Santa FE SM (2001-06) :: 2004 - Transmission Was Slipping Periodically
Jan 9, 2013
2004 2.4L suv with 98K + miles. Transmission was slipping periodically - fluid levels were fine. Someone suggested changing fluids as it may be contaminated. This car has a manual option also that I don't normally use but I did take car out on a longer drive and it shifted as I directed. Since car is almost out of warranty (naturally) I was trying to find answers as I don't feel dealership will be honest with me. While I have not had an actual slip (engine revving and not moving) since fluids changed 2 weeks ago it does seem slow to shift. Since it was not consistent someone said the sensor may be going.
View 4 Replies
Advertisement
I have an 04 2.7 litre V6 AWD Santa Fe with 189235 KM , with a Shiftronic transmission, recently, while in "d", the transmission would feel like its slipping or perhaps trying to down shift, its hard to tell what it's doing really, but if you then slapped it over into shiftronic, it would operate fine, no slipping, locks into gear strongly, indicating that its not mechanical, but related to the computer controlling "drive" function of the transmission, I flushed the transmission just after the symptoms arrived (using the correct SP3 fluid) and this made no difference, the old fluid, although ready to be changed, was not burnt or blackend. I thought of getting it reflashed ( read it online) but I am not sure it will work, especially if its like a sensor or something.
View 3 Replies
I have been noticing that not only can I feel the trans. shifting but it feels like an old trans that is slipping. Is this normal?
View 18 Replies
We have a 2010 Santa Fe AWD LTD with about 140, 000km on it. It recently came back from front suspension work. The suspension is fine now, but we notice harder shifts in the transmission. Also, there seems to be a vibration just before shifting gears and when under load (like going up hill) seems to slip (like on ice) about once every second until the shift is made. Once the shift is made it drive smoothly until put under pressure again. Even stepping down a bit on the accelerator will cause this slipping feeling (or maybe its loss of power).
View 4 Replies
We have a 2010 Santa Fe AWD LTD with about 140, 000km on it. It recently came back from front suspension work. The suspension is fine now, but we notice harder shifts in the transmission. Also, there seems to be a vibration just before shifting gears and when under load (like going up hill) seems to slip (like on ice) about once every second until the shift is made. Once the shift is made it drive smoothly until put under pressure again. Even stepping down a bit on the accelerator will cause this slipping feeling (or maybe its loss of power). Just had new plugs put in and a tuneup so it's not that. Could something from the suspension work cause these symptoms?
View 29 Replies
My 2009 Santa-Fe AWD Limited is sick! Starting from a stop, the vehicle has abrupt shifts with the transmission slipping (RPM revving). Seems worse when cold. Checked the fluids, and found ATF fluid in the engine oil and engine oil in the ATF fluid. Quick internet check suggest a leaky vacuum modulator valve. (There is no way the fluids went in the wrong holes, the vehicle only has 69k kilometers on it, so it still has original ATF fluid, and I recently changed the engine oil myself.) So, do you think this is the correct diagnosis? How hard is it to change the modulator, and where is it located?
View 3 Replies
My 2001 santa fe has recently had a new clutch fitted as the old one was slipping but, when towing our caravan at the weekend the clutch is playing up again but, this time the clutch is slipping at anything above 2500 rpm yet she is pulling fine below this rpm.
View 4 Replies
Ok santa fe 2006 (facelift) clutch was slipping. We've put new clutch kit in it (thrust bearing; friction and pressure plate). We discovered it had already had the DMF concersion to single mass. So we ordered the single mass clutch kit for it and fitted. All back together, clutch won't disengage and allow you to put it in gear!!! So took it all apart again to check the fitting as the inspection hatch it just didnt appear all fingers on the pressure plate was being pulled.. all looked correct, thrust bearing snapped in to place as it should... we got box back on (making sure the lever entered the thrust bearing correctly) and still no luck. When you press the clutch you can pull the rubber on the slave cylinder back and the piston moves all the way to the circlip. There appears to be movement on the pressure plate in the box. At a complete loss.......... what could have happened?
View 3 Replies
I was driving out of a parking lot and as I accelerated onto the main road my vehicle stopped. I heard a grinding sound and could not go forward or reverse. While the car is in drive, park or reverse my car will roll any which way. It pushed it across the street. I tried to locate my tranny dipstick via visual inspection and manual. I could not find it. Could the stick have never been put back at some point in service and caused this issue. That seems unlikely but the thought occurred. Could it be the velocity joint? Whatever it is it certainly sounds like a transmission issue.
