SC/SL/SW :: 1998 Saturn Will Not Start - Turn Over Fine But Will Not Fire
Mar 17, 2005
My daughter's 1998 Saturn S-series will not start. It will turn over fine but will not fire until I shoot some starter fluid down the intake. Then it fires up and runs fine. It consistently will not crank unless I shoot the starter fluid to it. I can hear the fuel pump prime up when I turn the switch on. The Saturn dealer says it may be the ECM but I have my doubts. The ECM will cost my $800 from Saturn.
View 14 Replies
Advertisement
Ii have a '98 sc2 and its been sitting in my yard for a while. It started out one day when i got in it, turned the key and then it turned over but wasn't starting. We hooked it to a computer and it showed no bad signal so we bought a new computer for my car and that didn't work either. We changed the coil packs and the crank sensor and still nothing.
View 2 Replies
I have a problem with my Durango whenever i drive my car it is fine and normal. When i get to where I am at and i try to start my car again it will just turn over like it wants to start but doesnt. I just recently started driving the car for about 4 days ago and it drove fine. Until yesterday i got to my shop and tried to start it.. it will just crank. I scanned it and it turned out i had a bad crankshaft sensor. I gone ahead and replace that and the car starts up fine. I drove it around town and then this morning drove it to work and when i tried to leave for lunch it did the same thing. It cranks but does not fire up. I scanned it.. and no codes. My dad was saying something like sometimes it has sparks going to the crank and sometimes it doesn't.
View 2 Replies
I have a 2003 Ford Ranger 4X4 4L AUTO. About once every 6 months it will not start. It cranks just fine but doesn't fire. After about 45 min. it start and runs great for an other 6 Months. I have replace the plugs, wires, distributor cap but it hasn't solved the problem. It has had this problem when it is cold and warmed up.
View 4 Replies
I have a 2003 Silverado 1500 V6 vin code x with 260000 miles, for about a week now in the morning when its damp out or when it has rained the truck won't start, it cranks fine but will not fire. once it sits for a few hours and everything drys up it fires right up with the first turn of the key.
View 3 Replies
My 2001 Accent GS (1.6L DOHC) wouldn't restart after a short 2 mile trip to a local store. The engine cranks fine but doesn't fire.
It has had a CEL issue for awhile and after it wouldn't start I checked the codes and got:
303
335
722
I replaced the Crank Position Sensor and Fuel Filter but it still just turns over.
I hear the fuel pump run when I turn the key on and I broke the fuel line and it is Pressurized, so I doubt it is a fuel issue.
The 722 code indicates the output speed sensor has an issue. Need to know definitively if that sensor is completely shot could this prevent the ECU from firing the engine?
I have had this car since it was brand new and I'd like to keep it going a little longer.
View 5 Replies
My girlfriend has a 2003 f150 4.6lt pick up its a great truck most of the time. Problem is when the temp gets in the neg double digits it becomes very hard to start it cranks fine but doesnt want to fire. When it does fire it might stall a few times before it stays running. The last cold snap we had I replaced the battery and in the summer the starter got changed. I have heard that this model of truck are known for hard cold starts. I am just wondering if this is true and any other thing besides block heater. It is strange that my 89 gm pickup will start no matter what temp and I'm having problems with the newer truck.
View 1 Replies
Camry 2002 LE (4 cyl Auto), 140K mi
This morning, for the first time I can recall, the car would not start right away. Had been sitting in the garage for 2+ days. Starter would crank just fine, but engine would not fire. No lites were left on overnite. Finally (after about 6+ attempts), engine started -- runs fine now.
Took it to TOY dealer. Their diagnosis: weak battery, alternator low output.Happy, had recently (6 mos) replaced battery after 4 years of use, so got a new battery N/C.TOY ran a charging system check and it shows "Alternator Condition: OK" (midway between shitty and great I recall).
Funny, but my first thought when it would not start was the fuel system (fuel pump) or dirty ignitors. I did ask my regular mechanic for an opinion, and he thinks it might indeed be the fuel pump -- perhaps a clogged filter.
