I'm trying to replace the spark plugs of my 2006 Prius, but the deep well 5/8 socket attached to a 2 in extender just turns loose, as if it does not fit in the top of the spark plug. I tried also 3/4 and 13/16 but those don't even fit in the spark plug well. I tried in another spark plug to the same result. Problem to replace to spark plugs?
View 7 Repliesi just purchased an '01 expedition with the 5.4. I was told #5 spark plug blew out. Upon examination, it appears to be #6, second from the front driver side. Anyway, as I was looking, it just didn't look right. There was a spark plug socket stuck in the well, with the plug still in place. How to get the socket out? I can get an extension on it and it will turn, but it's tight. But I can't pull the socket out.
View 9 RepliesHave a 2005 F350 4x4 SRW 5.4L with roughly 90k miles and I am replacing the original plugs. Broke three out of seven which was expected and have them replaced. You probably noticed I wrote 7 plugs above. The 8th plug which happens to be the #8 plug is giving me fits. I can't get a socket on it. The socket spins smoothly by hand with no ratchet over the plug but no upward movement. I cleaned the base of the hole thinking it might have some debris preventing it from hitting bottom. From what I can see after cleaning and blowing it out, the base of the hole is clean and there plug appears to have something for the socket grab onto. Out of curiosity, I have tried smaller and larger sockets in both 6 and 12 point with no luck. Is it possible the plug was set too deep in the head from the factory?
View 13 RepliesI had the oil changed 2/27/11 drove it home parked it for the night next morning I went out to start it I heard loud clunk. I opened the hood and found a spark plug laying on the head seperate from the spark plug wire. What would make this happen? I have not had the sparks plug changed recently.190,000+ miles.
View 10 RepliesI took a long trip this last weekend and before the return trip I checked the oil and realized I need some. I put two quarts which brought the level just about even with the top mark on the dipstick. the return trip was fine. Next morning I started the car and right away notice that the engine was misfiring. I checked the spark plugs and noticed that one of them was loose and had some oil in it. I checked the oil and now it showed the level to be well above the top mark on the dipstick. Could too much oil cause the spark plug to get dirty, get loose and misfire? This car is a 1997 and has 206,000 miles. This is the first time this has happened. Could the same thing happend with a 1999 Honda Civic?
View 10 RepliesI have a 02 F250 with 137 thousand miles. When it had 130 thousand on it I had the plugs changed unknowing that this year 5.4 was known for blowing the plugs.
View 14 Repliesis there a diffrent spark plug socket too take out the plugs on the 5.4 3v motor cause i tried a socket i thought would work but i wouldn't go in the spark plug hole like what gives
View 4 RepliesMy accent (2001, 1.6L, with 179k miles) has service engine soon light on. Brought it to autozone and they said the upstream O2 sensor needs to be replaced. I borrowed the socket to take out the O2 sensor. It's very difficult even with the tool, because the O2 sensor was stuck with a lot of rust. I used an extension bar to get it out finally, but now when i tried to put the new sensor in, I found the hole's thread is very loose. Tried very hard but can't get the new sensor in securely. It seems I had to replace the whole exhaust manifold. The manifold is very expensive(because it has a build in catalyst converter). I'm wondering is there a way to make the O2 sensor in secure without replacing the whole thing? if I had to replace the manifold then I probably will just get rid of this car.
View 1 RepliesI want to change spark plug, took connector of spark unit and took bolt M6 out, lifted spark unit but not enough clearance to remove the unit in order to use wrench for unscrewing spark plug. How it works?
View 14 RepliesContinuing from this thread which I accidentally posted in the "main" forum.
I had trouble unscrewing the spark plug even though the advertised torque is only 13 ft-lb and the car is only 13K miles 1.5 year old.
I googled "spark plug stuck" and read some posts on line.
Lots of horror stories of broken spark plugs and stripped threads - big $ to repair.
[URL]
Experienced lower mileage after changing the plugs at about 120k miles?
In the 10 months (23.6k miles) since I had the dealer change the plugs, I have averaged 43.3 mpg overall.
So figured out how to put my head unit on my base model PiP into diagnostic mode. I can't disable the reverse beep from this window... is there anything else worthwhile I can do in this mode? Beside accidentally deleting all my destinations that is.
