Santa FE SM (2001-06) :: 2003 2.7L - Airbag Light Won't Clear And Stays On
Jan 3, 2013
2003 Santa Fe 2.7L, 2WD, 118K Mi.
This is a recurring problem. Air Bag light comes on and stays on. Seems to always get triggered by someone sitting in the front passenger seat AND the right side rear passenger seat. First couple of times I was able to clear it by removing the neg. battery terminal for 30 to 45 min. Then it stayed on and didn't clear. I took it to the dealership and they said they cleared it by cycling the connector behind the glovebox. It has been ok for a long time until yesterday night when I had 5 people in the car. Now this morning the "Air Bag" light is on and won't clear. I tried disconnecting the neg. battery terminal because it was easy to do but no luck. I have checked the connectors under the passenger seat thinking someone is bumping a connector with their feet but all connectors seem ok.
View 3 Replies
Advertisement
2003 Santa Fe GLS 120K mi. 2wd, 2.7L, AT.
Been having for some time an intermittent problem where the air bag light will come on and not clear. I can clear it sometimes by removing the neg. batt. term. and letting it sit for a few minutes. The "air bag" light always seems to come on when someone sits in the passenger seat. The dealer reported a trouble code of "B1382-- PSAB harness improper pin tension" They said that they re-seated a connector and it was good to go. Now the "air bag" light is on again. Does the description refer to the pin tension in a connector? which connector does it refer to and can I just tighten up the female part of the connector such that the male pin makes better contact? Is it the yellow connector under the seat?
View 7 Replies
2004 Santa fe- air bag light stays on-
Any trouble shooting protocol to follow?
View 14 Replies
After spilling coffee down emergency brake lever the airbag light intermittently stays on. OBD showed no codes.
Found a couple of recalls that deal with airbag problems. One messed with the wiring harness under neath both front seats. The old wires hung down to low. The 2nd added a cover to not allow liquid to get on the connector/airbag electronics. The airbag electronics connector is directly below the emergency handbrake lever.
My nephews 2002 had the carpet extended over the connector/airbag electronics and that was suppose to protect the connector from getting wet.
Found sticky coffee on connector/airbag electronics.
Used screw driver to pry up on console tray. Then removed 3 screws on both side of console. Disconnected battery then used contact cleaner on connector and electronic module. Took plastic lid from 42oz round container of oatmeal and used double side tape to secure over connector/electronic module.
Airbag light is off and connector/airbag electronics has better protection from spills.
View 1 Replies
I bought a used 2005 Elantra a couple years ago for my teenagers. The airbag light came on, so I took it to the dealer. The code they found is B1448. They said they need to replace the passenger side seat cushion module. (I think the value of the whole car can't be much more than that!).
View 2 Replies
The air bag light stays on & the blower in not working. I checked the fuses good.
View 2 Replies
I have a 2001 Ranger 4.0L 4x4 with 101,000 miles on it. I went to go get in it the other day and the Air Bag Light came on out of the blue. I've drove it some since and it is still on. The light blinks for about 1 minute upon startup and then stays on solid for the remainder of the trip. What would make this come on so suddenly and is there anything I can do/check?
View 3 Replies
New, to me, 2002 F-150 that developed heater core leak. I tore down the dash and replaced the heater core and reassembled everything.
All is good except that now the air bag light on the instrument cluster stays on continuously. There is no blinking...just a solid light that stays on.
I must have missed a connection, though I'm at a loss because I thought I got everything. Is there an obvious (though not obvious to me) connector that I should be looking for?
View 1 Replies
My 2002 Hyundai Santa Fe 2.7L V6 AWD failed to start a week ago. After towing to my neighborhood repair shop, it was diagnosed as a faulty ECM based on code P560 (System Voltage Problem). They replaced the ECM (along with relay) with a used one with the exact same part#. After that, the car was started and run OK but Check Engine Light stays on all the time. The codes displayed are:
P1529 TCU MIL Request Signal
P0501 VSS Range Performance
I was told that this is caused by the fact that each ECM is VIN/PIN locked. The replacing ECM was used in another car before and was locked with a different VIN thus cannot communicate with some components of the current car.
