Santa FE SM (2001-06) :: Cruise Control Just Quit Working
Jul 28, 2012
I was recently on a road trip, using my cruise control extensively (like usual) when it just quit working. I tried to reset to a lower speed, but it would rev itself back up to the original speed. I turned off the cruise control, drove a mile or so and turned it back on. The cruise dash light came on, but the right control buttons no longer worked. No check engine light. It's never worked since.
My local tire shop checked codes and found the tcm not communicating with the mod (cruise module?). I'm looking to take it to the dealer, but I'd like to be better informed with what I may be dealing with before I get there.
View 1 Replies
Advertisement
I have a 2003 2.7 auto. Quite suddenly the speedo and cruise control have stopped working. Everything else works just fine...
View 2 Replies
My 2002 Santa FE's cruise control has stopped working, light comes on but no hold or anything, any obvious faults they have that I can try. I checked the fuse, that's OK...
View 7 Replies
Never had any issues with it before and was working fine on a trip a couple of weeks ago. On the way home I had it on, we stopped to get some food, and then when we started up again cruise control wouldn't turn on at all. I tried turning on and then setting, but nothing happened so I don't think it's the light. Checked the fuse and it looks fine (no noticeable distortion or break to the wire anyway) and brake lights all work.
View 8 Replies
I have a 2004 Santa Fe GLS that the cruise control just stopped working. It will not turn on when I press the ON button. Could it be a blown fuse? I recently had a new AC compressor installed. Could it be related to that? Maybe something didn't get plugged back in?
View 1 Replies
Same car I posted about a couple of days ago. It was running fine. My son was driving on the freeway, and tapped the brakes to disengage the cruise control, and the transmission just stopped working. It was not in gear after doing this and the transmission would not engage. It was nothing like a slipping transmission. The engine just revs with no resistance.
Got it towed home and checked the codes: P1529, generic 'Check Engine' light from the TCU; P0760 Transmission solenoid C and P0765 Transmission solenoid D. I have googled these codes individually, but not sure how they tie together.
Oh, I overfilled the transmission. Probably a quart too much because I didn't know how much extra I needed for the torque converter. I doubt this is the issue, but I will drain the excess. Where to check next?
View 3 Replies
I noticed today that my cruise control quit working. Car has about 58K miles, the "cruise" light comes on when the button on the end of the switch is pushed in, but the device itself doesn't work.
View 7 Replies
In 1970 I bought one of the first Chevrolet Blazers. I drove it until two years ago when it finally was just too worn out to drive, at close to 300K miles. I sold it to someone who is in the process of restoring it for show. I knew that I wanted an other 2 door Blazer, but they quit making them in 1995. After a long search I purchased an original 86K miles on a 2 door 1996 GMC Yukon SLE. I love this car.However, I have just experienced my first mechanical failure. I am a fairly good shade tree mechanic. At 70 years old I have worked on every vehicle I have ever owned. So I am trying to figure out what has gone wrong with the cruise control. On a return trip from our lake house in Kansas (yes, there are lakes in Kansas) to my home in Nebraska, as I was going up and down the rolling prairie hills, the cruise control started having trouble going up the inclines. Then it quit working altogether. I checked the fuses and they are ok. My next thought is the control unit has quit working. I looked for a replacement unit and saw the price.... Is there something else that I could check before I replace the control unit? Is there any way that I can verify the control unit is at fault
View 1 Replies
I have a question on my '00 7.3. Cruise control just quit working. From reading the threads/forums I have gotten some ideas, but how about no dash light when turning the key to on? Nothing with the self test also. How can I troubleshoot the switch in the steering wheel? I could also have a bulb out in the cluster, but either way- no cruise function.
View 4 Replies
The ruck is a 2002 Ex limited v10 4x4. The cruise worked fine till my wife drove the truck! the green cruise light blinked a few times, now, there is nothing.I'm no good at electrical issues.
View 3 Replies
The cruise on my 06 F-150 just quit working. No light and can't set it .
View 1 Replies
My steering wheel controls on the lower half quit working last year , then the cruise control quit intermittently last month , then the air bag light starts appearing last week. Deciding this means a failed clock spring / spiral cable , I took apart my spiral cable housing, and found two obvious breaks in the electrical wiring . I first bought a salvage unit on Ebay, to find it arrived bound, didn't turn freely (and no returns from seller). I then bought one from the dealer and installed it last week and very happily have all symptoms fixed!
