I have a 2005 Santa Fe with the 2.7l engine....during the last two summers I've had this code pop up only to disappear. Well, we're into the winter here in New York and the code popped up again and after a week its still on. What's causing this and are there any easy fixes? The wife loves the SUV, its got 120,000 miles on her, the engine is strong and the tranny was rebuilt this summer (that another story).
View 1 Replies05 santa fe/3.5L/ owned since new. Had a misfire problem and solved that by changing coils/plugs/wires...
Still getting a P0430 code (bank 2 cat efficiency low)
Following the Repair manual troubleshooting of that code says
Read H02S - got a scan tool and did that -
Comparing Bank 1 H02S1 and 2 show they are are different voltages and do not follow.
Comparing Bank 2 H02S1 and 2 show nearly identical traces.
I also checked the wiring harness around the sensors and check for air leaks...couldn't hear/see/feel any.
My conclusion based on the info obtained is that the bank 2 cat is bad and needs to be replaced.
2001 V6 Passat with 125k miles throwing a P0430 code.
Having trouble on cold starts, takes about 10 minutes to finally get it to turn over. When it does the idle is extremely rough. For the first 1/4 mile the car bucks, stutters, and misfires. After that it runs fine and starts fine when already warm. I am noticing slightly decreased gas mileage but nothing major.
Valve cover gaskets were replaced 2 months ago, but were leaking oil for at least a year before I could afford to have them replaced. I am still noticing some oil leakage, however not as much as before. I have had both O2 sensors replaced twice in the past 5 years. Timing belt was replaced at 98k. What might be causing the starting issues?
About a week after my yearly inspection the "Air Bag" light on the dash popped on and has been on for the last few days. Are these comon failures? and could you give me a good starting point. My car is a 2005 Santa Fe GLS FWD with 125,000 on her.
View 9 RepliesA quick question for those with a manual. I was out with the kids yesterday and the passenger side tie rod end popped off. Luckily we were only backing up at the time, but the bad part was we were in the middle of no where and had to go home with my wife as we took both cars. But, I had to leave the car there. Anyway, what is the size of the castle nut that attaches the tie rod end? I want to be sure as the vehicle is about 40 miles from home.
View 5 RepliesI just changed the timing belt on my sisters car and finished yesterday and drove it today. A check engine light came on so I went to check it out and P0016 popped up. I've done some research and people say that it might be that the timing belt is misaligned or loose. I tightened the belt not too tight but not too loose. Note: I also spilled coolant on the crankshaft pulley and a bit on the belt itself. The car idles rough when driving too. I will tomorrow take off the cover and check the tension of the belt.
View 9 RepliesI have a 2001 Prius with 210,000 miles. The inverter and traction battery were replaced last year. I started getting triangle and check engine lights about a month ago and the scan tool read p3191 p3006 p0300. The car would barely start in the mornings and the dash lights would be dim. I replaced the 12v aux battery today and all the symptoms went away. Driving home the triangle/check engine light popped on again and I stopped at Orielly's to use their scan tool. It now only reads P3006. I called a local mechanic who suggested to drive it a bit and clear the codes because the battery needed to equalize. Is this true?
View 8 RepliesMy car is running great, no issues. I just changed the ignition coils, i was having a misfire. It was easier since i was changing the back to replace them all. My CEL and VSC went on and it is code P0430 bank 2. Before i spend a ton on a new catalytic converter i would like to change the o2 sensors. Problem is, I am not sure which ones to change or where to start. Is this even something i am able to do?
View 2 RepliesMy 2009 Camry came down with the p0157 code which I looked up & is oxygen sensor circuit, low voltage bank 2 sensor 2. I'm trying to figure out which side this is(driver or passenger)? Also have a p0430 code-catalyst system efficiency below threshold.
View 2 RepliesMy CEL came on and is throwing code P0430. Is it just an o2 sensor? if so which one primary or secondary?
View 2 RepliesI recently purchased a used, high mileage 2004 Infiniti G35x (AWD) 145K miles from a reputable new car dealer here in my town. The car was impeccably maintained and clean inside and out. Just a week or two after the purchase my SES light came on revealing engine Code: P0430 (catalyst efficiency below threshold bank 2) pointing to a new catalytic converter in my future. Infiniti recommends premium unleaded for this vehicle. I found out my son filled her up with mid-grade unleaded. Is there any chance this could have triggered the SES light to come on? (Previous owner states he always used premium unleaded in the vehicle since ownership.) I also double checked the gas cap to make sure it was on tight. I find it extremely odd that the SES light would come on so shortly after the purchase. I mean what are the odds? Don't dealers run a diagnostic scan of their trade-ins to check history and for potential problems prior to selling their used cars? I test drove this car numerous times without any indication of a problem and right on the heels of the purchase it passed state emissions... now just a few days later, the SES light comes on. Why wouldn't emissions pick that up? I have reset the SES light (code) and filled her up with premium unleaded. Now it's a waiting game to see if the light comes on again. If the light reappears, I plan on taking it back to the dealer to work out some kind of "reasonable solution" to repair costs. I'll find out just how willing he is to stand behind his cars. I realize that this is a high mileage car, and I hardly expect perfection, but I didn't see this coming. What to do... what to do... By the way, I checked all the fluid levels ... no discoloration in the oil (fresh, golden brown)... no discoloration in the coolant... transmission fluid, good... all other levels are good. Car runs fine, no rough idle in cold...
