Santa FE SM (2001-06) :: 2002 Turbo Diesel Engine Cuts Out Suddenly
Aug 11, 2012
Its a 2002 Santa Fe 2.0 turbo diesel. When driving the engine will suddenly cut out. Its as though the ignition has been turned off, there is no hesitation or warning, it just shuts down.
This is what has been done so far: New high pressure fuel pump fitted by main dealer in June. My mechanic has fitted a new high pressure fuel sensor, new low pressure fuel pump (at rear by fuel tank), changed relays around, checked all fuel injectors (found in good condition) and checked various connection plugs and wiring. At motorway speeds the engine will not cut, its only at lower speeds. When it cuts the EML comes on with a 'Fuel Pressure Fault' code. Sometimes the light doesn't come on. Sometimes the light comes on but will go out the next day. When the engine cuts out you have to wait 20 seconds before it will re-start. If you try to start before this the engine will only turn over without firing. The car has only done 79000 miles. The main dealer gave up and said they don't know where the fault is because the code is not specific enough.
View 6 Replies
Advertisement
I am new here just bought a santa fe 2002 2.4 model and its playing up it will start run for a few mins then die and wont start again for a while. the crank sensor has been renewed as has the cam position sensor the fuel pump makes the normal noise so fuel is getting threw the only other symptom is when it cuts out and wont start i check both ignition coils and neither are sparking yet there is power to both, all fuses are fine .
View 21 Replies
I have a 2006 2.4l petrol (and an LPG gas system) model that is becoming impossible to drive due to the engine cutting out. I had all the plugs changed an injector thingy and some leads last week when it first started to cut.
At first we thought it was the gas system because it was running on gas the first few times it died. I've just taken it out to road test the petrol (with the gas turned off) and it did it again. It happens mostly when at idle (traffic lights) but has also cutout twice at speed on the main road. You can't restart it, it turns over for ever and doesn't fire up...but I did bump start it once. The next day it will start as if nothing was wrong. I haven't been able to access whether any lamps come on (mainly due to being in panic mode at some junction).
So my questions to the experts are based on the 3 main culprits mentioned elsewhere:
Alarm or immobiliser.- is there any way to disable the alarm/immobiliser so I can check if it is that?
Fuel and fuel pressure systems. - can I assume that because it does it on both fuel types that it isn't fuel filter/pressure pump like?
Cam sensor. - I have a mechanic friend who repairs everyone's car at work (600+ people and I think he's mended a good half of those)..is the fitting of a cam sensor only doable with some strange specialist tuning/timing equipment or is it a simple case of unscrew, replace and good is?
View 7 Replies
My beloved Hyundai Santa Fe,2006 model's engine light came up. The engine starts and than about 10 seconds after cuts out straight away. What to do. I have always taken care of this car and being serviced well.
View 23 Replies
Cruising down the highway, my 2001 Santa Fe engine suddenly cut out. Would crank, but not fire. Not hearing a sound from the back when I flipped on the key, suspected the fuel pump, which I replaced. No go.
I'd pressed the fuel pump reset switch under the hood - checked it again. Should the switch, when it's pressed, stay in a locked position, like when you do a reset on a GFCI electrical outlet? Or is it normal for it to have the up/down 'play' in it?
Also noticed a strange buzzing on the other side of the engine compartment -- was the unit (don't know what it's called) that the throttle cable feeds into - hooks onto a pulley. The buzzing was intermittent and inconsistent, but it was happening with just the power switch on.
Oh, and did replace the fuel pump fuse, too. While it's at 280.000 miles, not quite ready to give up on 'er yet!
View 1 Replies
I just got a used Hyundai Santa Fe (2004). I was so excited until about 50 miles of driving it. Here is what happened:
I was idling at about 20 mph when all of a sudden the engine jumped (a little bit) - the RPM went down to 0 and the check engine light came on. I pulled to the side of the road and put it in park - then the car went back to normal like nothing happened, it didnt stall all the way. I was concerned and took it back to the dealership and they did a diagnostic test on it and it came back negative, nothing was wrong with it.
