I have a low beam that just isn't working at all on the right side. I changed the bulb 3 times now, confirmed I had the right dual beam bulb (Sylvania 9003) and still the same result. The low beam doesn't work on the right side, but the high beam works.
2002 Hyundai Santa Fe GL 2.4 CYL ...
Low beams don't work. The fuses are fine (under the dash, and in the engine compartment) and the bulbs look good. The fact that both went out at the same time has me wondering. One post on this forum for something not related mentioned a headlight relay behind the fuse panel?
View 9 RepliesI am having an issue with the passenger side low beam headlight on a stock 02 Passat. Bulb is fine but after testing confirmed no juice to that side. Drivers side works fine as do the running lights on both sides. Fuse is fine and after an afternoon of looking at it I am about ready to beat my head up against the wall. Only other clue is the cig lighter went out about (not sure if the exact) same time.
View 2 RepliesThis morning a dash light informed me a headlight bulb was out. It was my DTR light on the passenger side.
I purchased Sylvania H7 high intensity, installed it and it failed to work properly. Daytime light on only drivers side works.
High Beam on , both lights works.
I checked my manual and it said to check fuse in the 5 slot on the driver side dash/door panel and there actually is no fuse in there. I checked the driver side and there was no fuse there either.
I replaced my driver side bulb last year and it took 5 mins....i am already 4 hours into this!
I have a strange problem. My driver side low beam dont work and my right side high beam dont work. Try different relay (switching), check fuse, bulb etc. Also in my dashboard the right green arrow for the flasher always still on(solid).
If I activate (with the control arm) the right turn flasher the flasher light blink in the dash board and my outside flasher bulb flash but my left high beam also blinking in the same time!
02 Santa Fe 2.7L AWD
I noticed the other day while out on the property that the rear wheels were not pulling and after a little investigation found that my AWD has now become a FWD. I checked the transmission fluid (not sure if the trans fluid even goes to the transfer case or not) and it was about a quart low but clean and not burnt. Topped the fluids off and still only have the front wheels pulling.
I was going to pull the rear diff plug and see what it looked like in there but I have a feeling it's probably froze in there and the bolt may break taking it off. I may have to wait till I can dedicate a weekend to working on it before I start tearing anything apart. The drive train is flawless and has been minimal effort since we purchased the vehicle new and all the sudden without warning this is happening.
My daughters 02 santa fe's driver rear door will not open. The power door Can't figure out how to get it open so I can take the door panel off to find out what is wrong?
View 6 RepliesI have a Santa Fe 2001, 2.0 Crdi.
My low beam have shut down. I have checked the fuse for right and left, and as I can see, it's the same fuse as for the high beam ...
Is there any known problems regarding this faults ? Of course, the bulbs are ok ...
I'm driving a 2002 Hyundai Santa Fe with 83,000 miles on it.
Had it in the shop (dealer) a couple of weeks back for some work on the transmission. While there, I had the dealer perform the work for Recall 090 (corrosion of rear trailing arm). Since that time, there has been a clicking noise coming from what I believe to be the right rear wheel (it is definitely coming from the right [passenger] side). The noise sounds like metal rubbing up against metal, for lack of a better description. The noise is directly correlated to wheel rotation... the faster I drive the vehicle, the more frequently it occurs; the slower I drive, the less frequently it occurs.
The noise is very noticeable, and I am certain that it did not exist prior to my latest visit to the dealer. I am considering taking the vehicle to an independent mechanic this time, as the dealer repeatedly tells me that they aren't to blame, or I end up leaving the dealership with more problems than I arrived with.
A few weeks ago my passenger side low-beam failed to come on during a short road trip. After a failed attempt to find a replacement at 9PM I had no choice but to continue on my way, about an hour later, as I was driving along, it suddenly came back on with no trouble since. I haven't touched any wires or fuses.
