Santa FE SM (2001-06) :: Blower Motor Stuck On While Driving
Sep 23, 2012
I have an 02 Santa Fe and last night while driving the fan would not turn off. It also started switching speed by itself.
View 2 Replies
Sep 23, 2012
Advertisement
Santa FE SM (2001-06) :: No AC / Blower Motor Is Not Coming On
Today i had my ac running and switched the speed from 3 down to 1, then poof totally went off and will not come back on at all. I tried replacing the resistor, still nothing. Next tried the blower motor, still nothing. Then replaced all the fuses, still nothing. The compressor is kicking on. Can here the click under the passengers side when turning ac on, but the blower motor is not coming on.
View 1 RepliesSanta FE SM (2001-06) :: Impossible To Put Back Blower Motor
2005 Santa Fe - 3.5L w/ Auto a/c controls (it matters for price on the resistor. boo!)
I find myself having a really hard time sliding the motor back in. It was difficult to pull out before and now it's nearly impossible to put back in.
The Fan wheel measures 5 3/4"
I believe the issue has to do with prefab installation and a very large wheel causing this to be too difficult to push in at an angle.
I see different dimensions for fan wheels and I'm thinking that may be the key.
I already have to replace the blower motor.
Santa FE SM (2001-06) :: AC / Heater Blower Motor Replacement
How hard is it to change the A/C/Heater blower motor. I know about the switch problems but this is the blower motor. I'll probably clean it out and spray something in it before I replace it but I just wondered how hard it is to get to. On another note, this 4 wheel drive Santa Fe rocks in the snow! I can't believe what good traction it has!
View 3 RepliesSanta FE SM (2001-06) :: Climate Control - Blower Motor Constantly Running Anytime Key Is Turned On
I have an 04 Hyundai Santa Fe 3.5L V6 AWD with climate control. All other trucks this year I've only seen with manual HVAC controls. My blower motor is constantly running anytime the key is turned on. It feels like it is blowing 3/4 strong all the time and I can turn it up, what feels like one setting higher. Even if the climate control is turned off it keeps blowing. I can control the temp and AC and defroster, I just cannot control the actual airflow pressure from the vents. On an older car this seems like a resistor issue. Is this a common issue? If so, what can I do to try to rectify this?
View 4 RepliesFord F-150 (2009-2014) :: Blower Motor Stuck On High
What is the testing procedures for the blower motor controller on my 2009 150 Lariat. In the old days it was called the resistor but now it is computer controlled for the dual climate control. My fan is stuck on high, the fan switch does work(the bars on the display change when I push the fan speed button). The climate control works also, just blasts you with air and the temp is changing a lot due to the fact of the fan on High. I am 99% sure it is the blower motor controller, but I would like to test the controller.
View 14 RepliesSanta FE SM (2001-06) :: ECU Stuck In Open Loop-driving
2001 2.4 L AWD Manual Transmission.
Live data readings from vehicle continuously indicates "open loop- driving" for the Fuel System Status (Fuel System 1) . During idle and on open high way driving as 120 km for 10 minutes. I use an ELM327 diagnostic device with ScanMaster-EL 2.2 software.
After establishing this initially I disconnected the battery to do a complete ECU reset. I do not get error codes.
O2 Sensor1 Bank1 constantly reported as 1.275 V and sensor 2 as 0.02 V. I believe however the constant readings are as as a result of being in open loop.
No error codes reported.
The software report OBD1 ability on the diagnostic link.
During driving I got the following readings:
Fuel System 1: open loop-driving
Fuel System 2: not supported.
Calculated load: 6.27 to 83.14, avg 40.6
Fuel trims: 0
RPM: 1008 to 3988, avg 2407
Speed (km/h): 0 to 122, avg 77.66.
Timing Advance #1 degrees: 7 to 44 degrees, avg 22.42
Intake Air Temp (degrees C). 19 to 24
Air Flow Rate - (g/s): 3.18 to 69.27, avg 25.46
The software reports that the O2 Sensor bank 2 is not supported. I am not certain whether I should trust the software. In South Africa cats are not mandatory, hence is it possible explanation.
2) Is it possible to send a command on OBD to force closed loop?
Ford A/C :: 2010 Expedition - Blower Motor Not Turning Off / Stuck In Highest Fan Speed Setting
My 2010 Expedition Limited AC seems to be stuck in the highest fan speed setting. Changing the setting on the panel control do nothing to change the speed. But you can adjust the temp and it will respond. It is a dual control unit. When I try to turn the system to off completely it will go to what I believe is the vents and stay on full blast. If I turn the truck off and on again the whole system remains off until I turn it on again. The only way to turn it completely off is to turn it to off mode and turn the truck off.
