Santa FE SM (2001-06) :: Code B1382 - Airbag Light Came On And Will Not Clear
Mar 13, 2014
2003 Santa Fe GLS 120K mi. 2wd, 2.7L, AT.
Been having for some time an intermittent problem where the air bag light will come on and not clear. I can clear it sometimes by removing the neg. batt. term. and letting it sit for a few minutes. The "air bag" light always seems to come on when someone sits in the passenger seat. The dealer reported a trouble code of "B1382-- PSAB harness improper pin tension" They said that they re-seated a connector and it was good to go. Now the "air bag" light is on again. Does the description refer to the pin tension in a connector? which connector does it refer to and can I just tighten up the female part of the connector such that the male pin makes better contact? Is it the yellow connector under the seat?
View 7 Replies
Advertisement
2003 Santa Fe 2.7L, 2WD, 118K Mi.
This is a recurring problem. Air Bag light comes on and stays on. Seems to always get triggered by someone sitting in the front passenger seat AND the right side rear passenger seat. First couple of times I was able to clear it by removing the neg. battery terminal for 30 to 45 min. Then it stayed on and didn't clear. I took it to the dealership and they said they cleared it by cycling the connector behind the glovebox. It has been ok for a long time until yesterday night when I had 5 people in the car. Now this morning the "Air Bag" light is on and won't clear. I tried disconnecting the neg. battery terminal because it was easy to do but no luck. I have checked the connectors under the passenger seat thinking someone is bumping a connector with their feet but all connectors seem ok.
View 3 Replies
2004 Santa fe- air bag light stays on-
Any trouble shooting protocol to follow?
View 14 Replies
Ok I just bought my 2004 santa Fe last Saturday. I washed and detailed the entire car even washed under the hood with the washer from the car wash like I have done many times before on other cars. On sunday the air bag light came on. Could have this been from me washing under the hood or is there a true problem. How do I check the air bag system and how can I reset the light.
View 6 Replies
I bought a used 2005 Elantra a couple years ago for my teenagers. The airbag light came on, so I took it to the dealer. The code they found is B1448. They said they need to replace the passenger side seat cushion module. (I think the value of the whole car can't be much more than that!).
View 2 Replies
I picked up a 2001 Escape 2.0 manual with 160K. She runs great but I realized that the airbag light was burned out so I hooked up my scanner and pulled 2 codes C1414 and B1869. I changed the bulb and cleared the B1869 but the C1414 remains. the airbag light also flashes and gives me a 29 code. I am not finding much on the subject. The airbags appear to be there and it does not appear that it has been wrecked. I am guessing that it is the airbag control module. Where the module is located on this vehicle.
View 7 Replies
About a year ago, my airbag indicator light threw a code 47. It did this for about two days, then it stopped. Fast forward to this weekend, and it started again. From what I can tell, it is the passenger side seat belt pretensioner. It could be a coincidence, but my daughter pulled the seat recline lever without anyone being in the seat, causing it to fly forward as if James Bond was ejecting someone through the windshield. The next time I started my truck, it was throwing the code. I tried to check to see if the plug was knocked loose during the ejection sequence. I thought the connector was under the passenger seat, but I don't see any wiring (the passenger seat is manual). My next guess was behind the glove box, but I'm not sure what I'm looking for.
My truck is a 2001 F250 4x4 Lariat.
View 2 Replies
I bought some long beams at the local lumber yard. So drove home with the rear cargo door open. The ABS light went on brakes were pulsing mildly and making an odd sound. I cant see why the rear cargo door would have any connection with the ABS system so I assume that's a coincidence.I took the van to the local car store they scanned the code. It scanned code 4 indicating the passenger front sensor. I replaced the sensor but the ABS light is still on. Is there a reset function to clear the code disconnecting the battery didn't work? Or am I looking at another component failure?
View 2 Replies
I have an 05 GLI with many mods, far from stock. In the past i have tried to recode the ABS module with my vag com to ABS only because the traction control does not work when you make 300whp and im sick of pushing the button every time i get in the car. The module will not take the recode so i gave up. Then about a week ago the ABS light came on for no reason and i can not turn off the traction control with the esp button so i checked the code.