View 2 Replies
My dad has a 99 F250 with a no start issue. Everything was starting and running fine one day. The next he gets a no start. Cranks fast and fine but wont fire up and start. He has a scangaugeII hooked up to it and his oil pressures and volts look fine. His tach moves when he is trying to start it. He checked the icp sensor and it had oil through it so he replaced it with a Ford part. Unplugged it and the scangauge pressure goes up but no start. He also replaced the ipr with a new Ford one just in case. He checked and is getting low pressure and high pressure oil.
I am having him check the fuel heater fuse #22 to make sure it is not blown. He had the block heater plugged in all night along with a battery charger to make sure they are topped off as well. We have gone through a couple of the checklists on this site for a no start condition but nothing has solved it yet. I think he is sitting at about 200k on the motor. No major issues or problems until now. He is currently also pulling the ICM to check it out as well. No codes are being thrown.
View 14 Replies
I recently caught up on some maintenance with my truck, changed the turbo pedestal seals, replaced both batteries, brakes, e-brake cable etc and installed new 10k hid headlights. its a single cab 250 with a 7.3 and zf6 4x4 with 133k. a couple days ago I turned on the headlights and the truck died, restarted no problem and would die the next 5 times I tried to turn them on, then it worked fine. yesterday I got in my truck to leave for work and got no wait to start light, no glow plug chatter, no fuel pump running. turns over just fine but no fire.
I got a ride to work and tried it when I got home, fired right up. I pulled the pCM, checked it out, no weird smells and my TS chip wasn't corroded or anything like that, worked fine. drove to 711 to get a 6 pack and it did the headlight thing again. I removed the HIDs because this all started after I installed them and reinstalled my silvanias and it didn't die when I turned them on. this morning went to leave for work, same no start condition. I disconnected both batteries for 30 seconds to reset anything and same problem. I was about ready to light it on fire this morning.
View 1 Replies
1998 F150 with 4.6L Windsor SOHC. I just completely rebuilt the engine including pistons, rings, timing chains (timing is good; compression @ 180 psi), 2 new coils, wires, plugs etc. and there's no fire at the plugs when I crank it. It turns over good but doesn't start. The fuel pump comes on and there's fuel up to the injectors. Before I disassembled the engine, it still ran good except for one piston. The 2 new coils, wires, plugs were replace before I rebuilt it. I was very thorough when re-installing the electrical etc... and triple checked it all after the engine not firing. Fuses are good. I know it's hard to trouble shoot without seeing the truck? The battery has been disconnected for months as I started a long time ago. Computer maybe?
View 6 Replies
My 1996 Chevrolet cavalier will not start. It sat for two months while I looked for a neutral safety switch. New switch is in and brand new battery, Car does turn over. It gets close but no luck. I put new gas in. I really need to get this running before the snow flies.
View 1 Replies
I have a 2004 Escape, 4x4, V6 with 116k on it. Recently it won't start until it's sat for a few hours. I'll drive it for a couple of days without a problem and then it will refuse to start. The Battery is strong, the starter is trying to turn it over but it won't fire up. I've seen several other posts with Escapes having this same issue but none have given a resolution. I'm figuring it may be the fuel filter, the fuel pump, or the computer control.
View 14 Replies
I have a 1995 ranger with a 4.0 it cranks just fine wont fire has alot of fuel spark it will crank and crack then it stop and acts like it is going to fire up and stops cranking... This thing has 253k on it...
View 4 Replies
I have a 2002 Saturn SC2, it starts fine and runs fine for about 10 minutes. At that time it shuts off and no fire is going to the plugs. I have replaced the ignition control module and it made no difference. Once the engine shut off, I immediately replaced the icm with a new one and still no fire to the plugs. Once the car sits for a while, it will restart and continue with its vicious cycle.
View 1 Replies
Will not start. Engine turns over fine. Have electric to lights, radio, everything but the fuel pump, coil and fuel gauge. Ignition switch and fuel pump check out okay. Checked fuses, okay. Vehicle has an add on after market remote start/security system, has been working fine for years.
