Let my brother borrow my 98 S-10 and before he even got home with it he called and said the brake light was on. I figured it was the emergency pedal was down a little. Said there were no leaks. Got it back today and the fluid level is way down. Filled, but the low pedal is still there. Can find no leaks. Also the ck engine light is on. May not be related. Didn't get a chance to ck code.
View 14 Replies1994 Ranger XLT 4.0 5spd 4WD 168,000 miles
the emergency brake will hold vehicle but pedal won't stay down. figured it would do the normal "ratchet" feel and sound.
also, i did a really dumb thing with 4wd. i will try to make a long story short. a few months ago when we had that snow storm and then another shortly after, i decided to lock my hubs but DID NOT engage the 4wd. my top speed was 55 in the weather going to work. i came home one night for a brief moment, shut truck off and went inside. i came right back out to go to my mom's house (not a focal point in story but she lives only three blocks away)
when i started my truck i noticed the 4wd light was on (4H, not "low range") could NOT get light to go out and 4wd does not work, engage or "disengage". (i know it's not engaged by the little bit of a test wheel slip on snow packed street)
not sure what to do. was told to check vacuum hoses but it's an electronic shift. what should my next plan of action be?
I went to adjust my Santa Fe's parking brake (pedal version) and am trying to troubleshoot. The pedal goes all the way to the floor, something like 11+ clicks....
I jacked up the rear end, pulled the tires off, rotated the drum so that I could access the adjusting nut and used a flat head screwdriver to rotate it all the way back to where it wouldn't rotate anymore. After that I clicked it ~5-7 clicks. Same process on each side.
Went to go test the pedal, still goes to the floor, same number of clicks, etc.
Tried to locate an adjusting nut for the pedal but cannot find one, if one exists. The fuse box sits perfectly in the way but I was able to view everything with a little bit of effort and still couldn't locate the mythical adjusting nut.
I know I did the adjustment on the rear brakes correctly so it's an issue with the pedal/cable/nut.
I have a 2004 Santa Fe with the 2.7L V6. There is a recurring issue where the ABS and Emergency Brake light come on, followed by the fuel gauge dropping to E, then all lights dimming until they go out. The car continues to run, but if you shut it off it won't start for about 30 minutes, then it start just fine with full power. The alternator and battery have been replaced twice in the last 10 months, most recently 3 days ago. The problem persists. I did find the right downstream O2 sensor to have broken wires which were causing a short. I replaced the O2 sensor and wiring harness, which cleared all engine codes, however the problem does still exist.
View 7 RepliesI have an 03 Gx 470, original owner, 220K miles. When I go on the brakes the emergency brake light comes on on intermittently, not all the time, even when driving along sometimes it just comes on.... Braking seems fine, don't feel any issues.
View 1 RepliesEmergency brake light, VSC, ABS, and (!) On, after 02 sensor replacement by local shop. I'm having trouble with my 2004 Prius. I have been having this issue shortly after having an 02 replacement. It has about 232,xxx miles and instantly I started having issues.
View 6 RepliesI just bought an '07 Prius with all the options except leather, and when I took my wife out to show her how it works, it didn't. The emergency brake light wouldn't go off and the shifter light on the dash would only go to neutral. We turned it off and on again (more than once) and finally the e. brake light went off and the zero showed up for speed and we could go. I'm wondering if there is some safety feature that won't let you engage to go until the e. brake is released. And if the light is on, the car thinks the e. brake is still engaged. Plausible? How do I fix it? Would this be the switch on the pedal?
View 6 RepliesThere are a few threads on a sticking parking brake resulting in the warning light remaining on. Mine has developed to a stage that it requires a toe under the foot pedal every time to silence the alarm.
I finally stuck my head in the footwell this morning to look at the mechanism, expecting to see a strained spring. However there was no spring in evidence and I saw that when the parking break is released, the cable remains with some free play above the contact point with the pedal: i.e. there is no tension on the cable when the pedal is released, there is about 15mm of "free cable", leaving the pedal almost "floppy".
Observations
1) The pedal has no spring to return to it's correct position. Based on self study guide SSP_277 this is not as it should be as on page 37 this discusses a spring mechanism in the pedal
2) I would image there should be tension in the cable even when released; I feel the rear mechanism requires inspection as there are springs there.
3) While the parking brake works fine, It has a lot more travel that it previously had. Thus something is worn, stuck, or the self adjusting mechanism is not working.
4) For the record, car has 110K miles, the temperature is above freezing, the behaviour is not weather dependent and the parking brake has been routinely used (2008 car).
5) My recollection from new is the parking brake was released with a significant spring action: quite abruptly.
