intersection I might add). After putting it in park I try to restart it - the engine cranks over as usual and starts but roughly 4 to 7 seconds afterwards it stalls again. I did this 4 or 5 times again with the same results. I'm almost positive the check engine light is on. The next day I popped the hood to see if the belt broke but its fine so I tried to start it again (same results engine starts but after 4 to 7 sec. stalls again). Before this engine trouble I haven't had one ounce of trouble from my Santa Fe. Not to be funny but yes there is a half a tank of gas in it... with plenty of fluids in it. After some research I kind of think its the Crank-shaft sensor (seems to be a problem with them in the Santa Fe's).
View 14 Replies
1974 74 Dodge V8 360 ... So it's a carburetor. Starts up cold first thing in the morning no problem whatsoever. Choke plate nice and closed, idle screw on the highest step on the ladder, good vacuum, and all of that.
Once the engine warms up, and the choke plate slowly opens up to let more air in, idle and vacuum decrease, and when I hit the gas and idle screw drops down off to the lowest step, the engine dies.
Where should I start?
View 19 Replies
Recently I noticed that three LEDs in my 05 SantaFe's high mount stop light glow even without the brake applied. When the brake pedal is depressed, the entire light glows as it should. But only the three LEDs glow at all times.
View 13 Replies
I have a Hyundai Santa fe 2004 6cyl 2.7 L , AWD. I am having problem of slow acceleration which is worse after a stop sign or red light. Sometimes while taking turns I feels like that I will not move and I was lucky to be not hit by a Car coming from opposite direction while taking a left turn today.
The Truck’s exhaust pipe broke recently and a auto garage welded it. But I am facing the above problem immediately after the repair of exhaust pipe. If I put more pressure on gas pedal then a mal function indicator comes and today I took it to another mechanic and he gets the error code of P0303 –engine misfire and wants to charge me ~ $600 $ to replace spark plugs and wires. The malfunction indicator goes off also while I am driving and can comes back after a while or a day. With the indicator on, the car drives erratic (minor jolts ) for few meters and then its fine. Since when I am driving on highways then I can go higher speeds without any problem. Is it still misfire issue???
View 11 Replies
At idle, (600 RPMs, might need to bring it up?) the motor is Real rough, but doesn't stall out, just very "wobbly" Once the car is brought up to the 900-1000 RPM range everything flattens out, and at driving speeds it drives great! Pulled up to 90 mph on the high way, and passed a few cars on some back roads and everything ran great, until I hit idle.
It threw a code for the Cam Position Sensor after I tried to restart the car, and the person who work on this car before me had zip tied the connector into the sensor because he had broken it. Low and behold, you cant buy just the replacement part of the harness.
I tried to get the wires all plugged back in, and the CEL went away, but the idle was still pretty rough. Also, at idle, the oil light flickers just a bit.
View 6 Replies
I got an Error Code of U0D00. What this is or means. The scan tool says to refer to your manual but I don't have one.
What the vehicle is doing is that it will work fine for a while then when you stop (in park) the engine will rev really high and back down all by it self for example. It will go up to 3.5 and back to 1 rpm repeated. Then when you start moving the car it will continue to idle higher like you are pressing the gas. During all of this the check engine light will appear?
View 3 Replies
I have a 2003 Hyundai Santa Fe. Within the last 2 months or so I have changed my timing belt, spark plugs, and all belts that needed to be changed. I notice that when I am idle at a traffic light, the car is a little rough or bumpy. Is this normal for its age, or should I be looking at something specific.
View 11 Replies
2004 2.4l engine has high idle speed aprrox. 1000rpm.
View 2 Replies
Trying to get my daughters Santa Fe going. Engine stalling. Idles very slow. 2001 model with 2.4 engine, auto trans.
Code P0102 is active. Cleared with scan tool and it comes right back.
Replaced the MAF and no change.
Checked the intake for leaks / vacuum leaks and none found.
Checked for debris up-stream from MAF and all is clear.
Air filter is clean and dry.
Checked harness plug and found the pin 5 has 4.6 volts on it from PCM. This is the signal wire from MAF to PCM. 4.6 volts is KOEO.
IS THIS NORMAL OR IS PCM BAD ??? All other pins / voltages on harness plug are normal.
View 4 Replies
I bought the car 3 years ago 2003 2.4L Hyundai Santa fe , I have driven it around 200 miles ( to and from shops ), I am having an issue now where once the car is warmed up ( post 15 mins ) It will idle really low * almost stalling * and oil pressure light will flicker, If I hold the brake and get it to almost 800 - 1k RPM it goes off and driving is not an issue *no knock*. I just got it driving for the 1st time in the past year, and drove it for about 45 mins in stop an go traffic, Temp light was all the way to cold, once stopped in stop and go traffic it would go up half way, as soon as I could get above 50mph it would slowly work itself all the way to the bottom?
More Information
2003 2.4L Hyundai Santa fe
I should really count my losses and move on but I cant.
Bought the car with 89K on it I now have 90K
New Battery
New Radiator
New Motor mounts 3
New Trans mount 1
New Hoses
Oil Change ( 40 miles ago )
Trans Oil Change ( 40 miles ago )
Power Steering Fluid change ( 40 miles ago )
2nd cat delete ( didn't want to waste any more money )
After Market 1st Cat
View 2 Replies
2001 f350 v10, initial problem was when i came to stop at light it idled rough. I changed all plugs,injectors and COP, and bad connectors thereto. Changed the clock spring as well. Now the truck idles like crap at first start of of the day then run fine there after. Replaced IAC, TPS, Temp sensor. Condition getting worse and now the temp gauge does not work. I am thinking maybe CAT Converter loaded up?
View 2 Replies
I have a 2001 santafe with a 4 cyl The code 102 was up so I replaced the mass air flow censer . I go on a test drive and the light stays off , but when I go to re start it again the light come on and stays on, with the same code. The only strange thing is the idle will raise for a min then drop down to almost a stall.
View 2 Replies