My questions are:
Can this used ECM be unlocked and relocked with a new VIN/PIN? If so, does it require the previous VIN/PIN to unlock? Most likely the previous VIN/PIN is no longer available.
Does this service require the presence of the car or can it be done with the ECM alone? Do keys need to be re-registered? The car starts fine currently.
View 11 Replies
Ok I just bought my 2004 santa Fe last Saturday. I washed and detailed the entire car even washed under the hood with the washer from the car wash like I have done many times before on other cars. On sunday the air bag light came on. Could have this been from me washing under the hood or is there a true problem. How do I check the air bag system and how can I reset the light.
View 6 Replies
I have a 2001 Chevy S10 4.3L. The CHECK GAUGES light stays on, and the oil pressure gauge stays at 0. The oil is full, and the engine runs and sounds fine. I drove it about 5 miles with no change. Up until now, the gauge has worked normally. Could it be the sending unit?
View 2 Replies
My 2001 F150 has the ABS light on. I can startup and it runs thru the continuity test, light off, in park, no problem. Push on the brake pedal, no problem. Put it in gear and the light comes on, before you start to roll. Should mean its not the speed pickups, i checked them for ohms and 5 volt supply to each. I ran the scanner and got P0703 on the extended codes.
That normally means bad pressure switch on the brake booster. I knew that would effect cruise control and external leaks can be a problem, but could that be related to the 703 code ? Both "brake" related ? I am tempted to buy a switch and install. I do have the factory recall harness on the switch. And check for continuity thru the switch. Has continuity, but only a few ohms, not sure what it should be.
View 9 Replies
I have 228,000 miles on my wonderful GX 470. Love it!! Very Few Problems. My Airbag Light on the Cluster stays ON sometimes and sometimes is OFF. There is no consistency. I will be driving and the light will come ON and stays ON. And then, it will stay OFF for few drives. Why the light would sometimes come ON?
View 3 Replies
[URL]......................................................................
After I could not figure why I was having the alarm light I drove the car to a mechanic, explained my sleepless nights and many hours of problem analysis, and then the mechanic took his code reader, connected to the OBD car port, made a few clicks, and charged me $45 and then sent me off. The alarm light has not been back since - it blinks as expected when I start the car.
On my further research I have found that VW airbag light will come on if you check airbag with your ghetto OBD code reader - exactly what I had read! It registers "high resistance", and must be reset by someone with a qualified code reader!
View 3 Replies
I have a check engine and air bag light that stays on. I was told if I dis-connect the battery, it will clear the codes. I need an inspection and I'm short of time.
View 1 Replies
Over the past 2 days I drove without the center of the steering wheel in place because I was in the middle of removing the turn signal arm - I had to wait until I found a T55 torque bit for removing the steering nut. Anyway, the I installed a new turn-signal arm and re-assembled the steering wheel and such. Even after reconnecting the airbag I'm still getting an airbag light on my instrument cluster. Is this a fault code that needs to be reset from the dealer? I know I plugged all the connectors correctly - only one way to do it.
View 1 Replies
long time ago i had to change master cylinder and the calipers on the fronts and the break fluid well i decided to test it out and see if they were working fter i was done with them then the light on the dash came on i thought its because the floating thing in the master cylinder was not floating which was not the case i dont think its the sensor i also lost my emergency break shoes never replaced em
01 f250 2wd 7.3l v8 diesel straight pipe 310,xxx
View 10 Replies
I have a 2008 Toyota Camry that have a airbag light that stays on after I start my car and drive. However my passenger airbag stays off and the passenger seatbelt light blinks even when there's nobody sitting in the seat. When Someone does sit in the passenger seat with a seatbelt on, the light continues to blink along with the Airbag light showing off. How can I resolve this without going to the dealership?
View 2 Replies
I have a 2006 Sonata GL. The airbag light on the dashboard stays off when I turn the key on and starting the engine, I checked fuses of airbag they were good. where is the problem?
View 10 Replies
Got in my car yesterday and the airbag light on the dash stays on and a airbag fault message pops up in screen next to the speedo. What could be the problem?
View 3 Replies
I pulled my CD player and put it back in and now my air bag light won't go out when it self tests. It blinks for a while then stays on steady. What's up with that -- I thought I was having enough problems with the CD player as it was?
View 14 Replies