View 1 RepliesSanta Fe (CM - 2007-12) :: Blower Motor Is Much Noisier
12 Santa Fe, I decided I better give it the once over. I found the cabin air filter was pretty bad and that surprised me because I don't drive in dusty areas etc and usually don't drive much at all any more since I got a company car but anyway....to the question: AFTER I changed the filter, making sure the airflow arrow was correct, I noticed that the blower motor is much noisier than before especially when set on the higher fan speeds. The sound is much like a off balance fan with a bit of a thump to it. Could I have dropped some of the dead bugs into the fan when I changed the filter? I was careful and didn't see anything fall into the fan area but the noise is annoying as heck. Is this something that would be covered under Hyundai's warranty? Headed to the Florida Keys Saturday and not looking forward to hearing that racket all the way down there.
View 3 Replies2001 GMC Jimmy - Low Speeds On Blower Motor?
I have a 2001 GMC Jimmy and I am having an issue with the blower motor. Speeds 1 and 2 do not seem to work. Speeds 3 and 4 work fine. This is the manual climate control not the automatic. I searched and it seems everyone usually has a problem with the high speeds & not the low speeds...
View 9 RepliesFord Super Duty (1999-2016) :: F250 - HVAC Blower Motor Stopped While Driving
My HVAC blower motor stopped today while the wife was driving the F250. I thought I should swap relays (with the heated mirror relay - same Ford Part Number) to rule it out or identify it as the culprit. However, since these are close to the firewall, I have a hard time getting the grip and leverage to pull the relay out of the Battery Junction Box (BJB). How to make this a bit easier?
View 5 RepliesSanta Fe (CM - 2007-12) :: Driver Seat Stuck / Adjustment Motor Failed
Driver's seat is stuck in partial recline mode. It goes down, but won't come back up...
View 4 RepliesFord Super Duty (1999-2016) :: 2001 F350 - No Blower Motor / Just Defrost
Like the title says; I have a 2001 F350 with No blower Motor and Just Defrost, it is actually a friends, he is building a fence, and I am looking into the truck problem. The just defrost is probably a vacuum issue, but I do not have any book for this truck, so I have no vacuum or wiring diagrams. As far as the blower motor, I am thinking switch or motor, fuse has been checked? Is there any other "control" box involved with this year/model? Also any dash tear-out instructions, to make the access easier?
View 1 RepliesFord Super Duty (1999-2016) :: 2001 F350 - Blower Motor For AC / Heater Only Works Sometimes
2001 f350 blower motor for (A/C - Heater) works sometimes and sometimes does not.
View 5 RepliesSanta FE SM (2001-06) :: Blower Relay Keeps Going Out
I replaced the blower relay around this time last year. I noticed this morning idling that the vents weren't blowing then when i was moving i heard it tick back on and would blow normally. This happens when driving too but more noticeable when idling. The AC light also flickers and goes on/off.
I can go ahead and replace it again but this seems to have gone through this brand new relay pretty fast. What I can fix to stop going through relays?
Santa FE SM (2001-06) :: Blower Fan Running Even After AC Switch Is Off
I have strange issue with my a/c fan, its running continues even will the a/c switch is off.
I cant stop it. So I have to remove the fuse to stop it. My ac panel is automatic.
Santa FE SM (2001-06) :: Blower Switch Replacement
How to remove center panel in order to replace faulty blower switch?
View 1 RepliesSanta FE SM (2001-06) :: Blower Only Working On High Speed
Blower only works on high speed. From what I have read the problem is either the switch or the motor resistor. I am leaning toward the resistor which is behind the glove box. Where can I find directions for removing the Glove box?
View 1 RepliesSanta FE SM (2001-06) :: 2005 - Heater Blower Runs Continuously
I have a 2005 Hyundai Santa Fe 3.5 litre 4wd and am having a crazy problem. It has the automatic heating and air conditioning module (digital). The heater fan comes on as soon as i start the engine and runs in the 2nd highest speed. I can adjust it so it goes one speed higher but never lower than the one it comes on at and cannot shut it off. It operates the same under heat OR A/C modes. The temperatures adjust o.k. but it is always on. Where would i find the a/c control module? Could it be the transistor or resistor and where are they located?
View 2 RepliesSanta FE SM (2001-06) :: 2004 - Clicking Noise From Blower Relay / Fan Turns Off Then Comes Back On
I replaced blower switch last year a couple of years ago. I recently starting to get clicking noise from blower relay, and fan turns off then comes back on.
Question:
1- Problem more likely to be from the relay or the fan switch? Should I just replace the relay?
2- I can see and touch the fan relay, but how do I get to it to replace it? What dis-assembly is required?
Santa FE SM (2001-06) :: Large Coolant Leak On Top Of Motor
I just purchased a 2006 Santa Fe Limited with the 3.5l for a great deal. It has a huge coolant leak though that needs fixed. It is coming from the top of the motor on the left side by the timing belt. It is really a small flood, when you fill the coolant and turn on the motor it runs across the top of the motor toward the drivers side. There isn't oil in the coolant and it doesn't smoke. I had it dropped off at my mechanic though. Does the motor really need pulled in these to do the head? I heard that there is a overflow channel from the water pump that comes out right about there as well. Could that maybe be it? Any other options if it is the head gasket to reduce the cost any?
View 17 Replies