Rodeo :: 2000 - MIL Light Keeps Illuminating With Code P0401 Low EGR Flow
Feb 6, 2003
The MIL light on my Rodeo keeps illuminating with code P0401 "Low EGR flow". I had the EGR valve replaced and it ran fine for a while but came back on less than a week later. It was then found to have a leaking intake manifold gasket (which was still covered by warranty) but the code still came back on less than 24 hours later. This has been going on for about 2 weeks and no one around here seems to know why. What else would cause this code to be returned?
View 14 Replies
Advertisement
I recently purchased a 2000 Accord coupe v6 with 180k on the clock. I've noticed the gas mileage isn't what it should be. The check engine light was on when I bought it turns out it was a p0401 code. I was told at the dealership insufficient egr flow would cause the car to run rich. So I figured that's what is killing my gas mileage. Well after cleaning the egr port, replacing the egr valve, changing the spark plugs and changing the oil there is no improvement.
View 7 Replies
My '96 4L developed the infamous P0401 insufficient EGR gas flow code 6 months ago. Rough running. Forgot to license it, now the St. Emissions Test was due before I could get new tabs issued. Finally got some warm dry weather to work on it. Started with the electrical measurements per DPFE graph of EGR flow vs electrical output to the PCM.
Showed the DPFE sensor failed, low V output max 2v. The old OEM aluminum body DPFE sensor was still in the old girl after 16 years. Corroded internally and ext., one hose nipple almost corroded off. Eureka. Put in a new Motorcraft plastic body upgrade. Same darn code.
Retested everything from the EGR vacuum valve that feeds the EGR valve to the new DPFE and then the EGR tube from the exhaust pipe. All tested ok electrically and leak wise. No fresh air leaks in the EGR V or EGR tube.
All pointed to restriction in EGR gas flow when PCM demanded it. Ran small stainless steel wire down the upper EGR tube line nipple to the EGR orifice trying to clear carbon build up, still the same P0401. Poured several cups of paint store acetone down each EGR tube hose with engine off and at 2k rpm to emulsify and dissolve the exhaust carbon out. Engine vacuum sucked the acetone up thru the EGR valve also cleaning it internally.
Let set overnight and took out for test drive. Still P0401. Almost ready to drive the green beast to the crusher of death.
Poured more acetone in the EGR and let set for 2 days prepared for the emissions station test failure then repair at emissions cert. shop with a shop waiver for no effective repair. Decided that the EGR tube or EGR valve were leaking fresh air, rusted and corroded. The end nuts on the tube were rusted away. EGR tube NLA from any source.
Went to the emissions test today and passed flying colors. NO P0401, drove all day on business. Got relicensed.
The old girl runs and drives like a dream, she's actually parked and sleeping in the garage tonight all pretty and shiny with a wash and wax job, got a reprieve from the Jaws of Death
View 5 Replies
I just got a Check Engine light on yesterday. I went to Autozone and got an OBD-II Trouble Code: P0401, Insufficient EGR Flow Insufficient. The Autozone guy showed me an EGR valve for $164 and said it maybe blocked or something. I also checked with a friend who says that as long as the engine is not overheating it should be okay for driving for now.
So the far the car runs just fine, I haven't experienced any issues out of normal. Does the code mean the value need to be replaced?
View 14 Replies
EGR insufficient flow. EGR valve was pretty bad looking seemed a bit sticky when opened so I replaced it along with gasket. Reset the computer but check engine light came back on code p0401 again. I know you can test by pinching the yellow striped hose at the throttle body to see if the solenoid is bad. The engine will stumble a bit when you pinch it closed, or so I am told. However when I pinch the hose, nothing happens. I do notice that the car does idle kind of roughly.
View 1 Replies
My 2001 F-150 came up with this code and I changed the EGR valve cleared the code and it returned 15 miles later. The truck only has 30K miles and the warranty expired 24 May.