My boyfriend was driving up north with it and it happened to him, this time, it stalled. He said that the engine jumps a bit- but all of the lights go on on the dash. I remember it smelling pretty hot when I opened the hood before with it happened the first time, so I asked him to open the hood. He said it did smell hot. He checked the coolant and it was empty. It looks like there is fluid in it from the outside, but that was just the line that previous fluids had. He put coolant in (not in the actual radiator, but in the place where coolant goes) and it still stalled. I didn't want him to drive it anymore for fear of something worse happening, so there it sits.
Is this something that happens with most cars, or this kind of car? I am kicking myself for not purchasing the extended warranty, but I didn't have the extra cash to add over 1k to the price. Could it be just the coolant needing to go into the radiator? Do Santa Fe's typically shut down before they overheat? I was doing some research and it seems that cars stall because of either the fuel system or electrical system.
View 5 Replies
My 1989 740 Turbo wagon cuts out while I'm driving. It only ever does it at about the point when the engine first reaches its normal operating temperature. It can cut out while idling or when driving at normal speed. I'm not sure if it's related to temperature or time (it usually cuts out at about the 5-8 minute mark), or if this is simply coincidental. It does it nearly every day.
It's definitely caused by the fuel pump relay cutting out. I've replaced this already, with no improvement. Something is causing the relay to suddenly lose an input.
Once cut, it takes a few quick flicks of the key to the START position for the fuel pump relay to receive power again. It will then drive faultlessly for the rest of the day. Although, if allowed to sit and cool for many hours, it will sometimes do this again.
View 7 Replies
Suddenly today, I get a "Check Engine" light while driving. Scangauge II says it's a P1430 error. I found two different suggestions, but where these are located on the car.
P1430-Electric Air Pump secondary Failure
P1430 -Vacuum Sensor for Adsorber and Catalyst System Circuit Malfunction
View 13 Replies
Looking for a picture/location etc of where the crank position sensor is in the engine compartment? It seems to be a common issue where the engine stalls during driving and you pull over and are able to restart the vehicle and go on about your business.
My 02 has over 160k in miles and so am believing this part is going out according to what I've read here. My problem before was somehow the 2wire plug to the alternator worked it's way off and got that taken care of and so now while my wife is driving, it'll occasionally stall. Did a load test on the battery and it's good. Didn't check the charging system but not sure it needs to be tested.
By the way, have ran the diagnostics with the actron pocket obdII and no error codes came up and all looked good scrolling through everything.
View 5 Replies
2002 2.7L. Engine seized. Bought a replacement also from a 2002. Tried to start today and no spark. I just replaced the physically broken crank position sensor. That seemed like it would be an obvious and easy fix, but still no spark. The broken sensor had frayed/shorted wires. Could that have damaged the PCM /ECU? There is a 2003 Santa Fe at U-Pull-It that was running when it came in. Will the PCM from that work? I am running out of time. I have to have this running before I leave on a flight tomorrow night. I do have a code reader (if I can find it) but I can't imaging it would have any codes if it hasn't started since I had the battery out. Not sure how that works.
View 4 Replies
I am struggling to find out any information regarding a droning noise coming from my engine. It generally does it when its just ticking over and disappears when accelerating.
View 4 Replies
2002 hyundai santa fe GL2 4 Cyl Automatic ... I noticed that there is a super heavy motorcycle-ish loud noise from my engine when I put it in drive. When it's idle or in reverse or neutral the problem does not occur. but then when I switch it to drive, uber loud noise...which gets louder when I step on the gas.
What has been done so far - replaced spark plugs, ignition coils and plug wires so far...also changed the oil, no fix.
No check engine light at all.....however the battery did die due to someone leaving a light on for days So I am unable to get any code readings.
View 5 Replies
Those are the codes I'm getting. P0340, P1166 and P1167
Here's the story. Engine running flat under load. Easy acceleration is ok, but merging onto the turnpike causes a noticeable loss of power. Replaced the cam sensor, cleared the codes, ran ok for a day. Same codes came back, same flat performance.
Returned the cam sensor with another new one to make sure it wasn't a dud out of the box. Advance Auto Parts is awesome - replaced it no questions asked.
Installed the new cam sensor, cleared the codes. Ran great for a day, then the same symptoms came back, with the same codes. I'm thinking it might be the ECU? If it is, how expensive are they? And do they have to be programmed by the dealer?
This is a 2002 Santa Fe 2.7l automatic with around 147k miles on it.