From what I've been able to gather there is a proclivity in the 2004-2007 Prii for the emergency brake light switch to break resulting in the dash brake light staying on endlessly. Here is a diagram on page 4 (Powered by Google Docs) of the emergency brake system with the switch labelled and here is a picture of the switch itself (RockAuto Parts Catalog).
I've located my switch and found that one of the plastic side pins is broken off and the whole thing is swiveling around. The problem is that I can't figure out how to get it off so I can replace it with a new one. I don't want to go to the mechanic for something like this.
Also, some of the information I've seen says that I need to replace the entire emergency brake pedal assembly. That could run several hundred dollars and I'm not prepared to do that just so a silly light will go off.
I own a 2005 Toyota prius and when I turn on the car, all the lights on the dashboard turn on but when the e-brake won't turn on when I put the e-brake on.
View 8 RepliesI have a 2000 VW Jetta GL. A few weeks ago I noticed my charging light come on followed by abs and airbag lights. Which would mean that the alternator is not charging the battery. However I kept on driving and this light would go off. However when I hit a bump on the road this light goes off meaning that the battery is being charged by the alternator. I recently installed a sound system in the vehicle which worked without problems for a few weeks before I started having this problem. Since then I have changed the alternator, battery and taken out the sound system. I now have a 125 amp alternator instead of a 90 amp alternator. The charge light doesn't come on anymore after startup but the abs, airbag and emergency brake light with a beep is now occurring.
View 3 RepliesIf I make a right turn at anything above a snail's pace, my emergency brake light comes on and it chimes. Had the brakes checked and they are fine for now but since they are original, they will need to be replaced soon. The car has 50,000 miles. Recently had the cam sensor replaced and the dealership checked the car over.
View 6 RepliesI own a 04 Grand Cherokee and have recently had problems with my passenger side brake light. Now the light itself does work under normal running light conditions, but when I go to press the brake pedal it doesn't engage the bright brake light. Drivers side works fine and so do all my other lights, I replaced the bulb to no avail, and am now currently looking into replacing the bulb socket.
View 1 RepliesWas checking fuses for why my 3rd brake light and pedal adjustment switch does not work. Was also looking for a fuse to tie into so that a light in the cab floorboard will stay on when the headlights or marker lights are on... After trying several spots to no avail (finally putting it into the bright headlight fuse). I got the light to work.... But now my ABS light stays on!!! Also 3rd brake still not working...
View 1 RepliesOkay let me start by saying my car is APR Stage 1. The other day I was driving with my cruise control on and held in the accelerate button to speed up. After holding in the button for a couple seconds the check engine light and battery light flashed back and forth as if I changed some setting with the tune. Ever since that happened, if I turn the TCS off, the emergency brake light comes out and the error message 'check brake pads' is displayed on the MFI. Also, the weird part is that it's not just the light. The actual emergency brake is slightly on without pulling the handle. I can feel it when I accelerate. It's harder to get the car going. Once I turn the car off and leave it off for a few hours it goes back to normal. Why this is happening?
View 1 RepliesMy friend's Emergency Brake is tricky: It usually doesn't hold, but pops off again. Its as if the 'teeth' somewhere inside were worn or maybe a ratchet has been rounded.
View 3 RepliesMy 2007 Prius has started making an unusual sound. At first I thought it was some kind of pump or something, but now???
When I put on the emergency brake, the brake pedal or when I put the car in park or take it out of park and put it in D, it makes a "chuck chuck chuck" sound, not high pitched, but not a low sound either. It seems to be coming from under the hood on the left side. It sounds something like a belt slipping or a pump with a squeak maybe?
It does not appear to make this noise when simply depressing the brake while driving, so I'm not sure it's the same abs actuator issue.
Do you use Emergency Brake every time you Park, and why?
View 14 RepliesI just bought a 2001 1.8t passat and the emergency brake the other day stopped working. The button is pushed in all the way and will not come back out, so it does not click when the brake lever is pulled up and will come back down when let go of. The brakes do work when the lever is pulled however. Also, keeping the car in 1st gear while parked is alright? Even on a hill?
View 2 RepliesHad this issue on my first Touareg as well as the replacement. When you pull the emergency release handle (firmly and all the way) it doesn't fully release the brake. You realize this when the vehicle begins moving and you get the "Release Emergency Brake" message in the MFI.
They replaced the emergency brake assembly. The service rep told me before he returned the car to me that his tech was less than satisfied with the design of the hydraulic assembly and that he expected it to develop the issue again. He was right. Two weeks later the thing is sticking again.
The emergency brake doesn't hold on my truck. It's two-wheel-drive. Is there any way to adjust it?
View 4 Replies