I recently noticed that my 01 Rodeo is loud when starting out. It almost sounds like the air cleaner is off when I start off. I've looked everywhere and nothing is lose but it sounds loud. Is there a way to quiet this down or is it a characteristic of all Rodeo's...
View 3 RepliesThe air box on my 01 Rodeo almost sounds like there is no filter inside it. I've checked the box and their is a filter. Still when I give it the gas it has a very throaty sound....is this normal or is my air box missing a baffle or something.
View 3 RepliesEvery time I start this car there is a strong smell of gasoline. I've already checked for leaks and didn't find any. Could this be caused by the fuel canister in the rear of the vehicle this has gone bad?
View 2 Replies1999 Rodeo LS 3.2L V6 M/T 287K miles
It has been starting "harder" a few times per day over the last week. Sometimes it starts right up normally, quick crank and no gas. Other times it requires much more cranking and then a few taps of the pedal to start.
It seems to be happening more frequently over the past few days but it will always start.
I replaced the fuel pressure regulator and the fuel filter (external) along with the air filter, and that seemed to do it the first day, but then the occasional hard starting returned.
I also swapped positions of the fuel pressure relay and the heater relay just to see if maybe the pump relay was sticking intermittently, which I didn't think was happening since I can hear the fuel pump running when I turn the key before cranking the engine.
No hesitation while driving/accelerating, runs fine once started. Starts hard at different times during the day.
I'm planning to change the spark plugs this coming weekend just because they're due, but I don't expect that to cure this since it runs great once started and I have no CEL.
I have Holden Rodeo, am assuming these are very similar cars if not the same. Our 2004 Rodeo is having intermittent trouble starting, sometimes when the key is turned it is dead, no clicking noise, all lights on dash are on and engine light flashing. it goes from being dead to a short turning of engine, eventually it will turn over but may have trouble firing. the next time it will start perfectly.
View 10 RepliesWell its the coldest this SF has endured while in my barn. It was -23C last night or early this morning went we got up. -19C now but it doesn't warm up with a slight change sitting outside. I started it ok but these newer vehicles sure make a lot of whining and other noises when its this cold until they run for a minute they quiet down.
My old Grand Cherokee was a lot quieter even with near 300k on it it. But my wife's Jeep Compass a 2009 made enough noises as well. Both have synthetic oil in them. I just don't like hearing all that and wonder what its like for you that are in much colder climate with your SF since -30 to -40C is common in other parts of Canada in the Winter. Just curious because it cannot be good and the PS pump must be one of the complainers I am sure.
Any tips for keep rear tire wear to a minimum? Mine are starting to cup along the inner edge and are very noisy at 20, and 40 mph. 20mph is worse even in the front end.
View 7 RepliesI have this problem about 3 weeks ago,when i start the engine i have sound dont know how to describe it but something like tik tik mostly come from crank pully it is not so loud and disappear after few minutes from 5 to 10 min . and if i turn off the engine and start it again does not appear only if kept turned off several hours.
View 12 Replies1993 Transport 3.8 L
Starting out from stop it seemed to get noisy and was very late shifting to 2nd. Slowed down and tried again; this time it did not want to shift to 2nd at all. Brought it home slowly.
Trans fluid was right up. I did another road test, running it manually through the gears so I could easily hear and feels the shifting. 1-2-D-OD perfect; did this twice of thrice. Starting out from stop on the highway a couple times, it shifted up perfectly. I did some kick-downs and manual shifting; everything is working fine.
Could this have been a linkage problem? Could running it manually through all the gears smarted up the linkage or something? Could it be related to the 'modulator valve'?
Why my '01 Passport will not start? Was driving down the road and it just shut down on me. It cranks but will not fire. Replaced timing belt, fuel pump, and now ECM still not luck. I know it's getting fuel to the rail but no spark!
View 1 RepliesThe Rodeo runs great, looks great, and very clean, EXCEPT when I start to accelerate from stop lights, or just before it stops, it bumps, knocks or jerks a little. Feels like the noise is coming from the rear end. what is causing this noise and how to correct the problem?
View 2 RepliesHow many bolts actually holding the intake manifold onto the heads. Are there more inside the plenium when you take the top off or can you remove the unit as one piece to replace the intake manifold gaskets?
View 1 RepliesJust started two days ago... My '01 Rodeo stutters and then the Check Trans and Cruise Control Lights come on and go out about 10 seconds later.
It seems like it only happens when at lower speeds between 10-30 Mph and when first starting out on a drive.
Vehicle Info : 2001 Isuzu Rodeo V6 3.2L Automatic 2WD with 108k Miles
I have a standard 2001 model VW Golf 1.6L automatic. For the size of the engine it has it is pretty noisy.
View 8 RepliesMy 05 beta 2 (CVVT) lifters are a bit noisy. On startup its a bit loud but quiets down after it warms up, but its still there. Kinda sounds like it needs a valve adjustment. Not sure if there is another way around the noise. Like a full synthetic or a heavier weight oil?
View 2 RepliesHow to replace this bad flex pipe....
View 25 RepliesJust replaced the drive belt on my 2001 Toyota Echo, 100k, AC. First replacement as far as I can remember - don't know if a shop ever did it in the past, but doubt it, and did this change myself. I opted to replace because,
1) it seemed about time, and
2) I was getting some belt screech before the engine warmed when it was cold and damp out.
But, now I have an even worse screech. I've only noticed it happening at night (alternator resistance from the headlamps?), when it's cold and there's dew on the windows. It's intermittent, but increases in volume under load (initial acceleration from stop, or downshift to engine brake). I thought it was connected to the dash fan being on, but apparently not, as the sound is present (again, only on cool, damp, nights) when the fan is off, both AC on and off.
One last detail - I may have a bit too much tension on the belt. In this car the tension comes from pulling the alternator away from the engine, and I had a hard time getting a good reading on my tension indicator. I'm likely at the high end of the recommended tension but may be exceeding that to some extent.
My 2002 Elantra Gls 1.8 got some weird sound coming from all 4 corners of the wheel... Recently I had replaced the front wheel bearing as the car goes very noisy when come into corners... But there still some knock... knock... sound after the car warming up especially from rear wheel.
I replaced all 4 absorbers 1 year ago as well as the tie-rods end... Still facing the same problems, the mechanic also don't know where to start...
What should I replace to settle the problem??? All the rubber bush??? Recently mileage on my car is 190000miles.
Just bought myself a nice low mileage 05 Elantra. Every time I start the car with the temp control at max & the direction knob turned to windshield or windshield/cabin, the green a/c light glows & my compressor starts. I have to click the button off every time. The car came with no owners manual.
View 1 RepliesI have 2001 Toyota Corolla which has 100k plus miles on it. I have recurrence problem with car not starting. After i jump start, it works. I took it to mechanic to get its battery(2 year old) and alternator checked out. The mechanic looked at it, and told me everything is working just fine. He started it and i was able to start it. Problem solved for a couple of weeks.
However, yesterday getting out from work, It came back. Had to jump start and make it work again. is there something i am not doing correctly?
I have a 2001 Pontiac Grand Am se that was overheating and I found out that it had a blown headgasket and the fuel pump was going out. So I changed the head gasket and fuel pump. After all that I proceeded to start it but all it did was crank and not start. I did Research on the passlock and bypassed it and the security light stopped blinking and went away but all it did was crank and not start. Could the timing be off and cause it not to start? It gets correct ammout of fuel and correct compression? Also the timing chain is loose enough for me to jiggle it.
View 8 Replies