View 11 RepliesJust read that a clogged EGR valve is common and reduced performance and increases emissions. Need to clean this valve? Where is it located?? Just noticed tonight that there is not a lot of suction from my vacuum lines and I wondered if this is related. Plus I have a p0430.
View 3 RepliesSO all three lights came on and wouldn't go away.
Ran a scanner for code and got p0430.
Took it dealership for estimate or fix.
Go figure : code summary: Causes.
Reported fixes or Causes: for code p0430
- catalytic converter has failed.
- Air fuel ratio sensor
- Bank 2 cat converter
- Bank 2 (A/F) ratio sensor
- Oxygen 02 sensor
- downstream Oxygen 02 sensor
- Exhaust pipe
- Mass Air flow sensor
So I am waiting thinking ok let be one of the above causes or fixes that is cheap.
It came on 2-3 miles after a cold start. 3.6 with 137,000 miles. What's next? First car I've owned that uses very little oil between oil changes.
View 1 RepliesI have an '04 F150 with a P0430 code. Not sure where to start, I have read that it could be numerous things so I thought I should start knocking them off the list one at a time. Thought I would start with the cats. 2004 F150, 4x4, 5.4L, 126,000 miles ...
View 6 Replies[URL] ..... I had the P0430 code come up in my 06 GS300 AWD so i changed both passenger side 02 sensors. i followed the above instructions on changing the pre-cat sensor, changed my 02 sensor plugged everything back up and the P/S light came on and i lost power steering. I unplugged and checked everything at least 10 times until i finally gave up and gave it to lexus today. been about a week though driving without power steering. I know I did everything right and plugged everything snug. Did my P/S just decide to die?
View 6 RepliesReplaced my post cat drivers side O2 sensor tonight because I was getting zero voltage and a p0430 code. This is bank 2 sensor 1.
But I'm still reading zero voltage!! How could I still be getting zero voltage?? I checked the connections and they are firm. Checked every single fuse in car.
After my recent accident, the center console lights don't illuminate. My nav door doesn't close too. Could these all be related?? The connector for the O2 sensor is right next to the console, so maybe there is a loose connection or plug or perhaps a stray ground?? I do have wires all over the place in under the shifter bezel from aftermarket stuff..
1997 F150, 4.2L V6 200k miles. Truck has been running fine. No CEL, or anything. Stopped and filled up the tank and within 10 minutes of leaving the pump, the CEL came on. Code is P0430.
I drive this truck 60 miles a day. It's shown no signs of any issues until the light came on today. Just curious if some bad gas could cause this or am I in for CAT replacement...
I got a P0430 code. My fuel trims are over 20% on both banks. A few days back I got a P0174 code but after disconnecting the battery it cleared and hasn't come back. Are these codes related in any way?
I'm a bit confused because I removed both cats and put O2 spacers in on both sides. I never get a P0420 code. Is one of the spacers not working correctly? I sent Toyota an email about the 430 code and they want to know which of the cats were removed - front or back. I didn't even there were front AND back ones! I thought there were just 2 side by side.
When I analyze the O2 readings on Torque they look pretty similar for both banks although I admit I'm not the best person to judge. Both rear O2 sensors are fairly new.
Unfortunately living in the middle of Africa I can't get hold of a smoke machine. I'd love to look for a vacuum leak, as from what I've read about the subject this might well be the cause of my problems.
One mechanic wants to put a new fuel pump in but I'd like to postpone that because it's a pricey item.
CEL came on today and when I ran the codes I got P0741. Torque converter CKT Performance or Stuck Off. What the next steps are.
View 1 RepliesAbout 2 months ago, the check engine light came on and I had the code read, it came out as P0031, which is the 02 Sensor. Today, I had this 02 Sensor replaced and had the code reset, but later on today the check engine light came on again. The mechanic said I needed to drive it for about 100+ miles before the car resets itself. I drove it for about 30 miles before it did come back on.
View 8 Replies