View 1 Replies
RE: FORD PROBE GL (non-turbo). Last week suddenly car wouldn't start Thurs. night. Cranked but would not turn over. Heard click at ignition switch area when key turned to start position. (Although I could only hear one click from inside the vehicle with windows shut, I was told that clicks audible under the hood from standing outside.) Tried jump starting (from a good battery using proper connections) unsuccessfully, repeated tries several minutes apart, allowing longer and longer time to charge. About every third attempt, instead of cranking sounds, I would get silence, with only the click audible.
Temperatures decreased from approximately 50s to 20s when symptoms began.Battery is old but tests good/replace soon: 330+ CCA at 43 degrees, original rating CCA 530 (silver battery now at 7 years. Will replace, but garage did not have required size 56). At that point, the amps gauge read at the low end of the normal range (and today it read mid-way in the normal range).Had car towed to garage on Friday. Mechanic looked at on Saturday and decided it was the inertia switch, which he said had "tripped".I watched video for technicians on inertia switch but it shows on newer Fords. Mine is not located at the kick panel and does not have a red button on top. I am not certain from my experience whether the reset button would actually be in a different position when tripped or he merely surmised that is what had happened, despite my telling the shop manager that I had not so much as bumped a curb. Also, the trunk was not slammed or even opened prior to the car not starting.
Car presumably started fine at mechanic when they pulled it into the garage to put air in tires and back out to the lot, as well as when I started it to drive home on Sunday. However, on Tuesday it would not start. Just in case, I depressed inertia switch reset and tried cranking again several times, giving it some gas, until I was actually pumping it vigorously in desperation as a last resort (several seconds turning key each time), and on about the 5th try, the engine began to catch just as I was releasing the key. Reset the inertia switch one more time (just in case), and after a couple more attempts, it finally started, but when I was going in reverse to back out and then putting in gear to start out in first gear, for about 15 seconds total, I heard a bizarre loud, fairly high-pitched whistle/whine type of sound that seemed to come from under the hood coming through the central area of the dash where the radio is located.
Drove about 5 miles to my job, and about 2 hours later was able to start the car on the first try. Lately usually driven relatively short distances of 2-4 miles, with a longer drive of 11 miles broken up into 6 miles + 5 miles on the return trip the night before this started happening.
View 19 Replies
My 2006, 4.2 has been really erratically not starting. Turns over fine but will sometimes fire up and tries to run on maybe 2 cylinders, then stalls. Now it won't even do that, nothing. No check engine light or codes. Guess what the thing started up this morning 7 degrees out and running like a charm. Turned off and nothing again. Replaced relay for PCM ,no change, still no codes.
View 9 Replies
I have a 2000 Saturn with about 140,000 miles on it. This morning after driving a short distance (maybe 2blocks) to the local gym my car wouldn't start when I came out about an hour later. When I put the key in and give it the first turn to the "run" (think that is what it's labeled) position the dash lights headlights, ac, radio, etc all turn on fine, however when I try to turn it to "start" nothing happens. No noise, no clicking, nothing.
This is the second time this has happened to me, first time was roughly a month ago pretty much the exact same situation drove a short distance this time the car was only off for maybe 10-15 minutes and wouldn't start. However, that time when I went back to my car about 30 minutes later it started just fine, that was not the case this time.
After that first time I brought my car into the local shop to see what the problem was, the mechanic couldn't find anything wrong. Can't recall everything he said he checked (battery, starter, alternator if I recall) and said everything was good and the conclusion he came to is that I must have left a light on or something. Which I didn't, as it was in the middle of the day and my dome light is always set to off anyways and the headlights weren't on and the doors were all properly closed and what not.
Also, I had the battery and spark plugs replaced about a year ago and aside from that everything in my car seems to be working fine...
View 6 Replies
I have a 99 Saturn SL2/auto. Cylinder 1 will not fire. It has spark to the end of the plug. But the cylinder will not fire. No oil is getting on the plug it isn't fouling out. A brand new plug doesn't work at all. The cylinder is DEAD!
View 8 Replies
My daughters 2009 ford escape will turn over fine but won't start. Hooked up code reader and it read p0690. I am trying to get a feel for what this really is. It seems to me a spark or fuel issue but that is not part of that code from what've read.
View 1 Replies
