I have a 1997 Ram 1500 when I apply the brakes the truck pulls to the left for a spit second then goes straight.
Example: doing about 40 MPH take hands off the wheel and slam on the brakes, truck pulls immediately to left, like I did a quick lane change then goes straight.
About a month ago I replaced a section of brake line going to left rear wheel.
02-F150-4.2L-102k. Truck was rolling down the road at approx. 35 to 40 mph. A speed bump/table appeared out of nowhere and was hit before beeing seen. Immediately since this event, the truck pulls to the left while applying the brakes. It pulls very hard and is fine while rolling down the road. Is there some damaged steering component or did one of the calipers go out from the jolt?
View 4 RepliesJust replaced break pads and rotors. Inner pad on left side was gone leading me to believe slides were not working properly. Pulled apart, cleaned and greased everything, and replaced pads and rotors. Calipers seem to be working fine. Now when I break hard, the truck pulls badly to the left. When I break softly, it seeks normal. My front end is a bit out of whack and veers just a bit to the left. Do you think this is my issue with the breaking ? I'm getting new tires and an alignment soon but was just curious.
View 3 RepliesMy 2003 F250 6.0 pulls to the right when driving at any speed. In order to keep it going straight the steering wheel must be slightly tilted to the left, not much but a little. When the brakes are applied hard it will go to the left slightly if you are not holding the wheel good. Neither of these are terrible, just a nuisance. I'm worried about uneven tire wear too. One front wheel bearing was replaced a few weeks ago. It had this problem before that and still does after. Does this sound like an alignment or maybe something more?
View 13 RepliesI recently took delivery of a new 2012 F250. It was a cab chassis, we had a utility bed and lift gate installed from the upfitter along with heavy rear springs. From day one the truck would pull left when the brakes were applied. The brake pedal also feels mushy, not firm. It will firm up when I pump it. I could also smell burning around the left front of the truck when I would get out of the cab. Hot brake smell. Took it to the dealer with only 400 miles on it and they replaced the front pads and turned the rotors, and gave it back. In relatively few miles the problem was right back again.
Took it back to the same dealer last week with 1200 miles on it now. This time they say they replaced the rotors. I went and picked it up it this morning. Within 5 miles drive of the dealership I can tell the brakes are still bad. Now, it will kind of do a "head fake" when the brakes are applied, pulling slightly left or right, before deciding which way it wants to pull. It will pull right or left now during firm braking. And the brakes were stinking by the time I had it back to them. I turned around and took it right back to them again. Brand new F250?
2011 Ford Taurus with 4000 miles. Car, at times, will pull to one side when brakes applied. Dealer could find nothing wrong first time(no cost). Second time they found that the "rear pads stuck in brackets on both sides. removed calipers brackets and pads and did full clean and reassembled". Third time road test found "no pull". "checked on ramp, all brakes seem fine, all free and moving properly. No problem found.". Road test with technician found slight vibration in steering wheel when braking but no pull. Technician says an uneven or slanting street could cause car to pull. Never heard of this before (my other car is fine on the same roads & streets). Is this a possibility as a cause of my problem?
View 17 RepliesWell just called it quits from working on the truck tonight. Had some issues with my brakes going to the floor and pulling to the right some, so I went to auto zone and bought all new pads. Didn't think it was time yet because I just replaced the rotors, pads, calipers, maybe 20,000 miles ago. When I got home and everything pulled apart I looked at the pads on the truck and they still had 60% life. I looked closely and noticed that the guider pins on the caliper bracket (front drivers side) were seized. I figured this is what was causing my truck to pull. Looked on the passenger side and it looked similar. Went back to auto zone and returned the pads and bought new brackets for both sides. I got the drivers side replaced and working and all seemed well. I got to the passenger and had a hell of a time getting the pistons on the caliper to compress so I could get it off. Once I finally got it, I noticed the pins on that side were not seized. I bought 2 sets of guider pins so I took the old ones out and greased up the new ones and installed them. Put everything back together and took the truck for a drive. Everything seemed normal at first, but once I got on the highway and hit the brakes, my truck pulled to the left. HARD.. Im assuming this is because of the pistons on the passenger side caliper I was having a problem with, not having the piston compress all the way causing my truck to pull. While I was looking at the caliper, I also noticed what '"looked" like a grease fitting, and also a bleeder valve a few inches away from it. Am I crazy, or is that fitting for bleeding the brake lines also...?
View 5 RepliesI have a pedal pulsation, steering wheel shimmy, and pull to the right when the brakes are applied in my truck. It is a 2009 F250 4x4 gas V8. I just replaced the pads, rotors, and calipers on the front and that's when the problem started. It definitely gets worse with speed too. I replaced the calipers because the right one had seized up and the left one looked to be on the way. There are no odd noises and the wheel bearing doesn't feel like there is any play in it. What this could be?
View 1 RepliesSo I've been noticing the truck pulls left when under braking. So, I replaced the front calipers. Now, it still pulls left. When I got home I felt the discs on all corners and found three about the same, barely touchable, and the front left a little warmer. So, it seems its braking more, but its brand new. So, what should I do? They are also pulsing a little.
