SC/SL/SW :: 1999 - Wipers Becoming Intermittent In Operation
Aug 20, 2014
The wipers on my '99 SW1 are becoming intermittent in operation. The intermittent speeds change, the set speeds work, but all operations are not stopping when turned off. They do turn off when I turn the ignition off. I think it is the multiswtch on the steering column, but haven't done much troubleshooting yet.
View 4 Replies
Advertisement
I'm trying to figure out what could be the reason why I have Intermittent wiper operation on this truck. It's a 99 Chevy 1500 4.8 4X4. It's almost like the wipers have a mind of their own. Sometimes working properly but most often not operating when needed the most. Is this one of the set-ups that has a pc board with a bad/cold solder connection? I'm sure that one of the regulars here has come across this at some time or another and found it to be a simple fix.
View 3 Replies
2010 SEL with projector headlights. Dash warning light comes on and passenger side headlights stop working - both high and low beam. Then light will go out and headlights start working. Jumps back forth and during the day between working and not working.
View 6 Replies
I just bought a used 2011 Santa Fe. Two weeks ago, the right window stopped working. Neither the left or right switch had any effect. All other windows worked. A few minutes later it was ok and has been since. Today the left window did the same thing; was inop for a while then ok.
View 2 Replies
2003 Trailblazer 4.2... Two times now, like every other start oil pressure gauge is 0. The engine runs fine, oil level is fine, thinking of replacing pressure switch, ie sending unit after checking connections of course
. Was curious this is a simulated pressure gauge as I read on some other posts?
Supposedly the gauge unlike the stepper motor I need to replace for the speedometer is actually voltage controlled by a circuit board in the cluster.
View 19 Replies
2000 Rodeo, wipers work when on, no intermittent control. They just stop where ever they are if you swtich to intermittent control. I've heard this is a module above the glove box that costs about $200. Is it parts on the board in the module that fail so the module has to be replaced, or can I open the module, resolder grounds etc and restore operation? If not, anywhere less expensive than the dealer to get a replacement module?
View 14 Replies
I have a 2001 Toyota Sequoia that started having problems with the intermittent setting on the wipers. It is now to the point that it runs just like the slow wiper setting with no delay, it also doesn't "park" the wipers when turned off. I found that with the ignition in ACC position the wipers work perfectly (intermittent works and wiper "parks" properly when turned off) but when the engine is running I only have a Low or High wiper speed and no "Parking". I have researched online and most say to replace switch or wiper motor but both work with engine off so I am wandering if it is being overpowered with the engine running.
View 4 Replies
2015 RX350 with Nav. Is there a way to disable the "auto" function of the intermittent wipers to gain manual control when in intermittent mode?. With the rain sensor and speed sensor, often even with the intermittent control at the fastest setting, the wipers don't swipe often enough. Especially when driving at slower speed or waiting at an intersection, the intermittent swipe takes so long that I must manually turn on the wiper to low speed. This makes no sense to me. Just because I'm driving slow or at an intersection, Lexus thinks I don't need clear vision?
This is the first vehicle with rain and speed sensing wipers and it will be my last. This is not only annoying it's a safety hazard.
Is there a user configurable setting to change this? Or is it something the dealer can disable?
View 8 Replies
I have a 2012 LS 460 and when I select intermittent wipers the wipers make 1 sweep and then nothing '
View 7 Replies
2008 rx400h issue with the intermittent wiper setting. I replaced the battery and now. The intermittent wipers are not working. I reset the windows, no issue there, but haven't seen any posts about battery replacement affecting wipers.
View 1 Replies
Okay, to start i've disconnected my rain sensor so i do not have auto wipers, instead the wipers are intermittent when in the first, AUTO, position. with that being said....
When I was driving and had the LOW wiper position selected (not AUTO) and the wiper speed dial set to (-) , when the car comes to a stop or is parked, the LOW wipers switch to intermittent where they will pause in the (-) dial setting, for about 2.5 seconds. if the dial is set to (+) you do not notice this happening as the wipers re-engage too quickly. and then once you start moving again, the wipers return to the LOW setting and run continuously.
Does it also happen when your rain sensor still works? My guess is it's a luxury function so when you are nto moving, less rain hits the water, and you don't have to deal with wipers on a drier windshield making the low squeegee noise.
View 9 Replies
The front intermittent wipers on my 2004 hyundai accent will start then stop half way,continue all the way in the same direction then return half way and finally park. I have replaced the wiper stork switch and wiper relay [blue one in engine bay fuse box]. What controls the intermittent function? is it the bcm? and where's located?. I also have 2000 accent and its fitted with an intermittent wiper relay p/n95240-33000. The '04 is not fitted with one. I have contacted Hyundai and they weren't support.
View 1 Replies
I have intermittent loss of the windshield wipers, AC/heater fan and lights (and the brake light is lit even with brake off). I can turn the bright lights on by pulling the lever. Other electronic things work- radio, inside lights, turn signals. Usually if I turn the car off and start over it goes away. Fuses appear ok. It's a VW Jetta 97 GLS with about 75K miles. where to start?
View 1 Replies
I have a 2001 f250 with a 7.3. What is the operation of the clutch fans on these trucks. Sometimes when pulling my camper and the truck downshifts it will roar like a sob. Other times I will hear it but like it is an electric fan. Then there are times you hear it and then the noise goes away. Can this fan be heat operated.
View 3 Replies
Turn wipers on and motor growls but wipers do not move, checked 30 amp fuse and it is good, all other functions of the multifunction switch are good.
View 2 Replies
I have a 99 f450 and the wipers work when not on. it's this an electrical issue or a bad wiper motor.
View 2 Replies
88 735il
No fan operation at what point on the gauge does the hi speed fan cut on? No fan operation with compressor on.
I have checked the fan works bypassed: Replaced the fan sensor and temp-2 sensor, coolant sensor works.
I have checked both relays hi and low both have voltage and fuses are good. It seems like the resistor maybe the issue I will check that today.
I never let the car heat up over 1/2 way which maybe why the hi speed fan does not come on unless bypassed. What value resistor is?
View 2 Replies
I have a F350 diesel which has recently had a new AC compressor, Now when I go to stop at a stop sign or slow down using brakes the wipers come on and swipe a time or two. I never noticed this before the new compressor was installed so I was wondering if something might have happened while installing compressor? Now I think stepping on the brakes makes the wipers come on, but not until the truck slows down and is just idling.
View 1 Replies
I've noticed lately that sometimes when I start the truck up that the wipers will cycle once. I do not have the courtesy wipe feature enabled and I'm pretty sure I'm not bumping the wiper/washer button. I like my truck but I've had more weird things go on with this truck than any other I've ever owned, I'm starting to think it's possessed. It's a 2013 F250XL with the 6.2 ....
View 14 Replies
s I drive my truck, every now and again the wipers turn on. Just once. Then are off again.
It's a '99 F-150 XLT. Is this the switch? other? little electrical gremlin?
View 4 Replies
Tried reset by holding while it went back, up, then down, then forward, still one touch operation does not work.
View 2 Replies