View 1 Replies
Before the question, this is what I have, 2001 V6 4-motion, Automatic. So tonight I was driving home from work. As I started off, the car shifted 1st-2nd fine, then when it hit third it just revs, felt like it was slipping or missing then kick to forth or second hard, then lit up all the the PRND234 on the dash instead of being in just drive. When I pulled over and restarted my car it clear but did the same thing. What is going on??? It happened once before (for a split second) but has been fine ever since. I just bought the car 3 months ago and the car has ran solid since i purchased it.
View 3 Replies
I just recently bought an 06 Santa Fe with a 2.7l v6. It was a rebuild. It had been hit in the left wheel. The lot put a new fender, suspension parts, axle, etc. It only has 25k actual miles.
We took it on a 100 mile trip today. I noticed if I am going up hill and it has to downshift, it feels like it looses power. The car continues to slow... Like the tranny is slipping. I stopped at Walmart and found the tranny fluid wouldn't even register on the dipstick. I bought Valvoline max life tranny fluid that matches the sp3 specs in the manual. I had to add almost 3 quarts before it was full. I think they may have forgot to add fluid back to replace what leaked out after they replaced the axle It didn't seem to work though when I continued to drive. After I stopped and let it cool about 30 minutes, it did seem a little better.
I guess my question is should I replace the tranny fluid? If so, what should I replace it with? Is there anything else what could be causing this now?
View 1 Replies
I have a 2005 Santa Fe that for the last week or so has been slipping/jerking at about 2500rpms (2nd and 3rd gear). This only happens after the car has been warmed up and running for 20 minutes or so. I have put it into manual and it does not do this, only when in auto.
View 2 Replies
MY 2003 Santa Fe is fwd with the 3.5 v6. While under normal conditions, the engine lost power and began "chugging" and "bucking". There was also a belt slipping "whine" associated with this problem. The problem continued for about two minutes, then corrected itself, and I was able to drive normally.
View 1 Replies
2001 Excursion V10 with E4OD. Transmission is around 4 years. Old with 40-50K on it. Here's my timeline of problems.
Day 1. Went to dive and it slipped and caught taking off. Never felt that before. I drove it about 7 miles, no problem, when coming to a stop it stuttered a little. Checked fluid it was OK. Added some SeaFoam. Seemed worse and thought I was outta luck.
Day 2. I dropped the pan and found the normal metal around magnet plus a few metal shavings(not brass). Not many. I took it to a tranny guy and he said something inside has failed but he wasn't sure what. I changed filter, used same fluid as it looked ok, put it back together and added Lucas treatment. It moves ok, still slipping around 15% of the time on takeoff. After moving it runs/shifts great.
View 8 Replies
My transmission seems to be slipping a little, but not regularly and when tested by the mechanic it shows no transmission problem. He did point out that the fluid was really black and had specks of metal in it. However, he suggested that I not replace the fluid because it has been experience that people change out the fluid and then their transmission fails. He's a mechanic I've never used before, but don't know if I should trust his assessment. I've owned the car its entire life and it only has 89,000 miles on it, primarily in San Francisco, and I'd like to get a lot more miles out of it.
View 4 Replies
I have a 2001 Accent GL 1.6L Automatic.
Yesterday it started acting up on the freeway. I was driving about 50 during traffic hour when it started revving. I got off the freeway and moved to 35mph on surface streets, the revving continued at lower speeds but much worse (4-5k rpms going 10-15mpg). Doesn't seem to do it in idle or park. If i shut the car off it'll drive fine for a while then start acting up but when I was driving, after awhile, it did return to normal.
What could cause the problem? TPS? Transmission? Sensor of some sort?
View 5 Replies
I just bought a 2004 prius with 187000 miles for $2,500 and it has a triangle with an exclamation point in it and check engine light on and another symbol on the dash. When I take off it revs like the transmission is slipping and it only will get up to about 50 mph.
View 17 Replies
Transmission on 04 V8 phaeton is slipping between first & second gears. transmission repair $4-10K. thought of just taking out the first gear via reprogramming (had a jag where you could do that for snow/ice conditions). do yo think taking out the first gear will cause extra wear & tear on the drive train? The first gear seems to be very short.
View 16 Replies
I have a 2006 Prius with 103k miles that runs and drives great but sometimes with no warning will display the red triangle and check engine light and seem to slip out of gear. All I can do is coast to a safe spot to reset the codes. Once I reset the code it runs fine again.
View 2 Replies
Transmission won't go into drive until I give it gas and then hard shift between 1&2 then a little slipping when I get on it in higher speeds , fluid and filter brand new, threw a speed sensor so code I replaced with new but no change, don't know what to do and can't find out why speed sensor code went off changed but didn't fix? Can't drive truck!!!
View 3 Replies
I have a 2004 4x4 with 305K on it. Never changed the transmission fluid and I think its slipping a bit.
Beentold that I should not change the fluid because the new fluid would somehow damage something and to just not worry about it.
So OK to change the fluid or not?
View 6 Replies