It said something about a system test (ill have to check it tomorrow to find out what the code was) i tried to clear it and it would come right back with no other codes. Then i took the car out and beat on it and the traction control still works (or trys to) and i hammered on the brakes and the ABS still works and the fluid is still full. Then i came to red light and i after i stopped i pushed the brake petal hard and the traction control light started flashing (im still stopped and not moving at all) It just kept flashing for over a minute even after i started driving. Then the tc light stayed on and the ABS light went off. As soon as i turned the car off and back on it was ABS light on and tc light off. Still only the same code stored. I tried recoding it to a car with ABS, ESP, and HD suspension and it took that coding. But still had the same code so i recoded it back to my oem one.
View 24 Replies
I have an 2004 Santa Fe and im having some Mass Air Flow Sensor problems but I dont know what's wrong. My engine light came on for the second time after awhile. And I got it checked for the code and of course it was my sensor again. The first time I just giggled it around and the light went off. I did the same thing today with giggling it again went off. So I feel like it might be a loose connection but I really hope it isn't failing because im pretty sure that's uber expensive to fix.
View 2 Replies
I have a 2003 diesel GS Santa Fe, every now and then when driving the ABS light comes on, not very often but it does, if I switch the ignition off and restart it goes out, I had it on a fault finder computer and it showed code c1274, I think its something to do with the G sensor and the way it breaks (ABS) is it an easy fault to fix? What are the costs involved and will it affect the driving of the car, like I say it rarely comes on and I don't notice any change in how it drives.
View 1 Replies
Engine light come on and everything is running great, this morning got this error code U0d00. Went to advanced auto and had them run a scan.
View 5 Replies
My 2010 Elantra sedan had an accident, the airbag and driver side seat belt was deployed. And the airbag light is on after that, beside the Hood and the headlight panel is curved, nothing is wrong. The people is also safe.
I bought an airbag and replaced it, and went to a body shop to clear airbag signal. That guy said my seatbelt was still need to be replaced, since he can only clear one signal, there was another signal there.
Several days later, I bought a seat belt and replaced it, and wen to him again. He said there is no signal there, but the airbag light is still on, there should be something wrong somewhere.
My hood is still cured, but nothing is wrong with it. What can I do? The signal doesn't bother me, but I think it cannot pass the inspection.
View 8 Replies
so I just installed a set of sportline seats and after the fact I have a parking brake light (no auto hold) and airbag light on. After checking fault codes in vag, I have determined that both these lights are due to the air bags.
My question is this, can I add resistors to the airbag wires in the new seats to trick the car into thinking that these are the old airbags? Everything else except memory works on the seats, just these damn airbag/parking brake lights.
View 6 Replies
I have a 2005 Santa Fe with the 3.5 with 112000 miles on it. I had the engine light come on with the code P0302 cyl #2 misfire, I got spark plugs, plug wires to do a tune up on it. I changed all of it and got it back together, started it up and it still had a miss to it. I then took the front spark plugs out and did a compression test on it. #2 was at 85, #4 was at 120, and #6 was at 160. I couldn't check the back cyls because I had already put the intake back on. I then did a wet test, and all the cyls came up to 160. So this tell me that the piston rings are bad in #2 and going bad in #4. I have kept all the oil changes up and up to this point I haven't had any trouble with it. Having this problem with there 3.5?
View 1 Replies
Check engine light on, car stalled once. Pulling code p0320 "Engine Speed Input Circuit Malfunction." Tachometer works intermittently. Where do I start?
View 2 Replies
Recently got check engine light fault code p0320
2005 3.5 with 172k miles
View 2 Replies
2001 explorer sport, need to reset and clear check engine light I know the problem a small pinhole in exhaust that opens up and i fill it in How do i reset check engine light...
View 1 Replies
My check engine light came on the other day and the code stated the the "throttle position is open" so after researching and everyone telling me that i need to change the sensor. I did everything after was fine running better but today only after 3 days replacing it i get the same problems. car has no get up and go hardly can push to 20 mph and when in idle i press the break it starts to bog down and almost want to shut off! and can be really loud...
Santa fe 05' 3.5L ....
View 5 Replies
I get a strange noise behind the passenger airbag, like parts moving.
Recently I noticed that the a/c does not come out cold. Could these issues be related?
View 2 Replies
I have suddenly acquired a new value added feature to my X. An airbag warning light flashing code 18. Through the research I have found it is either a pretensioner issue or a short. Would like to know for sure what it is.
It is a 2001 LTD 5.4L.
View 5 Replies
