Prius V :: WebElectric DRL-2P Installation Into 2012?
Jun 8, 2013
I will be "building" and correcting the attached document as I install a WebElectric DRL-2P kit into a 2012 Prius v Five with the Advanced Technology Package. I will add photos and describe the colors of the Prius v wiring harness wires to which I connect the DRL-2P kit as I determine them with a test light.
I am NOT a professional but I have done many automotive projects in my almost 50 years of driving ... engine rebuilds, audio and phone systems, Euro headlights with and without washers, front and rear fog lights, horn mods and on and on.
This looks like an easy project - maybe a "3" on my "1 to 10 difficulty scale" - with the most difficult part being crawling under the car to remove panels and to make the connections with the turn signals ... not fun as I get older. This project should be substantially easier than the install of Scion IQ signal mirror covers on this same car which I documented on this forum and which was perhaps a "6" on my difficulty scale.
View 19 Replies
Advertisement
Like most of PIPPOS (plug in Prius pre orderers) I have been planning this install for a while. I am glad it was so simple and came in under budget.
Charging transformer attached to wall with velcro command strips so can be removed if needed. Next to that (closest to car plug) is a plastic garden hose hanger I picked up at lowest.
I am perfectly pleased with how quick and easy this install was and how perfectly it works for the car.
View 15 Replies
Installion of hitch and trailer wiring on a 2015 PIP?
I found ZERO posts about installing a Curt 11276 hitch on a 2015 PIP. Or installing ANY OTHER hitch on a 2015 PIP.
Same applies to adding wiring for towing a trailer behind a 2015 PIP.
View 4 Replies
I recently purchased a Rear Bumper Protector for 2010-2014 Toyota Prius for my 2014 PIP. I thought I had it in the correct position when I removed the adhesive strips to install it but realized the next day that the curvature is not lined up properly causing a gap in between the bumper and the protector. My stomach sank when I realized this error.
View 8 Replies
I just bought HID for my fog lights. I was looking all over the internet for how to install them, but i couldn't find any. I have a 2013 Camry SE. It came with stock fog lights. Also there is a lip cover on the bottom of my bumper. I was wondering how to install HID fog lights successfully?
View 4 Replies
Who has installed the OEM Qi charger into their 2015 XLE yet? My phone has it, so I am looking to do this when I can find the parts.
View 14 Replies
From the past couple of days i've been trying to google but nothing. I want to install an amp and sub in my camry I have never done it before so I can run the power and remote wire . My question is how to connect / run the RCA wires.
View 9 Replies
I have a 2012 Corolla S and I'm trying to install footwell LED lights that are wired to the dome light, which wires do I need to tap in order to make this happen and how do I tap them correctly/safely?
View 2 Replies
I have a 2012 Camry SE. I want to get the navigation in my car. Anything specific I need to be aware of to get the Entune stereo with navigation?
View 2 Replies
I installed a DDM HID Kit for about two weeks week this morning the passenger side didn't come on. I have to turn off the light and turn it back on for the passenger side to come on and went it did it was slowly turning on took like 15 second to fully turn on. I have a relay harness. Do I have a bad bulb or a ballast should i try switching the bulbs?
View 9 Replies
How to install the Toyota Intuitive Parking Assist system in a US 2015 Camry XLE? Apparently, this system is sold with the 2015 Camrys elsewhere (I checked in TIS, and it is included in the 2015 Camry service manual), but not in the US.
I would dearly love to have this system in my car, because I find it difficult to judge how close I am in front to another car or other obstacle.
View 1 Replies
I have a 2012 corolla le and I'm looking into getting TRD lowering springs as I don't want to go too low and they work with the stock strut, however; I read that they work best with the XRS' shock and strut (might be just the strut but I'm not sure), my question is what are the XRS' struts called and where would I find them, also from what year would the XRS' struts fit on my le?
View 3 Replies
Installing some fog light HID's and was wondering how to remove the front bumper.
View 7 Replies
I have a 2012 F350 CCLB with camper package (front coil springs @ 6,000 lbs). I was thinking of installing F550 coils springs, which are rated at 7,000 lbs, to provide greater lift up front.
Before performing this modification, what lift was achieved up front?
My endeavor is not to achieve level, per se, but rather allow for increased tire size, such as 35's and ground clearance.
View 9 Replies
We just purchased a new 2012 F 350. Love it, however when shoping forgot about getting one with a step. Have found step and handle available (OEM) but need to know how hard/easy to install it on our current tailgate. I gather from another post the handle part is easy but what about the step itself?
View 2 Replies
Installing the Hellwig 1 1/4 inch Front Sway Bar on their 11 and up F250 or F350 SRW Pickup?
My 2012 F350 Super Cab LWB XLT 6.7L seems to have quite a bit of sway in the front end. This is especially true moving slowly such as turning into service stations or other off angle turns. The truck only has the FORD OEM puny Rear Anti Sway Bar but the front seems to accentuate sway. The Truck has Rancho 9000XL Shocks, Timbren Enhanced Suspension System as well as Torklift Quick Release Stable Loads in the rear.
The Truck I have is not overloaded but it does carry an Eagle Cap 950 Camper pretty much full time. True the Campers now days are tall so some sway is expected. I just want to reduce the apparent front end sway and wonder if others have used the Hellwig Sway Bar in the front.
View 1 Replies
I am installing a set on a '12 F350 for a customer. I already had to go buy an additional hardware in order to get the back bumper on correctly...and now I'm looking at the front bumper and I swear I don't have the parts I need to install it. It appears to be missing some brackets. There were NO instructions with them (apparently a chronic problem with Road Armor) and I can't possibly imagine it bolting to the flimsy brackets that hold the factory bumper (fairing would be a better word for it) in place.
View 6 Replies
I have a 2012 SD Reg cab 350XLT, I am installing the premium sound tweeters on the door pillar. Looking for the diagram for the big plug that connects all the door stuff to the truck body? I need to find the tweeter wires, or figure out another way to jump the gap from the door to the body.
View 1 Replies
Trying to install LED Light Bar on Prius?
View 6 Replies
The only other related post i could find was done in 2004. I am looking for information to install a 2-meter/440 rig in a Prius III? Also type and location of the antenna?
View 5 Replies
I ordered a complete ( almost) set of LED'S from iJDMtoy.
View 15 Replies
