Santa FE SM (2001-06) :: 2005 - Gear Shift Knob Replacement?
Sep 22, 2016
How do I take off the gear shift knob? I want to replace it with an aftermarket one.
View 1 Replies
Sep 22, 2016
Advertisement
Santa Fe (CM - 2007-12) :: 2008 - How To Take Gear Shift Knob Off
I'm new to this and not really sure if I'm doing it right. I need to know how to take the gear shift knob off my 2008 santa fe.
View 3 RepliesPassat (B5) :: Automatic Transmission - Shift Knob Replacement
Where I can find information on how to swap out the shift know on an automatic transmission in my 2003 Passat GLX? I bought a new knob but don't know how to get the old one off.
View 1 RepliesSanta FE SM (2001-06) :: Hard Shift From 3rd To 2nd Gear
My Santa Fe 2001 model V6 4X4 Automatic shift gears down hard from 3rd in to 2nd. I checked transmission oil and its light brown. Should I drain and refill or not worth it.
View 7 RepliesAzera TG (2006-11) :: How To Remove Gear Shift Knob
How Do You Remove Gear Shift Knob For Replacement ?? On My 07 Azera
View 2 RepliesSanta FE SM (2001-06) :: 2002 V6 Very Hard To Shift From 2nd To 3rd Gear
I have a 2002 Santa Fe V6 2.7 liter, FWD, 215,000+ miles. When it shifts from 2nd to 3rd the whole vehicle jerks. It does not do this on the other gears. I took it by a transmission place for a free scan and they said the transmission is fine.
View 19 RepliesGrand Prix :: BTSI / Gear Shift Knob Removal?
I've tolerated having to release my key with the manual push button for years. Now the interior is disassembled (after replacing evap core) so I'm looking into fixing the BTSI.
I've never been clear on whether the problem is in the console by the gear shift or in the steering column. The thing is in the steering and has a solenoid that will mechanically allow the key to turn to the LOCK position when energized. The manual release is at the bottom.
I connected the leads of that white thing to battery voltage and sure enough, the post retracts. So that seems to work. However, when connected to the car wiring, there is not enough voltage to retract. It retract, it will hold. I concluded the problem is near the gear shift. Probing the lead (with the white thing disconnected) indicate battery voltage, but that's without any current.
Battery voltage is getting to the wiring harness in the console. Probing the leads to the Park switch indicates 90 ohms resistance. I suspect this is too high and causing a big voltage drop so there's not enough to energize the solenoid in the column.
What can be replaced in the console to remedy this? Is it only the park switch?
How is the gear shift knob removed? I see a slit in the back of the knob, but don't know how the mechanism works.
Santa FE SM (2001-06) :: 2004 - Grabby / Sudden Shift From 2nd To 3rd Gear
Last week my wife's 2004 Santa Fe with 68k went into limp mode, when I ran the code reader it came up with throttle position sensor and pedal position sensor. After fixing both the car runs great except for a Grabby or sudden shift from 2nd to 3rd. It shifts at about the right rpm but very hard. I am wondering if there is trans codes that need to be reset that my code reader is not able to do.
View 3 RepliesSanta FE SM (2001-06) :: Lost Ability To Shift Gear - Stuck In 2nd
My 2001 Santa Fe 2,4l - Have suddenly lost the abillity to shift gear. Its stuck in 2 and the shift stick is very loose in the "front to back and back to front" motion.. in other words there are resistance sideways.
I suspect it to be a broken shift cable. So my question is : changing shift cable on a santa fe easy? Is the best approach to start from inside the vehicle or from transmission side?
Prius (Gen 2) :: Shift Knob Making Click Every Time On Selecting A Gear
This morning the Shift Knob made a click every time I selected a gear, for about an hour, then it went away.
It was colder than almost ever here (Berkeley, CA) last nite, 30F. But there was no click back in '05 at 10F (in Prudhoe Bay, AK).
Mechanics (even the dealership!) say not to worry--probably a plastic part--just advised me to shift gently.
Santa FE SM (2001-06) :: 2004 - Auto Trans Stuck In 3rd Gear And Does Not Want To Shift
I have a 2004 Hyundai Santa Fe, has 99,000 miles 3.5L. After changing the alternator (alternator did die and drained my battery, the shop recharged the battery) now it seems be stuck in 3rd gear and does not wont to shift (it is a automatic). Fluids are good, transmission was flushed between 50-60,000 miles.
View 3 RepliesAvalon 2005-12 :: Steering Wheel And Shift Knob Leather Discolored
2005 Avalon LTD. The leather on the steering wheel and shift knob are discolored and deteriorating. It is flaking off and getting sticky. Is this something that can be re-wrapped at an upholstery shop or elsewhere?
View 3 RepliesSanta FE SM (2001-06) :: 2002 Auto - 4wheel Drive Doesn't Shift Into 5th Gear
Have an 02 Auto with the 2.7, 4wheel drive, and it doesn't shift into 5th gear. Can go through the 4 gears with the manual shift, but when just in drive, only shifts up to 4th. At 65mph, RPM's over 2500.