View 12 RepliesI have a 2002 prius that threw a spark plug and loosened the coil pack. The mechanic just reinstalled the plug and tightened the coil pack and said it was fine. Why it would throw a spark plug?? It was running fine, no warning lights, i just heard an unusual slight noise and opened the hood to check it out, and notice the loose coil pack over the first spark plug
View 2 RepliesI have a 2007 Prius with ~180000, which runs great. The mechanic shop I used for oil change suggest me to change spark plug because they are dirty. After the change, I found I cannot step on the gas pedal too hard for acceleration. The car will hesitate, choking or die if I try to accelerate too fast. But if I step on the gas pedal gently, and let it reach the desired speed in a slower way, it has no issue. I went back to the shop and they replaced with another set of 4 plugs, and no improvement. I checked air intake tube and it looks no leak, but really old. Other than that, the car runs great.
View 19 RepliesI have a small problem, the dealer that serviced my car just told me that my water pump was leaking and I was low on coolant. I can't remember when was the last time I checked the coolant level but when the dealer top off the coolant, he nearly used the entire bottle. Needless to say, I believe the radiator was pretty low on coolant.
Now I've never noticed a high temperature warning lamp or ever broken down. Today at 125,000 miles, I went to change my spark plugs. The 1st plug to the far left as you are facing the car has oil in the spark plug. This is freaking me out, could my engine be damaged from the low coolant?
So I was changing my spark plugs and 3 of 4 went smooth. but one of them was very tough to get out. after a little while it came out, but.... porcelain was broken up. looked down the hole and saw some pieces. Vacuumed it up with a small hose. saw the pieces come into the vacuum, but i don't think i got them all.
Started the engine and made a terrible rattle sound. turned it off and researched a bit. one hit was on here from a few years back, saying the car ran rough for a sec and then cleared up. Hoping it was kicked out the exhaust. I started it up let it run and it cleared up and idled smooth.
Drove it today and seems fine. Slight click noise when accelerating but not sure if that was there before or I am just being paranoid now. Called some places and they all said same...could have cleared through exhaust, stuck in catalytic converter, damaged the interior walls etc etc.
Geo Metro loose head bolts... I have a 96 Metro, and for some reason the head bolts loosen by themselves, leading to over heating and planing head ... well you know.I had a farm for 20 years and took care of all equipment myself, have rebuilt numerous motors, but this geo is the first I have seen where the bolts loosen. This is the third time. I know they are tightened right , because I have the tools and experience, but not with this. Other than jb weld in the bolt holes.
View 7 RepliesMy 2004 honda civic hybrid has 8 spark plugs. The ones in the back of the motor look like they get much hotter and both times I have replaced them, all four in the back were really really loose.
View 2 RepliesMy 95 Ranger has been a good truck in the 6 years I've owned it. I had to pull the heads to replace a leaking head gasket and wound up having the heads rebuilt due to weak valve springs and worn valves. I replaced the gaskets, installed the heads, get it all back together.....won't start. Fuel pressure is good. Found that there is no spark. While putting the crankshaft position sensor connector back on I noticed it didn't look too good. I replaced the connector and that's all I did and no spark. Long story short, after a lot of research, the coil pack, cps and coolant temp sensor were replaced and still no spark.
Everything has the proper voltage to it. After a little more research I found a post with the same basic issue. His issue wound up being the ecm. So I removed the ecm....it's a used one from a salvage yard. I've owned the truck 6 years so I have no idea when the ecm was replaced. It showed up today and will get installed when I get home from work. I also ran across posts about the camshaft sunchronizer and they should be replaced at about 80K miles. Since the truck has 289K I'll replace it. Still no spark. I'm hoping it's the ecm.
So yesterday i was installing my new JVC Headunit, after taking ages to take of the dash so i can remove the old radio i plugged in the new one and all the lights and everything worked... Then later after putting the dash back and plugging in the head unit the lights came on for 1 second and then it wwent off. The clock isn't working now, when i plug in the headunit you can hear it starting up but there is no light or anything coming on, and also the side mirror controls don't work... I'm thinking possibly one of the fuses may have blown but i don't have a clue where the fuseboxes are, how to get to them and which one i should be looking at.
View 1 RepliesI have a 1998 Saturn SL1. My problem that I am having is I can start the car maybe once a day if I am lucky. About 2 minutes later it just dies.
The car has full electrical power and I can turn the starter over and fuel pump sounds like its working. I am pretty sure its not sparking.