View 14 Replies
Dreaded insufficient EGR flow. I've read I should clean the EGR ports.
I can't really find where these are? I took the throttle body off.
What I should do with this thing? I also get a hesitation on initial take off.
1999 F150 4.2 V6 ... 160k miles on it. Runs good otherwise.
View 14 Replies
Has a P0401 code EGR unSufficient flow. Ive read several things that it could be, from a DPFE sensor to the EGR valve it's self our that the port going into the TB could be plugged. Truck drives fine does not have a miss or anything noticeable when driving other than the CEL, trucks a 4.6 with 200k on it. Forgot to mention it sometimes gets a P0455 code but i assumed that is gas cap. or could it be related?
View 7 Replies
I have a 2000 Ford Ranger 3.0L engine, 2 wheel drive, with automatic transmission. Check engine light came on about 3 months ago. checked with scanner and P0401 EGR flow insufficient came up. cleared it and it came back. truck seems to be running fine. I didn't take autoshop as a kid, so i probably will need a little hand holding on this one.
View 14 Replies
I am preparing to combat the old P0401, Insufficient flow issue. While looking at the steps in Alldatadiy the very first decision essentially forks on "EGR System Module" or "Others".
I am just guessing that, since the choice is there, some engines will have one and some will have the other. But I thought I'd come here and see if I could learn a little more about it.
How can I tell what my truck has? I'm sure there is some difference...
View 1 Replies
The truck in question is a 2004 6.0L Excursion, stock original turbo, no tunes, and EGR cooler delete done 1 year ago. Scanned for codes and none were found except for EGR insufficient flow P0401 code which is due to the EGR cooler delete.
Upon startup (no issues there) the VGT reads 67-70, now once the truck goes to high idle to warm up (1150 or so RPM) the VGT slowing climbs to 85 and stays there. If I blimp the throttle or step on the brake it goes back to 67-70 at normal idle. This has been happening for a few months now on a regular basis. I have checked the MAP, BARO, and EBP readings at KOEO and they are all within 0.6 of each other (14.4-15.0). The EBP tube was checked and cleaned (no buildup present)..
View 4 Replies
I've researched the heck out of P0401.... I have an 04' F250 w/a 6.0, 61k miles, completely stock. I have been getting a reoccurring P0401 EGR flow CEL. I've checked all the fittings and tubes and see no cracks or breaks. I've checked the exhaust system and no signs of leaking soot anywhere except on the passenger side exhaust manifold, there is some minor deposits of soot near the first two cylinders, but that's it.
Everything else looks good and I can't hear any hissing either. I am not getting any white smoke from the exhaust. I pulled my EGR valve and looked at it, it looked fine. I cleaned it off and put it back in. Then I got a new one just to see if that fixed it. I am missing a little coolant. I'm adding maybe a few cups of coolant every few weeks. Truck is always serviced and only repairs was Ford replaced the EGR valve in 2008. When I pull my EGR valve, it is slightly moist in the housing but not wet and no sludge. Again, the EGR valve had a nice layer of soot, no build up or sludge on it....
View 1 Replies
2000 Amigo 3.2L V6.
My check engine light came on, and I went to autozone to get the code read. The code was P0446, "a malfunction in the electrical circuit for the vent control in the evap emission control system." I was wondering if this could be a simple fix...would cleaning the EGR valve do anything to get rid of this? Maybe this could work, but before the light came on, the amigo was taking awhile to start up (usually 4 cranks, with me pressing on the gas). And oh yeah, the check engine light didn't pop up until after I let the car sit for 12 days, while I was on vacation.
I also have a side problem...when I turned on my car for the first time after my vacation, besides the check engine light popping up for the first time, my ABS light also came on. I've tried the whole turning off, turning on the car and driving real slow process, but the light remains on. It just seems really interesting that both lights came on right after my car was sitting for awhile.
I'm thinking about taking the amigo to the dealership to get it checked out.