View 3 RepliesSanta FE SM (2001-06) :: 2005 - P0113 Code After Spark Plugs And Coils Replacement
Just replaced the spark plugs and coils yesterday, today it gives P0113 code, Intake air temperature (IAT) sensor - high input Wiring open circuit/short to positive, ground wire defective, IAT sensor, ECM...
View 3 RepliesSanta FE SM (2001-06) :: 2005 / 3.5L - Randomly Stuck In 3rd Gear
So my wife's santa fe will randomly get stuck in 3rd gear and not shift up or down (automatically or manually). It does not appear to be slipping as it speeds up slows down fine. The check engine light is on but have not read the codes yet.
View 5 RepliesSanta FE SM (2001-06) :: 2005 - Slipping / Jerking At About 2500 RPMs In 2nd And 3rd Gear
I have a 2005 Santa Fe that for the last week or so has been slipping/jerking at about 2500rpms (2nd and 3rd gear). This only happens after the car has been warmed up and running for 20 minutes or so. I have put it into manual and it does not do this, only when in auto.
View 2 RepliesMontana :: 1997 Venture - No 3rd Gear After Shift Solenoid Replacement
97 Venture, 4T60e trans, 197,000 mi. No shift or performance problems ever, solid as a rock. Well taken care of. Then a few months back it throws a P0758 code for Shift Solenoid B, and intermittently seems stuck in 3rd or 4th gear when starting from a stop. Wife drives w/ kids so immediately I park it to investigate and drive it myself and observe. Problem would happen usually after warming up and driving a couple miles, but would sometimes go away after shutting it off for a bit and going again.
After lots of research I decided it was probably a stuck solenoid and tried Sea Foam Trans Tune to see if it would clean it up, and it WORKED! For about 4 weeks that is, then came back. So I took the proper time and steps to replace both shift solenoids myself, and of course the fluid & filter (since you have to drain it to open the side cover anyway). My work is meticulous and clean, so I know nothing was done shoddy.
When removing shift solenoid A, however, a spring-loaded spool came partway out of that port in the valve body, didn't fall out, and I pushed it back in with the new solenoid. Everything else went back together flawlessly. On the first drive, it shifted to 1st as expected so all seemed well. Then after a several miles of driving I noticed something felt wrong - it was skipping 3rd gear altogether (1-2-4), and it would NOT downshift from 4th to 3rd. However if shifter was in "3" it would shift from 2nd to 3rd just fine, then I could put it in "D" and would hit 4th, but could only downshift to 3rd manually.
I am stumped, and it's been parked for months because something in the solenoid change has caused a major problem. I don't believe it could be mechanical gear/clutch failure as it shifts to 3rd w/ shifter in "3", and there was never a mechanical problem before. And it also still intermittently starts out in a high gear though quite seldom (3rd or 4th, not sure which but it barely moves) but putting shifter in "2" or "1" makes it start in 2nd. And never a SES light. Checked solenoid resistance at trans connector and they're perfect.
Tranny shop checked computer and said it's good, and also said "it's shifting just fine" which is absolutely not true. So much for a "free" diagnostic check... Could I have just gotten a bad solenoid? Could the spring-loaded spool that came part way out gotten hung up or the spring not reseated properly? Could it be the vacuum modulator (it got slightly bent upward when lowering engine)?
Ford 7.3L Power Stroke (1999-2003) :: Gear Shift Indicator Replacement
I need to replace the cable on my gear shift indicator. Of course you can't just replace the cable. I have even looked on you tube and not found anything. I don't know if maybe I am using the wrong search terms or not.
View 2 RepliesSanta Fe (CM - 2007-12) :: Can Shift Into Gear Without Pressing The Brakes?
On my Santa fe 2009 , Just noticed that I can shift from PARK to R, N, D or anything else without pressing on the brake. I checked the gear sticky by the mechanic , and we found that the lock on the gear sticky not exists. So I am worry if that normal and it's like safety option that not exists on my car? Also , is it something that may case damage to the transmission , or just Safety option .
View 8 RepliesSanta Fe (CM - 2007-12) :: 2011 - Gear Shift Plastic Shutters
Having issue with those plastic shutter flaps under the gear shift console? I think something might have been spilled in there because they have a tendency to be 'sticky' when moving the gear shift back and forth. Sometimes it gets bad enough that they get jammed up trying to move it forward into park. What I'd like to do is take the console cover off to get at them to either clean or replace them. Have part of the gear shift console off?
View 2 RepliesTouareg :: How To Take The Shift Knob Off
First the wife crushes the underbody on a huge rock cutting a corner. Now she spilled a whole pop down the shift lever, and its glued shut - it will hardly move. I know how to get the console off, but How do I take just the 'shift knob' off? I need to get the flexible piece underneath it off so we can wash all the parts.. I have the upper console part off.
View 11 Replies