View 25 Replies
So for about two months now, every time I get gas, the pump cuts off almost immediately after i start pumping. After that, I am able to pump about a second or two before the pump shuts off. It recently has started spitting gas back out of the tank (I'm assuming it's the gas I just pumped into it being spit out). I'm not sure what is wrong. I have not gotten into an accident, there is no smell of gas in the car, the gauge still works fine, and no check engine light on.
View 3 Replies
My 2002 Hyundai Santa Fe 2.7L V6 AWD failed to start a week ago. After towing to my neighborhood repair shop, it was diagnosed as a faulty ECM based on code P560 (System Voltage Problem). They replaced the ECM (along with relay) with a used one with the exact same part#. After that, the car was started and run OK but Check Engine Light stays on all the time. The codes displayed are:
P1529 TCU MIL Request Signal
P0501 VSS Range Performance
I was told that this is caused by the fact that each ECM is VIN/PIN locked. The replacing ECM was used in another car before and was locked with a different VIN thus cannot communicate with some components of the current car.
My questions are:
Can this used ECM be unlocked and relocked with a new VIN/PIN? If so, does it require the previous VIN/PIN to unlock? Most likely the previous VIN/PIN is no longer available.
Does this service require the presence of the car or can it be done with the ECM alone? Do keys need to be re-registered? The car starts fine currently.
View 11 Replies
Last night i noticed a slight hesitation during acceleration. Today i had driven around in town for awhile and did not notice any hesitation. When i got onto the interstate I pushed down the peddle to pass someone and it did nothing, I let off the gas and back on and the car bucked pretty bad. All the way home it has issues when I pressed on the gas but did fine at cruising speed. I would think a fuel filter would have been a slow progression issue so I am thinking maybe it is a sensor. I sprayed carb cleaner around vacuum hoses today and did not notice any surge so I think I eliminated a vacuum issue.
2004 Santa Fe 2.7 149k
View 5 Replies
Never had any issues with it before and was working fine on a trip a couple of weeks ago. On the way home I had it on, we stopped to get some food, and then when we started up again cruise control wouldn't turn on at all. I tried turning on and then setting, but nothing happened so I don't think it's the light. Checked the fuse and it looks fine (no noticeable distortion or break to the wire anyway) and brake lights all work.
View 8 Replies
Here's my problem I have a 02 ranger 3.0 with some problems and I need to bounce it off some one with knowledge.
1. starting and normal running fine / ok .
2. In drive at 2200 rpm t0 2800 rpm the engine is sluggish and at night the head lights dim about 30%
3. Sometimes the battery light will turn on during this problem.
4. The only code is for a air leak fuel / evap system .
5. Above 4200 -4500 rpm the engine staggers or cuts out.
Parts changed coil: / ECM, Fuel pump and filter, plugs & wires several relays and alternator.
Inspection: Checked most ground and common grounds, looked for damaged, cut worn an burnt wires or worn harness plug / connectors .
View 1 Replies
So I was driving home from work yesterday and the car just cuts off at the light. I try to start it and it only turns over, so I know its not the battery and the starter. I know there is a few threads on this but they are older ones and was just wanted to know how many of you guys have had to replace the fuel pump. I only have 40k on the car .
View 11 Replies
So, my brother has an 01' VW Jetta 2.8 VR6 with a 120k miles on it. He was recently driving around 50mph when the engine cut out, he lost all power and all the lights on the dash came on. He didn't get any loud bang when it happened, it just cut out. He tried to restart the car but heard the starter try and nothing else.
He got it towed to a garage who said they suspected it might be a timing chain but they couldn't say for sure until they started poking around. He doesn't recall getting the loud "marbles in an" noise when the chain is about to go. They were quoting around $4k to replace the engine. Being as my brother is a poor student this isn't something he can do, plus he'd already replaced the radiator, tires and all that and I want to verify what is wrong with it.
View 24 Replies
My 2012 V6 Santa Fe turned itself off on the freeway today, only 3500 miles,
was in stop and go traffic, stopped and the car just turned off! No shaking or anything. Turned back on (so its not the battery, and YES it had plenty of gas), went about 100 ft and turned off again! Took into the dealer, they won't have an answer until Monday.
View 6 Replies