View 3 RepliesI have a short somewhere in my 2007 Hyundai Santa Fe. I got in one night and had no lights. Found a fuse that was blown and thought i solved the problem. The left Low Beam is still out.All other lights work. I used a light tester and I get power on both sides LH Low beam fuse where on the right side low beam and all other fuses I only get power on one side (Light Lights up). The low Beam left relay is same way. I get power in center of relay where I don't get it power in center on right low beam relay. I have switch all bulbs. Even switched entire light assembly with the right side thinking short could be there but the left side low Beam still has no power to bulb and same short in fuse and relay. So somewhere from fuse box under hood to the Multifunction Switch is a short and is it possible for an average DIY to fix this. Is Multifunction Switch easy to replace and would that be the cause or is it inside tightly taped wire bundle or something else I am missing.
View 8 RepliesI have a 2002 Camry. The low beam headlights stopped working last night. All the other lights work. High beam, driving lights, marker/park lights. I checked all the fuses. I changed the headlight relay. Still nothing. Could it be the headlight switch on the steering column? Trying to do more research before I replace it.
View 2 RepliesDrivers side low beam not working. The bulb is fine saying something was tapped in, therefore, can't warranty headlight. Guy said the light gets power just light won't work. Can Vagcom fix this? Dealer wants $125 for inspection plus another $676 for parts and labor.
View 19 RepliesSo, last night I go to turn on the high beams on my 2002 Passat (pushing the bar on the left of the steering column forward) ... and nothing happens. The bar clicks into place as it should, but no high beams. The little indicator light on the dashboard does not come on, either.
I try to flash my high beams, and that DOES work. The brights come on, and the little indicator lights up when the beams engage.
So ... I know it's not a fuse, since the lights are actually functioning. What part/switch/relay/whatever needs to be replaced to get this fixed? I feel like this would involve me needing to pull apart the mechanism in the steering column, but I hope not ...
I have a 2005 Yukon Denali XL. The low beam headlight on the driver's side will not work. I replaced the bulb. Still won't come on. We had just driven the truck up the Dalton highway (The rough road seen on Ice Road Truckers).The passenger side low beam works fine, and all the other lights work fine.
View 1 RepliesI'm trying to troubleshoot an odd issue.
When the lever is in low beam mode I have no headlights or fog lights. (parking lights fine.)
When the lever is forward in high beam mode I have no headlights or fog lights. (parking lights fine.)
But if I hold the lever back in "fash the high beam" mode the high beams turn on. This got me home last night, but I don't know where to start looking for the issue?
Faulty relay? Faulty switch? Something else?
(2004 Santa Fe)
My high beam indicator in my dash is not working, I pulled the bulb and checked it and it is fine, so I did a voltage test and I am only getting 1.5 volts at the light terminals, I should be getting 12 volts. Is there a wiring diagram someone has so i can see if it is the dash display itself or that I could trace back to the switch to see if it is something in the headlight switch? or What it could possibly be. other than that, everything else works.
View 3 RepliesMy driver side low beam is out. I replaced the bulb and it is still out. I got a second new bulb, replaced it, and low beam still does not work. The high beam works, the turn signal, and fog lamps work, just not the low beam. the passenger side is fine. I checked the fuses and they are not burned out.
View 1 RepliesMy driver side low beam is not working. I checked the bulb and it's fine. I also checked the fuse and it's fine. Took it to the dealer and they said could be a few hours of labour to determine where the problem is in the wiring.
View 8 RepliesI have a 2006 Prius that I purchased with no upgrade on the headlights. There was an upgrade available for high intensity lights, but, I didn't get them. The low beam on the passenger side headlight just stopped working. Two questions:
1. I was just told by the Toyota dealership that to replace the headlight, the entire front end of the car would need to be dropped. They just told me that with them supplying the bulbs, the cost would be about $250 plus tax. If I supply the bulbs, only about $200 plus tax. My owners manual indicates that this is a do-it-yourself project. Is this true or is the dealership trying to make money off of me?
2. When I do replace the lights, I would like to put in something that would put out more light than what I have now. I have been told to be careful because many replacement lights throw off so much heat that the housing around the bulb could melt. Also, I have read that some of these replacement bulbs have a very short working lifetime of 1-2 years. Obviously, I would want to keep away from them.
i have a 2005 prius got it 2 years ago when it hade 120,000 miles now has 211,000 runs good but last week on my driver side the tail light and low beam light stopped working at the same time the high beam works fine what could it be?
View 19 Replies