View 7 Replies
I have a 2000 Ranger 2.5l, 4 cyl. Not long after the truck was purchased, there was a recall for the EGR valve, we took it in had that replaced, no issues. Well 2 years ago we had the P0401 code pop up, we replaced the DPFE and it seemed to fix things. Well a couple of weeks ago the code popped up again, we erased it and it came back a week or 2 later, along with the truck shuddering when the engine is cold. My husband said once the engine warms up the shuddering goes away. To make it more complicated it doesn't always shudder like that, seems to be intermittent. What could cause this problem? Does it sound like the DPFE again? Or something else we are missing?
View 5 Replies
I've read many threads in here, but I didn't find problem of my car. It's Toyota Prius-3 2010, check engine light on and code is P0401. EGR Valve works well, I cleaned pipe, gasket, cleaned throttle plate and everything but nothing works.
I have (light on) it maybe 1 year or more, the light goes away and come back,I'm in Los Angeles and all they time is sunny day and weather is nice, I've seen 3 times, when i drove in rain evening and morning I didn't see light on.. then, couple days and comes again. I think maybe EGR cooler has to be replace? or I do not know why in cold weather time light goes away..
View 19 Replies
I have a Toyota Prius (2010), and the car has run for about 2800000 kilometers. One day when a was driving my Prius the engine light suddenly get on. So I went to a car car mechanic, he checked the car and told me there was an error code (error code: P0401, exhaust problem (exhaust recirculation flow).
So I bought a liquid that I put in the gas tank, the liquid would clean the exhaust pipe, but the engine light was still on. The engine light is usually on at least 2 weeks, then disappear for about 2 days and come back in two weeks…The car is driving normally without any problems.
View 2 Replies
I am hearing a water flow sound under the right side of the dash when I turn corners or stop. It started when the radiator cracked. I have replaced the radiator and water pump. I have filled the radiator with the front of the SUV up and the engine running. Also tried jacking the rear of the SUV up. I have flushed the heater core. And re connected the hoses bleed air at the top of the hoses from the heater core, the return from the water pump to the radiator, and at the radiator to the water pump. Yesterday I pulled the dash out and found the heater core to be more center of the dash behind the climate control. The sound seems to be coming from more right behind the glove box. Any suggestions before I reassemble the dash. I have removed and cleaned the lower half of the ac coil/condenser box. There was no fluid in it and the drain line was not plugged.
View 17 Replies
My camry 2000 recently the engine light's on and the codes are P0446 and P0401
P0401:The PCM has determined that there is insufficient flow in the exhaust gas recirculation system.
P0446: The PCM has determined that a malfunction exits in the electrical circuit fo the vent control in the evaporative emission control system.
View 14 Replies
I have a new to me 07 MDX with 82k miles. Exactly at 1 mile over the 30day/1200 mile used car warranty the Check Engine Light illuminated along. The NAV screen showed an emissions code P0401. I really don't notice any symptoms in running at all. Anyway a few drives (on/off) and it turns off for four days. It happened again with same code. Again few drives it went off. It seems to happen when driving easy. It gets great MPG in mixed driving on average (20MPG) which is far better than its rating. Should I wait till it stays on steady before I address this?
View 3 Replies
I just picked up a 2011 Ford F350 about 8 months ago. I have had troubles with the check engine light coming and going. Now it's been on for good with loss of power. I have had the codes read and they came up as the p0401 and a code about the def heater. I can not remember that code off the top of my head. After some searching I have found a video about the def heater but nothing about the Egr cooler/valve. Is there anything out there about how to clean and remove the the cooler as I will be needing to do repairs myself as the truck has no warranty.
View 10 Replies
1996 izusu rodeo had check engine light on got code for egr valve. Replaced it light when out drove fine all day. Stopped at grocery store came back out would not start ... Will crank over but will not start. did a obg (two) scan get a p1640 output A circuit fault code along with a 1460 egr code ....
View 5 Replies