The replacement was easier than I expected, the steering wheel was not actually very tight, I doubt I needed the steering wheel puller I 'borrowed' from the parts store , could have just loosed the main nut, wiggled and tugged it loose. Just a note be sure to remove 12 volt power from the car, and mark the steering wheel center shaft to the steering wheel for reinstall .
As a rural mail carrier I deliver mail out of my prius with the window down, traveling about 5 hours a day on dusty ,sand roads in Kansas. The car interior gets dusty and this caused the failure of the spiral cable.
Pic's of the old failed unit, the new one comes with some lubricant, white perhaps lithium grease for the ribbons/ wheels, mine had dryed up patches of grease, some I cleaned off the ribbons before the pictures where taken. I'll check the new one in a year, may regrease , cleaning it out to try to prevent this from happening again. I did add some plastic under the airbag to improvise a dust shield for the new spiral cable. Car has 197k bought it with 106k , now has around 60 k from driving on the route.
View 4 Replies
I own Sta Fe 2014 DM CRDi 2.2L diesel engine automatic transmission. Recently I am encountering a problem on my unit, firstly the ABS, ESC, and Hill descent alarm indicator shows on my dash brought it to Hyundai and they replace wheel hub assembly on the rear right wheel. after a week it goes lit again but doesn't stays long it disappear right now it happens from time to time only. Secondly my cruise control wont engage the light stays on but could not keep the speed, Ive check the brake lights they are not busted. The service technician doesn't now what to do and no error code showing on the computer. Last is during start up transmission on neutral or park position the speedometer fluctuates then warning light on ABS, ESC appears.
View 6 Replies
I have a 2005 Santa Fe 2.7 ... My cruise control on the steering column began to work only intermittently. Now it doesn't work at all. It will turn on but won't set.
View 15 Replies
2010 UK Santa Fe manual box, suddenly will not set Cruise Control. At same time gear change advisory indicator also stopped working. OBDII tester will not initiate to check things out but first time I have tried this. Fuses checked all OK (I think).
View 1 Replies
I have to press Cancel before I can get my cruise control to work. I had a problem about a year ago where my cruise control wasn't working, and found out that a blown brake light fuse was the problem. Now I turn my CC on and the "Cruise" light comes on, I then press the set button, and nothing. I then press the cancel button and then the set button and then the "Set" light comes on.
View 2 Replies
My cruise control has been acting very funny lately. The light comes on normal all the time when I press on/off. However about half the time the cruise does not set when I press set. By this I mean, on Monday this week my cruise refused to set on my way to work, but on my way home it worked just fine. On Tuesday, the cruise worked perfect all day. Today, it did not work going to work or coming home.
View 6 Replies
I have a 2006 santa fe with th 2.7. The tail lights light up both films on both sides when you turn the lights on. Now the cruise control will turn on but it won't set the speed. I changed the brake switch and i tried to put it in the same exact spot. The old one was not sticking or anything. Now I was told the switch might need reset or something. I looked everywhere for shorts and sealed them up. Checked all the fuses which all are good. So im not sure whats going on. Now when you press the brake the small fuse will burn out.
View 10 Replies
I have this weird problem with the cruise control of my 2002 elantra gt: I cannot set the cruise control at 30 or 40 mph, but I can do it somewhere above that (just went to the highway and set it around 60 mph). What could be the problem? Do cruise control systems need calibration or would I have to replace it?
View 2 Replies
Looking for any pointers on fixing my cruise control Have looked around under hood but what it looks like. I've got the air working again,put Warn hubs on and have ordered the Hellwig rear sway bar,adjusted steering box i/2 turn....
View 14 Replies
The cruise control in my recently purchased '01 Excursion isn't working. I've done a lot of searches and discovered there was a recall for a wiring harness: 2001 FORD EXCURSION Recalls
I called my local dealer and they stated there aren't any open recalls for this vehicle, so the previous owner must have taken care of it.
Is there any way I can verify that the warranty work was done? Can I visually inspect the harness? What else I can check to fix the cruise control? The lights on the steering wheel are illuminated.
View 14 Replies