View 14 RepliesTruck pulls to the left while braking, pretty bad. So, pulled the front right wheel off thinking the pins are stuck again as last year. Bottom pin was fine, top pin pretty gummed up but not froze so I cleaned it up good, used thin layer of the good stuff, put back together and test drove........same thing. Pulls left upon braking just as bad as before. Caliper pistons seemed fine, didn't take much to compress them either. Would a right rear cause this?
View 14 RepliesMy 2012 f350 6 lift when I push the brakes it pulls to the left kinda bad and the steering wheel is off to the right..
View 4 RepliesAfter a brake job (rotors & calipers) on my '97 Saturn SW2, the car started pulling severely to the left. The mechanic re-aligned it; checked all the hardware, tire pressure etc & pronounced it fit. The pulling is still present, though not nearly as severe. The pulling has also become intermittent: it'll go for miles tracking straight as an arrow; then start pulling to the left. By the way it does not pull when I brake, & there does not seem to be any undo front tire wear. My mechanic states that he cannot find anything the could be causing this.
View 5 RepliesI have started hearing a noise with my brakes. First thing in the morning when I back up and apply the brakes, I get a clunk or pop noise from the left front wheel. It will pop again once I move forward and hit the brakes. It only does the noise one time when I first apply the brakes in either direction. Once the brakes have been used out on the road and are warm, there is no noise when changing directions. I've had this noise in another car I used to have and it was caused by the aftermarket brake pads not being exactly large enough and there was slight pad shifting in the caliper. Being this is a new car and has the OEM pads, I would hope there would be no pad shifting or movement in the calipers.
View 17 RepliesWell, I tried this Death Wobble Kit on my Ford F350 Super Duty from a company called WC Motorsports. Had it installed at a Ford Dealership. DO NOT BUY this kit. Missing parts right out of the box. Also makes a horrible clanking noise after install. Piece of junk. Possible fix to one problem only to have multiple other problems:
1. Clanking Noise
2. Truck pulls to the left
3. Have to cut the factory subframe. (Never a good idea)
4. Changes the degree (not recommended by Ford)
2001 Ex 7.3 4x4 with 4" lift (6" with 37" Pro Comp tires)
All new front end steering components.
All new Shocks (bilstein)
All tires properly inflated to same PSI
All new brake rotors, calipers, caliper mounts, and pads.
When under hard acceleration the vehicle pulls to the left and I have to compensate by steering to the right. Under deceleration the vehicle pulls to the right and I have to compensate by steering to the left.
I am about to change all four brake lines to Braided Stainless Steel lines, replace all leaf spring bushings with polyurethane, and install a rear anti-sway bar. I'm going through this methodically enough or am I just building a brand new truck one part at a time?
Going down a steep loose gravel drive way, going maybe 5 miles per hour. About 50 feet before the stop sign we lightly applied the brakes and the front right wheel completely locked up. If we didn't turn into the grass we would of stopped in the middle of the busy street. We picked up speed when we applied the brakes, like we were on ice. When I got out, I could see the one long brake mark in the driveway. This happened on a paved road about 6 months ago, it had some loose gravel at the stop sign. I couldn't tell which wheel locked up at the time. This happened on snow in December to, twice. Since the ABS light never came on. Brake pads and rotors needed replacing about 9 months ago. Tires have been rotated, no change. Not sure what it could be. I disconnected the Abs fuse for now.
View 5 RepliesI have a 2001 f150 4x4 5.4 Liter 72000 miles. There is a rubbing sound that is only audible when the brakes are applied. And only when applied with light pressure. The noise will continue intermittently until you come to a complete stop. If the brake is applied aggressively there is no sound at all. I am not sure if it is a brake issue or some thing in the front end that is flexing when slowing down.
View 3 RepliesI have a 1996 Ram with the V10 that only has 10,000 miles since it was replaced by Dodge. 7 years has passed since that shortblock warranty job. It now has a tick/knock that I cant seem to locate? I changed the lifters and one push rod since is was a little bent and put it all back together. Still getting the same thing - nothing has changed ...
View 13 RepliesAfter putting my Ford Ranger in park and pressing down on the E-break to get the news-paper or mail. I've noticed that there is a consistent squeaking coming from the back drum brakes when the brake pedal is applied. But only for a certain period of time; then the squeaking stops.
View 8 RepliesI have a 2001 f-150 the brakes are sticking and I get a bad shake which seems to come from the front and rear of the vehicle. It doesn't do it all the time but when it does it slowly gets worse. I have replaced 3 of the 4 calipers and will be replacing the forth, but not much is changing.
View 9 RepliesI put on a new set of tires (X Radial) at Sams Club with installation plan which includes balancing. I also brought the car to the dealer to have alignment (front I guess) done. The car goes a straight line no matter what except it always pulls left if I release the steering wheel when I brake from a high speed.
View 7 Replies